CIVIL WORK (A) 1 Providing and fixing corrugated galvanised iron sheets of 20 B.W.G. for roofing with wind ties including fastening with galvanised iron screw and bolts and lead and bitumen washers as per drawing complete. (TATA CG I) 2 Providing, fabricating and erecting at site of work the tubular steel structure (shed) of standard size as per standard design and specifications having various spans ranging from 6 mt. to 18 mt. Length in between trusses and in multiples of standard length of bays as specified as per standard specifications inclusive of cost of steel tubular trusses, tubular columns, purlins, tie runners, foundation bolts, base plates, nuts and bolts, welding wherever required etc. as per detailed drawing inclusive of one coat of anticorrosive paint and two coats of oil painting of approved quality and shade complete Spec. No. : As directed by Engineer-in-charge. Schedule of Quantities sqm 113.40 MT 2.00 3 Providing second class Burnt Brick masonry with conventional/ I.S. type bricks in cement mortar 1:6 in super structure including striking joints, racking out joints wateringand scaffolding complete. 4 Providing internal/external cement plaster 12 mm thick in a single coat in cement mortar 1:4 without neeru finish to concrete or brick surface in all positions including scaffolding and curing etc. complete. cum 13.00 sqm 282.00
5 Providing and fixing M.S. grills of required pattern in frames of windows etc. with M.S. flats, square or round bars etc. all complete. Fixed to steel windows by welding. 6 Providing and fixing factory made ISI marked steel glazed doors, windows and ventilators side /top /centre hung with beading and all members such as K11 B and K12 B etc. complete of standard rolled steel sections, joints mitred and flash butt welded and sash bars tenoned and riveted with 15x3mm lugs, 10cm long, embedded in cement concrete blocks 15x10x10cm of 1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20mm nominal size) or with wooden plugs and screws or rawl plugs and screws or with fixing clips or with bolts and nuts as required, including providing and fixing of hinges, pivots, float glass panes with glazing clips and special metal sash putty of approved make and a priming coat of approved steel primer excluding the cost of metal beading and other fittings except necessary hinges or pivots complete as per approved design. (Section weight of only steel members shall be measured for payment without weight of glass & other fittings) Kg 100.00 Kg 200.00
7 Providing and fixing suspended white/colour decorative ceiling of gypsum board which includes G.I. Perimeter channel ( MF6) of size 0.40 mm thick ( having one flange of 20 mm and another flange of 30 mm and web of 27 mm) along with perimeter of ceiling, screw fixed to brick wall / partition with the help of nylon sleeves and screws at 610 mm centers. Thereafter suspending G.I. intermediate channel ( MF 7) 600 mm. C/C of size 45mm (0.9 mm thick with two flanges of 15 mm each) from the soffit at 450 mm centre with connecting angle (ie ceiling angle) of width 25mm x 10mm x 0.40mm thick fixed to soffit with G.I.cleat and teel expansion fasteners. sqm 65.00 Celling sections ( MF 5 ) of 0.55 mm thickness having knurled web of 51.5 mm and two flanges of 26 mm each with lips of 10.5 mm are then fixed to the intermediate channel with the help of connecting clip and in direction perpendicular to the intermediate channel at 450 mm centers. 12.5 mm tapered edge Gyp board (conforming to IS 2095-1982) is then screw fixed to celling section with dry wall screws at 230 mm centers. Screw fixing is to be done mechanically with suitable attachment. The boards are to be joined and finished so as to have flush look which includes filling and finishing the tappered & square edges of the boards with jointing compound, joint paper tape and appropriate suitable primer and three coats of plastic acrylic paint. The item includes for light fitting, grill diffuseres and cut out etc. have to be made with frame of perimeter channels of size 20mm x 30mm x0.55mm.thick supported suitable and angle bead is to be used at steps to get straight line finish etc. complete Spec.No. : As directed by Engineer- in-charge
8 Providing and laying cement concrete flooring 40 mm thick with 1:2:4 cement concrete laid to proper level and slope in alternate bays, including compacting, PVC/ Glass/Aluminum strips at joints, marking lines to give appearance of tiles of 30 cm x 30 cm or other size laid diagonally/square etc. finishing smooth(with extra cement) in any colour as directed and curing complete. sqm 65.00 9 EXTERIOR FINISHING Finishing walls with water proofing cement paint of required shade : New work (Two or more coats applied @ 3.84 kg/10 sqm). sqm 141.00 10 INTERIOR FINISHING Application of J K White cement based J K Wall putty in 2 coats on old/new surface including removing of existing painted surface, cleaning of all loose particlea on the surface, washing of wall, prepare the surface for wall putty including one coat of primer. (including all labour charges) complet 11 Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge. In cement mortar 12 Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead. sqm 206.00 cum 0.20 sqm 25.00 13 Any other item which is not covered under this schedule will be paid as per DSR 2007 if not than SOR-2011-2011 Nagpur CIVIL WORK (A) % above or below 10000.00 Total in Rs.
