What you will do. Build a 3-band equalizer. Connect to a music source (mp3 player) Low pass filter High pass filter Band pass filter



Similar documents
How to Design 10 khz filter. (Using Butterworth filter design) Application notes. By Vadim Kim

Voltage. Oscillator. Voltage. Oscillator

PHYSICS LAB #2 Passive Low-pass and High-pass Filter Circuits and Integrator and Differentiator Circuits

ε: Voltage output of Signal Generator (also called the Source voltage or Applied

Making Accurate Voltage Noise and Current Noise Measurements on Operational Amplifiers Down to 0.1Hz

= V peak 2 = 0.707V peak

LAB 12: ACTIVE FILTERS

PROCEDURE: 1. Measure and record the actual values of the four resistors listed in Table 10-1.

Lab 3 Rectifier Circuits

Electronics. Discrete assembly of an operational amplifier as a transistor circuit. LD Physics Leaflets P

NAPIER University School of Engineering. Electronic Systems Module : SE32102 Analogue Filters Design And Simulation. 4 th order Butterworth response

Series and Parallel Circuits

Experiment # (4) AM Demodulator

EET272 Worksheet Week 9

TDA W Hi-Fi AUDIO POWER AMPLIFIER

Reading: HH Sections , (pgs , )

Lab #9: AC Steady State Analysis

LM 358 Op Amp. If you have small signals and need a more useful reading we could amplify it using the op amp, this is commonly used in sensors.

Kit Watt Audio Amplifier

Impedance Matching and Matching Networks. Valentin Todorow, December, 2009

FREQUENCY RESPONSE OF AN AUDIO AMPLIFIER

Laboratory #5: RF Filter Design

LR Phono Preamps. Pete Millett ETF.13.

Frequency Response of Filters

Laboratory 4: Feedback and Compensation

Analog and Digital Filters Anthony Garvert November 13, 2015

Lock - in Amplifier and Applications

LM386 Low Voltage Audio Power Amplifier

Inductors in AC Circuits

Annex: VISIR Remote Laboratory

A Simple Current-Sense Technique Eliminating a Sense Resistor

Unit2: Resistor/Capacitor-Filters

Understanding Power Impedance Supply for Optimum Decoupling

Chapter 10. RC Circuits ISU EE. C.Y. Lee

TDA W Hi-Fi AUDIO POWER AMPLIFIER

Measurement of Capacitance

TESTS OF 1 MHZ SIGNAL SOURCE FOR SPECTRUM ANALYZER CALIBRATION 7/8/08 Sam Wetterlin

See Horenstein 4.3 and 4.4

11: AUDIO AMPLIFIER I. INTRODUCTION

Fastastic Frequencies

An Adjustable Audio Filter System for the Receiver - Part 1

Lab 5 Operational Amplifiers

Diodes have an arrow showing the direction of the flow.

AN-837 APPLICATION NOTE

isim ACTIVE FILTER DESIGNER NEW, VERY CAPABLE, MULTI-STAGE ACTIVE FILTER DESIGN TOOL

Routinely DIYers opt to make themselves a passive preamp - just an input selector and a volume control.

Chapter 4: Passive Analog Signal Processing

Op-Amp Simulation EE/CS 5720/6720. Read Chapter 5 in Johns & Martin before you begin this assignment.

Sophomore Physics Laboratory (PH005/105)

Analog signals are those which are naturally occurring. Any analog signal can be converted to a digital signal.

Noise Specs Confusing

LM1036 Dual DC Operated Tone/Volume/Balance Circuit

PLL frequency synthesizer

DC Circuits (Combination of resistances)

SERIES-PARALLEL DC CIRCUITS

PIEZO FILTERS INTRODUCTION

Transistor Characteristics and Single Transistor Amplifier Sept. 8, 1997

13. Diode Rectifiers, Filters, and Power Supplies

Precision Diode Rectifiers

Oscilloscope, Function Generator, and Voltage Division

VOLUME AND TONE CONTROL - PREAMPLIFIER K8084

Measuring Impedance and Frequency Response of Guitar Pickups

Section 3. Sensor to ADC Design Example

Study Guide for the Electronics Technician Pre-Employment Examination

Active Speaker System LX523 AUDAC PROFESSIONAL AUDIO EQUIPMENT. Active Speaker System with remote input LX523. User Manual & Installation Guide

Chapter 19 Operational Amplifiers

LAB2 Resistors, Simple Resistive Circuits in Series and Parallel Objective:

Basic Op Amp Circuits

IEC Algorithmic Alert Tone Demo

The Calculation of G rms

A-145 LFO. 1. Introduction. doepfer System A LFO A-145

SUMMARY. Additional Digital/Software filters are included in Chart and filter the data after it has been sampled and recorded by the PowerLab.

