4. SSL-VPN Connection Guide of Configuring INAZUMA Certified Systems INAZUMA Head Office of Sony
Agenda Contents Explanation Scope on this document Overview 0. Getting Started Please be sure to read this for using INAZUMA Certified Systems. Preparation 1. Receiving the user registration notice An e-mail notices you that your registration application is accepted. 2. Installation of the Client Certificate Client Certificate is for proving your PC identity. 3. Obtaining the Global ID Each user should get unified ID for using INAZUMA Certified Systems. Connecting to INAZUMA Certified Systems 4. SSL-VPN Connection SSL-VPN is encrypted communication network. 5. Log in Common Authentication Service This authentication is common authentication system for users of INAZUMA Certified Systems. 4-1. Connecting to SSL-VPN Server About how to connect to SSL-VPN Server. 4-2. Select Client Certificate About how to select Client Certificate. 4-3. Add-On Installation for SSL-VPN Connection Installation of Add-On(ActiveX) is needed one time. 4-4. Activating Add-On Module and Establishment of SSL-VPN Add-On Modules starts automatically, SSL-VPN is established. 4-5. Quitting SSL-VPN connection About how to quit the SSL-VPN connection.
4-1. Connecting to SSL-VPN Server 4-1. Connecting to SSL-VPN Server About how to connect to SSL-VPN Server. 4-2. Select Client Certificate About how to select Client Certificate. 4-3. Add-On Installation for SSL-VPN Connection Installation of Add-On(ActiveX) is needed one time. 4-4. Activating Add-On Module and Establishment of SSL-VPN Add-On Modules starts automatically, SSL-VPN is established. 4-5. Quitting SSL-VPN connection About how to quit the SSL-VPN connection. Overview SSL_VPN, a form of telecommunication, is necessary to connect to INAZUMA Certified Systems, but not all systems require it. Please check if the system which you connect to requires SSL_VPN or not. SSL-VPN is automatically established by connecting to the specified URL by Sony through an internet browser Internet Explorer. This page describes how to connect to SSL-VPN Server. Steps 1. Run Internet Explorer. 2. Access the URL below. https://vpn.portal.sony.biz/jsaz Access to following URL. https://vpn.portal.sony.biz/jsaz Note You need to install the Client Certificate in advance.
4-2. Select Client Certificate 4-1. Connecting to SSL-VPN Server About how to connect to SSL-VPN Server. 4-2. Select Client Certificate About how to select Client Certificate. 4-3. Add-On Installation for SSL-VPN Connection Installation of Add-On(ActiveX) is needed one time. 4-4. Activating Add-On Module and Establishment of SSL-VPN Add-On Modules starts automatically, SSL-VPN is established. 4-5. Quitting SSL-VPN connection About how to quit the SSL-VPN connection. Overview If more than one Client Certificate have been installed on you computer, [Choose a digital certificate] dialog will pop up. Select Client Certificate downloaded from Sony when using INAZUMA Certified Systems. Steps Tip This window will NOT show up if only one Client Certificate has been installed. 1. [Choose a digital certificate] Dialog pops up. 2. [Choose a digital certificate] Dialog shows a list of Client Certificates installed on your PC. Choose a certificate. 3. Choose Client Certificate downloaded from Sony when using INAZUMA Certified Systems. 4. Click [OK]. Click [OK].
4-3. Add-On Installation for SSL-VPN Connection [1/2] 4-1. Connecting to SSL-VPN Server About how to connect to SSL-VPN Server. 4-2. Select Client Certificate About how to select Client Certificate. 4-3. Add-On Installation for SSL-VPN Connection Installation of Add-On(ActiveX) is needed one time. 4-4. Activating Add-On Module and Establishment of SSL-VPN Add-On Modules starts automatically, SSL-VPN is established. 4-5. Quitting SSL-VPN connection About how to quit the SSL-VPN connection. Overview Installation of Add-On(ActiveX) is necessary for SSL-VPN Connection. An install wizard will run automatically on a first access to a SSL-VPN Server. Tip Installing Add-On(ActiveX) for SSL-VPN Connection is required when you first connect to a SSL-VPN Server or the version of SSL-VPN is updated. Steps 1. Click on the information bar regarding [JuniperSetupClient.cab] displayed on Internet Browser. Click the information bar. 2. Click [Install ActiveX Control] on the Drop Down Menu. Click [Install ActiveX Control].
