1.0 Scope: 2.0 Site Status and Site Visit:

Transcription

1 1.0 Scope: Vendor is required to supply install and commission Telepresence grade Video Conference (VC) Equipment complying with "Minimum Technical Specifications" given in this document along with software with licenses, accessories including cabling and necessary hard-copy documentation and manuals at Nuclear Fuel Complex. Vendor is also required to provide training to the staff for operation and preliminary diagnostic/maintenance of equipment and also provide on-site warranty for equipment for three years and additional 3 years comprehensive AMC. The VC Equipment are to be installed at two Sites with-in NFC, Hyderabad.. The vendor has to ensure all accessories including signal/network cabling required for commissioning are quoted and supplied at each site. 2.0 Site Status and Site Visit: Out of two locations, one location already has VC Equipment which needs to be replaced. At both the locations vendor has to integrate VC Equipment in existing meeting rooms. Vendor shall survey the sites before submitting quote to estimate cable lengths, position of Visual Display Unit (VDU) / Camera etc. and must provide site survey report indicating scope of NFC. They may contact Shri G N Ramesh through / phone (ramesh@nfc.gov.in / ) or Shri Manish Mangal manish@nfc.gov.in/ ) for site visit. Communication through is preferable. Request for site visit shall be made at least five working days before tender opening date. Site visit before tender opening is mandatory. 3.0 Eligibility Criterion: Vendor shall be authorized by OEM for supply and providing Warranty / AMC Service Support. Vendor shall have Authorized Service Support Center at Hyderabad capable to provide all support required to maintain the equipment during warranty and post warranty. The vendor shall have supplied, installed & commissioned one or more setups at a single site of same make & model (at least same family model) equipment being offered within last three years to Central or State Government Unit, Public Sector Undertaking or Nationalized Banks. Following Document shall be submitted along with their offer else vendor will be considered ineligible and their offer will be ignored. OEM authorization indicating that they are authorized to supply and authorized for providing AMC / Warranty Service Support. The authorization shall be valid as on date of tender opening. Address of Vendor site located within Hyderabad for warranty / AMC service support for Video Conferencing Equipment and willingness of Vendor to allow it to be inspected by NFC staff. Copy of previous order placed on vendor for supply, installation and commissioning (in a single order) of Video Conferencing Equipment of same family / model, dated with-in three years of tender opening date, placed by any

2 4.0 Training: Central or State Government Unit, Public Sector Undertaking or Nationalized Banks. Satisfactory certificate from same customer also shall be enclosed with current contact person details (Name, Designation and , phone number etc.) at customer site. Vendor shall provide 3 days training at site for operation of equipment and also preliminary diagnostic / maintenance to staff of NFC already involved in operation and maintenance of Existing VC Equipment. The number of such staff to be trained is eight persons. 5.0 Annual Maintenance Contract (AMC): a) Comprehensive Annual Maintenance Contract will start after completion of three years OEM Warranty. b) Vendor has to quote AMC Charges for three years. c) Payment ( one third of the quoted value)will be made annually after successful completion of that year. 6.0 Other Terms and Condition: The equipment shall not be declared "END OF SALE" by OEM and shall be supported for at least six year from date of commissioning. All equipment shall be IPv6 Ready. Mixing of Equipment from different OEM is not acceptable except for PC, UPS, VDU and Equipment Rack. Vendor shall deploy certified engineer, by OEM at site for installation activity once order is placed. Vendor shall quote for all items and quantity indicated. Order will be placed on lowest aggregate offer meeting eligibility criterion and minimum technical specification. Vendor has to provide compliance statement with respect to minimum technical specification and their offer. Vendor shall be willing to supply, install and commission all systems with in 90 days from date of PO placement.

3 7.0 Minimum Technical Specifications: Tele-presence grade Video Conference Equipment for Site 1:. S.N. Specification Minimum Requirement Vendors Compliance 1 Unit Components The unit offered must be complete with Full High Definition Videoconferencing Codec, High Definition Camera, Visual Display Units, Microphone, Remote Control, Equipment RACK, PC Systems for presentation and required cables. 2 Bandwidth The unit offered must support: 128 kbps - 4 Mbps over IP (H.323) in a point to point call and SIP Up to 4 Mbps in multisite 3 Video Standards The unit should support the following ITU Standards: H.261, H.263, H Video Features The unit must support: minimum16:9 Wide screens. Both Picture in Picture (PIP) and side by side layouts on single screen. 5 Video Inputs The unit should have minimum three (3) video inputs as follows: 1 video Input for main HD camera 1 video input for PC / Laptop 1 aux video input to connect document camera Deviations, if any 6 Video Outputs The unit should have minimum three (3) video outputs as follows: 1 video output for main monitor HD 1 video output for second monitor HD 1 aux video out to connect to DVR / encoder 7 Live Video Resolutions following video resolutions: CIF, 4CIF, SIF, 4SIF, 720p (@30fps 60fps) and 1080p (@30fps) etc.