Analog Sound From A Digital Delay

Output Filter Design for EMI Rejection of the AAT5101 Class D Audio Amplifier

Physics 120 Lab 6: Field Effect Transistors - Ohmic region

Circuits with inductors and alternating currents. Chapter 20 #45, 46, 47, 49

ECEN 1400, Introduction to Analog and Digital Electronics

TDA2030A. 18W Hi-Fi AMPLIFIER AND 35W DRIVER

2. A conductor of length 2m moves at 4m/s at 30 to a uniform magnetic field of 0.1T. Which one of the following gives the e.m.f. generated?

Oscillations and Regenerative Amplification using Negative Resistance Devices

Fundamentals of Power Electronics. Robert W. Erickson University of Colorado, Boulder

Analog Filters. A common instrumentation filter application is the attenuation of high frequencies to avoid frequency aliasing in the sampled data.

Digital to Analog Converter. Raghu Tumati

The Effects Of Cable On Signal Quality

LAB 7 MOSFET CHARACTERISTICS AND APPLICATIONS

200W DISCRETE POWER AMPLIFIER K8060

LINEAR INTEGRATED-CIRCUIT FUNCTION GENERATOR

Physics 6C, Summer 2006 Homework 2 Solutions

Application of network analyzer in measuring the performance functions of power supply

Class D Audio Amplifier

Diode Applications. As we have already seen the diode can act as a switch Forward biased or reverse biased - On or Off.

Fundamentals of Signature Analysis

DRAFT. University of Pennsylvania Moore School of Electrical Engineering ESE319 Electronic Circuits - Modeling and Measurement Techniques

AC Line Voltage and Guitar Tone Mania

Constructing a precision SWR meter and antenna analyzer. Mike Brink HNF, Design Technologist.

Experiment 2 Diode Applications: Rectifiers

Karaoke Circuit Building Instructions

Experiment #11: LRC Circuit (Power Amplifier, Voltage Sensor)

Chapter 12: The Operational Amplifier

Germanium Diode AM Radio

Transcription:

Audio Filters

What you will do Build a 3-band equalizer Low pass filter High pass filter Band pass filter Connect to a music source (mp3 player) Adjust the strength of low, high, and middle frequencies Play result through a speaker

Gameplane Review sound waves and frequency Learn to read an electrical schematic Build the circuit

Sound waves Compressional waves Air density increases and decreases periodically These waves hit tiny hairs in your ear When they wiggle your nerves feel it Brain understands it s sound h"p://www.privateline.com/telephonehistory/ speech.jpg

Waves: periodic Frequency is 1 cycle per millisecond 1000 cycles/sec (1 khz) This one is a sine wave Sine wave=pure tone

Frequency relates to pitch Higher Frequency Lower Frequency P. Lundstrom, ECE 682 student presentation, Autumn 2008.

Electronic version Current is proportional to sound pressure What is the frequency of this wave? Will it sound higher pitched or lower pitched (when played through a speaker)?

The audible range The audible range for humans is approximately 20 Hz to 20 khz (20,000 Hz). The lowest note on a piano, A0, has a frequency of 27.5 Hz. The highest note on a piano, C8, has a frequency of 4.186 khz (4186 Hz). P. Lundstrom, ECE 682 student presentation, Autumn 2008.

Square wave What is the frequency? Will it sound higher or lower than 1 khz sine wave?

