SEMICONDUCTOR PFCM-1500M HERMETIC POWER FACTOR CORRECTION MODULE FEATURES: HERMETIC PACKAGE RECTIFIER BRIDGE 600 VOLT, 0.21 OHM, 26.0A MOSFET 1500/3000 WATT PFC ULTRAFAST DIODE HEAT SINK MOUNTING MOSFET RATINGS MAXIMUM RATINGS ALL RATINGS ARE AT T C = 25 C UNLESS OTHERWISE SPECIFIED. RATING SYMBOL MIN. TYP. MAX. UNITS GATE TO SOURCE VOLTAGE V GS - - ±30 Volts ON-STATE DRAIN CURRENT @ T C = 25 C I D - - 26 Amps ON-STATE DRAIN CURRENT @ T C = 100 C I D - - 17 Amps OPERATING AND STORAGE TEMPERATURE T OP /T STG -55 - +150 C TOTAL DEVICE DISSIPATION @ T C = 25 C P D - - 470 Watts ELECTRICAL CHARACTERISTICS CHARACTERISTIC SYMBOL MIN. TYP. MAX. UNITS DRAIN TO SOURCE BREAKDOWN VOLTAGE BV DSS 600 - - Volts V GS = 0V, I D = 1.0mA STATIC DRAIN TO SOURCE ON STATE RESISTANCE - - V GS = 10V, I D = 16A R DS(ON) 0.25 Ω GATE THRESHOLD VOLTAGE V DS =V GS, I D = 250uA V GS(th) 3.0-5.0 Volts FORWARD TRANSCONDUCTANCE g fs 13 - - S(1/Ω) V DS =50V, I DS = 16.0A ZERO GATE VOLTAGE DRAIN CURRENT - - V DS = 600V, V GS = 0V V DS = 480V, V GS = 0V, T J = 125 C I DSS 50 2000 µa GATE TO SOURCE LEAKAGE FORWARD V GS = 30V I GSS - - 100 na GATE TO SOURCE LEAKAGE REVERSE V GS = -30V -100 TURN ON DELAY TIME V DD = 300V, t d(on) - - 31 RISE TIME I D = 26A, t r 110 nsec TURN OFF DELAY TIME R G = 4.3Ω t d(off) 47 FALL TIME t f 42 TOTAL GATE CHARGE I D = 26A, Q g - - 180 nc
ELECTRICAL CHARACTERISTICS MOSFET RATINGS Cont. CHARACTERISTIC SYMBOL MIN. TYP. MAX. UNITS GATE TO SOURCE CHARGE V GS = 10V, Q gs - - 61 nc GATE TO DRAIN CHARGE V DS =480V Q gd - - 85 nc DIODE FORWARD VOLTAGE T C = 25 C, I S = 26A, V SD - - 1.5 Volts V GS = 0V REVERSE RECOVERY CHARGE T J = 25 C, Q RR - - 10 µc di/dt 100A/µsec, V DD 50V REVERSE RECOVERY TIME T J = 25 C, t rr - - 250 I F = 26A, nsec di/dt 100A/µsec THERMAL RESISTANCE Rthjc.25 INPUT CAPACITANCE V GS = 0 V C iss - 5020 - OUTPUT CAPACITANCE V DS = 25 V C oss 450 pf REVERSE TRANSFER CAPACITANCE f = 1.0MHz C rss 34 DIODE BRIDGE RATINGS MAX. RATINGS / ELECTRICAL CHARACTERISTICS All ratings are at T A = 25 o C unless otherwise specified. RATING CONDITIONS MIN TYP MAX UNIT Peak Inverse Voltage (PIV) - - - 800 Vdc Average DC Output (I o ) Current (T C = Case Temp) Peak Single Cycle Surge Current (I FSM ) T C = 100 o C - - 50 Amps t p = 8.3 ms Single Half Cycle Sine Wave, Superimposed On Rated Load - - 500 Amps(pk) Maximum Forward Voltage Per Leg (V f ) I f = 50Adc (300 µsec pulse, duty cycle < 2%) - - 1.2 Volts THERMAL RESISTANCE 1.5 Maximum Instantaneous Reverse Current At Rated (PIV) T A = 25 C T A = 100 C - - 5.0 300 µamps
