Quick Start The StarLeaf Touch

Transcription

1 Quick Start The StarLeaf Touch

2 Installing the Touch Before installing the Touch, refer to the safety information at: Step 1: Connect the base to the Touch Connect the base to the body of the Touch. 2

3 Personal Telepresence Step 2: Connect to the network 1. Connect one end of the supplied Ethernet cable to the network port on the rear of the Touch. The network port is marked with this symbol: 2. Connect the other end of the cable: For Personal Telepresence: Connect the other end of the cable to an Ethernet port in your network For Group Telepresence: Connect the other end of the cable to the StarLeaf Phone connector on the Group Telepresence system Network port 3

4 Personal Telepresence Step 3: Connect to the power Note: If you have connected the Touch to a Group Telepresence or to a PoE network port, you do not need to connect the power adaptor. Use the AC/DC adaptor to provide power to the Touch. Connect the adaptor to the DC +48V port and then connect the adaptor to the mains power supply using the power cable supplied with the adaptor. DC +48V port 4

5 Personal Telepresence Step 4: Connect to StarLeaf telepresence You will use the StarLeaf Touch to control one of: StarLeaf Group Telepresence StarLeaf Personal Telepresence Refer to the documentation accompanying that system to complete the installation. Tip: Use the cable guides Use the cable guides to channel your cables through the base of the Touch. This will allow it to sit firmly. 5

6 StarLeaf Quick Connect When you power the Touch for the first time, if it displays the StarLeaf quick-connect screen (shown below), enter your quick-connect code. If you do not have one, contact your reseller or StarLeaf technical support. When you have entered the quick-connect code, the Touch will check if there is an upgrade available. If there is, it will upgrade itself and restart. The Touch will now display the Home screen (refer to page 7). 6

7 Features of the Touch The diagram below shows the physical features of the Touch. Message waiting indicator Audio volume down Audio volume up Headset USB port for supported devices Speaker Keypad Home button Audio mute Video mute Microphone location 7

8 The Home screen Press the buttons on the touch screen to control the Touch. Press the Home button at any time to see the Home screen. The picture below shows you what you might see on your Home screen. Connected devices indicators Your name and dialing details Favorites video: Call acceptance slider New message indicator Messages Invite Contacts Recent calls indicator Recent calls 8

9 Where to find more information or get help For more information about using the StarLeaf Touch, refer to You or your reseller can get help from our support team by raising a case at Make sure you have the following information ready: The serial number of the Touch (double-press the Home button to find this) Your contact address or telephone number Details of the problem 9

10 Legal information Third party software acknowledgements Acknowledgements of third-party software are available at: Disclaimers and notices Copyright StarLeaf All rights reserved. This guide may not be copied, photocopied, translated, reproduced, or converted into any electronic or machine-readable form in whole or in part without prior written approval of StarLeaf Limited. StarLeaf Limited reserves the right to revise this documentation and to make changes in content from time to time without obligation on the part of StarLeaf Limited to provide notification of such revision or change. StarLeaf Limited provides this documentation without warranty, term, or condition of any kind, either implied or expressed, including, but not limited to, the implied warranties, terms or conditions of merchantability, satisfactory quality, and fitness for a particular purpose. StarLeaf Limited may make improvements or changes to the product(s) and/or the program(s) described in this documentation at any time. All other product and company names herein may be trademarks of their respective owners. 6 January