4-3. Add-On Installation for SSL-VPN Connection [2/2] Click [Install] Steps 3. Click [Install] on a [Internet explorer Add-on Installer - Security warning] Dialog. 4. It will be downloaded and installed automtatically. 5. It approximately takes one minute to be installed depending on network speed. 6. Once the installation is finished, SSL-VPN Connection runs automatically. (Refer to 4-4.) Note The installation needs Power User Authority or Administrator Authority.
4-3. Add-On Installation for SSL-VPN Connection [TIP] 1 2 Steps <If the pop-up window (1) appears > 1) Click [OK] 2) Close the browser 3) Access the URL again 4) Install Add-On again < If the screen (2) appears while establishing a connection > 1) Click[Continue the session] 2) Quite the existed connection and try to connect SSL-VPN again
4-4. Activating Add-On Module and Establishment of SSL-VPN 4-1. Connecting to SSL-VPN Server About how to connect to SSL-VPN Server. 4-2. Select Client Certificate About how to select Client Certificate. Overview If you try 4-1. and 4-2. once again after finishing [4-3. Add-On Installation for SSL-VPN Connection], the Add-On runs automatically and SSL-VPN connection will be established. 4-3. Add-On Installation for SSL-VPN Connection Installation of Add-On(ActiveX) is needed one time. 4-4. Activating Add-On Module and Establishment of SSL-VPN Add-On Modules starts automatically, SSL-VPN is established. 4-5. Quitting SSL-VPN connection About how to quit the SSL-VPN connection. [ Precondition ] An Add-On(ActiveX) for SSL-VPN Connection has been installed. Steps 1. Follow instructions in 3-1, and 3-2 again. (URLs connected to ; check Appendix1) 1. The Add-On runs automatically and SSL- VPN Connection will be established. Authentication Success. Please open new browser and type URL. 2. If SSL-VPN Connection is set, a message will be displayed on Internet Browser. 3. Also an SSL-VPN icon will appear on the [System Tray]. An SSL-VPN icon appears on the [System Tray].
4-5. Quitting SSL-VPN connection 4-1. Connecting to SSL-VPN Server About how to connect to SSL-VPN Server. 4-2. Select Client Certificate About how to select Client Certificate. 4-3. Add-On Installation for SSL-VPN Connection Installation of Add-On(ActiveX) is needed one time. 4-4. Activating Add-On Module and Establishment of SSL-VPN Add-On Modules starts automatically, SSL-VPN is established. 4-5. Quitting SSL-VPN connection About how to quit the SSL-VPN connection. Overview This page describes how to quit the SSL-VPN connection after logging out from each INAZUMA Certified Systems. Click the [Sign Out] from [Basic View] icon, and then quite the SSL-VPN connection. For log in each INAZUMA Certified System with SSL-VPN connection, please read 5.Log in Common Authentication Service. [ Precondition ] SSL-VPN connection has been established. Steps 1. Right click on the icon in task tray. 2. A pop-up window appears so that choose [Basic View]. 3. Click [Sign Out] on [Basic View] window. 4. The connection will be cut. Guide of SSL-VPN Connection ends here.
Appendix
Appendix1. SSL-VPN URL URL for SSL-VPN Connecting SSL-VPN, please access to following URL. https://vpn.portal.sony.biz/jsaz
Revision History
Revision History Date Ver. Contents for change Editor Apr. 08, 2011 1.0 First edition INAZUMA Head Office Sep. 20, 2011 2.0 The URL of SSL-VPN is revised on Page 3 Caution is deleted on Page 7 Appendix1 is added Feb. 13, 2012 3.0 3-3. Add-On Installation for SSL-VPN Connection(1/2) was updated. 3-3. Add-On Installation for SSL-VPN Connection(Note)was added. 3-5. Quitting SSL-VPN connection was added. The manual No. was changed from 3 to4. Mar. 01, 2013 3.1 Added SPIRITS to the sub title on the cover. Added and SPIRITS to [Agenda]. Deleted one of SSL-VPN URLs from [4-1. Connecting to SSL-VPN Server] and Appendix. Changed the client module name on [4-3. Add-On Installation for SSL-VPN Connection [1/2]]. INAZUMA Head Office IINAZUMA Head Office INAZUMA Head Office Jun. 27, 2013 3.2 Deleted the word of SPIRITS in this manual. INAZUMA Head Office Jun. 17, 2014 3.3 Changing layouts and some expressions. INAZUMA Head Office Apr. 13, 2015 3.4 Specifying Internet Explorer for internet browser on [4-1. Connecting to SSL- VPN Server]. INAZUMA Head Office
E.O.F.