Single and Two-Phase Flows on Chemical



Similar documents
Simulation of Water-in-Oil Emulsion Flow with OpenFOAM using Validated Coalescence and Breakage Models

Model of a flow in intersecting microchannels. Denis Semyonov

Enhancing Health and. Information Systems and Technologies for. Social Care. Reference. Polytechnic Institute of Leiria, Portugal

ME6130 An introduction to CFD 1-1

Express Introductory Training in ANSYS Fluent Lecture 1 Introduction to the CFD Methodology

Computational Fluid Dynamic Modeling Applications

Chemical Engineering - CHEN

Bahia, October 22, Paulo Varandas Organizing Committee

AgoraLink Agora for Life Science Technologies Linköpings Universitet Kurs i Fysiologisk mätteknik Biofluidflöden

NUMERICAL SIMULATION OF REGULAR WAVES RUN-UP OVER SLOPPING BEACH BY OPEN FOAM

NET SERVIÇOS DE COMUNICAÇÃO S.A. CORPORATE TAX ID (CNPJ) # / NIRE # PUBLICLY TRADED COMPANY

Chemical Engineering Dual Degree Courses & Credits Distribution

LIST OF ATTORNEYS. Maio Island

Fluid Dynamics of Blood Flow Modelling & Simulation

Periodical meeting CO2Monitor. Leakage characterization at the Sleipner injection site

Computational Fluid Dynamics (CFD) and Multiphase Flow Modelling. Associate Professor Britt M. Halvorsen (Dr. Ing) Amaranath S.

Orthogonal ray imaging: from dose monitoring in external beam therapy to low-dose morphologic imaging with scanned megavoltage X-rays

Research Team name: UNINA Presenter name: Stefano GUIDO

SYNERGISTIC APPLICATION OF ADVANCED PRIMARY AND SECONDARY WASTEWATER TREATMENT SYSTEMS

José M. F. Moura, Director of ICTI at Carnegie Mellon Carnegie Mellon Victor Barroso, Director of ICTI in Portugal

Oncology Meetings: Gastric Cancer State of Art March 27 and 28th, 2014

Mónica S. Neves Oliveira

Funding and Human Resources

AN EFFECTIVE THERMAL TECHNOLOGY FOR THE DETOXIFICATION OF THE MSW FLY ASH

4th LISBON VASCULAR FORUM 4º FORUM VASCULAR DE LISBOA. LISBON MARRIOTT HOTEL 13 and 14 DECEMBER 2013 PROGRAMA PRELIMINAR PRELIMINARY PROGRAM

Flow Assurance & Operability

Heat transfer in Rotating Fluidized Beds in a Static Geometry: A CFD study

Mechanical Engineering Spring Semester

Review of Heat Transfer Parameters of Serrated Plate Fin Heat Exchanger for Different Materials

Advanced Training and Industrial Research for Complex Engineering Systems, A+

Habitâmega Group GRANITOS, S. A.

Comparison of flow regime transitions with interfacial wave transitions

Geometric multiscaling in the circulatory system

ADVANCED COMPUTATIONAL TOOLS FOR EDUCATION IN CHEMICAL AND BIOMEDICAL ENGINEERING ANALYSIS

and Knowledge Management

CFD SIMULATION OF IPR-R1 TRIGA SUBCHANNELS FLUID FLOW

3D Conjugate Heat Transfer Analysis of the Next Generation Inner Reflector Plug for the Spallation Neutron Source

Rui Jorge Pereira Gonçalves. December 4, 1979, Porto Paranhos. Portuguese. Regularized

VISUALIZATION STUDIES OF VISCOELASTIC FLOW IN A 4:1 SQUARE/SQUARE CONTRACTION

CFD Code Validation Against Stratified Air-Water Flow Experimental Data

Introduction to CFD Analysis

DataStorm: Large-Scale Data Management in Cloud Environments

REACTION Workshop Overview Porto, FEUP. Mário J. Silva IST/INESC-ID, Portugal REACTION

CATALYTIC CONVERSION OF BIOGAS TO BIOFUELS - TAP STUDIES

Computational Fluid Dynamics in Automotive Applications

Pedro Valente PERSONAL INFORMATION. Date of Birth: 27 of March Home address: R. da Casquilha 16, 6Dto, Lisbon, Portugal

Mixing in the process industry: Chemicals Food Pharmaceuticals Paper Polymers Minerals Environmental. Chemical Industry:

STEADY STATE MODELING AND SIMULATION OF HYDROCRACKING REACTOR

CFD MODELLING OF HYDRODYNAMICS IN SUPERCRITICAL FLUID EXTRACTION SYSTEMS

Innovation and Teaching Technologies

BIOMEDICAL ULTRASOUND

Overview. also give you an idea of ANSYS capabilities. In this chapter, we will define Finite Element Analysis and. Topics covered: B.

