Gas and flame detection Stack gas and dust analysis Portable gas detectors Measurement and alarm units Detectors/transmitters Stack gas and dust analysers Accessories Gas detection / Stack gas monitoring
Portable gas detectors Protecting people Explosimeters For explosive gas detection, with various models featuring content display, catharometer function, or discrimination between natural gas and other explosive gases. EX 2000 C EX 2000 GDP 2000 GD 2000 NEW Infrared toximeter C 2000 CO 2 DETECTION Measures CO 2 using the infrared cell detection principle. Toximeters and oxygenometers autonomy 7000 hours OX/TX 2000 OX/TX 2000 + A series of toximeters and oxygenometers available in long-running version (2000+ series) and HBCO version RX 500 NEW To preserve the environment, a recyclable portable gas detector. 3 versions available : CO, H 2 S, O 2. Leak detector GLD 2000 NEW The only explosive gas leak detector. Explosimeter, catharometer, gas discrimination, sensitivity : 1 ppm CH 4. MX 2000 Multigas detector, for up to 4 gases simultaneously. Very good shock robustness. 2 threshold alarms. Multigas MX 2100 NEW Multigas detector for use in zone 0! Detects up to 5 gases simultaneously, up to 6 measurement ranges available. Stand alone Available in 2004 BM25 The new stand alone monitor with radio link.
Detectors / Transmitters For site safety A series of detectors to meet various needs, depending on your applications, and site classification. Flammable gas detectors CAPTEX Explosimetric detector for small units, equipped with flameproof cell. OLC 20/20D A generation of flameproof sensor blocks for explosive gases designed for assemblers (OLC 20) and manufacturers (OLC 20D). CEX 300 Designed for industry and service providers. This explosimetric cell with increased-safety casing and flameproof cell is placed in areas at risk. OLC 50 Equipped with explosimetric cell insensitive to poisons Infrared transmitter for CO 2 TCOD IR This detector/transmitter continuously measures the carbon dioxide concentration using the IR absorption principle. Flame detector SharpEye A series of flame detectors adapted to all types of fire, meeting the requirements of a wide range of applications by analysing radiation in the ultra-violet and infrared spectra. Infrared detector / transmitters NEW OLCT IR Infrared detector for industrial applications. For flammable gases and CO 2. Semi-conductor detector TBG Semi-conductor explosimetric detector. Analogue and digital detector TBGW EX Analogic and digital explosimetric detector (also exists in Toximetric version). Loop connection.
Accessories Detectors / transmitters for flammable gases and oxygen deficiency Detectors / Transmitters electrovalves A wide range with easy connections, waterproof, high wear resistance. Flameproof version available. Accessories CTX 300 The very wide range of cells in this detector / transmitter makes it a highly adaptable instrument. For explosive, toxic gases and O 2. OLCT 40 A generation of detectors / transmitters insensitive to corrosive agents, designed for industry. Depending on needs or gases to be detected, available with remote functions, enhanced-safety junction box, flameproof cell or intrinsic safety. For explosive, toxic gases and O 2. OLCT 60A A generation of detector/transmitters with display insensitive to corrosive agents, designed for industry. Available with remote function, flameproof or intrinsic safety versions depending on needs or gases to be detected. For explosive, toxic gases and O 2. Non-intrusive calibration and maintenance. Tubes and pumps More than 150 types of tubes available for qualitative and quantitative analysis. For site safety A series of detectors to meet various needs, depending on your applications, and site classification. NEW A very wide range of additionnal products available including : OLCT 20/20D A generation of detector block / 4-20 ma transmitters designed for assemblers (OLCT 20) and manufacturers (OLCT 20D). Flameproof or intrinsic safety depending on needs or gases to be detected. For explosive and toxic gases and O 2. OLCT 50 A generation of detector / transmitters insensitive to corrosive agents, designed for industry. Available with remote function, flameproof or intrinsic safety versions depending on needs or gases to be detected. For explosive, toxic gases and O 2. To optimise your installations BP 2000 Pump for portable gas detectors. OLCT 80 A multi-function detector / transmitter with display ; 4-20 ma input, built-in alarm and fault relay, memory setting and request remote controlled. 4-20 ma and RS 485 output, loop connection possible. Depending on needs or gases to be detected, available as remote function, flameproof or intrinsic safety versions. For explosive and toxic gases and O 2. Non-intrusive calibration and maintenance. Test terminal and calibration station To test reliability and operation of the products.
