BLOOD CIRCULATION Department of Biomedical Sciences Medical University of Lodz
CONSTRUCTION OF THE CIRCULATORY SYSTEM
Circulatory System
VESSELS CONSTRUCTION
HEART The primary function of the heart is blood pumping Pumping is done by the rhythmic contractions of different batches of the heart Factors causing contractions - are periodically passing through the heart muscle cells membranes - waves of depolarization and repolarization of cells to the resting phase
THE RHYTHM OF THE HEART It is relatively constant. At rest, the number of heartbeats per 1 minute depends on age (in children is higher), gender (in women is higher than man) and level of physical strenght In an adult an average value is 60-80 beats/min. Heart rhythm accelerates under the influence of emotional factors, elevated ambient temperature and physical effort During each contraction of the heart, the main artery is extruded to a certain amount of blood called the ejection fraction (in the systemic circuit). The average value for healthy adults in rest is 50-70 ml. Thus, the total amount of blood extruded per minute through the left ventricle into the circulatory system is defined as a minute or cardiac output it is the product of the rhythm and the level of the systol In adults and healthy people, with an average level of fitness, at rest, 4-5 liters of blood is pumped by the heart per one minute (the cardiac output)
ENERGETICS OF HEART ACTION Volumetric = External Work (P dv) performed against the pressure in the aorta and pulmonary artery Kinetic = Internal Work (½ ρν 2 ) performed in order to introduce kinetic energy to the blood (to move blood) were: W work [J] V volume [m 3 ] P pressure [Pa] ρ density [kg/m 3 ] ν velocity [m/s] Left Right Volumetric work 0.91 J/contraction 0.15 J/contraction Kinetic work W L = P L V + ½ ρν 2 V W R = P R V + ½ ρν 2 V 0.006 J/contraction 0.006 J/contraction At rest: Volumetric work = 1.1 J/contraction Kinetic work = 0.01 J/contraction
HEART ACTION The heart is a pump where energy is used not to fill the atrium and the ventricle with blood, but for emptying it It is not a lift-and-force pump, the vacuum is not produced during its filling The pressure in the heart chambers is always positive The efficiency energy of the heart is: at rest - 15% in stress conditions - 40%
BLOOD FUNCTIONS: Transport - atmospheric oxygen from the lungs to the tissues and CO 2 from the tissues to the lungs; of nutrients from the digestive tract and removal of metabolic products; of hormones, enzymes and antibodies. Maintaining a relatively constant H 2 O content in the tissues through the exchange of fluids (with lymph or urine). Control of body temperature - blood moves towards the skin to cool us down, as excess heat can escape easier. Protection - in the form of our immune system. Blood carries white blood cells which help fight disease. Platelets also clot the blood to stop us from bleeding.
BLOOD COMPOSITION
BLOOD OXYGEN CAPACITY 100 ml of blood contains 15 g of hemoglobin 1 g of hemoglobin binds ca. 1.34 ml of O 2 Maximum oxygen capacity of blood is 20 ml per 100 ml of blood (ratio 1:5)
PRESSURE GRADIENT IN LARGE AND SMALL CIRCULATION Aorta 100 hpa (70 mm Hg) diastole 160 hpa (120 mm Hg) systole Caval vein 0 Pulmonary artery 10 hpa (8 mm Hg) Pulmonary vein diastole 30 hpa (15 mm Hg) systole 9 hpa (7 mm Hg) MOVEMENT OF BLOOD IS CAUSED BY PRESSURE DIFFERENCE BETWEEN ARTERIAL AND VENOUS SYSTEMS AND THAT IS SUSTAINED BY HEART WORK
INFLUENCE OF GRAVITY FIELD Hydrostatic blood pressure P = ρ x g x h For ρ 10 3 kg/m 3 g 10 m/s 2 P = (100h) in hpa P = (75 h) in mm Hg Pressure in the artery of the head: (height (h) =0.5 m) = 130 50 = 80 hpa Pressure in the large artery of the foot: (h = 1 m) = 130 + 100 = 230 hpa
LAMINAR BLOOD FLOW Laminar flow - the normal condition for blood flow throughout most of the circulatory system Concentric layers of blood are moving in parallel down the length of a blood vessel The highest velocity (Vmax) - the center of the vessel. The lowest velocity (V=0) - along the vessel wall The flow profile is parabolic once laminar flow is fully developed Characteristic for the long, straight blood vessels, under steady flow conditions
