Airfield Signs Product Description SafeLED Signs. Airfield Guidance Sign Gate Sign (ASIS)

Transcription

1 Product Description SafeLED Signs Airfield Guidance Sign Gate Sign (ASIS)

2 Note: This page is blank for convenient double-sided printing.

3 Safegate Group 1. INTRODUCTION SafeLED illuminated airfield guidance signs are used as information, position and direction indicators in accordance with ICAO Annex 14, Section 5.4 Signs. SafeLED illuminated ASIS is used as aircraft stand identification sign in accordance with ICAO Annex 14, Section 5.4 Signs. SafeLED signs are available in two versions according to power requirements: Power 1. Constant Current Regulator (Series Fed) 2. Mains Power System (Parallel system) Light Current range A 14-45W LED modules Voltage range VAC, 50/60Hz 14-45W LED modules Dimensions SafeLED signs are designed with the following standard dimensions (outer dimensions): Dimension Guidance signs Height 700, 900 Measurement (mm) Width 1150, 1300, 1600, 1800, 2100, 2500, 2650 and Dimension Gate signs (ASIS) Height x width Measurement (mm) 900x900 and 1200x1200 Note: 900x900 mm sign fits stand number. 1200x1200 fits stand number and coordinates. Compliance The signs meet requirements and are in compliance with the following standards: ICAO: Annex 14 Volume I, July ICAO: Aerodrome design manual part 4 and 6. IEC STAC. Utilisation Airfield Guidance sign (AGS) Aircraft Stand Information Sign (ASIS) Page 1 of 6

4 Safegate Group 2. MAIN ADVANTAGES LED-based light source The LED technology offers a long lasting light source, low power consumption, a technology which is environmentally friendly and robust to vibration. By using SafeLED signs, the maintenance cost of signs and airport operation interruptions, is dramatically reduced. LED technology secures a future proof Airfield sign investment and removes the uncertainty of the proposed international phase out regulations for the traditional incandescent lamps. CCR friendly The SafeLED sign reacts as a halogen lamp with a resistive load profile. When turning on a Constant Current Regulator (CCR), the CCR does not trip as the current does not fluctuate with SafeLED technology. Designed for harsh environments SafeLED is designed for use in harsh environments. The electronic components are encapsulated in waterproof polyurethane and are well protected from wear and tear. Housings are anodised aluminium and fixings are stainless steel. Component life cycle is dramatically extended and operational lifespan is greatly increased. There is also built-in surge and lightning protection. The front plate is made of UV-resistant poly carbonate to withstand jet blasts and other external forces. To ensure a long life for the sign, the sign is tested and certified for IP67 protection. Page 2 of 6

5 Safegate Group 3. TECHNICAL CHARACTERISTICS 3.1 CHARACTERISTIC Symbol Min Max Unit Series Circuit Supply current from series circuit (50 or 60Hz) with 3-7 intensity levels CCR Power consumption ISUPPLY ARMS Total power consumption 6.6 ARMS Ptot - 19 W Total power consumption 6.6 ARMS Ptot - 21 W Total power consumption 6.6 ARMS Ptot - 26 W Total power consumption 6.6 ARMS Ptot - 29 W Total power consumption 6.6 ARMS Ptot - 34 W Total power consumption 6.6 ARMS Ptot - 39 W Total power consumption 6.6 ARMS Ptot - 41 W Total power consumption 6.6 ARMS Ptot - 43 W Total power consumption 6.6 ARMS Ptot - 25 W Total power consumption 6.6 ARMS Ptot - 28 W Total power consumption 6.6 ARMS Ptot - 34 W Total power consumption 6.6 ARMS Ptot - 37 W Total power consumption 6.6 ARMS Ptot - 42 W Total power consumption 6.6 ARMS Ptot - 49 W Total power consumption 6.6 ARMS Ptot - 53 W Total power consumption 6.6 ARMS Ptot - 57 W Total power consumption 900x900mm Gate 230VAC Ptot - 25 W Total power consumption 1200x1200 mm Gate 230VAC Ptot - 35 W Note: Power Factor (PF) typically >0.99. Environment Operating humidity range RH % Operating temperature range TA C Storage temperature range TSTG C Power Supply An integrated, encapsulated electronic converter for series circuits ( A) or mains power (120/230Vac). Power Factor (PF) typically >0.99. Optics Transilluminating LEDs, no reflectors are used. UV-resistant poly carbonate front panel is printed on the back side with UV-resistant color. Note: Lifetime of LEDs depends on operation. Photometry Distribution and homogenity comply with ICAO Annex 14. Colour Complying with ICAO Annex 14. Finish Protection External parts are made of aluminium alloy and poly carbonate. All fixings and fastening are stainless steel. IP67 Note: For more information, contact Safegate Group or see Page 3 of 6