ELECTRICAL WORK (B) 14 Supplying of 1200 mm (48") ceiling fan of Bajaj, Orient,Khaitan, Usha or equivalent make complete with all accessories as required as per the direction of engineer in charge. 15 Supply of following lighting fixtures complete in all respect with lamps and necessary control gear including supply of all connected materials ceiling rose, clamps, supports, chains, anchors, fastners, bolts, nuts and washers etc. as required and as per direction of Engineer-in-charge. Each 6 a b Surface/Pendent Mounting Industrial T5 Luminaires with white powder CRCA sheet steel housing with reflector cover T5 channel luminaires of Bajaj,CG, or equivalent make. Outdoor lighting with CFL luminaries with Bulkhead fittings water proof of Bajaj/Khaitan/CG or equivalent make. 16 Supply and drawing of LAN cable in existing PVC conduit pipe with RJ-45 connector of D-link or equivalent make. 17 Window mounted with stand,desert cooler (approx. covering 3000 Cu.m)with multiple speed regulator and submursible pump with the approval of Engineer-in - charge. 18 Wiring for light point/fan point/exhaust fan point/call bell point with 1.5 sq. mm. FR PVC insulated copper conductor single core cable in surface/recessed PVC conduit, with modular switch, modular plate, suitable GI box and earthing the point with 1.5 sq. mm. FR PVC insulated copper conductor single core cable etc. as required. Nos. 10 Nos. 2 RMT 60 Nos. 2 a Group C Point 25
19 Wiring for twin control light point with 1.5 sq. mm. FR PVC insulated copper conductor single core cable in surface/recessd PVC conduit, 2 way modular switch, modular plate, suitable size G.I. box and earthing the point with 1.5 sq. mm. FR PVC insulated copper conductor single core cable etc. as required. 20 Wiring for light/power plug with 2x4 sq. mm. FR PVC insulated copper conductor single core cable in surface/recessed PVC conduit alongwith 1 No. 4 sq. mm. FR PVC insulated copper conductor single core cable for loop earthing as required. 21 Wiring for light/power plug with 2x2.5 sq. mm. FR PVC insulated copper conductor single core cable in surface/recessed PVC conduit alongwith 1 No. 2.5 sq. mm. FR PVC insulated copper conductor single core cable for loop earthing as required. 22 Supplying and drawing following pair, 0.5 sq.mm FR PVC insulated copper conductor, unarmoured telephone cable in the existing surface/ recessed stell/ PVC conduit as required. Point 2 Metre 20 Metre 50 2 pair Metre 60 23 Supplying & fixing 25mm PVC conduit of ISI mark RMT. 90 alongwith accessories in recess including cutting the wall & making good the chases. 24 Supplying, fixing and commissioning of following way, three pole and neutral, sheet steel, MCB Distribution board, 415 volts on surface / Recess, complate with tinned copper busbar, neutral link, earth bar, din bar, detachable gland plate, interconections phosphatised and powder painted including earthing etc. as required complete with RCCB & MCCB as under. a 4 Way, Single door, horizontal type. Each 1 b Incoming 1 x 25 Amp RCCB Each 1
c Outgoing 5 to 32 Amp single pole MCB for 1 DB. Each 5 25 Installation, testing and commissioning of pre-wired, Each 10 flourescent fitting/compact flourescent fitting of all types, complete with all accessories and tube etc. including connection with 1.5 sq. mm. FR PVC insulated, copper conductor, single core cable and earthing etc. as required. 26 Installation, testing & commissioning of Ceiling fan at different locations complete including wiring the down rods with 1.5 sq. mm. FR PVC insulated copper conductor, single core cable, including providing and fixing phenolic laminated sheet cover on the fan box etc. as required. 27 Supply and fixing stepped type electronic fan regulator of Anchor (ROMA) or equivalent modular regulator with the approval of Engineer-In-Charge on the existing modular switch box including connections etc. as required. Each 6 Each 6 28 Supplying and fixing following modular switch/socket on the modular plate & switch box including connections with modular plate etc. as required of Anchor (ROMA) or equivalent make with the approval of Engineer-In-Charge. a 5/6 amps. Switch Each 25 b 2 way 5/6 amps. Switch Each 1 c 15/16 amps. Switch Each 2 d 3 Pin 5/6 amps. Socket outlet Each 7 e 6 Pin 15/16 amps. Socket outlet Each 2 f Telephone Socket outlet Each 1 MAINS AND SUB MAINS
29 Circuit/sub-main wiring in PVC conduit: Wiring for circuit/submain wiring alongwith earth wire with the following sizes of PVC insulated copper conductor, single core cable in surface/recessed PVC conduit as required. a 2 X 2.5 sqmm + 1 X 2.5 sq.mm earth wire RM 20 b 4 X 10 sqmm + 2 X 10 sq.mm earth wire ELECTRICAL WORK (B) Total quoted amount (Rs.), (A+B) RM 25 Total (in Rs) IN FIGURE (Rs) IN WORDS (Rs)