SITE INVESTIGATION FACILITIES



Similar documents
CONSULTANCY & MATERIAL TESTING FACILITY

Construction Materials Testing. Classes of Test

1 Mobilisation and demobilisation 1 Deep boring sum 2 Cone penetration tests sum 3 Miscellenous tests sum

CONSTRUCTION MATERIAL TESTING

c. Borehole Shear Test (BST): BST is performed according to the instructions published by Handy Geotechnical Instruments, Inc.

Quality control: Annex-A.

INDIRECT METHODS SOUNDING OR PENETRATION TESTS. Dr. K. M. Kouzer, Associate Professor in Civil Engineering, GEC Kozhikode

Work Type Definition and Submittal Requirements

product manual HS-4210 HS-4210_MAN_09.08 Digital Static Cone Penetrometer

FINAL REPORT ON SOIL INVESTIGATION

Schedule of Accreditation issued by United Kingdom Accreditation Service High Street, Feltham, Middlesex, TW13 4UN, UK

Anirudhan I.V. Geotechnical Solutions, Chennai

Recycled Concrete Pavement and Other Recycled Materials in Concrete Pavements

Shotcrete Quality Control and Testing for an Underground Mine in Canada

Eurocode 7 - Geotechnical design - Part 2 Ground investigation and testing

SERVICES 2015 ISO 18001

QUESTION TO AUDIENCE

Geotechnical Investigation Test Report

1.5 Concrete (Part I)

2009 Japan-Russia Energy and Environment Dialogue in Niigata S2-6 TANAKA ERINA

1.0 INTRODUCTION SCOPE OF WORK EXECUTION OF FIELD WORK LABORATORY TESTS FINDINGS OF THE GEOTECHNICAL INVESTIGATION 9

COMPENDIUM OF INDIAN STANDARDS ON SOIL ENGINEERING PART 2

KWANG SING ENGINEERING PTE LTD

Schedule of Accreditation Issued by United Kingdom Accreditation Service 2 Pine Trees, Chertsey Lane, Staines-upon-Thames, TW18 3HR, UK

ANNEX D1 BASIC CONSIDERATIONS FOR REVIEWING STUDIES IN THE DETAILED RISK ASSESSMENT FOR SAFETY

Module 1 : Site Exploration and Geotechnical Investigation. Lecture 4 : In-situ tests [ Section 4.1: Penetrometer Tests ] Objectives

Geotechnical Investigation using Standard Penetration Test (SPT) in Rangamati, Bandarban and Khagrachari Towns

TENDER NO: PSER:SCT:SNG-C1667:15 VOLUME III PRICE SCHEDULE (REV-00)

HIGHWAYS DEPARTMENT GUIDANCE NOTES ON SOIL TEST FOR PAVEMENT DESIGN

Quality Assurance Program. June by Texas Department of Transportation (512) all rights reserved

Strength and Workability Characteristics of Concrete by Using Different Super Plasticizers

INTERNATIONAL JOURNAL OF CIVIL AND STRUCTURAL ENGINEERING Volume 3, No 3, 2013

Pavements should be well drained both during and upon completion of construction. Water should not be allowed to pond on or near pavement surfaces.

INSITU TESTS! Shear Vanes! Shear Vanes! Shear Vane Test! Sensitive Soils! Insitu testing is used for two reasons:!

Testing and appraisal of Lucobit polymer effect as an additive on asphalt mixture performance

Successful Approach to the Repair of Reinforced Concrete Support Structures in Delayed Coking Units

SPECIFICATION FOR DYNAMIC CONSOLIDATION / DYNAMIC REPLACEMENT

King Saud University College of Engineering Civil Engineering Department DEFORMATION OF PARTIALLY SATURATED SAND. Sultan Musaed Al-Ghamdi

Evaluation of Initial Setting Time of Fresh Concrete

Structural Audit of Buildings

SPECIAL COMPOUND FOR RHEOPLASTIC AND ANTI-CORROSION SUPERCONCRETE WITH VERY HIGH DURABILITY

Introduction: Overview of Soil Mechanics

AGREGADOS RECICLADOS MITOS Y REALIDADES

How To Design A Foundation

Geotechnical Testing Methods II

SECTION 18 - CAST IN PLACE HIGH PERFORMANCE CONCRETE (HPC)