Using Computational Fluid Dynamics (CFD) Simulation to Model Fluid Motion in Process Vessels on Fixed and Floating Platforms

Customer Training Material. Lecture 2. Introduction to. Methodology ANSYS FLUENT. ANSYS, Inc. Proprietary 2010 ANSYS, Inc. All rights reserved.

Students from the 1st pgfma with their teachers.

CFD Analysis Of Multi-Phase Flow And Its Measurements

Qualification of Thermal hydraulic codes within NURESIM D. Bestion (CEA, France)

Numerical Calculation of Laminar Flame Propagation with Parallelism Assignment ZERO, CS 267, UC Berkeley, Spring 2015

Corticeira Amorim, S.G.P.S., S.A.

Thermische Speicherung von Solarenergie

CHEMICAL ENGINEERING AND CHEMICAL PROCESS TECHNOLOGY - Vol. I - Interphase Mass Transfer - A. Burghardt

Finite Element Modules for Enhancing Undergraduate Transport Courses: Application to Fuel Cell Fundamentals

Giorgio Bornia. Research statement. Primary interests

MAJOR LEARNING OUTCOMES ARCHITECTURE AND URBAN PLANNING 1ST CYCLE PROGRAMS GENERAL ACADEMIC PROFILE

Organizational Integration of Enterprise Systems and Resources:

S.L. Chang, S.A. Lottes, C.Q. Zhou,** B. Golchert, and M. Petrick

1st SEMESTER (beginning in September) Code Course Year ECTS Degree Lecturer Group(s) in English

Contents. Microfluidics - Jens Ducrée Physics: Fluid Dynamics 1

Curriculum Vitae. June, 1998 Graduation in Mathematics (5-years degree), Faculty of Sciences of the University of Lisbon (FCUL)

Transport phenomena and reaction engineering: basic research and practical applications

Introduction to CFD Analysis

CASL-U

Ana Paiva (group coordinator) Jornadas dos 20 anos da Engenharia FEUP, 7-8 nov 2014

walberla: A software framework for CFD applications on Compute Cores

walberla: A software framework for CFD applications

LISBON MARRIOTT HOTEL 19 and 20 DECEMBER 2014 PROGRAMA PRELIMINAR PRELIMINARY PROGRAM

LISBON MARRIOTT HOTEL 19 and 20 DECEMBER 2014 PROGRAMA PRELIMINAR PRELIMINARY PROGRAM

Use of OpenFoam in a CFD analysis of a finger type slug catcher. Dynaflow Conference 2011 January , Rotterdam, the Netherlands

Last year we started with: Workshop One: Year One July 2015: Natural Cork - Tradition: Gain an appreciation and understanding Cork as a material.

Joao Pedro Barreto. Dept. of Electrical and Computer Engineering R: Antonio Jose de Almeida, 295, 1Esq. University of Coimbra telf:

Session 1 Peripheral arterial disease and ulcer: basic principles

CFD Analysis of a Centrifugal Pump with Supercritical Carbon Dioxide as a Working Fluid

DESIGN, FABRICATION AND ELETRICAL CHARACTERIZATION OF SOI FINFET TRANSISTORS

Basics of vehicle aerodynamics

FLUID FLOW AND MIXING IN BIOREACTORS (Part 2 of 2)

Lecture 6 - Boundary Conditions. Applied Computational Fluid Dynamics

Entrained Gas Diagnostic with Intelligent Differential Pressure Transmitter

UNIVERSITY OF MINNESOTA DULUTH DEPARTMENT OF CHEMICAL ENGINEERING ChE DOUBLE PIPE HEAT EXCHANGER

Bone Structure and Properties Special Thematic Session

A moving piston boundary condition including gap flow in OpenFOAM

Fatigue Life Prediction of Complex 2D Components under Mixed-Mode Variable Loading

DIESEL ENGINE IN-CYLINDER CALCULATIONS WITH OPENFOAM

Guidelines for Course Selection MS Degree Students

Internacional Congress

Transcription:

Transport Transport Single and Two-Phase Flows on Chemical and Biomedical Engineering Editors Ricardo Dias Department of Chemical and Biological Technology, ESTiG, Braganca Polytechnic, C. Sta. Apolonia, 5301-857 Braganqa, Portugal - CEFT Phenomena Research Center, Faculty ofengineering, University ofporto (FEUP), Rua Dr. Roberto Frias, s/n, 4200-465 Porto Portugal Antonio A. Martins CEFT-Transport Phenomena Research Center, Faculty ofengineering, University ofporto (FEUP) Rua Dr. Roberto Frias, s/n, 4200-465 Porto, Portugal Rui Lima Department of Mechanical Technology, ESTiG, Braganca Polytechnic, C. Sta. Apolonia, 5301-857 Braganqa, Portugal CEFT - Phenomena Research Center Faculty ofengineering, University of Porto (FEUP) Rua Dr. Roberto Frias, s/n, 4200-465 Porto, Portugal Teresa M. Mata LEPAE-Laboratoryfor Process, Environmental and Energy Engineering Faculty ofengineering, University ofporto (FEUP) Rua Dr. Roberto Frias, s/n, 4200-465 Pnrtn Pnrtuonl

