File No. NJNE3737D MITSUBISHI ELECTRIC JET TOWEL HAND DRYER MODEL: JT-SB216ESH-W-CE JT-SB216ESH-DG-CE JT-SB216GSN-W-CE JT-SB216GSN-DG-CE CANNON AIR JET MODEL: JT-SB216ESH-W-CH JT-SB216ESH-DG-CH TECHNICAL DOCUMENTATION PART 1 CONTENTS GENERAL DESCRIPTION AND SPECIFICATIONS EC DECLARATION OF CONFORMITY ATTESTATION OF CONFORMITY (LOW VOLTAGE DIRECTIVE) CB TEST CERTIFICATE CERTIFICATE OF CONFORMITY (EMC DIRECTIVE) STANDBY AND OFF MODE TEST REPORT (ErP DIRECTIVE) ISO 9001:2000 MANAGEMENT SYSTEM CERTIFICATE ISO 14001:2004 CERTIFICATE OF APPROVAL ANNEXES RATING LABEL INSTRUCTION MANUAL INSTALLATION MANUAL January 2010 D. MITSUBISHI ELECTRIC CORPORATION NAKATSUGAWA WORKS, 1-3 Komaba-cho, Nakatsugawa-city, Gifu-pref 508-8666, Japan Phone +81-573-66-8249, Fax +81-573-66-7059
File No. NJNE3737D General description When wet hands after washing are inserted into the hand insertion unit 1, water on the hands is blown away towards the inner portion of the hand insertion unit 1 by high-speed airflow, and the hands dry after several seconds. In this way, Jet Towel can be obtained in which a process of drying wet hands can be terminated within a short period and without bothering the user to move or rub the hands, which can rapidly and surely conduct a drying process, and which can be used easily and simply without causing trouble. Jet Towel has hand detection sensors 2, 3. These sensors are mainly consisting of light emitting diodes the drainage hole formed in the bottom. When the hands are withdrawn from the hand insertion unit 1, the hand-nonexistence detection signal is generated to stop the high-pressure airflow generation device 5, thereby completing the rapid and sanitary treatment of drying hands. And Jet Towel (JT-SB216ESH) has a heater unit 12. When JT-SB216ESH is not used, the heater operates for accumulating heat. Therefore JT-SB216ESH can blow warm air when wet hands are inserted into the hand insertion unit 1. Also the heater 12 and motor 4 do not work at the same time. Therefore, the power consumption of JT-SB216ESH is lower than the conventional hand dryer with a heater. (LEDs) and photodiodes. The LEDs emit pulses As Jet Towel (JT-SB216GSN) does not have a heater, constantly while the photodiodes receive the pulse. When wet hands are inserted into the hand insertion unit 1, the LEDs pulse becomes the setting value. the power consumption is lower than JT-SB216ESH, and therefore JT-SB216GSN is recommended for an air-conditioned place to reduce a carbon footprint. Then, the control circuit causes the DC brushless motor 4 of the high-pressure airflow generation device 5 to start to rotate, whereby the turbo fan is rotated. By the rotation of the turbo fan, the air in the hand insertion unit 1 is drawn from the air inlet 6 equipped with an air filter into the high-pressure airflow generation device 5. The high-pressure air flow is sent from the outlet of the high-pressure air flow generation device 5 into the air ducts 7, 8, and then blown out from the nozzles 9, 10, to simultaneously hit against both the back and palm of the hands as a high wind and with a predetermined inclination. Water drops on the hands are blown away by the high-speed wind in the forward direction, or toward the inner portion in the hand insertion unit 1. The blown water drops are pushed by both gravity and wind to the end of the bottom of the hand insertion unit 1, and flow into the drain tank 11 from 9 1 3 7 11 (JT-SB216GSN) 6 (JT-SB216ESH) 10 2 8 4 5 12 (JT-SB216ESH). MITSUBISHI ELECTRIC CORPORATION NAKATSUGAWA WORKS, 1-3 Komaba-cho, Nakatsugawa-city, Gifu-pref 508-8666, Japan Phone +81-573-66-3170, Fax +81-573-66-5659