Condition assessment and repair of antenna towers concrete foundations

SUPPORTED STANDARDS BY

Module 3 : Sewer Material. Lecture 3 : Sewer Material

Site Investigation. Some unsung heroes of Civil Engineering. buried right under your feet. 4. Need good knowledge of the soil conditions

Material and methods. Värmeforsk report Niklas Hansson DIANAS utilization of waste inciniration bottom ash in bound construction materials

FAN group includes NAMVARAN UPSTREAM,

NorthEast Transportation Training and Certification Program (NETTCP) Course Registration Form

CIVL451. Soil Exploration and Characterization

Module 1 : Site Exploration and Geotechnical Investigation. Lecture 5 : Geophysical Exploration [ Section 5.1 : Methods of Geophysical Exploration ]

Geotechnical Investigation Reports and Foundation Recommendations - Scope for Improvement - Examples

Soil Mechanics. Soil Mechanics

The Concrete Life Cycle: Maintain to Sustain. Fred Goodwin BASF Construction Chemicals (EB-N) Beachwood OH

EGYPTIAN CODES FOR DESIGN AND CONSTRUCTION OF BUILDINGS

Hardened Concrete. Lecture No. 14

CHESTERFLEX ROOF WATERPROOFING MEMBRANES

Module 3: Sewer Material Lecture 3: Sewer Material

STP883-EB/Nov Subject Index

LABORATORY CLASSIFICATION OF SOILS FOR ENGINEERING PURPOSES

LABORATORY DETERMINATION OF CALIFORNIA BEARING RATIO

TECHNICAL NOTE: SI 01 SPECIFIC REQUIREMENTS FOR THE ACCREDITATION OF INSPECTION BODIES FOR SITE INVESTIGATION

Geotechnical Measurements and Explorations Prof. Nihar Ranjan Patra Department of Civil Engineering Indian Institute of Technology, Kanpur

Geotechnical Standards Eurocodes. An update

Testing Procedures. Note: Please refer to Table 2 for a list of completed borings.

Concrete Repair. Applications and Procedures

COMPARISON OF CORE AND CUBE COMPRESSIVE STRENGTH OF HARDENED CONCRETE

Example Specification for Concrete using Current Building Code Requirements

CONDITION ASSESSMENT OF BUILDINGS FOR REPAIR AND UPGRADING

Foundation Code compliance and Best Practices By Michael Coello

(1) Discuss the determination of the need for public visitation. Visitor center density within 100 miles.

International Journal of Scientific & Engineering Research, Volume 4, Issue 9, September ISSN

TABLE OF CONTENTS CHAPTER NO. TITLE PAGE NO. ABSTRACT

A study on the Effect of Distorted Sampler Shoe on Standard Penetration Test Result in Cohesionless soil

CGA Standard Practices Series. Article 600 Standard for Pozzolan Enhanced Grouts Used in Annular Seals & Well Destruction

USE OF GEOSYNTHETICS FOR FILTRATION AND DRAINAGE

TECHNICAL SPECIFICATIONS CEMENT-BENTONITE SLURRY TRENCH CUTOFF WALL

GUIDELINES ON NON-DESTRUCTIVE TESTING OF BRIDGES

TECHNICAL REPORT ON SCALA DYNAMIC CONE PENETROMETER IRREGULARITY

VOLUME III GEOLOGY, HYDROGEOLOGY & GEOTECHNICAL REPORT CAPITAL REGION RESOURCE RECOVERY CENTRE

ASPHALT, CONCRETE, SOILS

GEOSYNTHETICS ENGINEERING: IN THEORY AND PRACTICE

Measurement of Soil Parameters by Using Penetrometer Needle Apparatus

Stone crusher dust as a fine aggregate in Concrete for paving blocks

Figure CPT Equipment

PROPERTIES AND MIX DESIGNATIONS

Specification Guidelines: Allan Block Modular Retaining Wall Systems

ENGINEERING MATERIALS LABORATORY SECTION

Chittagong Hill Tract Development Facilities (CHTDF) United Nations Development Programme

The surface roughness of the polyurethane lining is 10 times lower than cement-lined pipes.