Measurement and alarm units Monitoring your installations For all detectors in the range and standardised 4-20 ma output detectors. 1 to 64 channel measurement and alarm units SV 4B MX 48 1 channel Low cost and easy to install Continuous self-checking Built-in relays MX 32 Fault alarm Wall mounted unit 1 to 2 channels Wingas 1 to 4 channels Vigipark 10 cyclic sampling channels, 4 fixed channels for CO-NO x Fire detectors can be connected 4 instant thresholds, 2 average thresholds 1 threshold per channel Centralised monitoring in network Continuous self-checking Networking of up to 32 instruments 1 to 8 channels 1 to 14 channels MX 52 1 to 16 channels MX 62 1 to 64 channels 3 gas alarm thresholds programmable per channel Programming by keyboard or PC Series output special model for car parks 1 to 16 channels 3 alarm thresholds, one trouble threshold Programming by keyboard or PC MX 42 A 1 to 4 channels Fixed or scrolling display 4 gas alarm and fault thresholds Built-in relays Fits with sensors in loop configuration 64 protected channels Direct network and loop connections Self-checking SIL 3 Biogas analysers DGM9 Analysis unit for gases released during decomposition of organic waste (CO 2 - CH 4 - O 2 - H 2 S). BIOWIN NEW Biogas analysis unit (CO 2 - CH 4 - O 2 - H 2 S - H 2 - other gases on request). RS 232 or RS 485 output.
Emission gas and dust analysis protecting environment Gas analysers Dust detectors FAN Series Continuous gas analysis and sampling unit, high adaptability. 300 Series NEW Ultra-sensitive dust detectors, technology using triboelectric effect with automatic adjustment procedure. Belgium t (33) 03 21 60 81 20 f (33) 03 21 60 81 02 oldham.belgium@oldham.fr Your agent or retailer Italia t 011-3801371 f 011-3806613 info@oldham.it E 6200 In situ gas analyser for simultaneous analysis of up to 6 gases. Dust analysers / opacimeters Česká Republica t 420 234 622 222/3 f 420 234 622 220 oldham@oldham.cz EP 500 NEW Dust analyser providing continuous and in-situ measurement of smoke opacity. EP 1000 A In-situ dust analyser using laser back-scattering technology. EP 2000 Dust analyser based on the laser post-diffusion principle, ideal for measuring very low quantities. Romania t (40) 21 222 4846 f (40) 21 222 5037 oldham@fx.ro LG 3000 NEW In situ gas and process control analyser, resisting to high temperatures and magnetic fields. Plant and head office : Z.I. Est - rue Orfila B.P. 417-62 027 ARRAS Cedex FRANCE Tel. : 33 3 21 60 80 80 Fax : 33 3 21 60 80 00 Web site : http://www.oldham.fr Switzerland Portable gas analysers t (41) 26 652 51 18 f (41) 26 652 51 19 info@oldham.ch PAN Series NEW Portable gas analyser for continuous and simultaneous measurement of several pollutants and combustion gases. United Kingdom t (44) 0 1782 562002 f (44) 0 1782 564414 sales@oldham.biz WINTER Deutschland t (49) 231 924 10 f (49) 231 924 125 info@winter-gmbh.com This is not a contractually binding document. SA reserves the right to make any changes, without notice, to the technical characteristics of its equipement. Designed and created by Audace 33 3 21 135 600. Edition ref.: GammeGB09