TEST REPORT RAPPORTO DI PROVA EMC tests on

Transcription

1 TEST REPORT RAPPORTO DI PROVA EMC tests on BIG POWER Test di compatibilità elettromagnetica BIG POWER Customer (Richiedente): - Dept./Firm (Ente/Società): T.P.A. IMPEX S.p.A. - Mr./Mrs. (Sig./Sig.ra.): Cristiano Tosin - Address (Indirizzo): Piazzetta Albere 3/ Romano d Ezzelino (VI) Test Request Form no.: Modulo Richiesta Prova n.: EMC15/137 Test Report sent to: Rapporto inviato a: Cristiano Tosin Name and Signature of the test engineer: Nome e Firma esecutore prova: Luciano Sillla Name and Signature of the Technical reviewer: Nome e Firma del Revisore tecnico: Giuseppe Mecchia Date of test samples receipt: Data ricevimento campioni: Date of test execution: Data esecuzione prove: 24/06/2015 From 24/06/2015 to 25/06/2015 Site of test execution (if different from the address in the footer): Località esecuzione prove (se diversa dal piè pagina): Witness to the test: Presenti alle prove: none The test results contained in this Test report relate to the tested samples only. I risultati del presente rapporto di prova si riferiscono esclusivamente al campione sottoposto a prova. The integral reproduction of the present Test report is allowed; the partial reproduction must be authorized in writing by the Lab. E' ammessa la riproduzione integrale del presente Rapporto di prova da parte del Richiedente; la riproduzione parziale dev'essere autorizzata per iscritto dal Laboratorio. Page 1 of 27

2 1 TEST SETUP SETUP DI PROVA 1.1 SAMPLE IDENTIFICATION IDENTIFICAZIONE CAMPIONE Product/material subjected to test: BIG POWER Description: Aspirapolvere con filtro ad acqua e funzione UVC Vacum cleaner with water filter and UVC function Level (Series product, prototype, etc.): Pre-series Part number: n.a Serial number: Sample identification code: C Codice identificativo del campione: 1.2 AUXILIARY DEVICES None DISPOSITIVI AUSILIARI Nessuno 1.3 TEST CONFIGURATION Stand-alone equipment CONFIGURAZIONE DI PROVA Apparato singolo 1.4 DIAGNOSTIC SYSTEM Normal running of vacuum cleaning SISTEMA DIAGNOSTICO In normale funzionamento di aspirapolvere Page 2 of 27

3 2 TEST LIST ELENCO DELLE PROVE Test Description Reference document Standardized Differencies 2.1 Measurement of conducted emissions Misura dei disturbi condotti EN : A1: A2:2011 Yes none 2.2 Measurement of disturbance power EN : Misura della potenza irradiata A1: A2:2011 Yes none 2.3 Measurement of harmonic currents EN : A1: A2:2009 Yes none Misura delle emissioni di corrente armonica 2.4 Measurement of voltage changes, voltage fluctuations and flicker EN :2013 Yes none Misura delle variazioni di tensioni, fluttuazioni di tensione e del flicker 2.5 Electrostatic discharge immunity test EN : A1: A2:2008 EN :2009 Prove di immunità a scariche di elettricità statica 2.6 Electrical fast transient/burst immunity test Prova di immunità a transitori/treni elettrici veloci EN : A1: A2:2008 EN :2012 Yes Yes none none 2.7 Surge immunity test EN : Prova di immunità ad impulso A1: A2:2008 EN : Immunity to conducted disturbances, EN : induced by radio-frequency fields A1: A2:2008 Immunità ai disturbi condotti, indotti da EN :2009 campi a radiofrequenza 2.9 Voltage dips, short interruptions and voltage variations immunity tests EN : Prove di immunità a buchi di tensione, A1: A2:2008 brevi interruzioni e variazioni di EN :2004 tensione Yes Yes Yes none none none Page 3 of 27

4 3 TEST EQUIPMENT USED APPARECCHIATURE UTILIZZATE Description Manufacturer Model Serial no./id EMI test receiver Rohde & Schwarz ESCI LISN Rohde & Schwarz ESH2-Z EMI test receiver Rohde & Schwarz ESVS / Absorbing clamp Schwarzbeck MDS Used in test n.: Power Source EM TEST NETWAVE P Power Harmonic Analyzer EM TEST DPA503N P Flicker impedance EM TEST AIF503N32.1 P ESD Simulator SHAFFNER NSG Fast transient / Burst simulator EM TEST EFT 500-M V Surge tester HAEFELY PC Coupling Filter HAEFELY FP 20/ Signal generator Amplifier Directional coupler HAEFELY PHV High Voltage Plugin HEWLETT- PACKARD AMPLIFIER RESEARCH AMPLIFIER RESEARCH 8656B 2703U A DC Power Meter Rohde & Schwarz NRVS / Coupling /Decoupling Network Fischer Custom Communication FCC-801-M3-25A Motorized variac EM TEST MV3P4032DS P Power Fail Simulator EM TEST PFS503N32 P Page 4 of 27

