product specifications 369-376 The processor provides control and communication to system components. The Ethernet links allow communication to the software, integration with third party systems and communication between multiple processors. processors may be connected using either standard networking or using ad-hoc networking. All processors on a project must be connected to a single network. The software and all integration equipment must be connected to the same network as the processors. The processor is powered from the power supply. Refer to the software to determine link power requirements. The processor can be installed in an HQ-LV21 enclosure. Processor Capabilities Each processor has 2 links that can be individually configured as one of three types: HomeWorks / Power Panels 16 addresses / 256 zones Wired Device Link 100 devices / 500 zones Control Interfaces Dynamic Keypad seetouch Keypad GRAFIK Eye QS Control Unit Sivoia QS shades RF Link 100 devices / 100 zones Dynamic Keypad Maestro Dimmers/Switches Lamp Dimmers RF seetouch Keypad Sensors, Occupancy/Vacancy Sivoia QS Wireless Shades Tabletop Keypad GRAFIK Eye QS Control Units Model Number HQP6-2-120 Lutron 1
product specifications 369-376a Specifications Model Numbers Power Typical Power Consumption Regulatory Approvals Environment Heat Generated Cooling Method Power Failure Memory Internal Timeclock Miswire Protection Low-Voltage Link Wire Type Low-Voltage Power Wire Type Communications Link Capacities ESD Protection Surge Protection Mounting Dimensions HQP6-2-120 Processor (P): - 250 ma Links (L1 / L2): - 2 A per link 5 W; 8 Power Draw Units (PDUs) conditions: Two Ethernet links connected, both device links in use UL, cul Indoor use only. 32 F and 104 F (0 C and 40 C), 0% to 90% humidity, non-condensing 17 BTU/hr typical (24 BTU/hr with 2 links at 2 A each output) Passive Cooling System data stored in non-volatile memory. Timeclock retention for 10 years ±1 minute per year All terminal block inputs are over-voltage and miswire protected against wire reversals and shorts. Two pair one pair 18 AWG (0.75 mm 2 ), one pair 18 to 22 AWG (0.34 to 0.75 mm 2 ) twisted shielded IEC PELV / NEC Class 2 cable 18 AWG (0.75 mm 2 ) Ethernet, RS485 (QS, RF, Power Panel) HomeWorks / Power Panels 16 addresses / 256 zones Wired Device Link 100 devices / 500 zones RF Link 100 devices / 100 zones Meets or exceeds the IEC 61000-4-2 standard Meets or exceeds ANSI/IEEE C62.41 standard Mounts in HQ-LV21 enclosure With terminal blocks (as shown): 4.27 in (108 mm) x 6.0 in (152 mm) Without terminal blocks: 4.27 in (108 mm) x 5.26 in (134 mm) Connections Two 5-pin removable terminal blocks* for Links 1 and 2. One 5-pin removable terminal block* for Power Input. Two RJ-45 standard Ethernet connections. *Each terminal will accept up to two 18 AWG (0.75 mm 2 ) wires. Warranty 8 Year Limited Warranty. http:///resiinfo NEC is a registered trademark of the National Fire Protection Association, Quincy, Massachusetts. 2 Lutron 24/7 Technical Support 800.523.9466
product specifications 369-376 Dimensions Dimensions shown as: in (mm) Front View 4.27 (108) Side View 5.26 (134) 6.0 (152) 1.06 (26.9) Lutron 3
PWR ERR P P L1 L1 TX/RX L2 L2 TX/RX L(+) N(-) PWR ERR P P L1 L1 TX/RX L2 L2 TX/RX product specifications 369-376a Mounting DIN Rail Power Supply () (5) Ground (4) Red L2 (Link 2) Power (3) Red L1 (Link 1) Power (2) Red P (Processor) Power (1) Black COM (Common) Wire Landing Boards (QS-WLB) 4 Lutron 24/7 Technical Support 800.523.9466
L(+) N(-) product specifications 369-376 Wiring Diagrams Networking Standard Networking: Connection using an Ethernet hub/switch/router HQ-LV21 Panel with 2 processors Ethernet cable: Cat5/Cat5e 328 ft (100 m) maximum per home run processors Ethernet Router WAN LAN Laptop PC Ethernet cable: Cat5/Cat5e 328 ft (100 m) maximum per home run processor Ad-hoc Networking: Direct Ethernet connection from PC to processors Ethernet cable: Cat5/Cat5e 328 ft (100 m) maximum each run 328 ft (100 m) max 328 ft (100 m) max 328 ft (100 m) max Laptop PC processor processor processor Up to 5 processors can be daisy-chained Lutron 5
product specifications 369-376a Wiring Diagrams Power Panel Link Power Panel Link* Up to 16 addresses total * Pin 2 does not get connected when using a power panel link. 6 Lutron 24/7 Technical Support 800.523.9466
Power 9 V Hybrid Repeater Repeater Status P 1 2 3 4 Communication Setup Repeater Link RF COM 1 2 3 4 Add Wired Activate Power 9 V Hybrid Repeater Repeater Status P 1 2 3 4 Communication Setup Repeater Link RF COM 1 2 3 4 Add Wired Activate Power 9 V Hybrid Repeater Repeater Status P 1 2 3 4 Communication Setup Repeater Link RF COM 1 2 3 4 Add Wired Activate product specifications 369-376 Wiring Diagrams RF Link HQP6-2-120 30 ft (9m) maximum RF Device Hybrid Repeater RF Device RF Device RF Link* 1000 ft (305 m) maximum wire length per run 30 ft (9m) maximum 60 ft (18 m) maximum RF Link* 1000 ft (305 m) maximum wire length per run 30 ft (9m) maximum * Hybrid Repeaters can be powered from the Processor link or a wall-mount transformer. If powering from a wall-mount transformer, Pin 2 does not get connected. Lutron 7
L(+) N(-) L(+) N(-) product specifications 369-376a Wiring Diagrams QS Link QS Link QS Link Max 2A combined Draw from processor when powering both links from the same power supply up to 99 device addresses up to 99 device addresses Wiring Diagrams Link Power More current can be supplied by an additional power supply (1) Black COM (Common) (4) Red L2 (Link 2) Power (5) Ground (3) Red L1 (Link 1) Power (2) Red P (Processor) Power (1) Black COM (Common) 2 A 2 A Max 2 A per link when using a separate power supply for each link 8 Lutron 24/7 Technical Support 800.523.9466
product specifications 369-376 Wiring Diagrams QS Wired Device Link with Shades (Controllable Window Solutions) 120 V~ 60 Hz QS Link wired devices QSPS-P1-10-60 QS Smart Power Panel wired devices Lutron 9