Labino MidBeam UV Led 4 UV LED 1 WHITE LIGHT LED MAINS OR BATTERY The Labino MidBeam Light is part of a new generation of products that Labino is introducing to the market. These unique new lights have one common characteristic; they weigh less, than many comparable products in the market today. MidBeam in particular is a handheld lamp, extremely compact in size, with a housing diameter of just 3.15 inches! MidBeam is available as Battery or Mains. The mains operated model weigh just 440 grams (0.97 lbs) and the battery operated model weigh 560 grams (1.23 lbs)! The light weight and compact size makes it extremely easy for the user to operate and carry around even the most difficult inspection areas and structures. This is made possible without compromising the performance of the lamp. Each MidBeam consists of 4 LEDs offering a very even beam. It is also equipped with a white light LED for after inspection. The start button provides instant power and the light is operated with a multifunctional switch UV / OFF / White Light on the handle for ease of use. It is easy for the battery version to switch batteries. The location of the batteries (inside pistol handle) makes the ergonomics of the unit stable. Four batteries are provided and two are needed to operate. The design of the mains version makes it easy to support the light with a common stand on a bench. The heat generated from the LEDs is managed via a mechanical cooling system no fans necessary! MidBeam is 100% free from UV-B and the LEDs emit almost no visible light due to a visible light filter. It is compliant with ASTM UV-A intensity and wavelength specifications for FPI and MPI. IP65 approved for dust and water jetting proof. TECHNICAL SPECIFICATIONS: Light Beam i. Midlight > 4 500 µw/cm 2 at 38 cm (15 inches) Ø 200 mm (total area with a minimum intensity of 1000 µw/cm 2 at 38 cm) Visible light from UV LED i. 1 Lux 1 / 0.09 Foot Candle 1 LED i. 4 UV LED, peak at 365 nm ii. 1 White Light LED DISTRIBUTOR: Battery i. 2200 mah Lithium-Ion, 3.7 volts ii. Running time: approx. 1.5 hrs iii. Charging time: approx. 8 hrs iv. Requires 2 batteries to operate v. Equipped with a current regulator Charger i. One 100-240 VAC charger for use from electrical outlet ii. Capacity: two batteries can be charged simultaneously iii. One 12 V charger for use in vehicle i. 100-240 V ii. 50-60 Hz iii. Operated by separate PSU with self-selecting voltage Cable for Mains i. Volt: 5 V ii. Length: 1.5 m (4.5 feet) i. Weight: without battery: 440 gr (0.97 pounds); with battery: 560 gr (1.23 pounds) ii. Housing diameter: 80 mm (3.15 inches) iii. Start-up time: Instant-on operation with immediate full power iv. Material in housing: anodized aluminium v. Equipped with a current regulator vi. CE approved vii. IP43 classified 1 The standard EN 3059 5.2 and ISO 9934-3 recommend the use of a UV-block filter on the sensor of the Visible light meter eliminating all UV (below 380 nm).
Labino MidBeam Aerospace 4 UV LED < 4 500 µw/cm 2 MAINS OR BATTERY 3 hrs BATTERY TIME The Labino MidBeam Aerospace is especially designed to meet the requirements of the Aerospace Industry. The differences between MidBeam Aerospace and the regular MidBeam light are as follows: Guaranteed intensity below 4 500 µw/cm 2 No white light LED for after inspection Longer battery running time, more than 3 hours MidBeam Aerospace is a handheld lamp, extremely compact in size, with a housing diameter of just 3.15 inches! MidBeam Aerospace is available as Battery or Mains. The mains operated model weigh just 440 grams (0.97 lbs) and the battery operated model weigh 560 grams (1.23 lbs). The light weight and compact size makes it extremely easy for the user to operate and carry around even the most difficult inspection areas and structures. This is made possible without compromising the performance of the lamp. Each MidBeam consists of 4 LEDs offering a very even beam. The start button provides instant power. It is easy for the battery version to switch batteries. The location of the batteries (inside pistol handle) makes the ergonomics of the unit stable. Four batteries are provided and two are needed to operate. The design of the mains version makes it easy to support the light with a common stand on a bench. The heat generated from the LEDs is managed via a mechanical cooling system no fans necessary! MidBeam is 100% free from UV-B and the LEDs emit almost no visible light due to a visible light filter. It is compliant with ASTM UV-A intensity and wavelength specifications for FPI and MPI. TECHNICAL SPECIFICATIONS: Light Beam i. < 4 500 µw/cm 2 at 38 cm (15 inches) Visible light from UV LED i. 1 Lux 1 / 0.09 Foot Candle 1 LED i. 4 UV LED, peak at 365 nm DISTRIBUTOR: Battery i. 2200 mah Lithium-Ion, 3.7 volts ii. Running time: approx. 