N type Coaxial Connectors

Transcription

1 N type Coaxial Connectors N Series Features. 50 ohms wide varieties standard connectors 2. Screw on locking 3. Applicable cable : RG cable, JIS cable 4. Applicable standard : MI-C-3902/MI STD Functional diagram s Straight plug for flexible cable UG-2D/U(40) In-line adapters Right angled jack-plug type UG-27C/U(40) s Straight jack for flexible cable UG-23D/U(40) Straight plug for semi-rigid cable N-P-4(40) T-type adapter -plug-jack type UG-07B/U(40) Panel mount jack for flexible cable N-PJ-58/U(40) Right angled plug for flexible cable N-P-5DW(40),N-P-58U(40) Fixed attenuator -jack type AT-4** Panel mount straight receptacle UG-58A/U(40) Conversion adapters BNC series conversion type M series conversion type S series conversion type SMA(HRM series) conversion type In-line adapters Straight plug-plug type UG-57B/U(40) Conversion adapters BNC series conversion type M series conversion type TNC series conversion type SMA(HRM series) conversion type Cap with a chain MX-93/U(40) Non-reflective Terminators N-TMP-* In-line adapters Straight jack-jack type UG-29B/U(40) Panel mount adapter -jack type N-PA(40) T-type adapter -jack type UG-28A/U(40) 204.w

2 Product Specifications Ratings Nominal characteristic impedance Frequency range 50 ohms DC to 2 GHz Operating temperature range Operating humidity -30 C to +0 C 95%RH max. Item. Contact resistance 2. Insulation resistance 3. Withstanding voltage 4. V.S.W.R.* 5. Durability (mating / un-mating, with corresponding plug). Vibration 7. Shock Specification 3 m ø max. 000 M ø min. No flashover or insulation breakdown..2 max. 0 m ø max. No electrical discontinuity of µs min. No damage, cracks or parts dislocation. 00 ma max. 500 V DC 500 V AC / minute Up to 2GHz 500 cycles Conditions Frequency: 0 to 500 Hz, single amplitude of 0.75mm, acceleration of 98m/s 2, for 0 cycles in the direction of each of the 3 axis. Acceleration of 490 m/s 2, ms duration, sine half-wave waveform, 3 cycles in each of 3 axes. 8. Humidity (Steady state) Temperature: -55 C/+25 to +5 C/+85 C/+5 to +35 C 9. Temperature cycle No damage, cracks or parts dislocation. Time: 30min./ 5min. /30min./ 5min. 5 cycles 0. Salt spray No excessive corrosion 5% salt water solution, 48 hours *V.S.W.R. Measurement System The above V.S.W.R. standard values were measured using the measurement connection as shown below. Network Analyzer Test Set Test Port Test Port Cable Material No damage, cracks or parts dislocation. D.U.T Termination Note : Connectors with cable are measured with 0 cm of suitable cable attached at both ends. 9 hours at temperature of 40ç and humidity of 80% to 9%. Part Material Finish Remark Shell Brass Silver plated/nickel plated Male contact Brass Silver plated/gold plated Female contact Beryllium copper Silver plated/gold plated Insulator Tetrafluoride resin Flame retardant Packing Silicone rubber Flame retardant Ordering information Standard N - P - 5DW Series name : N Connector style Blank : Straight type 3 : angle type T : T angle type 4 Connector type P : J : PJ : Panel jack R : Receptacle A : Adapter PA : Panel adapter Applicable cable Product with MI standard UG- 2 D /U High freguency coaxial connectors Product identification number Improved sign 2

3 Straight Flexible cable type Applicable cable UG-2D/U(40) RG-8/U,RG-9/U JUG-53/U(40) RG-58/U N-P-3DV(40) D-2V N-P-5DV(40) D-2V N-P-5DW(40) D-2W N-P-5DFB(40) D-FB N-P-0DFB(40) D-FB Semi rigid cable type Right angle plug Flexible cable type 34 Applicable cable N-P-4(40) UT-4A N-P-4-2(A)(40) UT-4A N-P-250(A)(4) UT Applicable cable Remarks N-P-5DW(40) N-P-58U(40) D-2W RG-58/U Nickel-plated ecxept for center conductor

