User's Guide Tlet Chrging Wll Mount 12 For the ltest User Instlltion Guide plese visit: www.ergotron.com User's Guide - English Guí del usurio - Espñol Mnuel de l utilisteur - Frnçis Geruikersgids - Deutsch Benutzerhnduch - Nederlnds Guid per l utente - Itlino Användrhndok - svensk 1 of 17
Hzrd Symols Review These symols lert users of sfety condition tht demnds ttention. All users should e le to recognize nd understnd the signifi cnce of the following Sfety Hzrds if encountered on the product or within the documenttion. Children who re not le to recognize nd respond ppropritely to Sfety Alerts should not use this product without dult supervision! Symol Signl Word Level of Hzrd NOTE CAUTION WARNING ELECTRICAL A NOTE indictes importnt informtion tht helps you mke etter use of this product. A CAUTION indictes either potentil dmge to hrdwre or loss of dt nd tells you how to void the prolem. A WARNING indictes either potentil for property dmge, personl injury, or deth. An Electricl indictes n impending electricl hzrd which, if not voided, my result in personl injury, fire nd/or deth. Sfety WARNING: Becuse surfces vry widely nd the ultimte mounting method is out of Ergotron s control, it is impertive tht you consult with pproprite engineering, rchitecturl or construction professionl to ensure tht your Ergotron mounting solution is mounted properly to hndle pplied lods. CAUTION: Mke sure the wll mount rcket is level, flush nd snug to the wll surfce. DO NOT OVER- TIGHTEN THE BOLTS. < 44.4 ls. (20.1 kg) CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR! 2 of 17
1 2 Components 1 2 1x A B C D 1x 5x 1x 1x 4x 1/4-20 x 2 3 4x 1x 5/32 5x M6 x 70mm Tools Needed Stud Finder 10mm WOOD STUD HOLLOW WALL Ø 3/16" (5 mm) Ø 1/2" (13 mm) CONCRETE Ø 3/8" (10 mm) 3 of 17
1 MOUNTING CONSIDERATIONS Spce Requirements: 35.3" (900 mm) When mounting to wood stud, t lest one screw in the upper mounting rcket must e instlled in stud (preferly the center hole). 6" (152 mm) 7" (178 mm) 11.8" (300 mm) 6.5 (168 mm) 4 (102 mm) 6" (151 mm) 3" (74 mm) Mounting Holes 32.75" (831 mm) 35.6" (905 mm) 62-68 (158-173 cm) Recommended Mounting Height Aove Floor Individul tlet or chromeook weight: Individul dimensions (including cover): < 8.5" (215 mm) < 11.4" (289 mm) < 3 ls (1.36 kg) < 1" (25 mm) 2 WOOD STUD HOLLOW WALL CONCRETE 5 8 4 of 17
WOOD STUD HOLLOW WALL First Choose Hole Option: The stud cn e locted t one of five mounting holes on the top rcket. While the first option (center hole of rcket) is recommended, you should consult with construction professionl to confirm which method is est suited for your prticulr sitution. After you decide on Hole Option, follow ttchment instructions on the following pge. Hole Option 1 RECOMMENDED Center Hole in Stud Hole Option 2 Extreme Left Hole in Stud Hole Option 3 Hole Option 4 Hole Option 5 Extreme Right Hole in Stud Middle Right Hole in Stud Middle Left Hole in Stud 5 of 17
WOOD STUD HOLLOW WALL Find stud nd drw mrk. c Put mrk on the stud 62-68 (158-173 cm) from floor. 62-68 (158-173 cm) d Plce templte on wll lining up the chosen hole with the stud nd the mrk 62-68 (158-173 cm) from floor. e Secure templte to wll. 62-68 (158-173 cm) 7 6 of 17
WOOD STUD HOLLOW WALL f 1. Drill the three holes for the top rcket tht correspond with the hole option determined on previous pge. 2. Drill the ottom two holes. NOTE: Use the Ø 3/16 (5 mm) drill it when drilling directly into the wood stud. Use the Ø 1/2 (13 mm) drill it when drilling into the hollow wll for the nchors. Use hollow wll nchors where ever screw does not get inserted directly into the wood stud. WOOD STUD Ø 3/16" (5 mm) 10mm M6 x 70mm HOLLOW WALL Ø 1/2" (13 mm) 1x 5/32 62-68 (158-173 cm) 1/4-20 x 2 1 2 3 4 g h Insert nchors then ttch rcket to wll ccording to the hole option determined on previous pge. Verify wll rcket is level efore tightening screws. 9 7 of 17
CONCRETE Put mrk on the stud 62-68 (158-173 cm) from floor. Attch templte to the wll lining up the chosen mounting holes with the mrk 62-68 (158-173 cm) from floor. 60-66" (1524-1676 mm) 60-66" (1524-1676 mm) c Drll the top 3 holes, then the ottom two holes. Ø 3/8" (10 mm) d 3-1/8" (80 mm) 62-68 (158-173 cm) WARNING: Mounting holes must e t lest 3-1/8 (80mm) deep nd must e locted within solid concrete, not mortr or covering mteril. If you drill into n re of concrete tht is not solid, reposition mounting holes until oth nchors cn e fully inserted into solid concrete! e Insert nchors into holes, then ttch mounting rcket. 5x M6 x 70mm 10mm WARNING: Anchors tht re not fully set in solid concrete will not support the pplied lod resulting in n unstle, unsfe condition which could led to personl injury nd/or property dmge. Consult construction professionl if you hve ny dout out wht this mens in regrd to your prticulr sitution. 8 of 17 5x 9
3 Hng unit onto top rcket. Wrning: 2 people re required to lift this product. 4. Remove two screws on left side. Sve screws for rettching cover.. Unlock door nd turn wing kno 90 clockwise. 5. Open door nd remove these 3 screws. Sve screws for rettching cover.. Remove left cover 9 of 17
6. Secure unit to wll y inserting screw through ck wll nd into ottom right wll nchor.. Close door, then insert screw through ck wll nd into ottom left wll nchor. WOOD STUD HOLLOW WALL CONCRETE 2x 1/4-20 x 2 5/32 5x M6 x 70mm 10mm 10 of 17
7. Plug in ll the tlet power cles into the outlets inside.. Route cles through the ccess holes. c. Open door n pull cles through the ccess holes. c 11 of 17
8 Pull out tlet try nd insert tlet. NOTE: Tlet should e positioned so power plug is t top or left side. 9. Pull cle clip off of tlet slot nd route cle through clip, then rettch cle clip. NOTE: Leve enough slck in cle to plug into tlet.. Plug tlet cles into tlets. NOTE: When tlet is removed, store unconnected cle in the pproprite tlet slot. 12 of 17
10 Tie up excess cle with velcro cle ties. NOTE: Keep cles wy from power system components tht might get hot during opertion. 11. Attch left cover with 2 screws sved from removl of cover.. Open door nd ttch 3 inside screws sved from removl of left cover 13 of 17
12. Close door.. Lock door y rotting wing kno 90 counterclockwise. 13 Plug power cle into ottom ccess nd then into wll outlet to strt chrging. 14 of 17
Tlet Chrging To egin chrging the tlets, plug in the power cord. The power cord is used to turn the power on nd off. Chrging occurs whenever the power cord is connected to n outlet. LED NOTE: The power cord cts s the connect/disconnect device switching power off nd on. The socket outlet shll e instlled ner the equipment nd shll e esily ccessile. Power Indictor Communictes chrge sttus with the following signls: Light Off On - solid Description No power to the module. Tlets or Chromeooks re chrging. Specifi ctions Dimensions 26.4 W x 35.6 H x 5.9 D (669 x 905 x 151 mm) Weight (w/o equipment) 64.5 ls (29.3 kg) Rted weight cpcity 44.4 l (20.1 kg) Power system Prt numer DM12-1005-1 DM12-1005-2 DM12-1005-3 DM12-1005-4 DM12-1005-5 DM12-1005-6 Power System Input: 100-120V~, 12A, 50/60 Hz Input: 220-240V~, 8A, 50/60 