LIFETIME REPLACEMENT WARRANTY Self Monitoring Power Supply (BPSM) Application - When interfacing with a fire alarm system where the system s auxiliary relay cannot handle the full current potential of the power supply, or when monitoring power systems for AC failure or DC battery failure, the BPSM linear power supply is the right choice. The power supply status LED indicators and status output terminals combine with BPS features to offer the next stage of protection. 6" [152mm] 18" [457mm] 15" [381mm] How To Order - 12VDC Provides eight (8) automatically breakered outputs Slide switches connect or disconnect load from power LED indication (AC & DC) showing power supply status Emergency low current fire release terminals AC status output terminals, SPDT, 3 Amp Battery status output terminals, Form C SPDT, 3 Amp Line voltage and DC fuses Sealed lead acid-gel battery charging capability (battery not included) During battery operation, if voltage drops below 10.4VDC for 12VDC (20.8VDC for 24VDC) the battery will automatically disconnect to prevent possible damage to the system Clean linear power for flawless operation with all sensitive active electronic components Voltage and Capacity: 12VDC - 6A, 9A, 15A 24VDC - 4A, 6A, 10A Monitoring: 110VAC Status Battery Status Power Supply batteries available on page 54 How To Order - 24VDC BPSM-12-6 Power Supply 12VDC-6A w/status BPSM-24-4 Power Supply 24VDC-4A Monitor w/status Monitor BPSM-12-9 Power Supply 12VDC-9A w/status BPSM-24-6 Power Supply 24VDC-6A Monitor w/status Monitor BPSM-12-15 Power Supply 12VDC-15A w/status Monitor BPSM-24-10 Power Supply 24VDC-10A w/status Monitor 49
800-MAGLOCK 800-624-5625 WWW.SECURITRON.COM Boxed Power Supply (BPS, BPSH) Application - Recommended where an interface with a fire alarm system or battery backup is needed. The BPS linear power supply delivers more current than PSPs or PMs, and all BPS models are UL Class 2 listed, allowing for wire runs without the use of conduit from power supply to door. The BPSH series operates with 220VAC. 50 How To Order - BPS BPS-12-13 BPS-12-3 BPS-12-45 BPS-12-6 BPS-12-9 BPS-12-15 BPS-24-1 BPS-24-2 BPS-24-3 BPS-24-4 BPS-24-6 BPS-24-10 Power Supply 12VDC-1 Amp Power Supply 12VDC-3 Amp Power Supply 12VDC-4.5 Amp Power Supply 12VDC-6 Amp Power Supply 12VDC-9 Amp Power Supply 12VDC-15 Amp Power Supply 24VDC-1 Amp Power Supply 24VDC-2 Amp Power Supply 24VDC-3 Amp Power Supply 24VDC-4 Amp Power Supply 24VDC-6 Amp Power Supply 24VDC-10 Amp 1, 4 or 8 separate output circuit breakers based on model LEDs monitor zone status (voltage, no voltage) Slide switches connect or disconnect load from power Internal capability of charging optional 12 or 24 VDC sealed lead acid backup batteries while operating the DC load (battery not included) Complete! Requires only 110VAC to the fused input (BPS) Rugged steel enclosure Provided with terminals, for fire alarm relay connection, allowing release of all devices upon fire alarm activation Clean linear power for flawless operation with all sensitive active electronic components UL listed How To Order - BPSH BPSH-12-1 BPSH-12-3 BPSH-12-45 BPSH-12-6 BPSH-12-9 BPSH-12-15 BPSH-24-1 BPSH-24-2 BPSH-24-3 BPSH-24-4 BPSH-24-6 BPSH-24-10 Power Supply 12VDC-1 Amp 220VAC Power Supply 12VDC-3 Amp 220VAC Power Supply 12VDC-4.5 Amp 220VAC Power Supply 12VDC-6 Amp 220VAC Power Supply 12VDC-9 Amp 220VAC Power Supply 12VDC-15 Amp 220VAC Power Supply 24VDC-1 AMP 220VAC Power Supply 24VDC-2 Amp 220VAC Power Supply 24VDC-3 Amp 220VAC Power Supply 24VDC-4 Amp 220VAC Power Supply 24VDC-6 Amp 220VAC Power Supply 24VDC-10 Amp 220VAC