3 hrs iii. Charging time: approx. 8 hrs iv. Requires 2 batteries to operate v. Equipped with a current regulator Charger i. One 100-240 VAC charger for use from electrical outlet ii. Capacity: two batteries can be charged simultaneously iii. One 12 V charger for use in vehicle i. 100-240 V ii. 50-60 Hz iii. Operated by separate PSU with self-selecting voltage Cable for Mains i. Volt: 5 V ii. Length: 1.5 m (4.5 feet) iv. i. Weight: without battery: 440 gr (0.97 pounds); with battery: 560 gr (1.23 pounds) ii. Housing diameter: 80 mm (3.15 inches) iii. Start-up time: Instant-on operation with immediate full power Material in housing: anodized aluminium v. CE approved vi. IP43 classified 1 The standard EN 3059 5.2 and ISO 9934-3 recommend the use of a UV-block filter on the sensor of the Visible light meter eliminating all UV (below 380 nm).
MidBeam Aerospace RRES 90061 COMPLIES WITH ROLLS-ROYCE MANUFACTURING REQUIREMENTS RRES 90061 The Labino MidBeam Aerospace RRES 90061 is especially designed to meet the manufacturer s requirement from Rolls-Royce. The differences between MidBeam Aerospace RRES 90061 and the regular MidBeam Aerospace is: Intensity approximately 2 600 µw/cm 2 Extremely homogenous light beam Supplied with test report according to RRES 90061 MidBeam Aerospace RRES 90061 is a handheld lamp, extremely compact in size, available as Battery or Mains. The mains operated model weigh just 440 grams (0.97 lbs) and the battery operated model weigh 560 grams (1.23 lbs). Each light consists of 4 LEDs offering an extremely even beam. The start button provides instant power. It is easy for the battery version to switch batteries. The location of the batteries (inside pistol handle) makes the ergonomics of the unit stable. Four batteries are provided and two are needed to operate. The design of the mains version makes it easy to support the light with a common stand on a bench. The beam profile is very crucial for the Aerospace industry. This UV light is specially developed to offer a beam that is homogenous without any footprints showing from the LEDs, shades, dark spots or other disturbing defects in the beam. The edge of the beam is fading out according to the requirements in the Rolls-Royce manufacturer s requirement. See illustrations below. BEAM PROFILE Beam profile to illustrate the UV intensity: Beam pattern (white paper test):
MidBeam Aerospace RRES 90061 INCLUDED IN THE MIDBEAM BATTERY KIT TECHNICAL SPECIFICATIONS: Light Beam 4 UV LED, peak at 365 nm Intensity 2 600 µw/cm 2 at 38 cm (15 ) No UVB 1 Lux 1 / 0.09 Foot Candle Battery 2200 mah Lithium-Ion, 3.7 V Running time: approx. 3 hrs Charging time: approx. 8 hrs Requires 2 batteries to operate Equipped with a current regulator INCLUDED IN THE MIDBEAM MAINS KIT Charger 100-240 VAC charger for use from electrical outlet Two batteries can be charged simultaneously 12 V charger for use in vehicle 100-240 V 50-60 Hz Operated by separate PSU with self-selecting voltage Cable: 5 Volt Cable length: 1.5 m (4.9 feet) Weight: without battery: 440 gr (0.97 pounds); with battery: 560 gr (1.23 pounds) Housing diameter: 80 mm (3.15 ) Start-up time: Instant-on operation with immediate full power Material in housing: anodized aluminium Mechanical cooling system Certification CE approved IP43 classified Complies with: RRES 90061