6 Safegate Group 3.2 PHOTOMETRICS This section includes photometric examples of different configurations according to standard (ICAO). Photometric examples Average luminance yellow Average luminance red Average luminance white Maximum ratio between two adjacent points Maximum ratio across sign Note: cd/m 2 candela per square meter. Requirement ICAO > 150 cd/m 2 > 30 cd/m 2 > 300 cd/m 2 < 1.5 < 5.0 Typical value 205 cd 57 cd 375 cd Chromatic examples Chromatic coordinates yellow Chromatic coordinates red Chromatic coordinates white CIE Chromaticity diagram Requirement ICAO See diagram See diagram See diagram Typical value x:0.4822, y: x:0.6651, y: x:0.3174, y: Page 4 of 6

7 Safegate Group 4. DESIGN Design Image example 1. Frame profile 2. Front panel 3. Light module 4. Back plate 5. Converter box 6. Power switch 7. Pole 8. Bracket 9. Frangible pole 10. Foot 11. Chain For more information, contact Safegate Group or see Page 5 of 6

8 Safegate Group 5. SPECIFICATION The SafeLED sign family includes numerous technical benefits: The maximum total power consumption is 57 W for a 900x3000 mm sign External power switch. Control and Monitoring capabilities with built-in IQ-functionality and the ASP system. The electronic components are encapsulated in waterproof polyurethane. Over voltage surge and lightning protection. Front plate made out of UV-treated poly carbonate. Long life time of LEDs. All external parts are made of aluminium alloys. All fixings and fastenings are stainless steel. Compatible with the 2A system*. Possibility to be powered by an isolating transformer on a standard AGL primary loop*. The sign meets the requirements and is in compliance with the standards: ICAO: Annex 14 Volume I. ICAO: Aerodrome design manual part 4 and 6. IEC STAC. *For more information, contact Safegate Group regarding compliance with other standards. All descriptions and photometric characteristics in this publication present only general particulars and shall not form part of any contract. The right is reserved to change them without prior notification. Page 6 of 6

9 Note: This page is blank for convenient double-sided printing.

10 Check in to the future How many aircraft can your airport handle today? Can this number be increased without adverse effects on the airport s safety level? It is a known fact that traffic volume will rise in the foreseeable future. More movements will demand monitoring of the entire airport. Requirements will be sharpened and the development of an integrated system controlling not only ground movements but also air traffic close to the airport is of the highest interest. The International Civil Aviation Organization (ICAO) already describes A-SMGCS, Advanced Surface Movement Guidance and Control System, as the answer to the future modern airport need to control the entire airport space in one superior system. To a larger extent than today s systems, A-SMGCS will rely on automated processes to give both pilots and traffic controllers exact information about positions and directions. Safegate Group delivers complete A-SMGCS solutions already, as well as all vital parts relating to it. Safegate Group can check your airport into the future today! Safegate Group HQ Djurhagegatan 19 SE Malmö, Sweden Phone: +46 (0) Fax: +46 (0) market@safegate.com Australia australia@safegate.com +61 (0) China china@safegate.com Dubai dubai@safegate.com Finland finland@safegate.com +358 (0) France france@safegate.com +33 (0) Germany germany@safegate.co m +49 (0) India india@safegate.com Malaysia malaysia@safegate.co m Qatar qatar@safegate.com Russia russia@safegate.com Singapore singapore@safegate.co m Spain spain@safegate.com UK uk@safegate.com +44 (0) USA usa@safegate.com Safegate Group offers solutions for increased safety, efficiency and environmental benefits to airports around the world. The company was founded in 1973 and has its headquarters in Malmö, Sweden. Safegate Group has over 70 partners around the globe in order to be close to its customers. The latest members of Safegate Group, Thorn AFL and Idman, have both over 40 years of experience in airfield lighting solutions for airports and heliports worldwide. Safegate Group s complete range of products and services, a one-stop shop, provides solutions to customers and airborne travellers around the globe. For more contact information and details: