Extra Questions - 1. 1. What current will flow in a 20Ω resistor when it is connected to a 50V supply? a) 0.4A b) 1.6A c) 2.5A



Similar documents
2. A conductor of length 2m moves at 4m/s at 30 to a uniform magnetic field of 0.1T. Which one of the following gives the e.m.f. generated?

Inductors in AC Circuits

Circuits with inductors and alternating currents. Chapter 20 #45, 46, 47, 49

45. The peak value of an alternating current in a 1500-W device is 5.4 A. What is the rms voltage across?

AC Generators. Basic Generator

RLC Resonant Circuits

Chapter 35 Alternating Current Circuits

Chapter 11. Inductors ISU EE. C.Y. Lee

Application Note. So You Need to Measure Some Inductors?

104 Practice Exam 2-3/21/02

DIRECT CURRENT GENERATORS

ε: Voltage output of Signal Generator (also called the Source voltage or Applied

Application Guide. Power Factor Correction (PFC) Basics

Homework # Physics 2 for Students of Mechanical Engineering

ANADOLU UNIVERSITY DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING

BASIC ELECTRONICS AC CIRCUIT ANALYSIS. December 2011

EDEXCEL NATIONAL CERTIFICATE/DIPLOMA UNIT 5 - ELECTRICAL AND ELECTRONIC PRINCIPLES NQF LEVEL 3 OUTCOME 4 - ALTERNATING CURRENT

REPORT ON CANDIDATES WORK IN THE CARIBBEAN ADVANCED PROFICIENCY EXAMINATION MAY/JUNE 2008 ELECTRICAL AND ELECTRONIC TECHNOLOGY (TRINIDAD AND TOBAGO)

Diodes have an arrow showing the direction of the flow.

MULTIPLE CHOICE. Choose the one alternative that best completes the statement or answers the question.

Equipment: Power Supply, DAI, Transformer (8341), Variable resistance (8311), Variable inductance (8321), Variable capacitance (8331)

Diode Applications. As we have already seen the diode can act as a switch Forward biased or reverse biased - On or Off.

Rectifier circuits & DC power supplies

How To Understand And Understand The Theory Of Electricity

Current and Temperature Ratings

Equipment: Power Supply, DAI, Variable resistance (8311), Variable inductance (8321)

Three phase circuits

BSNL TTA Question Paper-Instruments and Measurement Specialization 2007

Last time : energy storage elements capacitor.

Properties of electrical signals

The full wave rectifier consists of two diodes and a resister as shown in Figure

Inductors & Inductance. Electronic Components

Transformer circuit calculations

Slide 1 / 26. Inductance by Bryan Pflueger

DHANALAKSHMI COLLEGE OF ENGINEERING DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING EE ELECTRICAL MACHINES II UNIT-I SYNCHRONOUS GENERATOR

Science and Reactor Fundamentals Electrical CNSC Technical Training Group. Table of Contents

Line Reactors and AC Drives

Solution Derivations for Capa #11

Eðlisfræði 2, vor 2007

The W5JCK Guide to the Mathematic Equations Required for the Amateur Extra Class Exam

PHASOR DIAGRAMS HANDS-ON RELAY SCHOOL WSU PULLMAN, WA. RON ALEXANDER - BPA

8 Speed control of Induction Machines

Power Supplies. 1.0 Power Supply Basics. Module

Impedance Matching and Matching Networks. Valentin Todorow, December, 2009

Impedance Matching. Using transformers Using matching networks

CURRENT ELECTRICITY INTRODUCTION TO RESISTANCE, CAPACITANCE AND INDUCTANCE

Understanding Power Factor and How it Affects Your Electric Bill. Presented by Scott Peele PE

Principles and Working of DC and AC machines

Experiment #11: LRC Circuit (Power Amplifier, Voltage Sensor)

RLC Series Resonance

Induction Motor Theory

Aircraft Electrical System

PHYS 222 Spring 2012 Final Exam. Closed books, notes, etc. No electronic device except a calculator.

ES250: Electrical Science. HW7: Energy Storage Elements

AP Physics Electricity and Magnetism #4 Electrical Circuits, Kirchoff s Rules

Chapter 12 Driven RLC Circuits

W03 Analysis of DC Circuits. Yrd. Doç. Dr. Aytaç Gören

Experiment1: Introduction to laboratory equipment and basic components.

