BARIS AVAR. February 2006 July 2006: Visiting Researcher - Adam Mickiewicz University, Faculty of Physics, Poznan, Poland

Transcription

1 BARIS AVAR Bulent Ecevit University, Department of Metallurgical and Materials Engineering, Incivez - Zonguldak/ Turkey Phone: Fax: barisavar@beun.edu.tr EDUCATION Ph.D. September 2007 August 2012 : Kahramanmaras Sutcu Imam University, Institute for Graduate Studies in Science and Technology, Department of Physics Thesis: Nanostructured Metallic Alloys. M.Sc. October August 2007 : Kahramanmaras Sutcu Imam University, Institute of Natural and Applied Sciences, Department of Physics Thesis: Production of Al-Cu-Fe Quasicrystalline Alloys by Mechanical Alloying, Conventional Solidification and Rapid Solidification, and Investigation of Their Properties. B.Sc. October June 2004 : Kahramanmaras Sutcu Imam University, Faculty of Sciences and Arts, Department of Physics Thesis: Atomic Spectroscopy. ACADEMIC EXPERIENCE June 2013 Current: Assistant Professor - Bulent Ecevit University, Faculty of Engineering, Department of Metallurgical and Materials Engineering, Zonguldak, Turkey September 2012 July 2013: Post-Doctoral Researcher - Hacettepe University, Faculty Engineering, Department of Physics Engineering, SNTG Lab., Ankara, Turkey February 2006 July 2006: Visiting Researcher - Adam Mickiewicz University, Faculty of Physics, Poznan, Poland October 2006 August 2012: Research and Teaching Assistant - Kahramanmaras Sutcu Imam University, Faculty of Sciences and Arts, Department of Physics, Turkey 1

2 RESEARCH INTERESTS Amorphous, Quasicrystalline and Nanocrystalline alloys Metallic glass materials Soft magnetic materials Mechanical alloying/milling Rapid solidification Phase transformations in solids COURSES Fall Semester MMM101-Introduction to Metallurgical and Materials Engineering CEV217-Materials Science NTM704-Nanomaterials Technology Spring Semester CEV208-Materials Science MMM708-Metallic Glass Materials NTM727-Nanostructured Alloys PUBLICATIONS 1. M. Gogebakan, B. Avar: Formation and Microstructure of Quasicrystalline Al-Cu-Fe Alloys by Mechanical Alloying, American Institute of Physics. AIP Conf. Proc. Vol.899, Issue.1, 2007, p B. Avar, M. Gogebakan, F. Yilmaz: Characterization of the icosahedral quasicrystalline phase in rapidly solidified Al-Cu-Fe alloys, Zeitschrift fur Kristallographie Vol.223, Issue.11-12, 2008, p M. Gogebakan, B. Avar, O. Uzun: Quasicrystalline phase formation in the conventionally solidified Al-Cu-Fe system, Materials Science-Poland Vol.27, No.3, 2009, p B. Avar, M. Gogebakan: Synthesis of the quasi-crystalline phase in Al63Cu25Fe12 powders prepared by mechanical alloying, Journal of Optoelectronics and Advanced Materials Vol.11, No.10, 2009, p M. Gogebakan, B. Avar: Quasicrystalline phase formation during heat treatment in Mechanically Alloyed Al65Cu20Fe15 Alloy, Materials Science and Technology Vol.26, No.8, 2010, p