TURBULENT FLOW Laminar flow a fluid flows in parallel layers Turbulent flow only immediately after the semilunar valves close (heart sounds) ν k = R e η r ρ Re Reynolds number (approx. 1000) ν k critical velocity [m/s] η viscosity coefficient [Ns/m 2 ] r vessel radius [m] ρ blood density [kg/m 3 ]
CHANGE IN VESSEL LUMEN
LAWS REGULATING BLOOD FLOW
1) FLOW CONTINUITY PRINCIPLE t t V ν1 V ν 2 Flow rate J = V [m 3 ] S 1 x ν 1 = S 2 x ν 2 S area [m 2 ] ν- velocity [m/s] t time [s] V volume [m 3 ] J 1 = J 2 t [s] Accounting for vessel ramification J = J n S = Sn S capillary S aorta = 750 Not accounted for: vessel pulsation exchange of blood with the surroundings
2) BERNOULLI S LAW p + hρg + ½ ρv 2 = const where: p static pressure [Pa] h hight [m] ρ density [kg/m 3 ] v velocity [m/s] g acceleration of gravity [m/s 2 ] For horizontal vessel: p + ½ ρv 2 = const THE TOTAL SUM OF STATIC PRESSURE (p), HYDROSTATIC PRESSURE (hrg) AND HYDRODYNAMIC PRESSURE (½ ρv 2 ) IS CONSTANT DURING THE FLOW FOR ANY CROSS-SECTION OF THE TUBE
3) POISEUILLE S LAW For non-turbulent, non-pulsatile fluid flow through a uniform straight pipe, the volume flow rate (J) is: 1) directly proportional to the pressure difference ( P) between the ends of the tube, 2) inversely proportional to the length (l) of the tube, 3) inversely proportional to the viscosity (η) of the fluid, 4) proportional to the fourth power of the radius (r 4 ) of the tube. J = V t J = 1 R P R = 8 π η l r 4 = π 1 r4 8 η l P [m 3 /s] R resistance of the vessel blood inflow [Pa s/m 3 ] 2-FOLD INCREASE IN RADIUS DECREASES RESISTANCE BY 16-FOLD! I.E. RESISTANCE VERY SENSITIVE TO RADIUS
VASCULAR WALL RESILIENCE left ventricle arteries veins heart (right part) pump air chamber container resistance Arterial walls characterized by large resilience module, are always outstretched, fulfill the role of potential energy container Venous walls easily change their volume, fulfill the role of voluminal container, the venous part contains 70% of the blood
VASCULAR RESISTANCE VOLUME veins RESISTANCE venules arteries arterioles arteries Capillaries veins venules Capillaries arterioles Volume vessels Resistance vessels
GEOMETRIC FACTOR OF VASCULAR RESISTANCE TO BLOOD FLOW L r 4 F L = geometric factor = spring tension The effect of spring tension is spring pressure of the wall in accordance with the law of Laplace : P = T r where: P wall spring pressure on blood [Pa] T spring tension in the wall [N/m] r vessel radius [m] Small deformations (elastin fibers) Large deformations (collagen fibers)
PULSE Every 0,8 s 70 cm 3 of blood is ejected (ejection volume at rest) Loop resistance causes bulge in aorta, i.e. blood kinetic energy is changed into potential energy of the aorta wall resilience Pulse wave occurs a wave of spring deformations in the wall of artery vessels C = F Ε d 2 ρ r C pulse wave velocity [m/s] F empirical coefficient ρ density [kg/m 3 ] E Young module [Pa = N/m 2 ] d artery wall thickness [m] r vessel radius [m]
BLOOD VISCOSITY F = η A ν H [N] F A - shear stress [N/m 2 ] ν H - shear rate [1/s] η = shear stress shear rate Viscosity coefficient [Ns/m 2 ] is the ratio of the shearing stress to the shear rate in a fluid. where: A area [m 2 ] H hight [m] v velocity [m/s] η viscosity coefficienty [Ns/m 2 ]
FACTORS AFFECTING BLOOD VISCOSITY diameter of blood vessels - below 0.3mm viscosity is lower (Magnus Effect) temperature in 0 C viscosity is 2.5-times higher concentration of plasma proteins flow rate diameter 0.1-0.2mm: velocity increases but viscosity decreases presence of cellular components of blood, particularly hematocrit (% of content of erythrocytes in the blood volume) size (7µm) and deformability of erythrocytes
AXIAL ACCUMULATION OF BLOOD CELLS (MAGNUS EFFECT) VISCOELASTICITY Vessels smaller tham 3 µm viscosity increases, but elasticity occurs