Step 1: Install the program SecureW2_333. To download the program click on this link: http://www.uhu.es/sric/wifi/securew2_ttls_333.exe Once you have downloaded the program, extract the.zip file and run the.exe file. The following window will appear. 1. Select the language you require and click ok. 2. Click Next to continue with the Installation.
3. Click I Agree 4. Click Install. 5. Click I want to manually reboot later and then click Finish
Step 2: Connecting to the Network: There are 2 different ways to do this: 1. Click Start and then Connect to 2. Click Start and then Control Panel, Network Connections, then Manage Network Connections. The following screen should appear once you have done either of the 2 methods above Click Setup a Connection or Network and the following window will appear.
Click Connect Manually to a Wireless Network and the following window will appear. Type the Network Name uhu, change the Type of Security to WPA-Enterprise and the Type of Encryption to TKIP. Now Select Start this connection automatically, if not already selected and click next. The following window will appear. Click Change Network Configuration The following window will then appear.
This window has two tabs: Connection and Security Click on the Security tab. Click on the Choose method of Network Authentication and select the SecureW2 TTLS method. Now click Properties The following window will now appear. Now create a new Profile by clicking New. Type in uhu in the Profile ID box and click OK. Now click Configure The following window will appear.
In the first tab called Connection deselect the option Use Alternate Outer Identify Now click on the tab called Certificates In the Certificates tab deselect the option Verify Server Certificate
There is no need to make any changes to the last 2 tabs. They should look like the pictures above. Now Click Ok in this window and in the SecureW2 Profile window. Step 3: Restart your computer to complete the configuration process. Step 4: Connect yourself to the network You should pick up the network when you start your computer again and a message should appear like in the picture below. Click on this message and the following window will appear.
Select the network uhu and click Connect The following window should now appear.
Your username and password are the same as the ones for your University Email account. Normally the usernames are as follows: If you are a student: Name.Surname If you are PAS/PDI: Name.Surname.Service Only enter your username and password, leave the Domain blank Very important, for security reasons its recommended not to select Save User Credentials.