4 Straight jack Flexible cable type Ø. Ø Panel mount jack Fexible cable type Receptacle Ø S Ø3.2 Ø5.8 Ø5.8 Applicable cable N-J-3DV(40) D-2V 5. UG-23D/U(40) Applicable cable RG-8/U,RG-9/U 4 Ø3.2.7 Applicable cable S UG-22D/U(40) N-PJ-58/U(40) RG-8/U,RG-9/U RG-58/U Ø UG-58A/U(40)

5 Straight plug(waterproof type) Ø23.3 2HEX Spanner width Applicable cable N-P-5DFX(4) N-P-8DGXC(40) * IP7 compliant D-FX 8D-GXC Straight jack(waterproof type) Applicable cable N-J-5DFX(40) N-J-8DGXC(40) * IP7 compliant D-FX 8D-GXC

6 Adapter Straight adapter (jack-jack type) Ø UG-29B/U(40) (-plug type) 40. UG-57B/U(40) Panel mount adaper (jack-jack type) Ø Ø3.2 N-PA(40) Right angle adapter (-jack type) UG-27C/U(40)

7 T-shaped adapter (-jack-jack type) UG-28A/U(40) (-plug-jack) Conversion adapters Mating portion Mating portion 2 Series name Mating portion Series name Mating portion BNC M S SMA (HRM) N BNC Cap With a chain M TNC SMA (HRM) NP-BNCP(40) JUG-20A/U(40) NP-MJ(40) N.P-S.J(40) HRM-555S(40) HRM-554S(40) UG-349/U(40) NJ-BNCJ(40) NJ-BNCJ-PA(40) NJ-MP(40) NJ-MJ(40) N.J-TNC.P(40) HRM-553S HRM-557SV HRM-552S HRM-55SV UG-07B/U(40) Ø3. Ø3.2 4 MX-93/U(40) Ø9. 7

8 BCable assembly procedure Insulater The cable ends are processed as shown in the drawing. For the dimensions, refer to Table, which shows dimansions arranged by part number. Tightener Gasket et Outer conductor Center conductor Gasket (3) 2±0. Surface A Clamp Soldered Male or female contact () Insert clamp from tip of cable and fold outer conductor of cable back onto clamp. Using a knife, cut off excess outar conductor left at this time. (2) Cut off center conductor of cable at 2, from surface A of cable insulation. For dimensions of 2 and 3, refer to Table. 3 is a reference dimension. (3) Solder cable center conductor and male contact (or female contact). It is a good idea st this time to solder the contact preliminarily in advance. ( Note: There must be no gap between the contact and the cable insulation.) Insert cable and parts into shell and fit sharp end of clamp completely into V-shaped surface of gasket. Tighten tightening nut sufficiently. Nut Gasket Clamp Remarks. The cable dimensions are based on the MI and DSP standards. They may differ somewhat depending on the type of cable. In such cases, match the dimensions with the connectors. 2. Some clamps and gaskets does not have not V-shaped, but the assembling procedures are the same. Table Dimensions arranged by part number 0 2±0. 3 JUG-53/U(40) UG-2D/U(40) N-P-5DW(40) UG-23D/U(40) UG-22D/U(40) N-PJ-58/U(40) N-P-58U(40) N-P-3DV(40) N-P-5DV(40) N-P-5DW(40) N-P-5DFB(40) N-P-0DFB(40)

9 Non-reflective Terminators(Coupling portion plug) 34 Ø 5/8-24NEF-2B Frequency range V.S.W.R.(Max) Power Weight (GHz) DC~4GHz 4~GHz ~8GHz (W) (g) N-TMP--(50) DC~ Ø M /8-24NEF-2B Frequency range V.S.W.R.(Max) Power Weight (GHz) DC~2GHz 2~GHz (W) (g) N-TMP-5(40) DC~

10 Fixed Attenuators(plug-jack) 52 5/8-24NEF-2A 5/8-24NEF-2B AT-40(40) AT-402(40) AT-403(40) AT-40(40) AT-40(40) AT-420(40) Frequency range V.S.W.R.(Max) Attenuation(dB) Power Weight (GHz) DC~2GHz 2~4GHz 4~3GHz DC~2GHz 2~4GHz 4~3GHz (W) (g) ± ± DC~ ± ±0.3 0±0.5 20± BTypical data Non-reflective Terminations N-TMP-- (50) Fixed Attenuator V.S.W.R AT-403(40) FREQUENCY[GHz] ATTENUATION(dB) AT-403(40) FREQUENCY[GHz] ATTENUATION(dB) AT-40(40) FREQUENCY[GHz] ATTENUATION(dB) AT-40(40) FREQUENCY[GHz] 0

