TEST REPORT SUMMARY Nota de interpretación técnica de la equivalencia de la separación galvanica de la conexión de instalaciones Generadoras en baja tension Sobre conexión de instalaciones fotovoltaicas a la red de baja tensión Report reference number... : 11TH0026-DC-Injection_0 Date of issue......: 2012-09-21 Total number of pages......: 6 Testing laboratory name... : Address... : Bureau Veritas Consumer Products Services Germany GmbH Businesspark A96 86842 Türkheim Germany Applicant's name... : Address... : SMA Solar Technology AG Sonnenallee 1, 34266 Niestetal Test specification Standard... : Nota de interpretación técnica de la equivalencia de la separación galvanica de la conexión de instalaciones Generadoras en baja tension Zertifikate... : Test report form number.... : Master TRF... : Certificate of compliance DC-Injection Bureau Veritas Consumer Products Services Germany GmbH Test item description... : Grid connected photovoltaic inverter Trademark... : Model / Type... : SB 1300TL-10, SB 1600TL-10, SB 2100TL Ratings...: SB 1300TL-10 SB 1600TL-10 SB 2100TL MPP DC voltage range [V]... : 125V - 480V 155V - 480V 200V - 480V Input DC voltage range [V]... : max. 600V max. 600V max. 600V Input DC current [A]... : Output AC voltage [V]... : Output AC current [A]... : nom. 5,7A max. 7,2A max. 11A nom. 230V nom. 7A max. 8,9A nom. 8,5A max. 11A Output power [VA]... : nom. 1300W max. 1300VA nom. 1600W max. 1600VA nom. 1950W max. 2100VA
Page 2 of 6 Testing Location... : Address... : Tested by (name and signature)... : Bureau Veritas Consumer Products Services Germany GmbH Businesspark A96, 86842 Türkheim, Germany Georg Loritz Approved by (name and signature)... : Ingo Röhr Manufacturer s name... : Factory address... : SMA Solar Technology AG Sonnenallee 1, 34266 Niestetal, Germany Document History Date Internal reference Modification / Change / Status Revision 2012-09-21 Georg Loritz Initial report was written 0 Supplementary information:
Page 3 of 6 Test items particulars Equipment mobility... : Operating condition... : Class of equipment... : Permanent connection Continuous Class I Protection against ingress of water.. : IP65 according to EN 60529 Mass of equipment [kg]... : SB 1300TL-10 16kg SB 1600TL-10 16kg SB 2100TL 16kg Test case verdicts Test case does not apply to the test object... : Test item does meet the requirement... : Test item does not meet the requirement... : N/A P(ass) F(ail) Testing Date of receipt of test item... : 2012-01-26 Date(s) of performance of test... : 2012-09-07 General remarks: The test result presented in this report relate only to the object(s) tested. The report shall state compliance of the tested objects with the requirements of NOTA DE INTERPRETACIÓN TECNICA DE LA EQUIVALENCIA DE LA SEPARACIÓN GALVÁNICA DE LA CONEXIÓN DE INSTALACIONES GENERADORAS EN BAJA TENSIÓN. This report shall not be reproduced, except in full, without the written approval of the applicant. (see Annex #)" refers to additional information appended to the report. "(see appended table)" refers to a table appended to the report. Throughout this report a comma is used as the decimal separator.
Page 4 of 6 Copy of marking plates:
Page 5 of 6 General product information: The Solar Inverter converts DC voltage into AC voltage. The input is protected by varistors to Earth. The unit is providing EMC filtering at the output toward mains. The unit does not provide galvanic separation from input to output (no transformer). The output is switched off redundant by the high power switching bridge and two relays. This assures that the opening of the output circuit will also operate in case of one error. The input of the inverter is EMC filtered, the input dc voltage is PWM modulated by the inverter bridge. These PWM blocks are filtered by the following inductors and capacitors and finally result in the 50Hz sine wave. The automatic disconnection facility is integral part of the inverter, permanently monitoring the grid frequency and voltage. In Addition the unit provides active anti islanding detection via frequency shifting. The inverter model SB1300TL-10 and SB 1600TL-10 are software derated versions of the SB 2100TL. The hardware is identical. The product was tested on Hardware Version: SB 2100TL Software Version: SB 2100TL-10: 3.14 SB 1600TL-10: 3.14 SB 1300TL-10: 4.22
Page 6 of 6 Test report NOTA DE INTERPRETACIÓN TECNICA DE LA EQUIVALENCIA DE LA SEPARACIÓN GALVÁNICA DE LA CONEXIÓN DE INSTALACIONES GENERADORAS EN BAJA TENSIÓN Article Test Result 14 Type test: 14 Monitoring of DC-Injection P