ATTESTATION OF CONFORMITY WITH EUROPEAN DIRECTIVE Page 1/2 Order No. 120316 A sample of the following product has been tested and is stated by Nemko to be in conformity with the applicable European standards referred below. Product Manufacturer Hand Dryer Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan Factory Ratings Trade mark Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan See next page(s) 1010-1200W 4.6-5.0A 220-240V 50-60Hz Model / Type Ref. Principal characteristics JT-SB216ESH-x-... Cl. l The "x" in the model name denotes external color. The symbols "..." can be 0 to 9, A to Z or blank and denotes destination of the appliance. See next page(s) A sample of the product was tested and found to be in conformity with HOUS EMF EN 60335-2-23:2003;A1 EN 60335-1:2002;A11;A1;A12;A2;A13 EN 50366:2003;A1 Test Report Ref. No. 120316 It may therefore be presumed that the tested sample of the product is in conformity with the technical provisions of the following European Directives including the latest amendments, and with national legislation implementing these Directives: - Low Voltage Directive 2006/95/EC Provided that other applicable Directive requirements are satisfied, the manufacturer (or the European authorized representative), may draw up an EC/EEA Declaration of Conformity and affix the CE-marking to each conforming product. Additional model(s) See next page(s) Additional information See next page(s) Date of issue 02-02-2009 Signature Hanne Yndestad Certification Department Nemko AS Office address Internett Telephone Fax P.O. Box 73, Blindern Gaustadalléen 30 www.nemko.com +47 22 96 03 30 + 47 22 96 05 50 N-0314 Oslo, Norway Oslo Enterprise number: NO 974404532
ATTESTATION OF CONFORMITY WITH EUROPEAN DIRECTIVE Page 2/2 Order No. 120316 Product Hand Dryer Pos. No 1 Model / Type Ref. JT-SB216GSN-x-... Trade mark (if different from page 1) Ratings Principal characteristics 560W 3.1-3.5A 220-240V 50-60Hz Cl. l The "x" in the model name denotes external color. The symbols "..." can be 0 to 9, A to Z or blank and denotes destination of the appliance. Date of issue 02-02-2009 Signature Hanne Yndestad Certification Department Nemko AS Office address Internett Telephone Fax P.O. Box 73, Blindern Gaustadalléen 30 www.nemko.com +47 22 96 03 30 + 47 22 96 05 50 N-0314 Oslo, Norway Oslo Enterprise number: NO 974404532
Ref. Certif. No. NO51165 IEC SYSTEM FOR MUTUAL RECOGNITION OF TEST CERTIFICATES FOR ELECTRICAL EQUIPMENT (IECEE) CB SCHEME SYSTEME CEI DACCEPTATION MUTUELLE DE CERTIFICATS DESSAIS DES EQUIPEMENTS ELECTRIQUES (IECEE) METHODE OC CB TEST CERTIFICATE CERTIFICAT D'ESSAI OC Product Produit Name and address of the applicant Nom et adresse du demandeur Name and address of the manufacturer Nom et adresse du fabricant Name and address of the factory Nom et adresse de l'usine Note: When more than one factory, please report on page 2 Note: Lorsque il y plus d'une usine, veuillez utiliser la deuxième page Ratings and principal characteristics Valeurs nominales et caractéristiques principales Trademark (if any) Marque de fabrique (si elle existe) Hand Dryer Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan Additional information on page 2 1010-1200W 4.6-5.0A 220-240V 50-60Hz Cl. l Model / Type Ref. Ref. De type Additional information (if necessary may also be reported on page 2) Les informations complémentaires (si nécessaire, peuvent être indiqués sur la deuxième page) A sample of the product was tested and found to be in conformity with Un échantillon de ce produit a été essayé et a été considéré conforme à la As shown in the Test Report Ref. No. which forms part of this Certificate Comme indiqué dans le Rapport d'essais numéro de référence qui constitue partie de ce Certificat JT-SB216ESH-x-... The "x" in the model name denotes external color. The symbols "..." can be 0 to 9, A to Z or blank and denotes destination of the appliance. Additional information on page 2 IEC 60335-1(ed.4);am1;am2 IEC 60335-2-23(ed.5);am1 120316 This CB Test Certificate is issued by the National Certification Body Ce Certificat d'essai OC est établi par l'organisme National de Certification Gaustadalléen 30 NO-0373 Oslo, Norway Date: 02-02-2009 Signature: Hanne Yndestad Certification Department Issued 2007-04 1/1
