MT4-024/MT4-230 MT8-024/MT8-230

Transcription

1 Smart-T MT4-024/MT4-230 MT8-024/MT8-230 SMLL LINER THERMOELECTRIC CTUTORS PRODUCT DT FETURES No mounting tools required (easily mounted using valve adapter) Water-protected housing design in all mounting positions Pluggable cable for easy installation and servicing uxiliary switch models for driving pumps or fans Low power models Normally-open and normally-closed models Compact design allows installation in limited space Visual indicator showing valve position and type of action (NO or NC) Noiseless operation Reliable long-term operation Overload protection (4 kv) for 230 V models PPLICTION Smart-T small linear actuators are used in room and zone applications for -controlled two-point and pulse-widthmodulated (PWM*) regulation of heating and cooling systems such as fan coil units, radiators, floor heating systems, chilled ceilings, and convectors. Fit on standard M30 x 1.5 heating/cooling valves, thermostatic radiator valves, and valve inserts for manifolds and compact radiators. Special valve adapters on request. *Recommended controllers: Excel 10 and Excel 12 controllers (use with other, non-honeywell controllers may adversely influence PWM-operation). SPECIFICTIONS Max. stroke MT4: 4 mm MT8: 8 mm Power supply MTx-024: 24 Vac/dc ± 20% MTx-230: 230 Vac +10% % Stem force 90 N Opening/closing dependent on ambient temperature (see Table 3) mbient temperature max. 50 C Electrical See Table 3 on page 3. specifications Protection standard IP44 in all mounting positions Cable length 1 m, other cable lengths upon request Cable wires MTx-xxx: 2 x 0.5 mm 2 MTx-xxxS: 4 x 0.35 mm 2 Max. permissible MTx-xxxS: 5 (3) auxiliary switch current Medium temperature max. 120 C U.S. Registered Trademark EN0-0490GE51 R0208 Copyright 2008 Honeywell Inc. ll rights reserved

2 MT SMLL LINER THERMOELECTRIC CTUTORS ORDERING INFORMTION Table 1. ctuators order number action* additional features voltage stroke MT4-024-NC MT4-024-NO MT4-024-NC-2.5M MT4-024-NO-2.5M MT4-024LC-NC MT4-024LC-NO MT4-024S-NC MT4-024S-NO MT4-230-NC MT4-230-NO MT4-230-NC-2.5M MT4-230-NO-2.5M MT4-230LC-NC MT4-230LC-NO MT4-230S-NC MT4-230S-NO MT8-024-NC MT8-024-NO MT8-024-NC-2.5M MT8-024-NO-2.5M MT8-024LC-NC MT8-024LC-NO MT8-024S-NC MT8-024S-NO MT8-230-NC MT8-230-NO MT8-230-NC-2.5M MT8-230-NO-2.5M MT8-230LC-NC MT8-230LC-NO MT8-230S-NC MT8-230S-NO 24 Vac/dc 230 Vac/dc 24 Vac/dc 230 Vac/dc *Without power, in combination with standard 2-way valve; "" = stem extends, "" = stem retracts 4 mm 8 mm MT-CLIP MT-CLIP-TP MT-DPT-HW MT-DPT-HP MT-CLE-1.5M MT-CLE-2.5M MT-CLE-5M MT-CLE-10M EV10R HC1VEL order number Table 2. ccessories mounting clip, 10 units description mounting clip, with anti-theft protection feature, 10 units mounting adapter M30 x 1.5, 10 units mounting adapter for Herz/Polytherm valves, 10 units cable suitable for MT4-024/-230/-024LC/-0230LC and MT8-024/-230/- 024LC/-0230LC, 10 units Danfoss-R adapters, 10 units Mounting adapter for Velta compact manifold EN0-0490GE51 R0208 2

3 MT SMLL LINER THERMOELECTRIC CTUTORS ELECTRICL SPECIFICTIONS order number initial current* Table 3. Electrical specifications permanent current* power min. run for full nominal valve stroke * 4 mm models 8 mm models MTx-024-xx, MTx-024S-xx ~0.7 < 0.1 < 3 W 4.0 min 6.0 min MTx-024LC-xx ~0.2 < 0.05 < 2 W 6.0 min 7.5 min MTx-230-xx, MTx-230S-xx ~0.6 ** W 2.5 min 3.5 min MTx-230LC-xx ~0.4 ** W 3.5 min 5.5 min *ll values at nominal voltage. **verage during first 500 msec. MOUNTING NOTE: Connection leads must not touch piping (heat transfer). Fig. 1. Mounting / installation positions Fig. 2. Dismounting FUNCTION When the operating current is applied, a PTC resistor heats up a wax element. fter a delay, this wax element expands, causing stroke movement. 3 EN0-0490GE51 R0208

4 MT SMLL LINER THERMOELECTRIC CTUTORS Position Indicator The position indicator (the red indicator behind the window on the face of the actuator) shows the model's type of action (NO or NC) as well as the current stroke position. NC NO Fig. 3. Position indicator WIRING grün, vert, verde, green, zielony grün, vert, verde, green, zielony 230 Vac / 24 V MTx-xxxS 5 (3) braun, brun, marrone, brown, brazowy blau, bleu, blu, blue, niebieski R-T 230 Vac / 24 V Ω 3 W braun, brun, marrone, brown, brazowy blau, bleu, blu, blue, niebieski R-T 230 Vac / 24 V Ω Fig. 4. Wiring diagrams Opening and Closing Time MTx-xxx, MTx-xxxLC 3 W (MTx-xxxLC: 2 W) stroke NO NC power on off dead opening dead closing Fig. 5. Opening and closing NOTE: Opening and closing s depend upon ambient temperature and model. EN0-0490GE51 R0208 4

5 MT SMLL LINER THERMOELECTRIC CTUTORS Valve ction DIMENSIONS NC (normally-closed) version NO (normally-open) version NC NO NC NO H X L dimension MT4-xxx MT8-xxx W W H L X Fig. 7. Dimensions (in mm) Fig. 6. Valve action Normally open: 2-way valve, - open without power; Normally closed: 2-way valve, - shut without power; NOTE: Fig. 6 is a schematic diagram showing typical valve action. ctual function can vary depending upon the individual type of valve. y using this Honeywell literature, you agree that Honeywell will have no liability for any damages arising out of your use or modification to, the literature. You will defend and indemnify Honeywell, its affiliates and subsidiaries, from and against any liability, cost, or damages, including attorneys fees, arising out of, or resulting from, any modification to the literature by you. Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route du ois 37, Switzerland by its uthorized Representative: utomation and Control Solutions Honeywell GmbH öblinger Straße 17 D Schönaich Phone: (49) Fax: (49) Subject to change without notice. Printed in Germany EN0-0490GE51 R0208