11 MEMO :

12 USA: HIROSE EECTRIC (U.S.A.), INC. HEADQUARTERS 288 Westhills Court, Simi Valley, CA Phone : Fax : USA: HIROSE EECTRIC (U.S.A.), INC. SAN JOSE OFFICE 3255 Scott Boulevard, Building 7, Suite 0 Santa Clara, CA Phone : Fax : USA: HIROSE EECTRIC (U.S.A.), INC. CHICAGO OFFICE 580 Waters Edge ane, Suite 205 ombard I 048 Phone : Mail : inquiries@hirose.com USA: HIROSE EECTRIC (U.S.A.), INC. DETROIT OFFICE (AUTOMOTIVE) 3777 Professional Center Drive, Suite #00C ivonia, MI 4854 Phone : Fax : GERMANY: HIROSE EECTRIC EUROPE B.V. NUERNBERG OFFICE Muggenhofer Str Nuernberg Phone : Fax : THE NETHERANDS: HIROSE EECTRIC EUROPE B.V. Hogehillweg #8 0 CC Amsterdam Z-O Phone : Fax : UNITED KINGDOM: HIROSE EECTRIC EUROPE BV (UK BRANCH) 4 Newton Court, Kelvin Drive, Knowlhill, Milton Keynes, MK5 8NH Phone : Fax : GERMANY: HIROSE EECTRIC EUROPE B.V. GERMAN BRANCH Herzog-Carl-Strasse 4 D-7370 Ostfildern (Scharnhauser Park) Phone : Fax : CHINA: HIROSE EECTRIC (SHANGHAI) CO., TD. 0, Henderson Metropolitan, NO.300, East Nanjing Road, Huangpu District, Shanghai, China Phone : Fax : CHINA: HIROSE EECTRIC (SHANGHAI) CO.,TD. BEIJING BRANCH A00, Ocean International Center, Building 5# East 4th Ring Middle Road, ChaoYang District, Beijing, Phone : Fax : CHINA: HIROSE EECTRIC TECHNOOGIES (SHENZHEN) CO., TD. Room 09-3, 9/F, Office Tower Shun Hing Square, Di Wang Commercial Centre, 5002 Shen Nan Dong Road, Shenzhen City, Guangdong Province, Phone : Fax : HONG KONG: HIROSE EECTRIC HONGKONG TRADING CO., TD. Room 00, West Wing, Tsim Sha Tsui Centre, Mody Road, Tsim Sha Tsui East, Kowloon, Hong Kong Phone : Fax : TAIWAN: HIROSE EECTRIC TAIWAN CO., TD. 03 8F, No.87, Zhengzhou Rd., Taipei Phone : Fax : KOREA: HIROSE KOREA CO., TD. 2-0, Jeoungwhang-Dong, Shihung-City, Kyunggi-Do Phone : ,724 Fax : SINGAPORE: HIROSE EECTRIC SINGAPORE PTE. TD. 0 Anson Road #2-, International Plaza , Singapore Phone : Fax : INDIA: HIROSE EECTRIC SINGAPORE PTE. TD. DEHI IAISON OFFICE Office NO.59, Regus-Green Boulevard, evel5, Tower C, Sec2, Plot B-9A, Block B, Noida, 2030, Uttar Pradesh, India Phone : Fax : INDIA: HIROSE EECTRIC SINGAPORE PTE. TD. BANGAORE IAISON OFFICE Unit No.03, Ground Floor, Explorer Building International Tech Park Whitefield Road, Bangalore 500 Karnataka, India Phone : Fax : MAAYSIA: HIROSE EECTRIC SINGAPORE PTE. TD. (REPRESENTATIVE OFFICE) -0-07, Penang Cybercity (4),intang Mayang Pasir 3,950, Bayan Baru, Penang, Malaysia. Phone : Fax : ,Nakagawa Chuoh,Tsuzuki-Ku,Yokohama-Shi ,JAPAN TE: Fax: The characteristics and the specifications contained herein are for reference purpose. Please refer to the latest customer drawings prior to use. The contents of this catalog are current as of date of /204. Contents are subject to change without notice for the purpose of improvements.