Equipment Specifications Rebate/Unit Rules

Transcription

1 Fluorescent T8 Fixtures with High Efficiency Electronic Ballasts Replacing T12 Fluorescent with Magnetic Ballast -- Rebate per fixture All 4 foot lamps and ballasts must be on Consortium for Energy Efficiency list. No 700 series T8s rebated. 1- to 2-lamp, low ballast factor 4 foot or less, linear or u-bends (.85) $15 1- to 2-lamp, normal or high ballast factor (>.85) $5 One for one lamp retrofit. For example, retrofitting 2-lamp T12 fixture 3- to 4-lamp, low ballast factor (.85) $34 with 2-lamp T8 fixture. 3- to 4-lamp, normal or high ballast factor (>.85) $26 5 to 8 foot 1- to 2-lamp, low ballast factor (.85) $13 One for one lamp retrofit. High efficiency electronic ballast required. No 1- to 2-lamp, normal or high ballast factor (>.85) $ series T8s allowed. 8 foot to 4 foot Two 4-foot T8 fluorescents, any ballast factor $34 Retrofit 2-lamp 8 foot T12 fixture with two 4-foot T8 fixture (delamping). Must permanently remove one set of sockets. Four 4-foot T8 fluorescents, low ballast factor (.85) $27 Retrofit 2-lamp 8 foot T12 fixture with four 4-foot T8s. 2x2 u-bend 2-3 linear lamp, any ballast factor $24 Retrofit 2x2 u-bend T12 magnetic ballast fixture with 2x2 17-watt T8 linear fluorescents. 2 or 3 17-watt T8 allowed. High efficiency electronic ballasts required. No 700 series T8s allowed. T8 to T8 1- to 4-lamp, low ballast factor (.85) $6 Retrofit standard or magnetic ballast 32-watt T8 fixture with high efficiency electronic ballast with 28-watt or less T8. No 700 series T8s allowed. Low-Wattage Fluorescent T8 Lamps 4 foot, 28-watt or less per lamp rebate $1 Install 28-watt or less T8 lamps instead of 32-watt T8 lamp.

2 Delamping T12 to T8 - Install 1- to 2-lamp T8, Rebate based on permanent removal of lamps, ballasts, and sockets in the any ballast factor $47 fixture. For example, retrofitting 4-lamp T12 to 2-lamp T8. Reducing T12 to T8 - Install 3-lamp, any quantity of fixtures does not qualify. Ballast AND lamps must be on ballast factor $37 Consortium for Energy Efficiency list. May take reflector kit and lowwattage T8 rebate. Reflector Kits Delamping only $4 Reflector kits must be installed in conjunction with delamping and must be 90% reflectivity. Rebate is per fixture. Fluorescent T5 Fixtures with Electronic Ballasts Replacing T12 Fluorescent with Magnetic Ballast -- Rebate per fixture 1- to 2-lamp $16 Retrofit 4-foot T12 fixture with T5 fluorescent and electronic ballast. Exit Signs LED or LEC Exit Signs LED or LEC Exit Signs LED Lamps Replace incandescent with LED or LEC Exit Sign $25 Replace fluorescent > 15 watts with LED or LEC Exit Sign $14 Must replace entire exit sign. 5 watt or less Replace incandescent or halogen $11 Greater than 5 watt to 10 watt lamps with Energy Star qualified LED lamps $15 Greater than 10 watt to 20 watt $26 Must be Energy Star qualified or listed on Lighting Facts. Finding qualifying LEDs at

3 Interior LED Recessed Luminaires Replace incandescent or halogen Must be Energy Star qualified or listed on Lighting Facts (see websites 25 watt or less lamps with LED $32 above). Must be rated for commercial use. Integrated Ceramic Metal Halide 25 watt Replace 65 watt or greater incandescent or halogen with integrated ceramic metal halide. $17 25 watt Integrated ceramic metal halides only. Permanently Installed Lighting Controls No controls or non-working Photocell for Exterior Fixtures photocell $30 Wall Occupancy Sensor No Controls $20 Daylighting, Ceiling or Fixture Sensor No Controls $30 Must be permanently installed. Lighting controls may be wall-, fixture-, or ceiling-mounted, passive infrared, ultrasonic, wireless, or dual technology sensors. Refrigeration EC Motors Replace shaded pole motors $90 walk-in $50 display Must be installed in refrigeration or freezer applications only Rebate is per door. Must install a controller that reduces the energy use of anti-sweat heater by 50% by sensing humidity, dew point or condensation. Rebate only applies to adding ASH controls to existing or new display cases and existing walk-in or warehouse coolers/freezers doors. No rebate is available for NEW walk-in/warehouse. Anti-sweat Heater Controls No controls $90