CONTENTS Foreword i Preface ii List ofcontributors Hi Acknowledgements xii Part I: Single Phase Flows on Chemical Engineering 1. Spacims-Probing the Internal Behaviour of 3D Structured Materials 3 Jacinto Sd, Cristina-Elena Stere and Alexandre Goguet 2. Modelling of a Monolithic Reverse Flow Reactor for Selective Catalytic Reduction of NO by Ammonia 26 Emilio Muhoz, David Lesser, Pablo Marin, Salvador Ordonez and Fernando V. Diez 3. Mesoscopic Simulation of Rarefied Gas Flow in Porous Media 52 Alexandros N. Kalarakis, Eugene D. Skouras and Vasilis N. Burganos 4. Mixing Through Half a Century of Chemical Engineering 79 Ricardo J. Santos, Madalena M. Dias and Jose Carlos B. Lopes 5. Application of the Probability Density Function Method to Turbulent Mixing with Chemical Reaction 113 Andrei Chorny 6. Activated Sludge Models Coupled to CFD Simulations 153 Pereira J.P., Karpinska A., Gomes P.J., Martins A.A., Dias M.M., Lopes J. C.B. and Santos R.J.

7. Using CFD to Estimate External Mass Transfer Coefficients and Intra-Particle Diffusional Effects on the Supercritical Hydrogenation of Sunflower Oil 174 A. Guardo, E. Ramirez, M.A. Larrayoz and F. Recasens 8. Mass Transfer Around a Single Soluble Solid with Different Shapes Buried in a Packed Bed and Exposed to Fluid Flow 196 J.M.P.Q. Delgado 9. Advances on Viscoelastic Fluid Flow Simulation 233 Jovani L. Favero, Argimiro R. Secchi, Nilo S. M. Cardozo and Hrvoje Jasak 10. Tree-Shaped Flow Structures Viewed from the Constructal Theory Perspective 266 Antonio F. Miguel 11. Determination of Effective Transport Properties of Metallic Foams: Morphology and Flow Laws 292 J. Vicente, E. Brun, J.M. Hugo, J.P. Bonnet andf. Topin Part II: Two Phase Flows on Chemical Engineering 12. Flow Visualization in Gas-Solid Packed Beds by Spatially Resolved Near-Infrared Imaging 332 Aiouache Farid, Nic An tsaoir Meabh and Luis Abreu Fernandes Daniel 13. Interfacial Area Modelling in Two-Phase Flow Studies 361 Christophe Morel 14. Mass Transfer Models for Oxygen-Water Co-Current flow in Vertical Bubble Columns 386 Valdemar Garcia and Joao Sobrinho Teixeira

15. Characterization of Turbulence and Flow Regimes in Bubble Columns Based on Nonlinear Chaos Analysis of Various Data 412 Stoyan Nedeltchev 16. Characterization and Modeling of Flotation Processes 440 G.G. Kagramanov and V.A. Kolesnikov Part III: Single and Two Phase Flows on Biomedical Engineering 17. Pulse Wave Propagation in Large Blood Vessels Based on Fluid- Solid Interactions Methods 460 Tomohiro Fukui, Kim H. Parker and Takami Yamaguchi 18. An-Harmonic Modeling of the Peripheral Distortion of the Arterial Pulse 472 Panagiotes A. Voltairas, D.I. Fotiadis, A. Charalambopoulos and L.K. Michalis 19. Numerical Analysis of Blood Flow in Stenosed Channels 489 Stephanie Ferreira, Ricardo P. Dias, Carlos Balsa and Carla S. Fernandes 20. Blood Flow Behavior in Microchannels: Past, Current and Future Trends 513 R. Lima, T. Ishikawa, Y. Imai and T. Yamaguchi 21. A Survey of MicroChannel Geometries for Mixing of Species in Biomicrofluidics 548 Francesco Pennella, Francesco Mastrangelo, Diego Gallo, Diana Massai, Marco A. Deriu, Giuseppe Falvo D'Urso Labate, Cristina Bignardi, Franco Montevecchi and Umberto Morbiducci 22. Endothelial Cell Responses to Fluid Shear Stress: From Methodology to Applications 579 Toshiro Ohashi and Masaaki Sato

23. Micro-Flow Visualization of Magnetic Nanoparticles for Biomedical Applications 600 R. Lima, R.J. Joseyphus, T. Ishikawa, Y. Imai and T. Yamaguchi 24. A Computational Study on the Possibility of the Initialization And Development of Intracranial Aneurysms Considering Biofluid and Biosolid Mechanics 613 Yixiang Feng, Shigeo Wada and Takami Yamaguchi Index 634