= V peak 2 = 0.707V peak

Module Title: Electrotechnology for Mech L7

Alternating-Current Circuits

DOE FUNDAMENTALS HANDBOOK ELECTRICAL SCIENCE Volume 3 of 4

Physics 6C, Summer 2006 Homework 2 Solutions

CHAPTER 30: Inductance, Electromagnetic Oscillations, and AC Circuits

NATIONAL CERTIFICATE (VOCATIONAL)

Induced voltages and Inductance Faraday s Law

Chapter 29 Alternating-Current Circuits

Chapter 24. Three-Phase Voltage Generation

EE301 Lesson 14 Reading: , , and

An equivalent circuit of a loop antenna.

Power Factor Correction for Power Systems First Semester Report Spring Semester 2007

13 ELECTRIC MOTORS Basic Relations

Fundamentals of Signature Analysis

Frequency response: Resonance, Bandwidth, Q factor

Edmund Li. Where is defined as the mutual inductance between and and has the SI units of Henries (H).

DIMENSIONING OF CURRENT TRANSFORMERS FOR PROTECTON APPLICATION

Chapter 12: Three Phase Circuits

Prepared By: Sheilani Binti Shaari Department of Electrical Engineering/PKB

Power Quality Paper #3

1. The diagram below represents magnetic lines of force within a region of space.

Critical thin-film processes such as deposition and etching take place in a vacuum

DRAFT. University of Pennsylvania Moore School of Electrical Engineering ESE319 Electronic Circuits - Modeling and Measurement Techniques

Unit 33 Three-Phase Motors

Diode Applications. by Kenneth A. Kuhn Sept. 1, This note illustrates some common applications of diodes.

Basics of Electricity

Power supplies. EE328 Power Electronics Assoc. Prof. Dr. Mutlu BOZTEPE Ege University, Dept. of E&E

Lab 14: 3-phase alternator.

Since any real component also has loss due to the resistive component, the average power dissipated is 2 2R

Lesson 3 DIRECT AND ALTERNATING CURRENTS. Task. The skills and knowledge taught in this lesson are common to all missile repairer tasks.

The Importance of the X/R Ratio in Low-Voltage Short Circuit Studies

Basic Electrical Technology Dr. L. Umanand Department of Electrical Engineering Indian Institute of Science, Bangalore. Lecture phase System 4

Power Factor The Basics

The D.C Power Supply

Effect of Frequency on Inductive Reactance

TAN δ (DELTA) CABLE TESTING OVERVIEW AND ANSWERS TO FREQUENTLY ASKED QUESTIONS. What Is Tan δ, Or Tan Delta?

Apprentice Telecommunications Technician Test (CTT) Study Guide

Measurement of Capacitance

Lecture 24. Inductance and Switching Power Supplies (how your solar charger voltage converter works)

Equipment: Power Supply, DAI, Wound rotor induction motor (8231), Electrodynamometer (8960), timing belt.

Transcription:

Extra Questions - 1 1. What current will flow in a 20Ω resistor when it is connected to a 50V supply? a) 0.4A b) 1.6A c) 2.5A 2. A current of 500mA flows in a resistance of 12Ω. What power is dissipated by the resistor? a) 3W b) 6W c) 18W 3. Three 12Ω resistors are connected in parallel. What will the resistance of this combination be? a) 3Ω b) 4Ω c) 48Ω 4. A power of 240W appears in a load for a total time of 120 seconds. What energy is used? a) 2J b) 2kJ c) 28.8kJ 5. A charge of 1mC appears in a capacitor of 2uF. What voltage appears across the plates of the capacitor? a) 50V b) 200V c) 500V 1

6. Capacitors of 1uF and 2uF are connected in series. What is the capacitance of the series combination? a) 0.33uF b) 0.67uF c) 3uF 6. Four capacitors, each of 100uF, are connected in parallel. What is the capacitance of the parallel combination? a) 25uF b) 200uF c) 400uF 7. Capacitors of 2uF and 8uF are connected in series across a 100V DC supply. What voltage appears across the 8uF capacitor? a) 20V b) 80V c) 100V 8. A straight length of wire moves through a uniform magnetic field. The e.m.f. produced across the ends of the wire will be maximum if it moves: a) along the lines of magnetic flux b) at 45 to the lines of magnetic flux c) at 90 to the lines of magnetic flux 9. A conductor of length 2m moves at 4m/s at 30 to a uniform magnetic field of 0.1T. Which one of the following gives the e.m.f. generated? a) 0.2V b) 0.4V c) 0.8V 2

