Multipoint Scanning Alarm System Many gas detection applications require multiple sensing locations to provide adequate area protection for plant personnel. Signals from a variety of field measurement sites are often transmitted to a central location where display and alarming functions are needed. ATI's Series l4 Scan Alarm) Receiver provides a versatile central monitor that can be configured to meet most multipoint gas detection applications. Features Monitors up to 16 analog 4-20 ma inputs from remote transmitters. Provides 24 VD power for up to 16 looppowered toxic gas transmitters or 12 3-wire combustible gas transmitters. Two line alphanumeric LD provides sequential display of each channel and the alarm status for that channel. Display locks on any channel that goes into alarm. Remote alarm reset input. Two programmable alarm setpoints for each analog input plus a trouble alarm for each channel. Six assignable SPDT alarm relays in standard configuration, with expansion for up to 36 total relay outputs. One output relay is factory set for global alarm and one is set for system failure. Battery backup module available to operate the system for up to 30 minutes with the maximum number of combustible gas transmitter inputs (worst case). Standard RS-232/485 serial interface allows all configurations to be set up by computer and alarm events to be automatically monitored by computer. Up to 32 separate monitors can be connected to a single RS-485 communication link. Standard NEMA 4X wall mount enclosure. Optional panel mount configuration.
Multipoint Scanning Alarm System
Series 14 ScanAlarm - General Arrangement Diagram SYSTEM DIAGRAM SERIES 14 ScanAlarm POWER 85-255 VA, 50/60Hz OR 12VD RS232/RS485 RELAY OUTPUTS BATTERY BAKUP MAX. 28 EXTERNAL RELAYS MAXIMUM 16 INPUTS (2 OR 3 ONDUTOR ABLE FOR EAH INPUT) INPUTS MAY BE LOOP-POWERED 4-20mA OR POWERED 4-20mA (SEE PAGE 5&6) OTHER MFG'S TRANSMITTER SERIES B12 2-WIRE TRANSMITTER MODEL B12-17 OMBUSTIBLE GAS TRANSMITTER MODEL A12 UniSens 2-WIRE TRANSMITTER SS-14RA.PM5, DATE: 7/25/97, DRAWN: A.W., APPD: ATI-0261 Page 1 of 10
Series 14 ScanAlarm - Dimensional Diagrams WALL MOUNT VERSION - ENLOSURE DIMENSIONS HINGE HINGE 10.0" 254 mm 9.48" 241 mm 6.68" 170 mm (20) Pg 16 KKOUTS **6.50" 165 mm 7.1" 180 mm (4) Pg 21/29 KKOUTS **.60" 15 mm 21.31" 541 mm **13.62" 346 mm ** MOUNTING DIMENSIONS **9.72" FRONT VIEW 239 mm SIDE VIEW 4.37" 111 mm TES ATI-0247 BOTTOM VIEW (2) Pg 16/21 KKOUTS PANEL MOUNT VERSION - FRONT PANEL STAK 1) Enclosure Ratings: Nema-4X/IP 65 2) Enclosure Material: Polystyrene base and cover, hinged transparent door with push-release latch. 3) Knockouts: Pg 16 (.90" dia.) Pg 21 (1.15" dia.) Pg 29 (1.50" dia.) GLOBAL ALARM A SYSTEM FAULT B A FAIL 1 2 3 4 ATI-0255 Page 2 of 10
Series 14 ScanAlarm - Dimensional Diagrams - Panel Mount Version PANEL UTOUT - FRONT PANEL STAK 9.14" 232 mm 4.57" 116 mm 8.94" 227 mm 4.47" 114 mm (6).166" DIA. UTOUT 3.43"O.. 87 mm 3.08"O.. 78 mm ATI-0254 POWER SUPPLY / I/O PB ON SUB-PANEL 13.0" 330 mm 11.24" 286 mm TE: THIS ASSEMBLY IS SUPPLIED. (4) 3/8" DIA. MOUNTING HOLES HARDWARE IS USTOMER SUPPLIED 21.0" 533 mm 19.24" 489 mm ATI-0257 Page 3 of 10