4 Rebate is per fan motor. Must control 4 fans or more. Evaporator fan control systems must turn off evaporator fans at least 70% of the time the compressor is not running. Must reduce the airflow of evaporator fans in walk-in coolers when compressor(s) cycles off while no refrigerant flows through the evaporator, and must control a minimum fan load of 1/20 horsepower when the fan(s) operate continuously at full speed. Rebate only applies to existing or new display cases and existing walk-in or warehouse coolers/freezers doors. No rebate is available for NEW walkin/warehouse. ECM Fan Controls No controls $40 Rebate is per LED light strip/tube. Must be Design Lights Consortium listed. Find qualifying equipment at: Replace T12, T10, or T8 fluorescent LED Case Lighting case lighting $65 v2.php LED Case Occupancy Control No controls $10 Rebate is per LED controlled. Night Covers - Vertical or Horizontal No covers $6.50 Rebate is per linear feet. Night covers must be used when store is closed. Miscellaneous Variable Frequency Drive (VFD) Constant speed motor with no VFD $100 Engine Block Heater Timer No timer $10 Rebate per horsepower (hp) hp only. Equipment over 100 hp will be evaluated via custom efficiency application. VFD must operate a minimum of 2,000 hours per year to be eligible for rebate. Must be programmable timer. Holy Cross recommends using engine block heater just 2-4 hours before using vehicle. Be sure the timer is (1) a heavy duty, outdoor timer; (2) cold weather resistant; and (3) rated for 15 Amps (1800 watts) capacity.

5 Commercial Energy Efficiency Rebates Equipment Specifications Programmable Thermostat (gas heat) Non-programmable thermostat Programmable Thermostat (electric heat) Non-programmable thermostat Rebate/Unit Rules Participants in this program are encouraged to properly dispose of old thermostats containing mercury. Thermostats can be recycled at Charles D $20 Jones in Glenwood or your county household hazardous waste facility. All electric account only; Participants in this program are encouraged to properly dispose of old thermostats containing mercury. Thermostats can be recycled at Charles D Jones in Glenwood or your county household $50 hazardous waste facility. Commercial Rebate Rules -- all rebates over $5,000 need pre-approval 1. Rebates are subject to change and/or discontinuation without notice. Funding is limited. Applications will be accepted on a first come, first served basis. 2. Rebates are for existing commercial spaces. All measures must be installed within Holy Cross territory. 3. New construction or major renovations will be considered under custom efficiency program. 4. Rebate checks will be sent 4-6 weeks after receiving completed rebate application. 5. Holy Cross Energy reserves the right to inspect the installation premises. 6. Any project not on a prescriptive list may be submitted for consideration under the custom efficiency program. 7. Holy Cross Energy is not liable or responsible for any act or omission of any party, consumer, or contractor whatsoever. 8. Rebate amount cannot exceed 50% of total project cost (material, labor, recycling fee -- no tax, shippping, or permit fees included in total costs). 9. Invoices and/or receipts for purchases and work performed must be furnished. 10. Rebate application and associated invoices/receipts must be received no later than 180 days from date of applicable invoices/receipts. 11. Consumer(s) of record must have an active electric account in good standing with Holy Cross Energy. 12. Commercial rebates are limited to $50,000 per year per member. 13. Itemized invoices showing manufacturer and model number of all equipment is required. 13. Ballasts, fluorescents, and other mercury containing lamps must be recycled and proof of recycling must accompany invoice. Contact Mary Wiener at or mwiener@holycross.com for more information or to submit proposal for rebates over $5,000 or custom projects.