Study of durability of sprayed concrete

Transcription:

SITE INVESTIGATION FACILITIES Drilling Hydraulic rotary & calax drilling rigs100/150mm Diameter boreholes having drilling capacity up to 200m depth. Auger drilling 100/150mm diameter boreholes up to maximum depth of 25m. Shell & auger drilling. Sampling Disturbed Samples Undisturbed samples 38 mm to 100 mm diameter. Core Samples(rock & hard clay) Field Tests Standard Penetration Test Dynamic cone penetration test Static cone penetration test Plate load test, Cyclic plate load test Vane shear test Field CBR test Field permeability test In-situ density & moisture content Electrical resistivity test Block vibration test Trial pits LABORATORY TEST Soil Grain size analysis Density & moisture content Specific gravity test Direct shear test Liquid, plastic and shrinkage limits Triaxial shear test Unconfined compression test Permeability test (constant & variable head) Consolidation test CBR test Chemical analysis of soil Swell index & swell pressure test

Concrete Mix design (NSC, HSC, HPC, DLC, HVFA) Compressive strength Tensile strength Flexural strength Cement content Density Slump/CF/Flow value Durability Test DIN permeability Rapid chloride ion permeability test Initial surface absorption test Abrasion test, Cement content Cement Consistency Fineness Compressive strength Chemical analysis Aggregates Gradation(sieving) Water absorption Flakiness Index Abrasion value Impact value Ten percent fine value Crushing value Elongation Index Alkali aggregate reactivity Sand Grain size analysis Fineness modulus Specific Gravity Silt content

Bitumen Specific gravity Flash & fire point Softening point Penetration test Ductility Viscosity Water Content by dean & stark apparatus Mix design by Marshal stability method Rock Tests Uniaxial compression test Hardness Water absorption Slake Durability Index Porosity & Density Point load strength index Modulus of Elasticity Specific gravity test NON DESTRUCTIVE TESTING/QUALITY ASSURANCE SERVICES ULTRASONIC PULSE VELOCITY TEST to know the Compactness & Durability of hardened concrete. SCHMIDT DIGITAL HAMMER TEST with Electronic Hammer PROCEQ, to know the actual compressive strength of hardened concrete. CARBONATION TEST to know the weathering action and durability of Concrete. RESISTIVITY TEST & HALF CELL POTENTIAL TEST to know the probability & presence of Corrosion of Rebar of hardened PULL OUT/OFF TEST to know Direct Tensile & Compressive Strength of Hardened Concrete. CORE DRILLING to know actual compressive strength as per BIS/ASTM standards.

Planning, Project Preparation & Monitoring Design & Detailed Engineering Construction Management & Quality Control Topographical Survey and Geo Technical Investigation GIS, Remote Sensing & Cadastral Survey Mapping Mineral Prospecting, Mine Planning Forest Diversion Clearences Ecology & Biodiversity Study Environmental Management Occupational Health Services Rehabilitation & Resettlement Study Agricultural Development Laboratory Services Infrastructure Engineering Water Resource Management Highyway & Bridges Waste Water, Hazardous Waste, Ambient Air, Ambient Noise, Solid Waste, Fly ash & Minerals EIA / EMP Study Environment & Safety Audit,On Site Emergency LABORATORY Faciliated With MoEF Accrediated Env.Lab. Accreditation of A grade by SPCB. Implementation of IMS. Goverment Certified Infrastructure Laboratory. Upgradation of Air Quality Lab to meet NAAQ Standards. Analysis & Monitoring Industrial Pollution Control Water & Waste Water Treatment Air Pollution Control Solid & Hazardous Waste Management TURNKEY Project Execution Effluent Treatment Process(ETP) Sewage Treatment Process(STP) Secured Landfill Slope Protection Control Treatment of Ponds & Lakes Soil,Cement, Concrete, Bitumen, Aggregates, Reinforcement & Materials Visiontek Consultancy Services Pvt. Ltd. BHUBANESWAR Plot No.: 108, District Center, Chandrasekharpur Bhubaneswar-751016, Odisha, India Phone : +91-674-6600800-39, 6451781, 3250790, Fax : +91-674-2744594, E-mail : visiontekin@gmail.com visiontekin@yahoo.co.in, visiontek@vcspl.org RANCHI 357A, Road No. : 5 Ashok Nagar, Ranchi - 834002 Phone : 0651-2242175 (An Enviro Engineering Consulting Cell) ISO 9001:2008 and OHSAS 18001:2007 Certified Visit us : www.vcspl.org ASANSOL Manoj Cinema Basement, Kumarpur, Asansol-713304 District - Burdwan West Bengal Phone : 03412252011 PUNE Janaki Appartment Flat No-12, 47/5A, Erandwane Nalstop, Karvey Road, Pune - 411004 (INDIA)