INITIALIZATION OF THE MSU032/MSU064

Transcription

1 Release Date: Page: 1 / 7 INITIALIZATION OF THE MSU032/MSU064 NOTE: THE MSU HARD DISKS WILL BE INITIALIZED IN THIS PROCEDURE. ALL EXISTING DATA WILL BE REMOVED FROM THEM. USING THE MEDIA STORAGE UNIT (MSU) To start or shut down the MSU, press the Rocker Switch (ON/OFF) (2.) shortly (0.5 3 sec). Note that shutting down the MSU takes approximately seconds. Do not press any switches while the MSU is shutting down. 1. Connector for Power Cable 2. Rocker Switch (ON/OFF) 3. Network adapter for connecting teacher PC to MSU 6. Keyboard connector 5. Mains power switch 8. PCI cards for connecting SCU to MSU (Audio LAN) 4. Voltage selector (115 V / 230 V) 7. Display adapter

2 Release Date: Page: 2 / 7 CREATING AN MSU BOOT DISK 1. Insert a floppy disk into the teacher computer floppy disk drive 2. Insert the LAB 100 software CD into the teacher computer CD drive 3. Run MakeDisk.exe in the MSU\MakeDisk folder on the LAB 100 software CD. 4. The Make Disk program starts 5. Click Set drive, select the appropriate floppy disk drive, and accept the selection by clicking OK

3 Release Date: Page: 3 / 7 6. Click Start to create the MSU boot disk 7. The following warning message appears. Click OK to proceed. 8. A slider indicates how the boot disk creation proceeds.

4 Release Date: Page: 4 / 7 9. When the boot disk is ready, click Close to exit the application.

5 Release Date: Page: 5 / 7 INITIALIZING THE MSU SOFTWARE 1. In the MSU, switch on the mains power (5.). Do not start the MSU yet. 2. Run Install.exe in the Install folder on the LAB 100 software CD. This starts the MSU Install application. The software update starts to proceed automatically and the following dialog is displayed: 3. If you are absolutely sure that you want to completely remove all data in the MSU hard disks and then install the MSU software, click Yes. After this the MSU Install application proceeds normally and the following screen is displayed: 4. Insert the created boot disk into the floppy disk drive of the MSU (the floppy disk drive may be inside the MSU), and start the MSU by pressing the ON/OFF switch shortly (0.5 2 sec). 5. Note that the initialization procedure will take approximately 15 to 30 minutes. The following sequence of information will be displayed during the installation:

6 Release Date: Page: 6 / 7

7 Release Date: Page: 7 / 7 6. When the installation is completed, the following message box appears: 7. Click OK. The Setup Wizard closes. 8. Remove the boot disk from the MSU floppy disk drive. 9. Switch off the MSU power by pressing down the ON/OFF switch (2.) for approximately 4 seconds. Keep the switch pressed down until you hear the MSU shut down. 10. Wait for seconds, switch the power on again by pressing the ON/OFF switch (2.).