High performance LED industrial lighting Where LED technology meets durability Up to 0% energy saving Zero maintenance, no need to relamp LED reliabilty eliminates unsafe & unlit areas Durable vandal resistant construction *Extended warranty requires registration at YEAR EXTENDED Warranty*
Zero maintenance no corrosion, no need to relamp ToughLED is maintenance free and is backed by our trusted year extended warranty* ToughLED uses advanced LED technology that outperforms fluorescent and extends the life of the product, eliminating maintenance costs and reducing energy usage ToughLED features a fully polycarbonate base and diffuser construction for shock and impact resistance with a fully sealed, continuous gasket to prevent water ingress and corrosion The complete range of sizes and outputs is designed to replace single and twin, and ft fluorescent. ToughLED is ideal for commercial, industrial and leisure applications, including car parks, corridors and factories Performance & efficiency that exceeds linear fluorescent The highly efficiency LEDs produce a light output that exceeds traditional fluorescent tubes, while using up to 0% less energy. Wide beam light distribution has a dual diffuser system providing light distribution that is directly comparable to traditional fluorescent LEDs are protected by a thin, inner layer designed to reduce glare and maximise efficiency Fully polycarbonate outer casing provides a super-wide beam angle Vandal resistant casing can easily be used as a direct like-for-like replacement. The number of fittings and their spacing doesn t have to change, but areas appear brighter and more evenly lit, while also helping to significantly reduce electricity costs. A true fit & forget solution with no costly lamp replacement throughout the life of the fitting, installing reduce maintenance and eliminates lamp disposal costs. Lower energy LED 9W 8W Higher output LED 00 Lumens 00 Lumens is exceptionally efficient, providing up to 9 lumens per circuit Watt. Comparatively, T8 fluorescent fittings typically realise only 70 lumens per circuit Watt ToughLEDTM * *Single ft Traditional fluorescent outperforms comparable fluorescent light fittings, providing better illumination and removing dark areas Microwave sensor For optimum energy saving ToughLED is available with an external on/off microwave sensor. Activated by both movement and daylight, ToughLED remains on only when required, switching off when no motion is detected. Occupancy sensing can provide an additional 0% energy saving *Extended warranty requires registration at
Ideal for carparks, warehouse facilities cold stores and food preparation areas Durable construction ToughLED s sturdy construction makes it ideal for rugged applications and is suitable for harsh environments Fully polycarbonate base and diffuser creating a light weight, impact resistant fitting with higher levels of durability Fully sealed, continuous gasket to ensure IP protection from water and dust Solid-state LEDs eliminate the risk of lamps shattering 1 Heavy-duty stainless steel clips as standard, ready for use with anti-tamper screws (supplied) Attached diffuser for quick & easy installation In addition to eliminating maintenance cost, is quick and easy to install, meaning new-builds go up quicker and retrofits suffer less downtime. Detachable gear tray with retainer clip for quick access to the inside of the fitting. 1 Stainless steel clips ensure that the diffuser remains connected during installation, avoiding damage. Multiple wiring options ToughLED s unique strap connects the back to the body ensuring a quick and easy installation. Knock outs at the back and ends of the fitting, plus conduit entry provide three connection points allowing for various installation options. 1 1 Continuous gasket The use of a continuous, one piece gasket ensures that there are no breaks whatsoever in the IP seal Fully polycarbonate base and diffuser Corrosion and impact resistant base and diffuser for durable, maintenance free operation One piece inner diffuser As part of the dual diffuser system, the thin, inner diffuser removes any harsh glare from the LEDs that could be hazardous in industrial environments Unique connection strap Unique strap connects the back plate to the body of the fitting, ensuring a quick and simple installation 7 Highly efficient LEDs Using a linear LED configuration, provides crisp, clean light with a cool 000K colour temperature, designed to make areas appear brighter and provide a sense of security Stainless Steel anti-tamper clips High quality stainless steel clips add greater strength during installation and do not become brittle over time like plastic clips. Prepared and ready for use with anti-tamper screws Mounting hooks can be either surface mounted or suspended from fitted mounting hooks for quick and easy installation
Outperforms fluorescent light output Attached diffuser for quick & easy installation Wide beam angle Instant start up, flicker free Fully polycarbonate base and diffuser IP, fully sealed continuous gasket Stainless steel anti-tamper clips Ideal for commercial, industrial and leisure applications year, industry leading commercial warranty* Single ft Single ft (ft) 100mm (ft) 1800mm JC7101 JC710 Twin ft Twin ft (ft) 100mm (ft) 1800mm JC710 JC710 Product Lumens Wattage Lumens pc/w Colour Temperature IP Rating Single ft 00 9W 91 000K IP Twin ft 9000 98W 91 000K IP Products Lumens Wattage Lumens pc/w Colour Temperature IP Rating Single ft 00 9W 91 000K IP Twin ft 10800 118W 91 000K IP Outstanding cost saving Outstanding cost saving Single ft (8W) Single ft (9W) Twin ft (11W) Twin ft (98W) No. of fittings 0 0 0 0 Total energy usage per fixture 8 9 1 98 Energy cost per hour 0.1 0.9 0.8 0.9 Annual maintenance cost 197.08 N/A 9.1 N/A Annual energy usage,7.08,7. 7,18.1,10.88 Total annual operating cost,771.1,7. 7,.,10.88 Total annual saving 1,19.7 ( per fitting),91. ( 8 per fitting) Assumed commercial usage of hours per day, days per year at a cost of 1p per kw/h Single ft (70W) Single ft (9W) Twin ft (11W) No. of fittings 0 0 0 0 Total energy usage per fixture 8 9 1 118 Energy cost per hour 0.9 0. 0.98 0.71 Annual maintenance cost 197.08 N/A 9.1 N/A Annual energy usage,09.9,101.0 8,19.8,0.08 Total annual operating cost,07.00,101.0 9,01.00,0.08 Twin ft (118W) Total annual saving 1,0. ( 8 per fitting),811.9 ( 7 per fitting) Assumed commercial usage of hours per day, days per year at a cost of 1p per kw/h *Requires online registration at 7
Single ft The direct ft linear fluorescent replacement Outperforms ft linear fluorescent light output Up to 0% energy saving JC7101 JC7101 ft single 9W 00 JC710 ft single emergency 9W 00 JC7109 ft single microwave on/off 9W 00 1 10 Twin ft The direct xft linear fluorescent replacement Outperforms xft linear fluorescent light output Up to 0% energy saving JC710 JC710 ft twin 98W 9000 JC7107 ft twin emergency 98W 9000 JC7111 ft twin microwave on/off 98W 9000 1 1 Single ft The direct ft linear fluorescent replacement Outperforms ft linear fluorescent light output Up to 0% energy saving JC710 JC710 ft single 9W 00 JC710 ft single emergency 9W 00 JC7110 ft single microwave on/off 9W 00 187 10 Twin ft The direct xft linear fluorescent replacement Outperforms xft linear fluorescent light output Up to 0% energy saving JC710 JC710 ft twin 118W 10800 JC7108 ft twin emergency 118W 10800 JC711 ft twin microwave on/off 118W 10800 187 1 Code JC71 JC71 Description 1.m Chain Suspension Kit (Single ) 1.m Double Chain Suspension Kit (Twin ) Lamp White 000K CRI: Ra (80) Construction Diffuser Polycarbonate Body Polycarbonate JCC Lighting Products Ltd Innovation Centre, Beeding Close, Southern Cross Trading Est, Bognor Regis, West Sussex PO 9TS Tel: 01 88999 Email: sales@ Fax: 01 88998 JCC Lighting Products Limited 01 LIT0090