Juan F. Esteban Müller

Similar documents
Dinamica dell Electron Cloud: Calcolo dei Coefficienti della Mappa

Running in Luminosity. Mike Lamont Verena Kain

Activities at the University of Frankfurt (IAP)

HIGH-ENERGY COLLIDER PARAMETERS: e + e Colliders (I)

SIMULATIONS OF ELECTRON CLOUD BUILD-UP AND SATURATION IN THE APS *

Results: Low current ( ) Worst case: 800 MHz, GeV, 4 turns Energy oscillation amplitude 154 MeV, where

Tune and Chromaticity Tracking in the Tevatron. C.Y. Tan 09 May 2006

Lawrence Berkeley National Laboratory Lawrence Berkeley National Laboratory

Design and development of Configurable BPM readout system for ILSF

Spin Tracking with COSY INFINITY and its Benchmarking

Electron cloud effects on beam evolution in a circular accelerator

Beam Instrumentation Group, CERN ACAS, Australian Collaboration for Accelerator Science 3. School of Physics, University of Melbourne 4

Frequency Map Experiments at the Advanced Light Source. David Robin Advanced Light Source

ELECTRON-CLOUD EFFECTS IN THE TESLA AND CLIC POSITRON DAMPING RINGS

FCC JGU WBS_v0034.xlsm

LHC MACHINE PROTECTION

DEVELOPMENT OF BUTTON ELECTRODES FOR SUPERKEKB RINGS

ULTRAFAST LASERS: Free electron lasers thrive from synergy with ultrafast laser systems

C.-K. Ng. Stanford Linear Accelerator Center. and. T. Weiland. University oftechnology. FB18, Schlossgartenstr. 8. D64289, Darmstadt, Germany.

LLRF. Digital RF Stabilization System

SUMMARY OF THE 4TH LHC CRAB CAVITY WORKSHOP LHC-CC10

OPTICAL PARTICLE SIZER MASS CALIBRATION METHOD

Study of electron cloud at MI and slip stacking process simulation

RF-thermal-structural-RF coupled analysis on the travelling wave disk-loaded accelerating structure

Numerical Calculation of Beam Coupling Impedances in the Frequency Domain using the Finite Integration Technique

Coupling Impedance of SIS18 and SIS100 beampipe CERN-GSI-Webmeeting

System Protection Schemes in Eastern Denmark

Large Systems Commissioning

Development of the New Electron Cloud Detectors in the PS

Electron Cloud Development in the Proton Storage Ring and in the Spallation Neutron Source

The BESSY HOM Damped Cavity with Ferrite Absorbers. Review of prototype cavity test results, taperedwaveguidesvshomogenouswaveguides

Cryogenic Current Comparator Status at GSI/FAIR -

Status of the HOM Damped Cavity for the Willy Wien Ring

Project X: A multi-mw Proton Source at Fermilab. Steve Holmes Extreme Beam Lecture Series

TTF OPERATIONS STATISTICS

Digital vs. Analogue Control Systems

m Antenna Subnet Telecommunications Interfaces

RF FRONT END FOR HIGH BANDWIDTH BUNCH ARRIVAL TIME MONITORS IN FREE-ELECTRON LASERS AT DESY

Simulation of Electron Cloud Effects in the PETRA Positron Storage Ring

Machine Protection and Interlock Systems for Circular Machines Example for LHC

Reliability and Availability Aspects of. the IPHI Project

Institute of Accelerator Technologies of Ankara University and TARLA Facility

Simulations and Testing of Retarding Field Analyzers for Electron Cloud Monitoring

AUTOMATION OF OPERATIONS ON THE VEPP-4 CONTROL SYSTEM

Development of High Stability Supports for NSLS-II RF BPMS

The TOTEM experiment at the LHC: results and perspective

IEC TC106. Standards for the Assessment of Human Exposure to Electric, Magnetic, and Electromagnetic Fields, 0 to 300 GHz

physics 112N magnetic fields and forces

A NEAR FIELD INJECTION MODEL FOR SUSCEPTIBILITY PREDICTION IN INTEGRATED CIRCUITS

Status of the SOLEIL project Commissioning from Linac to beamlines

Artisan Technology Group is your source for quality new and certified-used/pre-owned equipment