3 6. M. Gogebakan, B. Avar, M. Tarakci: Microstructures and mechanical properties of conventionally solidified Al63Cu25Fe12 alloy during heat treatment, Journal of Alloys and Compounds Vol.509, Supp.1, 2011, p Y. Kara, B. Avar, A. Kayraldiz, B. Guzel, M. Kurtoglu: Synthesis and genotoxicity of schiff base transition metal complexes, Heteroatom Chemistry Vol.22, Issue.2, 2011, p M. Gogebakan, B. Avar: Structural evolutions of the mechanically alloyed Al70Cu20Fe10 powders, Pramana - Journal of Physics Vol.77, No.4, 2011, p M. Gogebakan, I. Karteri, B. Avar, C. Kursun: Crystallization behavior of Mg-Cu-Y amorphous alloy, Journal of Thermal Analysis and Calorimetry Vol.110, 2012, p B. Cabir, B. Avar, M. Gulcan, A. Kayraldiz, M. Kurtoglu: Synthesis, spectroscopic characterization and genotoxicity of a new group of azo-oxime metal chelates, Turkish Journal of Chemistry Vol.37, 2013, p S. Kerli, U. Alver, H. Yaykasli, B. Avar, A. Tanrıverdi, C. Kursun: Synthesis of fluorine doped zinc oxide particles by hydrothermal method, Asian Journal of Chemistry Vol.25, No.13, 2013, p B. Avar, M. Gogebakan, M. Tarakci, Y. Gencer, S. Kerli: Microstructural investigations of rapidly solidified Al-Co-Y alloys, Advances in Materials Science and Engineering vol. 2013, Article ID , 7 pages, doi: /2013/ M. Bal, G. Ceyhan, B. Avar, M. Kose, A. Kayraldiz, M. Kurtoglu: Synthesis, X-ray powder diffraction, electrochemical and genotoxic properties of a new azo-schiff Base and its metal complexes, Turkish Journal of Chemistry 2013, DOI: /kim B. Avar, S. Ozcan: Structural evolutions in Ti and TiO2 powders by ball milling and subsequent heat treatments, Ceramics International Vol.40, 2014, p S. Bitmez, K. Sayin, B. Avar, M. Kose, A. Kayraldiz, M. Kurtoglu: Preparation, spectral, X-ray powder diffraction and computational studies and genotoxic properties of new azo-azomethine metal chelates, Journal of Molecular Structure Vol.1076, 2014, p B. Avar, M. Gogebakan, S. Ozcan, S. Kerli: Structural, Mechanical and Magnetic Properties of Fe-40 at%al Powders during Mechanical Alloying, Journal of the Korean Physical Society (JKPS) Vol.65, Issue 5, 2014, p S. Kerli, U. Alver, A. Tanriverdi, B. Avar: Boron and fluorine doped ZnO films obtained from zinc chloride precursor via chemical spray pyrolysis, Protection of Metals and Physical Chemistry of Surfaces Vol.50, No.6, 2014, p G. Kurtoglu, B. Avar, H. Zengin, M. Kose, K. Sayin, M. Kurtoglu: A novel azoazomethine based fluorescent dye and its Co(II) and Cu(II) metal chelates, Journal of Molecular Liquids Vol.200, 2014, p

4 PRESENTATIONS 1. M. Gogebakan, B. Avar: Formation and Microstructure of Quasicrystalline Al-Cu-Fe Alloys by Mechanical Alloying, 6 th International Conference of the Balkan Physical Union, August, 2006, Istanbul University, Istanbul, Book of Abstracts, p B. Avar, M. Gogebakan: Characterization of Quasicrystalline Phase in Al-Cu-Fe Alloy System by Mechanical Alloying, 24 th International Physics Congress, August, 2007, Inonu University, Malatya, Book of Abstracts, p B. Avar, M. Gogebakan, O. Uzun: Production of Al-Cu-Fe Quasicrystalline Alloys by Conventional and Rapid Solidification, 24 th International Physics Congress, August, 2007, Inonu University, Malatya, Book of Abstracts, p M. Gogebakan, B. Avar, M. Tarakci: Microstructural Characterization of Conventionally Solidified Al63Cu25Fe12 Alloy During Heat Treatment, Condansed Matter Physics Conference Of Balkan Countries CMPC BC2008, May, 2008, Mugla University, Mugla, Book of Abstracts, p B. Avar, M. Gogebakan, F. Yilmaz: Characterization of the Icosahedral Quasicrystalline Phase in Rapidly Solidified Al-Cu-Fe Alloys, 10 th International Conference on Quasicrystals ICQ10, 6-11 July, 2008, ETH, Zurich, Switzerland, Book of Abstracts, s M. Gogebakan, B. Avar: Production and Structure of Quasicrystalline Al- Based Alloys, 25 th International Physics Congress, August, 2008, Bodrum, Mugla, Book of Abstracts, p A. Gundes, M. Gogebakan, B. Avar: Mekaniksel Öğütme Tekniği ile Üretilen Al85Ni10Nd5 Alaşımında Faz Dönüşümlerinin İncelenmesi, 25 th International Physics Congress, August, 2008, Bodrum, Mugla, Book of Abstracts, p B. Avar, M. Gogebakan: Synthesis of Quasicrystalline Phase in Al63Cu25Fe12 Powders Prepared by Mechanical Alloying, 15 th International School of Condensed Matter Physics, the ISCMP 2008, 31 August-6 September, 2008, Varna, Bulgaria. 9. B. Avar, M. Gogebakan: Icosahedral Phase Formation in Al-Cu-Fe-TM (TM=Si,Mg,B) Alloys, 26 th International Physics Congress, September, 2009, Bodrum, Mugla, Book of Abstracts, p M. Gogebakan, B. Avar, M. Tarakci: Microstructures and Mechanical Properties of Conventionally Solidified Al63Cu25Fe12 Alloy During Heat Treatment, 17th International Symposium on Metastable, Amorphous and Nanostructured Materials (ISMANAM 2010), 4-9 July, 2010, ETH, Zurich, Switzerland, Book of Abstracts, p B. Avar, M. Gogebakan: Icosahedral Phase Formation in Mechanically Alloyed Al-Cu- Fe-TM (TM=Si, Mg, B) Alloys, 17th International Symposium on Metastable, Amorphous and Nanostructured Materials (ISMANAM 2010), 4-9 July, 2010, ETH, Zurich, Switzerland, Book of Abstracts, p

