2 lights module ON / OFF

Transcription

1 2 lights module / OFF Ref: MOD-0415-N The MOD-0415-N is a lighting control module that allows to switch on/off and monitoring of 2 light sources of up to 500W respectively. This lighting circuits can be controlled locally via local push buttons and remotely via the vivimat III home automation system. The lighting circuits can be controlled by the local control buttons, and remotely by the vivimat III home automation systems. Technical characteristics Number of circuits controlled 2 Control types /OFF (switched on/off) Output type per circuit 1 relay contact NO connected to phase (5A/250VAC) Power supply 14VDC (supplied by the vivimat BUS) Consumption <30mA Maximum charge per circuit 500W Incandescent and halogen lamps 220V 500W Fluorescent and inductive load Overcurrent and overvoltage protection Temperature range -10ºC / 40ºC Compatible with vivimat III LED status indication ID configuration in the BUS Via switch Panel installation DIN rail installation Required adaptation kit ADP-0010 (NOT INCLUDED)

2 2 lights module / OFF Dimensions 42 mm 70 mm 70 mm 70 mm 25 mm 25 mm 44 mm 35 mm * MOD-0415-N + adaptation kit for rail installation DIN ADP-0010 (NOT INCLUDED) Connections Switches vivimat BUS GND vivimat BUS data vivimat BUS +V vivimat BUS Push buttons inputs 1 y 2 To controlled circuits 1 y 2 Phase Neuter -Wiring: vivimat Bus wire hose of 4x0,22mm 2. N, L,, : cable of 1,5mm 2

3 2 lights module / OFF Configuration Via the switches the MOD-0415-N can define its module address in the vivimat BUS. vivimat III can have up to 50 light modules (MOD-0400-N + MOD-0415-N). Select the address of each module as indicated in the configuration made with vivimat Project. The addresses of the modules are consecutively assigned by vivimat Project (There must not be 2 modules of the same type with the same address). ADDRESS 1 ADDRESS 2 ADDRESS 3 ADDRESS 4 ADDRESS 5 ADDRESS 6 ADDRESS 7 ADDRESS 8 ADDRESS 9 ADDRESS 10 ADDRESS 11 ADDRESS 12 ADDRESS 13 ADDRESS 14 ADDRESS 15 ADDRESS 16 ADDRESS 17 ADDRESS 18 ADDRESS 19 ADDRESS 20 ADDRESS 21 ADDRESS 22 ADDRESS 23 ADDRESS 24 ADDRESS 25 ADDRESS 26 ADDRESS 27 ADDRESS 28 ADDRESS 29 ADDRESS 30 ADDRESS 31 ADDRESS 32 ADDRESS 33 ADDRESS 34 ADDRESS 35 ADDRESS 36 ADDRESS 37 ADDRESS 38 ADDRESS 39 ADDRESS 40 ADDRESS 41 ADDRESS 42 ADDRESS 43 ADDRESS 44 ADDRESS 45 ADDRESS 46 ADDRESS 47 ADDRESS 48 ADDRESS 49 ADDRESS 50 The modules MOD-0415-N belonging to a vivimat III system must be registered in the configuration of the installation which is implemented by vivimat Project, asingning an ID number to the module and specifying which light source/s, the module is going to control.

4 2 lights module / OFF Functioning LOCAL CTROL : Local control is carried out by on or more buttons connected in parallel (see connections). A short keypress (less than 0,5 sec.) will switch on/off the lights (light circuit). Depending on the status: - If the light is switched on, it will switch off the light - If the light is switched off, it will switch on the light REMOTE CTROL: The control is carried out by the vivimat home automation system BUS. It is possible to activate the following functions remotely: - Switch on the lights. - Switch off the lights. - Know the status of the lights (switched on/off) - Configure the module. The module prioritizes local orders to remote orders. LED STATUS INDICATI: 1- Green blinking: Module operative. 2- Red blinking: Module in comunication. 3- Red or NOT iluminated: Problems with the module.

5 2 lights module / OFF Installation recommendations - Installation corresponding to a > 100 x 100mm box: The 100 x 100mm box is embedded in the wall of the housing. With 2 screws (NOT INCLUDED) we fix the MOD-0415-N to the box (1). 1 - DIN rail installation: For the DIN rail installation, you require the adaptation kit ADP-0010 (NOT INCLUDED), consisting of 2 pieces, which has to be inserted into the rear of the module (1). Once the pieces are inserted, we fit the module into the DIN rail (2). 1 2 Adaptation part x 2 3 FT-MOD-0415-N_11/01/10-ENG Product manufactured by: Dinitel 2000 S.A. - Avda. Otaola Eibar ( Guipúzcoa ) Spain T / F dinitel@dinitel.com