ULTRAFAST RECTIFIER RATINGS MAXIMUM RATINGS All ratings are @ T A = 25 c unless otherwise specified RATING SYMBOL MAX. UNITS PEAK INVERSE VOLTAGE PER LEG PIV 800 Volts MAX DC OUTPUT CURRENT (T C =100 O C) COMMON CATHODE / ANODE I O 25 Amps MAXIMUM SURGE CURRENT (T C =25 O C, T=8.3 MSEC) PER LEG I FSM 100 Amps REVERSE RECOVERY TIME (I f = 25A, di/dt = 100A/µsec, V R = 30V, T C =25 O C) 50 nsec THERMAL RESISTANCE 1.5 MAXIMUM OPERATING AND STORAGE TEMPERATURE RANGE Top/Tstg -55 to + 150 C ELECTRICAL CHARACTRISTICS CHARACTRISTIC SYMBOL MAX UNITS MAXIMUM FORWARD VOLTAGE DROP, Pulsed, PER LEG T C = 25 C (I f = 25 Amps) MAXIMUM FORWARD VOLTAGE DROP, Pulsed, PER LEG T C = 100 C (I f = 25 Amps) V f 2.60 Volts V f 2.45 Volts MAXIMUM REVERSE CURRENT PER LEG T C = 25 C I r @ 800V PIV I r 200 µa MAXIMUM REVERSE CURRENT PER LEG T C = 100 C I r @ 800V PIV I r 2 ma MODULE RATINGS MAXIMUM OPERATING AND STORAGE TEMPERATURE RANGE Top/Tstg -55 to + 150 AVERAGE THERMAL RESISTANCE R thjc 1.1 C o C/W
MECHANICAL DIMENSIONS: in Inches PIN DEVICE FUNCTION NUMBER 1 BRIDGE RECTIFIER AC INPUT 2 BRIDGE RECTIFIER AC INPUT 3 BRIDGE RECTIFIER + DC OUTPUT 4 MOSFET DRAIN 5 ULTRAFAST RECTIFIER ANODE 6 ULTRAFAST RECTIFIER CATHODE 7 MOSFET GATE 8 MOSFET SOURCE (DUAL USE) BRIDGE RECTIFIER - DC OUTPUT 1 8 SCHEMATIC DIAGRAM
SEMICONDUCTOR DISCLAIMER: 1- The information given herein, including the specifications and dimensions, is subject to change without prior notice to improve product characteristics. Before ordering, purchasers are advised to contact the Sensitron Semiconductor sales department for the latest version of the datasheet(s). 2- In cases where extremely high reliability is required (such as use in nuclear power control, aerospace and aviation, traffic equipment, medical equipment, and safety equipment), safety should be ensured by using semiconductor devices that feature assured safety or by means of users fail-safe precautions or other arrangement. 3- In no event shall Sensitron Semiconductor be liable for any damages that may result from an accident or any other cause during operation of the user s units according to the datasheet(s). Sensitron Semiconductor assumes no responsibility for any intellectual property claims or any other problems that may result from applications of information, products or circuits described in the datasheets. 4- In no event shall Sensitron Semiconductor be liable for any failure in a semiconductor device or any secondary damage resulting from use at a value exceeding the absolute maximum rating. 5- No license is granted by the datasheet(s) under any patents or other rights of any third party or Sensitron Semiconductor. 6- The datasheet(s) may not be reproduced or duplicated, in any form, in whole or part, without the expressed written permission of Sensitron Semiconductor. 7- The products (technologies) described in the datasheet(s) are not to be provided to any party whose purpose in their application will hinder maintenance of international peace and safety nor are they to be applied to that purpose by their direct purchasers or any third party. When exporting these products (technologies), the necessary procedures are to be taken in accordance with related laws and regulations. 221 West Industry Court Deer Park, NY 11729-4681 (631) 586-7600 FAX (631) 242-9798 World Wide Web - http://www.sensitron.com E-Mail Address - sales@sensitron.com