5 4 ENVIRONMENTAL CONDITIONS CONDIZIONI AMBIENTALI 4.1 ROOM TEMPERATURE 23 C ± 2.3 C TEMPERATURA AMBIENTE 4.2 RELATIVE HUMIDITY 47 % ± 7 % UMIDITA RELATIVA 4.3 PRESSURE 989 mbar ± 6 mbar PRESSIONE 5 MEASUREMENT UNCERTAINTY INCERTEZZA DI MISURA Measurement uncertainties was estimated as expanded uncertainty obtained multiplying the standard uncertainty by the coverage factor k corresponding to a confidence level of about 95%. Declared uncertainties are obtained with factor k=2 except if otherwise specified. Measurement Expanded uncertainty Found in test n.: Conducted emission Level ± 1.5 db 2.1 Disturbance power Level ± 2.2 db 2.2 Measurement of harmonic currents Level ± 6 % 2.3 Measurement of voltage changes, voltage fluctuations and flicker Electrostatic discharge immunity test Electrical fast transient/burst immunity test Surge immunity test Level ± 6,4 % 2.4 Output open circuit voltage ± 1,48% First peak value ± 1,6% Value 30ns ± 1,61% Value 60ns ± 1,61% Rise time of the first peak value ± 0,3% Open circuit impulse duration ±1,65% Rise time loaded at 50Ω ±3,52% Pulse duration loaded at 50Ω ±4,46% Output voltage ±1,08% Repetition frequency ± 4,56% Duration of burst ± 1,66% Repetition time ±1,97% Voltage value ± 1,08% Measured value of current ± 2,19% Time scale (1,2-50µs) ± 3,11% Immunity test to conducted disturbances, induced by radio-frequency fields Voltage value ± 6,2% Voltage dips Value of voltage fluctuations ± 10% 2.9 Page 5 of 27

6 6 SAMPLING PLAN PIANO DI CAMPIONAMENTO Sample selected by the customer. 7 TEST AND/OR MEASUREMENT RESULTS RISULTATI DELLE PROVE E/O MISURE 7.1 Measurement of conducted emissions Misura dei disturbi condotti Test Interface Specification Limit Diagrams Test result (pages) Conducted emission 150 khz-30 MHz mains EN EN :2006 Clause 4.1 table 1 7 Passed Page 6 of 27

7 Discontinuous interference conducted emissions (EN ) Click rate N < 5; according to paragraph : test passed PK AV Page 7 of 27

8 7.2 Measurement of disturbance power Misura della potenza irradiata Test Interface Specification Limit Diagrams (pages) Disturbance power 30 MHz-300 MHz Mains EN EN /A1:2009 Clause 4.1 table 2a Test result 9 PASSED Page 8 of 27

9 freq [MHz] V-QP [dbpw] freq [MHz] V-QP [dbpw] , , , , , Page 9 of 27

10 7.3 Measurement of harmonic currents Misura delle emissioni di corrente armonica Average harmonic current results Hn Ieff [A] % of Limit Limit [A] Result E E-3 PASS PASS E E-3 PASS E PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E-3 PASS E E-3 PASS E-3 PASS Harmonic currents less than 0.6% of the input current measured under the test conditions, or less than 5 ma, whichever is greater, are disregarded. Page 10 of 27

11 Page 11 of 27

12 Page 12 of 27

13 7.4 Measurement of voltage changes, voltage fluctuations and flicker Misura delle variazioni di tensioni, fluttuazioni di tensione e del flicker EUT values Limit Result Pst PASS Plt PASS dc [%] PASS dmax [%] PASS dt [s] PASS Reference clause 5 Limits Legend Pst - The Highest Short Term Flicker Value Plt - The Highest Long Term Flicker Value dc [%] - The Highest Relative Steady State Voltage Change (1s) dmax [%] - The Highest Maximum Relative Voltage Change dt [s] -The Highest Instantaneous Voltage Change (10ms) Page 13 of 27

14 7.5 Electrostatic discharge immunity test Prove di immunità a scariche di elettricità statica Immunity level required : +4kV contact discharge, +8kV air discharge with B Criterion Discharges Procedures Test level Test result Contact discharge Direct+Indirect ± 4 kv No degradation during and after the test ( Test passed ) Air discharge Direct ± 8 kv No degradation during and after the test ( Test passed ) 7.6 Electrical fast transient/burst immunity test Prova di immunità a transitori/treni elettrici veloci Immunity level required : + 1 kv with B Criterion AC input power line Test level Test result L,N,PE GND ± 1kV No degradation during and after the test Test passed Page 14 of 27

