DATA SHEET. KGL Gbps D-Flip Flop IC 0.2µm Gate Length GaAs MESFET Technology

Transcription

1 DATA SHEET O K I G a A s P R O D U C T S KGL Gbps D-Flip Flop IC 0.2µm Gate Length GaAs MESFET Technology February 2000

2 Oki Semiconductor

3 KGL Gbps GaAs D-Flip Flop IC INTRODUCTION Oki Semiconductor s KGL4205 is a 10-Gbps D-Flip Flop IC designed for ultra high-speed digital communications systems. The KGL4205 uses 0.2-µm gate length GaAs MESFETs and Oki s unique MCFF ( Memory Cell type Flip Flop ) technology to achieve operations of 10-GHz or more. The KGL4205 is available as a 24-pin ceramic packaged device. Due to the KGL4205 s high sensitivity, capacitive coupling is recommended for IC s DA and CK connections. FEATURES High-speed operation: 10-Gbps data rate (typ) Low-power dissipation: 340 mw (typ.) using 2-V power-supply 0.2-µm gate length GaAs MESFET process MCFF ( Memory Cell type Flip Flop ) technology 24-pin ceramic package APPLICATION High-speed optical communication systems: 10 Gbps High-speed test equipment Oki Semiconductor 1

4 KGL4205 BLOCK DIAGRAM DA DR 50 Ω D D-Flip Flop (MCFF) Q Q D C C Q CK CR 50 Ω QN DA Data Input Terminals CK Clock Input Terminals DR, CR Output Reference Voltage Terminals Q, QN Complimentary Data Outputs VDD Power Supply of Internal Circuit ELECTRICAL CHARACTERISTICS Absolute Maximum Ratings Parameter Symbol Min. Max. Units Supply Voltage, V B V Data, Clock Input Voltage V DI, V CI V Temperature at Package Base Under Bias Ts C Storage Temperature Tst C Exceeding these maximum ratings could cause immediate damage or lead to permanent deterioration of the device. Electrical Characteristics = 2 V ± 0.1 V, Ts = 0 C to 70 C Parameter Symbol Min. Typ. Max. Units Operating Data Bit Rate Range DAR 10 Gbps Power Dissipation PW W High-Level Data, Clock Input Voltage VIH V Low-Level Data, Clock Input Voltage VIL V High-Level Output Voltage ( Q, QN ) VOH V Low-Level Output Voltage ( Q, QN ) VOL V Output ( Q, QN ) Rise time and Fall time TRF ps Phase 10 Gbps ( PRBS) TOM 240 degree 2 Oki Semiconductor

5 KGL4205 PACKAGE DIMENSIONS (Units: mm) ± ± SQ 7.4 SQ ± Top View Dimension in mm. Pin Configuration Pin No. Description Pin No. Description Pin No. Description Pin No. Description 1 GND 7 GND 13 GND 19 CR 2 Q 8 GND 14 DA 20 VDD 3 GND 9 GND 15 GND 21 VDD 4 GND 10 GND 16 GND 22 GND 5 QN 11 DR 17 CK 23 VDD 6 GND 12 DR 18 GND 24 GND Oki Semiconductor 3

6 KGL4205 Notes: 4 Oki Semiconductor

7 The information contained herein can change without notice owing to product and/or technical improvements. Please make sure before using the product that the information you are referring to is up-to-date. The outline of action and examples of application circuits described herein have been chosen as an explanation of the standard action and performance of the product. When you actually plan to use the product, please ensure that the outside conditions are reflected in the actual circuit and assembly designs. Oki assumes no responsibility or liability whatsoever for any failure or unusual or unexpected operation resulting from misuse, neglect, improper installation, repair, alteration or accident, improper handling, or unusual physical or electrical stress including, but not limited to, exposure to parameters outside the specified maximum ratings or operation outside the specified operating range. Neither indemnity against nor license of a third party's industrial and intellectual property right,etc.is granted by us in connection with the use of product and/or the information and drawings contained herein. No responsibility is assumed by us for any infringement of a third party's right which may result from the use thereof. When designing your product, please use our product below the specified maximum ratings and within the specified operating ranges, including but not limited to operating voltage, power dissipation, and operating temperature. The products listed in this document are intended for use in general electronics equipment for commercial applications (e.g.,office automation, communication equipment, measurement equipment, consumer electronics, etc.).these products are not authorized for use in any system or application that requires special or enhanced quality and reliability characteristics nor in any system or application where the failure of such system or application may result in the loss or damage of property or death or injury to humans. Such applications include, but are not limited to: traffic control, automotive, safety, aerospace, nuclear power control, and medical, including life support and maintenance. Certain parts in this document may need governmental approval before they can be exported to certain countries. The purchaser assumes the responsibility of determining the legality of export of these parts and will take appropriate and necessary steps, at their own expense, for export to another country. Copyright 2000 Oki Semiconductor Oki Semiconductor reserves the right to make changes in specifications at anytime and without notice. This information furnished by Oki Semiconductor in this publication is believed to be accurate and reliable. However, no responsibility is assumed by Oki Semiconductor for its use; nor for any infringements of patents or other rights of third parties resulting from its use. No license is granted under any patents or patent rights of Oki. Oki Semiconductor

8 Oki REGIONAL SALES OFFICES Northwest Area 785 N. Mary Avenue Sunnyvale, CA Tel: 408/ Fax: 408/ North Central Area 300 Park Blvd. Suite 365 Itasca, IL Tel: 630/ Fax: 630/ Northeast Area 138 River Road Shattuck Office Center Andover, MA Tel: 978/ Fax: 978/ Southwest Area 2302 Martin Street Suite 250 Irvine, CA Tel: 949/ Fax: 949/ Southeast Area 1590 Adamson Parkway Suite 220 Morrow, GA Tel: 770/ Fax: 770/ Oki Web Site: For Oki Literature: Call toll free OKI-6388 (6 a.m. to 5 p.m. Pacific Time) Oki Stock No: Corporate Headquarters 785 N. Mary Avenue Sunnyvale, CA Tel: 408/ Fax: 408/