Ref. Certif. No. NO51166 IEC SYSTEM FOR MUTUAL RECOGNITION OF TEST CERTIFICATES FOR ELECTRICAL EQUIPMENT (IECEE) CB SCHEME SYSTEME CEI DACCEPTATION MUTUELLE DE CERTIFICATS DESSAIS DES EQUIPEMENTS ELECTRIQUES (IECEE) METHODE OC CB TEST CERTIFICATE CERTIFICAT D'ESSAI OC Product Produit Name and address of the applicant Nom et adresse du demandeur Name and address of the manufacturer Nom et adresse du fabricant Name and address of the factory Nom et adresse de l'usine Note: When more than one factory, please report on page 2 Note: Lorsque il y plus d'une usine, veuillez utiliser la deuxième page Ratings and principal characteristics Valeurs nominales et caractéristiques principales Trademark (if any) Marque de fabrique (si elle existe) Hand Dryer Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan Mitsubishi Electric Corporation 1-3 Komaba-cho, Nakatsugawa-shi Gifu, 508-8666 Japan Additional information on page 2 560W 3.1-3.5A 220-240V 50-60Hz Cl. l Model / Type Ref. Ref. De type Additional information (if necessary may also be reported on page 2) Les informations complémentaires (si nécessaire, peuvent être indiqués sur la deuxième page) A sample of the product was tested and found to be in conformity with Un échantillon de ce produit a été essayé et a été considéré conforme à la As shown in the Test Report Ref. No. which forms part of this Certificate Comme indiqué dans le Rapport d'essais numéro de référence qui constitue partie de ce Certificat JT-SB216GSN-x-... The "x" in the model name denotes external color. The symbols "..." can be 0 to 9, A to Z or blank and denotes destination of the appliance. Additional information on page 2 IEC 60335-1(ed.4);am1;am2 IEC 60335-2-23(ed.5);am1 120316 This CB Test Certificate is issued by the National Certification Body Ce Certificat d'essai OC est établi par l'organisme National de Certification Gaustadalléen 30 NO-0373 Oslo, Norway Date: 02-02-2009 Signature: Hanne Yndestad Certification Department Issued 2007-04 1/1
Certificate Of Conformity Electromagnetic Compatibility (EMC) A sample of this product has been subject to assessment by Nemko, and is hereby confirmed to be in conformity with the applicable European EMC standards referred below. Sufficient evidence of conformity with Article 4 of the EMC Directive (89/336/EEC + 91/263/EEC + 92/32/EEC + 93/68/EEC + 93/97/EEC) has been provided. Certificate No.: HF 062809 Applicant Mitsubishi Electric Corporation Nakatsugawa Works 1-3 Komaba-cho, Nakatsugawa-shi, Gifu-ken 508-8666, JAPAN Manufacturer Mitsubishi Electric Corporation Nakatsugawa Works 1-3 Komaba-cho, Nakatsugawa-shi, Gifu-ken 508-8666, JAPAN Product Hand Dryer Model Rating 1) JT-SB216ESH-*-# 2) JT-SB216GSN-*-# 1) 4.6-5A 220-240V AC 50-60Hz 2) 3.5A 220-240V AC 50-60Hz Additional information The "*" in model name is code for color of enclosure, the # is code for export area Brand Name - Documentation Test reports by Cosmos Corporation, # E78743, E60578, S60578, E51866 and S51866 Standards applied EN 55014-1(2006) EN 61000-3-2 (2006) EN 61000-3-3 (1995) + A1 (2001) + A2 (2005) EN 55014-2 (1997) + A1 (2001) This certificate is valid until 2009-03-30 + 4 years (provided that all signed certification conditions are complied with, and that possible changes to the product are notified to Nemko for acceptance prior to implementation) Nemko order number 121236 This certificate authorizes the manufacturer to affix the below shown Nemko EMC Mark to each conforming product. And provided it is otherwise confirmed that the product also conforms with any other applicable Directives, the manufacturer (or the European authorized representative) may prepare an EC/EEA Declaration of Conformity and affix the below shown CE-marking to each conforming product. Date of issue 2009-03-30 Certificate revision: 2.1 per Roger Berget [Section Manager] Note: The certificate is no longer valid if any of the reference standards cease to exist or are replaced Page 1 of 1 Nemko AS Gaustadallèen 30 P.O.Box 73 Blindern N-0314 Oslo Norway T +47 22 96 03 30 F +47 22 96 05 50 Enterprise number NO974404532