Series 14 ScanAlarm - System Wiring GENERAL USTOMER ONNETIONS ATI-0248 Page 4 of 10
Series 14 ScanAlarm - System Wiring A12 UniSens 2-WIRE TRANSMITTER INTERONNETIONS 14 ScanAlarm I/O PB TB5 HANNEL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 +24 SIG GND DRAIN OR SHIELD IF USED TB1 SHIELD 2 OND. 20 AWG UNSHIELDED OR SHIELDED ABLE, 5000 FT. MAX ( POLARITY REQUIREMENT) EARTH GROUND (OR ONDUIT) LOOP POWER STOP DRAIN AT ASE WALL (IF USED), DO T EXTEND DRAIN OR SHIELD INTO ASE WALL GND TERMINAL LOATED NEXT TO RELAY BASE GROUND TERMINAL SENSING MODULE AUTO-TEST OPTION ATI-0256 SERIES B12 2-WIRE TRANSMITTER INTERONNETIONS 14 ScanAlarm I/O PB TB5 HANNEL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 +24 SIG GND DRAIN OR SHIELD IF USED TB1 SHIELD B12 SENSOR/TRANSMITTER (TYP. WIRING OF 2-WIRE LOOP POWERED INPUT) 2 OND. 20 AWG UNSHIELDED OR SHIELDED ABLE, 5000 FT. MAX ( POLARITY REQUIREMENT) STOP DRAIN AT ASE WALL (IF USED), DO T EXTEND DRAIN OR SHIELD INTO ASE WALL REEIVER ONNETION ( POLARITY REQUIREMENT) ATI-0249 Page 5 of 10
Series 14 ScanAlarm - System Wiring B12-17 OMBUSTIBLE TRANSMITTER INTERONNETIONS 14 ScanAlarm I/O PB SHIELD POWERED 4-20mA INPUT TRANSMITTER INTERONNETIONS TB5 TB5 HANNEL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 +24 SIG TB1 GND DRAIN OR SHIELD IF USED 3 OND. SHIELDED ABLE B12-17 OMBUSTIBLE GAS SENSOR/TRANSMITTER (TYP. WIRING OF 3-WIRE INPUT) OMBUSTIBLE SENSOR ATI-0251 14 ScanAlarm I/O PB HANNEL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 +24 SIG GND TB1 SHIELD DRAIN OR SHIELD IF USED 2 OND. 20 AWG UNSHIELDED OR SHIELDED POWERED 4-20mA OUTPUT TRANSMITTER (SUPPLIED BY OTHERS) ATI-0250 Page 6 of 10
Series 14 ScanAlarm - Relay Module Option 2 RELAY MODULE, ENLOSURE DIMENSIONS FRONT VIEW SIDE VIEW 7.09" 180 mm 6.50" 165 mm MOUNTING DIMENSIONS 10.0" 254 mm 4.37" 111 mm TES 80-0040R 9.41" 239 mm MOUNTING DIMENSIONS BOTTOM VIEW KKOUTS 1) Enclosure Ratings: Nema-4X/IP 65 2) Enclosure Material: Polystyrene base and cover 3) Knockouts: Pg 16 (.90" dia.) Pg 21 (1.15" dia.) Pg 29 (1.50" dia.) 4) Enclosure may be close coupled to ScanAlarm enclosure using bulkhead fit ting supplied with relay module enclosure. Page 7 of 10
Series 14 ScanAlarm - Relay Module Option 4 RELAY MODULE, ENLOSURE DIMENSIONS FRONT VIEW SIDE VIEW 14.21" 361 mm 13.62" 346 mm MOUNTING DIMENSIONS 9.72" 239 mm MOUNTING DIMENSIONS 4.37" 111 mm 10.0" 254 mm KKOUTS 80-0036R BOTTOM VIEW TES 1) Enclosure Ratings: Nema-4X/IP 65 2) Enclosure Material: Polystyrene base and cover 3) Knockouts: Pg 16 (.90" dia.) Pg 21 (1.15" dia.) Pg 29 (1.50" dia.) 4) Enclosure may be close coupled to ScanAlarm enclosure using bulkhead fit ting supplied with relay module enclo sure. Page 8 of 10
Series 14 ScanAlarm - Relay Module Option ScanAlarm / RELAY MODULE WIRING DIAGRAM ATI-0271 Page 9 of 10
Series 14 ScanAlarm - Relay Module Option RELAY MODULE WIRING DIAGRAM 8 RELAY EXPANSION MODULE N TB1 N TB2 N TO DESIRED I/O PB TB4 (-) TERMINAL TO ANY I/O PB TB4 (+) TERMINAL 1 2 3 4 5 6 7 8 + TB9 N N TB3 TB4 TB5 N TB6 N TB7 N TB8 ATI-0273 Page 10 of 10