15 7.7 Surge immunity test Prova di immunità ad impulso Immunity level required : + 1 kv Differential mode + 2 kv Common mode with performance criterion B AC input power line Test level Test result L - N + 1 kv No degradation during and after the test ( Test passed ) L - PE + 2 kv No degradation during and after the test ( Test passed ) N - PE + 2 kv No degradation during and after the test ( Test passed ) 7.8 Immunity to conducted disturbances, induced by radio-frequency fields Immunità ai disturbi condotti, indotti da campi a radiofrequenza Immunity level required : 3 V ( rms,unmodulated ) with performance criterion A (Range frequency 150 KHz 230 MHz) AC input power line Used C.D.N. Test level Test result L,N,PE GND FCC 801-M V No degradation during and after the test Test passed Page 15 of 27

16 7.9 Voltage dips, short interruptions and voltage variations immunity tests Prove di immunità a buchi di tensione, brevi interruzioni e variazioni di tensione PHENOMENA Voltage Dip in % Vac Duration ( periods ) Performance Criteria Test result Interruption 100 % 0.5 C Voltage dips 60 % 10 C Voltage dips 30 % 25 C No degradation during and after the test Test passed See Remark. Test passed See Remark. Test passed Remark: During the test the machine turn off, after the test is need turn on machine by on/off key for restart. The test passed on reference of criterion C required. Page 16 of 27

17 8 REMARKS NOTE The configuration has been supplied by the customer. The customer is responsible for this data and for the configuration of tested EUT.(Reference paragraph 1.1 to 1.4) Sample under test has been returned to customer. Page 17 of 27

18 9 APPENDIX APPENDICE 9.1 PHOTO DOCUMENTATION DOCUMENTAZIONE FOTOGRAFICA Measurement of conducted emissions Page 18 of 27

19 Measurement of disturbance power Page 19 of 27

20 Measurement of the harmonic components, of induced fluctuation on the AC line (Flicker) and voltage dips, short interruptions and voltage variations immunity tests Page 20 of 27

21 Electrostatic discharges immunity test Page 21 of 27

22 Electrostatic discharges immunity test Page 22 of 27

23 Surge immunity test Page 23 of 27

24 Immunity to conducted disturbances induced by radiofrequency fields Page 24 of 27

25 Electrical fast transient/burst immunity test Page 25 of 27

26 9.2 ATTACHMENTS ALLEGATI None 10 SUMMARY SOMMARIO 1 TEST SETUP SAMPLE IDENTIFICATION AUXILIARY DEVICES TEST CONFIGURATION DIAGNOSTIC SYSTEM 2 2 TEST LIST MEASUREMENT OF CONDUCTED EMISSIONS MEASUREMENT OF DISTURBANCE POWER MEASUREMENT OF HARMONIC CURRENTS MEASUREMENT OF VOLTAGE CHANGES, VOLTAGE FLUCTUATIONS AND FLICKER ELECTROSTATIC DISCHARGE IMMUNITY TEST ELECTRICAL FAST TRANSIENT/BURST IMMUNITY TEST SURGE IMMUNITY TEST IMMUNITY TO CONDUCTED DISTURBANCES, INDUCED BY RADIO-FREQUENCY FIELDS VOLTAGE DIPS, SHORT INTERRUPTIONS AND VOLTAGE VARIATIONS IMMUNITY TESTS 3 3 TEST EQUIPMENT USED 4 4 ENVIRONMENTAL CONDITIONS ROOM TEMPERATURE RELATIVE HUMIDITY PRESSURE 5 5 MEASUREMENT UNCERTAINTY 5 6 SAMPLING PLAN 6 7 TEST AND/OR MEASUREMENT RESULTS MEASUREMENT OF CONDUCTED EMISSIONS MEASUREMENT OF DISTURBANCE POWER MEASUREMENT OF HARMONIC CURRENTS MEASUREMENT OF VOLTAGE CHANGES, VOLTAGE FLUCTUATIONS AND FLICKER ELECTROSTATIC DISCHARGE IMMUNITY TEST 14 Page 26 of 27

27 7.6 ELECTRICAL FAST TRANSIENT/BURST IMMUNITY TEST SURGE IMMUNITY TEST IMMUNITY TO CONDUCTED DISTURBANCES, INDUCED BY RADIO-FREQUENCY FIELDS VOLTAGE DIPS, SHORT INTERRUPTIONS AND VOLTAGE VARIATIONS IMMUNITY TESTS 16 8 REMARKS 17 9 APPENDIX PHOTO DOCUMENTATION ATTACHMENTS SUMMARY 26 Page 27 of 27