Client: Project name: Order #: Type: Qty: FEATURES AND BENEFITS Physical : Low copper content high pressure die-cast aluminum housing Steel formed yoke (standard yoke included) Stainless steel hardware Silicone sealing devices Clear tempered glass Dual chamber design for heat management and ease of maintenance Electro-statically applied polyester powder coat finish 16.33 kg / 36 lbs EPA: Front = 2.75 sq. ft./ 0.26 sq. m. Side = 1.17 sq. ft./ 0.12 sq. m. IP66 IK09 rated Corrosion-resistant option for marine environments Meets 3G ANSI C136.31 Vibration standard for bridge applications Performance : Minimum 1fc (10.7 lux) @ 528 feet (160m) distance (4000K, 6 optic, RO version) Minimum 1fc (10.7 lux) @ 810 feet (246m) distance (4000K, 6 optic, HO version) 7,982 delivered lumens and 279,622 candelas at nadir (4000K, 6 optic, RO version) 10,447 delivered lumens and 656,461 candelas at nadir (4000K, 6 optic, HO version) CRI value: 78+ 6, 10, 20, 40 or 60 optics available Lumen maintenance 120,000 hrs [L70 @ 25 C] Resolution per board or per (see page 6) Lumen measurements comply with LM - 79-08 standard Operating temperatures: -25 C to 50 C [-13F to 122F] Electrical : Line voltage luminaire for 100 to 277V Power and data in 1 cable, 3ft/1 m cord (#16-5) Regular Output version: 140 watts High Output version: 205 watts Dimming options: 0-10 volt, DMX, DALI, Lumentalk, or Lutron EcoSystem enabled IK09 TOP VIEW 1 172 " [445mm] 5 3 4 " [146mm] 0 68 board #2 board #3 board #1 171 4 " [438mm] 231 8 " [587mm] 90 160 5 year warranty FRONT VIEW Standard Yoke (as shown, included) SIDE VIEW Standard Yoke Mounting Adjustable Pivot Limits (Adjustable in 6 degree increments) 1/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
MOUNTING OPTION 5 3 4 " [146mm] 17 1 2 " [445mm] 0 18 3 4 " [476mm] 70 110 SY Short Yoke Mounting Short Yoke mounting adjustable pivot limits (Adjustable in 6 degree increments) 3" [76mm] 1 5 " " 2 8 [13mm] [16mm] Standard and Short Yoke mounting holes Pattern OPTICAL OPTIONS *Factory installed LSLH Linear Spread Lens Horizontal distribution (not adjustable on site) LSLV Linear Spread Lens Vertical distribution (not adjustable on site) Factory installed, available for 6 to 40 optics. See Optical Accessories for field adjustable spread lens. *See photometric section for optical performance data with the spread lens. 2/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
ACCESSORIES Order separately Mounting Accessories 28 5 16 " [719mm] PM4-1, PM4.5-1, PM5-1 Round Pole Mounting accessory single 7 5 " 16 [185mm] 5 3 " 16 [132mm] 2 3 16 " [55mm] PM4-2, PM4.5-2, PM5-2 Round Pole Mounting accessory twin s When PM4-2, PM4.5-2 or PM5-2 are specified, one bracket assembly is supplied per 2 s unless otherwise specified. PM4 Round Pole Mounting Accessory Shown *Consult factory for square pole section 5 7 8 " [149mm] TN2 Tenon adapter to fit on 2 3/8 O.D. tenon 4" 2 2 1 " [102mm] [64mm] 5 7 8 " [149mm] TN4 Tenon adapter to fit on 4 O.D. tenon 4" [102mm] 4 1 8 " [105mm] 3/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
ACCESSORIES - continued Order separately Optical Accessories: LBX-SN- -BK *Interior surface painted black. LBX-SNW- -BK *Interior surface painted black. LBX-VS- -BK *Interior surface painted black. Snoot accessory. Please specify desired exterior finish : BKM - Matte black CC - Custom, please specify RAL color Snoot Wide accessory. Please specify desired exterior finish : BKM - Matte black CC - Custom, please specify RAL color Visor accessory. Please specify desired exterior finish : BKM - Matte black CC - Custom, please specify RAL color LBX-WG- Wire Guard accessory. Please specify desired exterior finish : BKM - Matte black CC - Custom, please specify RAL color LBX-LSLA- Linear Spread Lens Adjustable accessory. Please specify desired exterior finish : BKM - Matte black CC - Custom, please specify RAL color Accessory combinations: + Snoot Snoot Wide Visor Wire Guard Snoot NO NO NO YES Visor NO NO NO YES Linear Spread Lens Adjustable YES YES YES NO Accessory combinations must be ordered together on a single line. Ex: A Snoot + Wire Guard combination order code is LBX-SNWG-BK-BK. 4/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
ACCESSORIES - continued Order separately Control Systems: LTO2 Lumentouch is a wall mount DMX 512 controller keypad. LCU Lumencue is a USB / mini SD DMX 512 controller. LID LumenID is a diagnostic and addressing DMX 512 controller. It must be specifi ed on all DMX applications. Refer to LID specifi cation sheet for details. LTN Lumentone is a simple pre-programmed DMX 512 controller with a push button rotary dial and live feedback. Control Boxes: CBX DMX/RDM control box. Up to six power and data outputs to fi xtures or fi xture runs. Ethernet enabled option. Refer to CBX specifi cation sheet for details. 5/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