LIFETIME REPLACEMENT WARRANTY Power Supply Monitor (PSM) Application - The PSM Series Power Supply Monitor is for use with larger DC power supplies. It can operate with all BPS supplies having capacities of 2 Amps or more, and functions as a power supply alarm system, monitoring all key functions and reporting any trouble. The output voltage is read to ensure it remains within tight limits for proper float charging of the battery pack. Available for both 12 and 24 VDC systems Monitors the power supply system s output voltage Audio and visual alarm Load tests the battery pack every 8 hours Monitors/tests DC output of power supply load 4" [102mm] 12" [305mm] Recommended : PSM-12: 3 Amp or greater at 12VDC (BPS-12-3, BPS-12-4.5, BPS-12-6, BPS-12-9, BPS-12-15) PSM-24: 2 Amp or greater at 24VDC (BPS-24-2, BPS-24-3, BPS-24-4, BPS-24-6, BPS-24-10) Voltage: VDC power from corresponding power supply Current Draw: 250mA at 12VDC, 200mA at 24VDC Warranty: MagnaCare Lifetime Replacement Warranty How to Order PSM-12 PSM-24 Power Supply Monitor 12VDC Power Supply Monitor 24VDC 9" [229mm] Power Supply batteries available on page 54 51
800-MAGLOCK 800-624-5625 WWW.SECURITRON.COM Power Supply (PM) Application - The PM Series linear power supplies are regulated 1 Amp DC supplies, using plug-in transformers. The PM Series includes AC fusing, DC output, automatic circuit breakers, battery charging capability and fire alarm compatibity. Emergency fire alarm release Separate, plug-in transformer Circuit board housed in a steel enclosure Does not require the services of an electrician Regulated, adjustable power with connectors for lead acid/gel cell battery (battery not included) Clean linear power for flawless operation with all sensitive active electronic components Voltage and Capacity: 2.8" [71mm] 8.0" [203mm] 6.0" [152mm] PM - 12: 12 volt, 1 Amp capacity PM - 24: 24 volt, 1 Amp capacity Power Input: 110VAC (transformer supplied) Warranty: MagnaCare Lifetime Replacement Warranty How to Order PM-12-1 Power Supply 12VDC with Plug-in Transformer PM-24-1 Power Supply 24VDC with Plug-in Transformer 52 Power Supply batteries available on page 54
LIFETIME REPLACEMENT WARRANTY Plug In DC Power Supply (PSP) Application - DC units in two versions: 12 volts @ 700mA max. capacity (model PSP-12) and 24 volts @ 350mA max. capacity (model PSP-24). Internal thermal fuse. 16 ft. output cable is included. PSPs are ideal for powering a wide range of DC devices. 2.34" [59mm] Internal thermal fuse 16 ft. [4.8m] output cable incl. Hard-to-find DC units! How To Order Capacity and Voltage: PSP-12: 12VDC, 700mA output PSP-24: 24VDC, 350mA output Power Input: 110VAC 2.35" [60mm] 1.85" [47mm] PSP-12 PSP-24 Plug in Power Supply 12VDC Plug in Power Supply 24VDC Hard Wired AC Power Supply (BACS) Capacity and Voltage BACS-12-20: 20 Amps 12VAC BACS-24-10: 10 Amps 24VAC BACSH-12-20: 20 Amps 12VAC BACSH-24-10: 10 Amps 24VDC Application - Intended primarily for powering CCTV cameras. BACS employs the same multiple zone concept as the BPS, including nearly identical control boards providing eight automatically breakered outputs, individual control switches and LEDs. Hard Wired power supply Provides eight (8) automatically breakered outputs with individual control switches and LEDs Additional 8-zone expansion boards available based on load and power supply size. How To Order 18" [457mm] BACS-12-20 Power Supply 12VAC - 20 Amp BACS-24-10 Power Supply 24VAC - 10 Amp 15" [381mm] 6" [152mm] BACSH-12-20 BACSH-24-10 Power Supply 12VAC - 20A 220VAC Power Supply 24VAC - 10A 220VAC 53
800-MAGLOCK 800-624-5625 WWW.SECURITRON.COM & Accessories TP-12-3, TP-24-2 AC plug in transformer 3.5" [89mm] TP-12-3 Transformer TP-12-3 2.75" [70mm] 2.24" [57mm] Plug In 12VAC-3 Amp TP-24-2 Transformer Plug In 24VAC-1.5 Amp B-12-4, B-24-4 3.25" [83mm] 2.75" [70mm] Compliment the BPS series power supplies Applications where the doors must not open in the event of a power failure 4" [102mm] For best system performance, add the PSM series power supply monitor B-12-4 B-12-4 Battery 12VDC 5 Amp Hour B-24-4 Battery 24VDC 5 Amp Hour BR-7 1" [25mm] 1" [25mm] CCB-8 Board 1" [25mm] BR-7 Will convert an AC input to full wave rectified DC output Maximum 7 Amp capacity BR-7 Bridge Rectifier 7 Amp The CCB-8 slave board may be optionally ordered to add eight additional Class 2 outputs to BPS Series power supplies For added safety, the CCB-8 module has emergency release terminals 54 CCB-8 CCB-8-12 Control Board 8 Fused Outputs 12VDC CCB-8-24 Control Board 8 Fused Outputs 24VDC