10. In a shunt-wound generator: a) none of the armature current flows through the field b) some of the armature current flows through the field c) all of the armature current flows through the field 11. A compound-wound generator: a) has only a series field winding b) has only a shunt field winding a) has both a series and a shunt field winding 12. A waveform has a frequency of 50Hz. Which one of the following gives its period? a) 20 ms b) 50 ms c) 100 ms 13. A waveform has a period of 10 ms. Which one of the following gives its frequency? a) 10 Hz b) 50 Hz c) 100 Hz 14. Which one of the following gives the angle between the successive phases of a three phase supply? a) 60º b) 90º c) 120º 15. An aircraft supply has an RMS value of 100V. Which one of the following gives the approximate peak-peak value of the supply voltage? a) 50V b) 200V c) 282V 3

16. The peak value of current supplied to an aircraft TRU is 14A. Which one of the following gives the approximate value of RMS current supplied? a) 7A b) 10A c) 28A 17. A circuit consisting of a pure capacitance is connected across an AC supply. Which one of the following gives the phase relationship between the voltage and current in this circuit? a) The voltage leads the current by 90º b) The current leads the voltage by 90º c) The current leads the voltage by 180º 18. A circuit consisting of a pure inductance is connected across an AC supply. Which one of the following gives the phase relationship between the voltage and current in this circuit? a) The voltage leads the current by 90º b) The current leads the voltage by 90º c) The current leads the voltage by 180º 19. The core of a transformer is laminated in order to reduce its: a) weight b) size c) eddy current losses 20. An inductor has an inductive reactance of 20Ω and a resistance of 20Ω. Which one of the following gives the phase relationship between the voltage and current in this circuit? a) The current leads the current by 45º b) The voltage leads the voltage by 45º c) The voltage leads the voltage by 90º 4

21. A capacitor has a capacitive reactance of 500Ω. If the capacitor is connected in series with a resistance of 500Ω which one of the following gives the phase relationship between the voltage and current in this circuit? a) The current leads the current by 45º b) The voltage leads the voltage by 45º c) The voltage leads the voltage by 90º 22. A series circuit consists of a resistance of 6Ω connected in series with a capacitor with a reactance of 8Ω. Which one of the following gives the impedance of the circuit? a) 2Ω b) 10Ω c) 14Ω 23. A capacitor having negligible resistance is connected across a 220V AC supply. If the current flowing in the capacitor is 2A, which one of the following gives its reactance? a) 110Ω b) 220Ω c) 440Ω 24. A pure capacitor having a reactance of 50Ω is connected across a 100V AC supply. Which one of the following gives the power dissipated in the capacitor? a) zero b) 200W c) 500W 25. The power factor in an AC circuit is defined as: a) the ratio of true power to apparent power b) the ratio of apparent power to true power c) the ratio of reactive power to true power 26. The power factor in an AC circuit is the same as: a) the sine of the phase angle b) the cosine of the phase angle c) the tangent of the phase angle 5

27. The phase angle in an AC circuit is 60 degrees. What is the power factor of the circuit? a) 0.5 b) 0.6 c) 0.667 28. An AC circuit consists of a resistance of 10Ω connected in series with a reactance of 10Ω. What is the power factor of the circuit? a) 0.5 b) 0.707 c) 0.667 29. An AC circuit consists of an inductor and a resistor connected in series. If the phase angle is found to be 45º, which one of the following is TRUE? a) The resistance will be equal to the inductive reactance b) The resistance will be greater than the inductive reactance c) The resistance will be less than the inductive reactance 30. An AC circuit consists of an inductor connected in parallel with a capacitor. If both components are considered to be perfect, which one of the following statements is TRUE? a) At a certain frequency the impedance of the circuit will be zero b) At a certain frequency the impedance of the circuit will be infinite c) The impedance of the circuit will remain constant at all frequencies 31. An AC circuit consists of an inductor connected in series with a capacitor. If both components are considered to be perfect, which one of the following statements is TRUE? a) At a certain frequency the impedance of the circuit will be zero b) At a certain frequency the impedance of the circuit will be infinite c) The impedance of the circuit will remain constant at all frequencies 6

32. A transformer has 1,200 primary turns and 600 secondary turns. If the primary is supplied from a 220V AC supply which one of the following gives the resulting secondary voltage? a) 55V b) 110V c) 440V 33. A transformer has 2,000 primary turns and 400 secondary turns. Assuming that the transformer is 'loss free', if the primary current is 0.5A which one of the following gives the secondary current? a) 0.1A b) 0.5A c) 2.5A 34. The copper loss in a transformer is due to: a) the I 2 R power loss in the transformer windings b) the power required to magnetise the core of the transformer c) eddy currents flowing in the magnetic core of the transformer 35. The iron loss in a transformer is due to: a) the I 2 R power loss in the transformer windings b) the power required to magnetise the core of the transformer c) eddy currents flowing in the magnetic core of the transformer 7