RESOLUTION DETAILS APPLICABLE FOR DMX DIMMING OPTION ONLY DMX 1BD - Resolution per board: each board is addressed independently (recommended for most installations). DMX ADDRESSES: board #3 7,8,9 board #2 4,5,6 board #1 (master) 1,2,3 LBX DMX 1FX - Resolution per : each is addressed independently DMX ADDRESSES: 1,2,3 LBX *Warning: resolution is a factory setting and cannot be changed in the field. 6/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
TYPICAL WIRING DIAGRAMS Non-Dimming or Lumentalk Dimming Version American CE USE Green Yellow/Green Ground Black Brown Live White Blue Neutral Red/Purple Black 0-10V / Data + Orange Grey 0-10V / Data - #16-3 Power cable To previous To next Wire-nuts Dimming Version (0-10V) 10% minimum dimming value #16-5 Power & data cable dimmer Dimmer Data+ red Data- orange To To next Wire-nuts Maximum run length by 15A circuit @ 120V: 8 LBX RO (16AWG cable), 6 LBX HO (16AWG cable), 10 on center spacing 100 max cable length. 0-10V ma Ratings: Passive Dimmer (Current Sink): 3mA per Active Dimmer (Current Source): 0.5mA per 7/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
Open Preset Close 1 2 3 4 Off SPECIFICATION SHEET TYPICAL WIRING DIAGRAMS - continued Dimming Version (DALI) 1% minimum dimming value American CE USE Green Yellow/Green Ground Black Brown Live White Blue Neutral Red/Purple Black 0-10V / Data + Orange Grey 0-10V / Data - Typical DALI Controller DALI Controller #16-5 Power & data cable Data+ red Data- orange To To next Maximum run length by 15A circuit @ 120V: 8 LBX RO (16AWG cable), 6 LBX HO (16AWG cable), 10 on center spacing 100 max cable length. Dimming Version (EcoSystem ) 1% minimum dimming value #16-5 Power & data cable Lutron EcoSystem Controller LUTRON Grafik Eye shown Data+ red Data- orange To To next Maximum run length by 15A circuit @ 120V: 8 LBX RO (16AWG cable), 6 LBX HO (16AWG cable), 10 on center spacing 100 max cable length. 8/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
TYPICAL WIRING DIAGRAMS - continued Star Layout (DMX Dimming) 1% minimum dimming value American CE USE Green Yellow/Green Ground Black Brown Live White Blue Neutral Red/Purple Black 0-10V / Data + Orange Grey 0-10V / Data - #16-5 Power & data cable CBX-ST lumenterminator (use at the end of each run only) Lumentouch 2.0 Data input or CBX DMX- orange DMX+ red To Fixture Wire-nuts 100-240V 8 LBX RO (16 AWG cable) max. per CBX-ST, 6 LBX HO (16 AWG cable) max. per CBX-ST, 10 on center spacing. 6 outputs max. per CBX-ST. 100 max. total cable length per CBX-ST. (based on a 15A @ 120V) Daisy Chain Layout (DMX Dimming) 1% minimum dimming value DMX terminator is required at the end of each run to maintain data integrity. (2x) DMX lumenterminator included per CBX-DS (6x) DMX lumenterminator included per CBX-ST See installation instructions for details. CBX-DS #16-5 Power & data cable Lumentouch 2.0 Data input 100-240V or CBX lumenterminator (use at the end of each run only) DMX- orange DMX+ red To Fixture Wire-nuts 8 LBX RO (16 AWG cable) max. per CBX-DS, 6 LBX HO (16 AWG cable) max. per CBX-DS, 10 on center spacing. 2 outputs max. per CBX-DS. 100 max. total cable length per CBX-DS. (based on a 15A @ 120V) 9/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289
HOW TO ORDER LBX 1 Housing Voltage Colors and color temperatures Board 1/ Board 2/ Board 3 Optic Optical Option Finish Control Option 1 2 3 4 5 6 7 8 5 Housing: LBX RO - Lumenbeam XLarge, Regular Output, 140W LBX HO - Lumenbeam XLarge, High Output, 205W Optical Option: LSLH - Linear Spread Lens Horizontal distribution LSLV - Linear Spread Lens Vertical distribution 2 Voltage: 100-100 volts 220-220 volts 6 *Factory installed, available for 6 to 40 optics. See Optical Accessories for field adjustable spread lens. 3 4 120-120 volts 240-240 volts 208-208 volts 277-277 volts Colors and Color temperatures: 27K - 2700K 30K - 3000K 35K - 3500K 40K - 4000K 57K - 5700K RD - Red GR - Green BL - Blue Optic (Please specify for each board): VN - Very Narrow 6 NS - Narrow Spot 10 NF - Narrow Flood 20 7 8 Finish: BK - Black SandText CC - Custom (please specify RAL color) Control: NO - No Dimming LT - Lumentalk (1% minimum dimming value) DIM - 0-10V Dimming option (10% minimum dimming value) (Current Sink: 3mA/) (Current Source: 0.5mA ) DMX 1BD - DMX Dimming option, resolution per board (9 addresses per ) (1% minimum dimming value) DMX 1FX - DMX Dimming option, resolution per (3 addresses per ) (1% minimum dimming value) DALI - DALI Dimming option (1% minimum dimming value) ES - Lutron EcoSystem Enabled Dimming (1% minimum dimming value) FL - Flood 40 WFL - Wide Flood 60 (cannot be combined with other optics) Option: SY - Short Yoke SY-3GV - Reinforced Short Yoke to meet 3G ANSI C136.31 Vibration Rating standard CRC - Corrosion-resistant Coating 10/10 Lumenpulse, 1751 Richardson, Suite 1505, Montreal (Quebec) Canada H3K 1G6 1.877.937.3003 P. 514.937.3003 F. 514.937.6289