Square wave contains many frequencies COMPONENTS SUM Here are three frequencies As you add more, looks more like a square wave http://sirius.ucsc.edu/demoweb/images/waves/sound/fourier%20analysis_schem.jpg

Sounds like? Pitch is that of fundamental frequency Timbre (character) of tone is different than pure tone (sine wave) www.chemicool.com/img1/ graphics/fourier-waves.gif

Other waveforms TRIANGLE WAVE SAWTOOTH WAVE

What would this sound like? https://chip.physics.purdue.edu/protected/ Prelab220newimg/m10q3beats.jpg

Sound consists of: Pitch Timbre Volume And all of this varies with time Music is a wildly complex combination of frequencies output of a.wav file P. Lundstrom, ECE 682 student presentation, Autumn 2008.

Audio equalizer Lets you attenuate some frequencies Boost others This one is a 20-band equalizer We ll build a three-band equalizer http://www.smeter.net/slc/info/equalization.php

Electronic Filters Filter A circuit or device that passes certain frequencies and blocks others. Pass Band The range of frequencies that are allowed to pass through the filter. Stop Band The range of frequencies that are stopped by the filter.

Low Band Low Pass Filter A low pass filter passes all frequencies lower than a cutoff frequency and stops all frequencies higher. Cutoff frequency Audio Output 20Hz 1kHz Passband Stopband http://www.its.bldrdoc.gov/projects/devglossary/images/ lpfiltec.gif Audio Input 20Hz 20kHz

High-pass filter IN OUT Passes only parts that are changing rapidly http://www.its.bldrdoc.gov/projects/devglossary/images/ hpfiltec.gif http://homepages.which.net/~paul.hills/circuits/failsafe/detectortiming.png

Passband http://www.atis.org/glossary/images/pbfiltec.gif

READING SCHEMATICS

Electrical schematics Shows how components are connected Not how they re arranged physically Once you can read one, you can wire up any circuit Even if you don t know what it does or how it works

What s this? AC signal source

How about this? Resistor Resists electricity Why? Lets you control how much current flows Protect components

And this? Capacitor Stops DC, passes AC The lower the frequency, the less it passes We ll use it in our filters

What s this one? Inductor Passes low frequencies, stop high frequencies We could use them But hardly anyone uses inductors anymore

Another useful symbol Ground In your house, for safety Connected to a cold water pipe Earth is infinite source (and sink) of electrons Sometimes we pick a common point and call it ground By convention is always at zero volts

This is a loop Every circuit has to have at least one loop That s why they call it circuit

This is the same circuit Still a loop We know that all grounds are connected together Don t have to draw them that way

The point: We can draw things lots of different ways and still have them be the same electrically

Which of these things is not like the others? A B C D

Series vs. parallel Series Parallel

Series Series or parallel?

Series or parallel? Parallel

Series or parallel? Series

Series or parallel? Parallel

Series or parallel? Series!

Series or parallel? Parallel!

Are these the same? YES

Are these the same? NO

Now, our filters Recall capacitor blocks low frequencies Is this a high-pass or low-pass filter? High pass! Low frequencies can not pass to output

What is the cutoff frequency? f = 1 2π RC We adjust the cutoff frequency by our choice of R, C We ll use: R=680 C=0.1 µf f 2,500 Hz Will pass frequencies above 2.5 khz

Low-pass filter All frequencies pass through R High frequencies pass through C They go to ground! Only low frequencies go the output

What is the cutoff frequency? f = 1 2π RC Same equation Here we ll use: R=1.6 k C=0.1 µf f 1000 Hz Will pass frequencies below 1 khz

Bandpass First filter out high frequencies (highpass filter) Pass remaining signal on to the next stage Low-pass-filter what s left

Potentiometer Add variable resistor to output As you turn the wheel, the amount of signal passed to output changes This is a volume control You ll have one for each filter

Now we re ready to build We ll use a breadboard All holes in long columns connected together These are called buses Handy for when you have to connect many things to the same point Holes in short rows connected

Example of the Circuit Capacitor Potentiometer Low Pass Filter Schematic Resistor

Start with low pass Here s the entire circuit We ll provide amplifier, speaker You provide music source

Connect player to breadboard Use a row Use a bus bus row Not connected

Input connects to 1.6k R Stripes: brown, blue, red

Install pot and cap Photo courtesy Bowser, Frankart, Lee, Lundstrom, Reed, Dec 2008

And grounds

Finally, amp and speaker

Plug it in and try it

Now start the high-pass filter

And finish it Stripes: blue, gray, brown

If you have time, add the bandpass