ANOISON HPQN SERIES HPQN CONNECTORS INTERFACE DIMENSIONS. Description. Interface Dimensions 21 Characteristics

Transcription

1 SERIES HPQN CONNECTORS DESCRIPTION CONTENT Designed by James Qu at Anoison in 2006, the HPQN is a quick locking version of the widely used type N connector. By replacing the threaded interface of the original N with a snap-on coupling mechanism, the HPQN series is able to provide x faster mating, denser packaging and greater flexibility since the connector may be rotated 360º while in the mated position. This was achieved without impairing electronic performance up to 11 GHz. by designing the locking mechanism around the industry standard geometry of threaded N connectors. The resulting high performance, in addition to the increased speed and convenience, makes the HPQN ideal for a wide range of applications. Additionally, when the HPQN is used with semi-rigid cable, conformable cable, test adaptors or high frequency terminations, it may be utilized in applications up to GHz. 21 Interface Dimensions 21 Characteristics 22 Cable Connectors 23 Panel Receptacles 2 In Series Adapter 26 Between Series Adapters 27 Termination 29 INTERFACE DIMENSIONS Plug (male) [.394] Jack (female) 11 [.433] 21

2 CHARACTERISTICS ELECTRICAL Impedance Frequency range Dielectric Withstanding Voltage Working Voltage VSWR Insulation Resistance Power Handling Contact Resistance - Center contact - Outer contact Passive Intermodulation RF-leakage DC to 3 GHz 3GHzto6GHz REQUIREMENTS 0 DC to GHz 200 V rms 0 Hz, sea level 1,000 V rms 0 Hz, sea level Straight connector,.141": 1.28 (DC~ GHz) Straight connector, RG316: 1.24 (DC~6 GHz) Right angle connector,.141": 1.4 (DC~ GHz) Right angle connector RG316: 1.32 (DC~6 GHz) ³ M Ohms min.(initial) GHz typical 1. m max. 1. m max GHz 2x20 W static -90 db min. -7 db min. MECHANICAL Mating Characteristics -EngagementForce - Disengagement Force Interface Retention Force Durability ( Mating Cycles) REQUIREMENTS 3 N typical 4 N typical 200 N (standard) 40 N (special application) 200 min. ENVIRONMENTAL REQUIREMENTS Temperature Range -40 C to +12 C Climactic Category 40/12/21 (IEC 60169_1 16.2) Rapid Temperature Change IEC (-40 C to +12 C) Corrosion Salt spray test per MIL-STD-202 F, Method 1 D, Condition B Moisture Resistance MIL-STD-202 F, Method 6 F Vibration IEC Paragraph9.3.3(-00 Hz;g) Dust & Moisture protection IP Rating interface IEC 6029 IP 68 Note The above characteristics are typical but may not apply to all connectors. 22

3 CABLE CONNECTORS Straight Cable Plugs (male) for semi-rigid cables ANO HPQN straight plug solder for semi-rigid.141/rg [.81] ANO HPQN straight plug crimp for RG8/LMR [1.169] ANO HPQN Straight plug clamp for LMR [1.79 REF.] 3 [1.382] SW 14 [.1 HEX.] SW 1 [.91 AF.] 23

4 Right Angle Cable Plugs (male) for semi-rigid cables ANO HPQN right angle plug solder for semi-rigid.141/rg402 2 [.984] 20.7 [.81] 14 [.67] [.394] ANO HPQN right angle plug crimp for RG8/LMR19 2 [.984] 20.7 [.81] 26.7 [1.01] 14 [.1] Straight Bulkhead Cable Jacks (female) for semi-rigid cables ANO HPQN straight jack bulkhead solder for semi-rigid.141/rg [1.004] 17 [.669] MAX. 2 [MAX..079] [.12 DIA.] 24 SW 17 [.669 HEX.] 1/2-28 SW 16 [.630 HEX.] 12.1 [.476]

5 ANO HPQN straight jack bulkhead crimp for RG8/LMR [1.622] MAX. 9 [MAX..34] 26 [1.024] [.12 DIA.] SW 17 [.669 HEX.] 1/2-28 SW 16 [.630 HEX.] 12.1 [.476] ANO HPQN straight jack bulkhead crimp for RG400/RG [1.476] 20 [.787] MAX. 3. [MAX..1] [.12 DIA.] SW 17 [.669 HEX.] PANEL RECEPTACLES 1/2-28 SW 16 [.630 HEX.] 12.1 [.476] Panel mount, receptacles ANO HPQN straight jack press-in chassis mount 2.1 [.083 DIA.] 2. [.098]. [.728] 1.2 [.047] 12.2 [.480] 9.9 [.390 DIA.] 12 [.472] 2

6 Panel mount, receptacles ANO HPQN straight jack screw panel mounted 3 [.1] 21 [.827] [.12] 2 [.079].60 [.3] 2 [.079 DIA.] Mx0.7 SW 12 [.472 HEX.] Mx0.7 Panel mount, receptacles ANO HPQN jack receptacle,4 hole square flange 17. [.689 SQ.] 12.7 [.00] 2.1 [.083 DIA.] 19 [.748] 1 [.91] 2 [.079] 2.2 [.087 DIA.] 12.7 [.00] 3.2 [.126 DIA.] IN SERIES ADAPTER HPQN / HPQN ANO HPQN male to HPQN male 32 [1.260] [.0 DIA.] 26

7 HPQN / HPQN ANO HPQN female to HPQN female 30 [1.1] HPQN / HPQN ANO HPQN male to HPQN female 3 [1.378] BETWEEN SERIES ADAPTERS HPQN / SMA ANO HPQN female to SMA female 28. [1.122] 1/4-36 UNS-2A 12 [.472 DIA.] 27

8 HPQN / SMA ANO 3I HPQN male to SMA female 36.6 [1.441] 1/4-36 UNS-2A HPQN / SMA ANO HPQN male to SMA male 37.7 [1.484] 7.8 [.307 DIA.] HPQN / SMA ANO HPQN female to SMA male 29.6 [1.16] 7.8 [.307 DIA.] HPQN / N ANO HPQN female to N female 30.4 [1.197] /

9 HPQN / N ANO HPQN male to N female 38. [1.16] /8-24 HPQN / N ANO HPQN male to N male 40.6 [1.98] 20 [.787 DIA.] HPQN / N ANO HPQN female to N male 32. [1.280] 20 [.787 DIA.] TERMINATION Low power 1 to 2W CW, 0W peak ANO RF Termination, HPQN Male, 1W, 0-6GHz 29.2 [1.10] [.12 DIA.] 29