Hz Input: 220-240V~, 8A, 50/60 Hz Input: 220-240V~, 8A, 50/60 Hz Input: 220-240V~, 8A, 50/60 Hz Input: 100-120V~, 12A, 50/60 Hz Mximum tlet or chromeook size Individul dimensions (including cover): up to 11.4 H x 8.5 W x 1.0 D (290 x 216 x 25 mm) Individul tlet or chromeook weight: up to 3 l (1.4 kg) Cooling/ventiltion One 12V DC continuous opertion fn Shipping dimensions 40.9 x 28.9 x 8.4 (1040 x 735 x 214 mm) Environmentl Temperture rnge: Operting 0 to 30 C (32 to 86 F) Storge -40 to 60 C (-40 to 140 F) Reltive humidity (mximum): Operting 10% 90% (non condensing) Storge 5% 95% (non condensing) Altitude (mximum): 2000 m (6,562 ft) Comptiility: Tlets nd chromeooks Shipping weight 77 l (34.9 kg) 15 of 17
Clening nd Mintennce Equipment Electric Sfety There re specific risks ssocited with the use of equipment hving power cles. You must e wre of, nd void these risks when this product is locted in close proximity to children. WARNING: Filure to oserve the following Electricl Sfety notices cn result in fire or deth y electric shock. Electricl cles cn e hzrdous. Misuse cn result in fire or deth y electricl shock. Doule Pole / Neutrl Fusing Inspect power cles thoroughly efore ech use. Do not use cles tht re dmged. Insert the plug completely into the outlet. Grsp the plug to remove from the outlet. Do not unplug y pulling on the cle. Do not use excessive force to mke connections. Do not plug the cle into n extension cle. Do not remove, end or modify ny metl prongs or pins of cle. Do not drive, drg or plce ojects over the cle. Do not wlk on the cle. Avoid overheting. Uncoil the cle nd do not cover it with ny mteril. Do not run cle through doorwys, holes in ceilings, wlls or floors. Keep this product wy from wter. Do not use it when wet. Do not plce this product in close proximity to flmmle liquids or gses. This product is intended for use only with loding s indicted. Use with lods greter thn indicted my result in instility cusing possile injury. The power cord cts s the connect/disconnect device switching power off nd on. The socket outlet shll e instlled ner the equipment nd shll e esily ccessile. CAUTION: Chnges or Modifictions not expressly pproved y Ergotron could void the user s uthority to operte the equipment. Use Sfety There re specific risks ssocited with the use of this product (for chrging or storge). You must e wre of, nd void these risks when this product is locted in close proximity to children. WARNING: Filure to oserve the following Use Sfety notices my result in serious personl injury or equipment dmge. Only Adults should use this product. Do not llow nyone to clim or hng on this product. Do not lock the fns nd vent openings. To prevent overheting, leve t lest 127 mm (4-inch) clernce round fns nd vents. This product is designed to e used indoors only. Do not use this product to store equipment other thn wht hs een noted in this guide. Do not use this product to store liquids or clening supplies. Do not plce hevy ojects on this product. The mximum weight cpcity is 44.4 ls (20.1 kg). This device complies with Prt 15 of the FCC Rules. Opertion is suject to the following two conditions: 1) This device my not cuse hrmful interference. 2) This device must ccept ny interference received, including interference tht my cuse undesired opertion. CAN ICES-3(A) / NMB-3(A). 16 of 17
Service nd Wrrnty For locl customer cre phone numers visit: http://contct.ergotron.com NOTE: When contcting customer service, reference the seril numer. www.ergotron.com MADE IN CN 12-345-678 1234567-1234 17 of 17