MidBeam 2.0 THE PERFECT TOOL! AN EXTREMELY ROBUST, LIGHTWEIGHT AND COMPACT UV INSPECTION LIGHT MidBeam 2.0 is an extremely robust hand held lamp especially designed for use by heavy industries with very difficult operating environments. The light is compact in size, with four LEDs in a housing diameter of just 3.15 inches (8 cm)! Unique Features of MidBeam 2.0: IP68 Waterproof classification: Solids and liquids that often find their way into a light causing UV LEDs to burn cannot penetrate a MidBeam 2.0 unit. Battery indicator: Four colors, green, yellow, orange and red signal the user when the batteries are over 75%, 50-75%, 25-50% and below 25% charged respectively. With less than 10% left the red signal starts flashing. Operates while charging batteries: The battery version can operate like mains while charging the batteries via a connector at the back of the head. Each light consists of 4 LEDs offering an extremely even beam. The switch located at the back of the head provides instant power. It is easy for the battery version to switch batteries. The location of the batteries (inside pistol handle) makes the ergonomics of the unit stable. Four batteries are provided and two are needed to operate. The design of the mains version makes it easy to support the light with a common stand on a bench. MidBeam 2.0 Standard and Aerospace is classified as a Risk Group 3 (High Risk) in accordance with IEC / SS-EN 62471. The MidBeam 2.0 is available in three different versions, as Standard, Aerospace and Aerospace RRES 90061. Standard Version: The MidBeam 2.0 Standard generates an intensity in excess of > 4 500 μw/cm 2 (at 15 inches) and is equipped with a white light LED for after inspection. Battery life is 1.5 hours. Aerospace Version: The MidBeam 2.0 Aerospace differs from the Standard version as follows: A. The Aerospace version does not have a white light LED for after inspection. B. The intensity of the Aerospace version is adjusted to never exceed 4 500 μw/cm 2 at 15 inches. C. The battery life of the Aerospace version is in excess of three hours. Aerospace RRES 90061 Version: The MidBeam 2.0 Aerospace RRES 90061 generates an intensity of approximately 2 600 µw/cm 2 (at 15 inches). While the remaining characteristics are the same as with MidBeam 2.0 Aerospace above, the optics of this unit is specifically designed to meet the Rolls Royce engineering specification RRES 90061. The beam profile is very crucial for the Aerospace industry. This UV light is specially developed to offer a beam that is extremely homogenous without any footprints showing from the LEDs, shades, dark spots or other disturbing defects in the beam.
MidBeam 2.0 Differences between MidBeam 2.0 and MidBeam 1.0: MidBeam 2.0 MidBeam 1.0 IP Class IP 68 IP 43 On-Off Switch On the Head On the Handle Battery Indicator Yes No Operate while charging batteries Yes No Camera mount on battery version (e Yes extra battery set No Squared pin hole to mount on stand Yes No (round) Cable for mains equipped with connectors for easy Yes No replacement and flexible length Clear glass protection filter Yes No TECHNICAL SPECIFICATIONS Light Source and Light Output 4 UV LEDs peaking at 365 nm, 1 White Light LED (Optional) Intensity Standard Version: > 4 500 µw/cm 2 at 38 cm (15 ) Intensity Aerospace Version: < 4 500 µw/cm 2 at 38 cm (15 ) Intensity Aerospace RRES 90061 2 600 µw/cm 2 at 38 cm (15 ) White light output from UV source: 1 Lux 1 / 0.09 Foot Candle No UVB Battery (Supplied with four batteries) 2200 mah Lithium-Ion, 3.7 V Running time Standard: Approximately 1.5 hours Running time Aerospace: Approximately 3 hours Running time Aerospace RRES 90061: Approximately 3 hours Charging time: Approximately 8 hours Requires two batteries to operate Supplied with two extra Equipped with a current regulator to keep the intensity stable when Charger (Supplied with three chargers) 100-240 VAC charger for use from an electrical outlet. Two batteries can be charged simultaneously 12 V charger for use in a vehicle Power Supply for charging while operating: o 100-240 VAC o 50-60 Hz o Out: 12V DC 3A/40W 100-240 VAC 50-60 Hz Out: 12V DC 3A/40W Cable length of your choice. Standard cable is 2.5 m (3.3 feet). Weight battery version:: without battery: 688 gr (8.27 oz); with battery: 781 gr (11.55oz) Weight mains version: 702 gr (8.76 oz) Housing diameter: 80 mm (3.15 ) Instant-on operation with full intensity reached immediately Material in housing: anodized aluminium Material in handle: PA6, 30 Mechanical cooling system Certification CE Marked IP68 classified Complies with ASTM E3022-2015 Aerospace RRES 90061 version complies with Rolls Royce engineering specification RRES 90061 TECHNICAL SPECIFICATIONS