5 12. M. Gogebakan, I. Karteri, B. Avar: Structural Investigation of Mg-based Alloys Prepared by Mechanical Alloying, 17th International Symposium on Metastable, Amorphous and Nanostructured Materials (ISMANAM 2010), 4-9 Temmuz, 2010, ETH, Zurich, Switzerland, Book of Abstracts, p B. Avar, M. Gogebakan: Synthesis, Structural and Mechanical Properties of Al-Cu-Fe quasicrystalline alloys, 27 th International Physics Congress, September, 2010, Istanbul University, Istanbul, Book of Abstracts, p B. Avar, M. Gogebakan: A Study on Structural and Mechanical Properties of Al-Co-Y Melt-Spun Ribbons, 18th International Symposium on Metastable, Amorphous and Nanostructured Materials (ISMANAM 2011), 26 June - 1 July, 2011, Gijon, Spain, Book of Abstracts, p B. Avar, M. Gogebakan, N. Canal: Mechanical and Thermal Properties of Rapidly Solidified Al-Ni-Fe-(Nd,Y) Alloys, 18th International Symposium on Metastable, Amorphous and Nanostructured Materials (ISMANAM 2011), 26 June - 1 July, 2011, Gijon, Spain, Book of Abstracts, p B. Avar, M. Gogebakan: Crystallization and Hardness Behavior of an Amorphous Al85Co7Y8 Alloy, 12th International Symposium on Novel and Nano Materials (ISNNM), August 2012, Istanbul, Turkey, Book of Abstracts, p G. Gizer, B. Avar, S. Ozcan: Synthesis and hydrogen storage properties of an Mg-Ni- Mn-V alloy, 9th Nanoscience and Nanotechnology Congress (NanoTR-9), June 2013, Erzurum, Turkey, Book of Abstracts, p B. Avar, M. Gogebakan, S. Ozcan: X-ray diffraction, thermal and magnetization studies of mechanically alloyed nanostructured Fe-40 at% Al powder, 9th Nanoscience and Nanotechnology Congress (NanoTR-9), June 2013, Erzurum, Turkey, Book of Abstracts, p B. Avar, M. Gogebakan, S. Ozcan: Structural, Mechanical and Magnetic Properties of Nanocrystalline Fe-based Alloys Synthesized by Mechanical Alloying, International Conference on Nanoscale Magnetism (ICNM2013), 2-6 Eylül 2013, Istanbul, Türkiye, Abstract Book, s B. Avar, M. Gogebakan: Crystallization Process and Microhardness Evolution in asspun (Al85Co7Y8)98Si2 amorphous alloy, Advanced Materials World Congress (AMWC 2013), September 2013, Izmir, Turkey, Peer Reviewed Book, p B. Avar, S. Ozcan: Formation and characterization of Co-(Fe, Ni)-Ti-B amorphous powders, 7th International Powder Metallurgy Conference and Exhibition (PM7), June 2014, Ankara, Türkiye, Abstract Book, s B. Avar, M. Gogebakan: Nanocrystallization Kinetics of Al85Co5Ni5Y5 Metallic Glass, 14th International Balkan Workshop on Applied Physics and Materials Science (IBWAP2014), 2-4 July 2014, Constanta, Romanya, Book of Abstracts, s B. Avar, S. Ozcan: Investigation of Structural, Thermal And Magnetic Properties of Nanocrystalline Co65W5Ti25B5 Powders by Mechanical Alloying, 14th International 5

6 Balkan Workshop on Applied Physics and Materials Science (IBWAP2014), 2-4 July 2014, Constanta, Romanya, Book of Abstracts, s E. Çinar Avar, B. Avar, E. Logoglu: Structural and Antibacterial Properties of Ni Doped ZnO Nanopowders, 14th International Balkan Workshop on Applied Physics and Materials Science (IBWAP2014), 2-4 July 2014, Constanta, Romanya, Book of Abstracts, s.71. 6