4 8 Audio Standards The unit should support following ITU standard: G.711, G.722, G.722.1, G.728, MPEG4 AAC-LD or Siren 14 or equivalent / higher standard to be supported. 9 Audio Features The unit should support: Audio Error concealment Should have Automatic gain Control (AGC) feature Must have automatic noise reduction feature and Echo canceller. Active Lip Synchronization 10 Audio Inputs The unit should have support minimum 2 audio inputs as follows : 1 microphones 1x SPDIF/ RCA 11 Microphone The unit should support: 1 number of Omni directional microphone with 360 degree pick up. Initial requirement is one microphone but system should have capability to connect minimum two (2) microphones 12 Audio Outputs The unit should have minimum audio outputs as follows 1 x HDMI / RCA for main audio 1 x SPDIF / RCA for any other auxiliary purpose 13 Video Frame Rates The system must support the following frame rates: and 60fps 14 Dual Stream The system must support: Dual Stream i.e. must be capable of carrying video and presentations simultaneously. The Dual Stream must be available for both H.320 and H.323 (ISDN & IP). The system should support the ITU protocol H.239 (Presentation). 15 Network Features The system should: be capable of dialing for both H.323 & SIP have Down speeding on IP

5 16 H.323 / IP Features 17 Multisite Features (Future Software Upgrade ) 18 Embedded Encryption 19 Security Features 20 Network Interfaces The unit should support: IP Precedence (QoS), DiffServe. IP Type of Service- TOS, Auto Gatekeeper Discovery Auto Network Address translation (NAT) support Packet Loss Recovery feature on H.323 call URL Dialing Should support Secure Firewall protocols - H and H The unit must have multipoint capability of (1+3) sites It should be possible to have conference layout in Continuous Presence (CP4) and voice switched mode. It should support H.264, encryption when in multiparty conference Must support Dual Stream from any site. Dial In and Dial out Mode in IP should be supported. Capability to mix IP and SIP and Dial In and Dial out participants in the same call It must support at least AES encryption standards The unit should have following security features: Management via HTTPS and Telnet IP Administration Password SNMP Security alerts Possibility of Disabling IP Services The unit should provide the following network interfaces: 2 x LAN / Ethernet (RJ-45) 10/100 Mbps full / half duplex 1 x management console 1 x USB 1 x ISDN PRI Should support following network connectivity's TCP / IP, DHCP, FTP, Telnet, HTTP and HTTPS.

6 21 Protocols supported The system should support the following standards: H.239, H.241, H.243, H.221, H.264, H.281, SIP and H Camera The camera must be of Full High Definition type with the following minimum features: Min 12x zoom, Min 60 degrees total field of view Full HD1080P pixels Min 30fps Auto and manual focus / brightness / white balance Far-end camera control 12 near and far-end camera presets. 23 System Management 24 Directory Services System should support total management via embedded web server, SNMP, Telnet, Remote Software Upload over LAN. The system should provide console port (RS-232) for management Support for Local, Global server Directories. Unlimited entries using Server directory supporting LDAP and H.350 Last number called 25 Remote The unit should come with easy to use infra-red hand held remote control with operating distance of at least 10m. 26 PC System Rack Mount PC System with Operating Systems as Windows 8 Pro and 4 GB RAM, one HDMI Port, two USB 2.0 and one RJ45 Ethernet port. The PC will be used for making presentation to remote end. Keyboard and Mouse of PC shall be wireless type and one USB input of PC shall be wired inside meeting room for connecting pen drives to PC. 27 UPS Rack Mount UPS of 5 KVA, 15 Min rating of reputed make with SNMP interface to manage it.

7 28 Visual Display Unit Commercial Grade Plasma Display(2Nos per VC Equipment).Screen Size (diagonal): 60, Aspect Ratio : 16:9, Resolutions : 1920 x 1080 pixels (RGB), Pixel Pitch : X mm, Contrast Ratio: 5,000,000: 1, Panel Life: about 100,000 hours, Full HD with 3 D support, Interface: S-Video (Y), Audio (W/R), Component/RGB-IN, HDMI, DVI-D, PC-IN. Control Terminal: LAN, RS232, Audio Out: 10 Watt, Power Consumption: 510 watt. Weight (Max) : 50 Kgs. The panel shall support Video Wall feature. 28 Equipment RACK 42 U Network RACK to house all equipment except VDU & Microphones. 29 Power 230VAC, +/- 10%, 50Hz single phase 30 Temperature Operating Temperature:10 to 40 Centigrade 31 Warranty and AMC. Warranty Comprehensive onsite Warranty & support for three Years. Warranty should be back to back from OEM. Advance Replacement of Hardware Software updates and upgrades free of cost during Warranty period. L2 support from OEM. Comprehensive on-site support from vendor AMC Comprehensive onsite AMC & support for 3 years after expiry of Warranty. The scope of AMC would be same as warranty and should include: Back-to-back support from the OEM.

8 Advanced replacement of hardware Software updates and upgrades free of cost during AMC period. Comprehensive on-site support from vendor All patches, upgrades and updates of software/firmware should available during warranty and AMC at no extra cost. Tele-presence grade Video Conference Equipment for Site 2: Specifications are same for both Sites but Site 2 shall be supplied with dual camera (instead of one) and two microphones (instead of one) and without any VDU. Also it shall be integrated with existing audio system and existing VDUs of the meeting room. Vendor may supply quality grade HDMI signal splitter for connecting VDUs to codec. Two VDUs shall be configured to display remote end and two will be for local site.