Relativistic kinematics basic energy, mass and momentum units, Lorents force, track bending, sagitta. First accelerator: cathode ray tube

Jet Reconstruction in CMS using Charged Tracks only

Thanks for discussion and input to: Oliver Bruning, Stephane Fartoukh, Ray Veness, Serge Claudet, Roberto Saban, Ralph Assmann, Andy Butterworth

Status And Future Plans. Mitsuyoshi Tanaka. AGS Department.Brookhaven National Laboratory* Upton NY 11973, USA INTRODUCTION

TESLA Report

DOE LHC Quarterly Review. Magnet Production Cable Testing Cost to Complete issues. Mike Harrison, BNL July 26, 2004

THE TAIWAN LIGHT SOURCE AND SUPERCONDUCTING CAVITY

CLIC accelerator and detector

Acousto-optic modulator

Status of Radiation Safety System at

10 Project Costs and Schedule

Comb beam for particle-driven plasma-based accelerators

XFEL Component Database

LHCC TOTEM STATUS REPORT

Application Note AN:005. FPA Printed Circuit Board Layout Guidelines. Introduction Contents. The Importance of Board Layout

Loop Bandwidth and Clock Data Recovery (CDR) in Oscilloscope Measurements. Application Note

Micro-CT for SEM Non-destructive Measurement and Volume Visualization of Specimens Internal Microstructure in SEM Micro-CT Innovation with Integrity

Slice Emittance Measurements at the SLAC Gun Test Facility*

Coaxial Cable Feeder Influence on Yagi Antenna Dragoslav Dobričić, YU1AW

SPARC Timing System: Design and User Manual. Alessandro Drago, INFN-LNF, Frascati (Roma), Italy

TDA4605 CONTROL CIRCUIT FOR SWITCH MODE POWER SUPPLIES USING MOS TRANSISTORS

T(CR)3IC Testbed for Coherent Radio Cherenkov Radiation from Cosmic-Ray Induced Cascades

Precision Analog Designs Demand Good PCB Layouts. John Wu

The commissioning of the LHC: first the technical systems, then the commissioning with beam

Higher National Unit Specification. General information for centres. Transmission of Measurement Signals. Unit code: DX4T 35

An equivalent circuit of a loop antenna.

Op Amp Circuit Collection

Description. Table 1. Device summary

Zero Degree Extraction using an Electrostatic Separator

VCO Phase noise. Characterizing Phase Noise

RF SYSTEM FOR VEPP-5 DAMPING RING

Figure 1: Lattice drawing for the APS storage ring.

A Polarimetry concept for the EDM experiment at COSY

Application Note, Rev.1.0, September 2008 TLE8366. Application Information. Automotive Power

& Tunnel Cross Section

Agilent AN 1316 Optimizing Spectrum Analyzer Amplitude Accuracy

Solutions Manufacturing Performance

45. The peak value of an alternating current in a 1500-W device is 5.4 A. What is the rms voltage across?

Towards large dynamic range beam diagnostics and beam dynamics studies. Pavel Evtushenko

BEPC UPGRADES AND TAU-CHARM FACTORY DESIGN

Information about the T9 beam line and experimental facilities

A c tiv itie s in Ita ly and at E u r o p e a n S y n c h ro tro n R a d ia tio n S ou rces. S. Tazzari INFN-LNF Frascati, Italy

Lab 4: Magnetic Force on Electrons

Brookhaven National Laboratoy, Upton, NY 11973, USA

FLASH Commissioning and Startup

Possible Upgrades and New Design. F. Velotti and B. Goddard

Spacecraft Computer Systems. Colonel John E. Keesee

Digital to Analog Converter. Raghu Tumati

Transcription:

Juan F. Esteban Müller P. Baudrenghien, T. Mastoridis, E. Shaposhnikova, D. Valuch Acknowledgements: T. Bohl, G. Iadarola, G. Rumolo, L. Tavian, LHC OP team IPAC 14 19.06.2014

E-cloud effects Synchronous phase shift measurements E-cloud observation in LHC operation Summary and future plans 2

Transverse instabilities Emittance growth Particle losses Vacuum degradation Excessive heat load in the cryogenic system Intensity in 25 ns spaced beam Present limitation for LHC operation with 25 ns beams Possible luminosity reduction 3

The energy loss U is compensated by the RF system through a synchronous phase shift Δφ s U = e V N sin φ s U:= bunch energy loss per turn V := RF voltage N := bunch intensity New method for e-cloud observation by measuring Δφ s (with a precision much better than 1 deg) φ s includes also energy loss due to: resistive impedance synchrotron radiation Use the first bunches as a reference Δφ s φ V sin φ 4

Bunch positions from longitudinal profiles? But Include the phase shift due to beam loading, comparable to e-cloud effect (~ 1 deg) Beam phase module from the RF phase loop Required accuracy: < 0.1 deg at 400 MHz 5

LHC at 450 GeV, scrubbing run Dec of 2012 Train of 72 bunches spaced by 25 ns 6

Systematic errors (1) Reflections in the cables: (2) affect subsequent bunches Offset in the IQ plane (vector representation): affects single bunch Transfer function measured with a Measured from the noise in the empty single bunch and used for correction buckets to correct the origin displacement 7

Data post-processing (1) Sine-wave fit of the (2) synchrotron oscillations Smoothing each bunch phase over time 8

Raw data After corrections After post-processing Train of 72 bunches spaced by 25 ns 9

E-cloud build-up leads to an increasing energy loss along the bunch trains Power loss along a few LHC batches Measurements & simulations Reference 1 st batch of 72 bunches Very good agreement with simulations (by G. Iadarola et al. [5]) 10

E-cloud density evolution in the ring can be estimated from the sum of the power loss over all bunches 450 GeV flat bottom Ramp to 4 TeV Δφ s Δφ s Beam 1 Beam 2 cryo cryo Beam 1 Beam 2 The heat load in the cryo system [9,10] can be estimated from Δφ s taking into account: 1) Slow response time of the cryogenic system Moving average filter applied 2) Only the superconducting magnets are measured by cryo Scale factor (0.7/0.79) 11

Scrubbing effect from the maximum power loss per particle for a given fill E-cloud activity at the end of 2011 SEY reduction 12

At the beginning of the scrubbing run (25 ns) No e-cloud for 50 ns beams At the end of the scrubbing run (25 ns) Scattering from the remaining errors 0.1 deg 13

A new method for e-cloud observation was developed using synchronous phase measurements E-cloud build-up along the bunch trains can be observed Total beam power loss due to e-cloud can be calculated Measurements were reproduced in simulations with a very good agreement The heat load in the cryogenic system can be estimated from these measurements The implementation of this method in the LHC Control Room (together with the Operation group) is in progress Real-time e-cloud observation Scrubbing run optimization An input for the cryogenic system feedback 14

1. F. Zimmermann, Review of single bunch instabilities driven by an electron cloud, Phys. Rev. ST Accel. Beams 7 (2004) 124801. 2. G. Rumolo et al., Electron cloud observation in LHC, IPAC 11, San Sebastian, Spain (2011). 3. Proceedings of ECLOUD 12, Isola d Elba, Italy (2012). 4. G. Iadarola et al., Electron cloud and scrubbing studies for the LHC, IPAC 13, Shanghai, China (2012). 5. G. Iadarola and G. Rumolo, Electron cloud simulations with PyECLOUD, ICAP2012, Rostock- Warnemünde, Germany (2012). 6. D. Valuch and P. Baudrenghien, Beam phase measurement and transverse position measurement module for the LHC, LLRF07 Workshop, Knoxville TN, USA (2007). 7. G. Papotti et al., Longitudinal Beam Measurements at the LHC: The LHC Beam Quality Monitor, IPAC 11, San Sebastian, Spain (2011). 8. J. F. Esteban Müller and E. Shaposhnikova, Synchronous phase measurements in the LHC for electron cloud observations, CERN-ACC-NOTE-2013-0007 PERF. 9. K. Brodzinski and L. Tavian, First measurements of beam induced heating on the LHC cryogenic system, ICEC 24 - ICMC 2012, Fukoaka, Japan (2012). 10. L. Tavian, Performance limitations of the LHC cryogenics: 2012 review and 2015 outlook, LHC Beam Operation workshop, Evian, France (2012). 15