SATLAB Field Tools User Guide for SL55 Date Update No 2013 / April 1 Page1
Contents 1. Bluetooth Connection 3-9 2. Static Data Collection 10-11 3. Register Code Access 12-13 4. NMEA Data Management 14-16 Page2
1. Bluetooth Connection In order to connect SL55 to receiver via Bluetooth; please click Start on the Windows desktop. In the Start menu, please click Settings. Page3
Please click Bluetooth icon to access Bluetooth settings. Please click Add new device Then, let the controller search if any device available for Bluetooth connection. Page4
Please wait while controller searching for Bluetooth devices. After searching is completed, controller finds all devices around which are available for Bluetooth connection. Please select your receiver s serial number and click Next. Page5
After that, Passcode screen appears. Please input your passcode and click Next. The passcode is: 1234 When Device Added message box appears, then Bluetooth connection between controller and receiver has been done. After that, please click Done. Page6
Please select COM Ports from the bottom tabs. Click New Outgoing Port to define COM Port. Page7
Secure Connection selection box must be unselected. Please remove the check from selection box. After that please select COM Port from drop down list. Then click Finish. Page8
Then please click OK to apply. After that please turn back to the Windows desktop and run SATLAB Field Tools. Page9
Please click GPS Off Line button to connect GNSS receiver via Bluetooth. Setting Parameters: HPC: imap SL Series Type: Serial Port Port: 8 (Same as Outgoing) Baudrate: 19200 Analyzer: SL500 Input setting parameters and click button. Page10
Connected 3011940 Connection between SL500 receiver, which serial number is 3011940, and controller via Bluetooth has been successful. Page11
2. Static Data Collection After controller connects with receiver, please select Static> Static. Keyboard Exit Set Parameters Start Observation Point Name Elevation Mask Antenna Height Page12
Please input Static Mode Setting parameters and click Set to apply parameters. When Successful operation! message box appears then you can make sure that your settings has been defined. Please click Start button to start survey. After start surveying; In order to finish the observation, please press Stop button. Do not shut down the controller. In order to stop observation without using controller, please press F2 button on SL500 receiver twice. Page13
3. Register Code Access Please click Pos icon. Then click Regist button. Page14
Please insert your registration code without space, then click button to confirm. When you see this message box, it means your registration code has been confirmed. Then please click OK button. Page15
4. NMEA Data Management In order to access NMEA output, please click Pos icon. Then, please click button. Page16
Select Clear check box and please click. Please select NMEA types which is needed. Then, please select data port; COM1: Serial and Bluetooth COM2: Serial After data port selection, please insert your time interval in seconds. Then click NMEA flow. button to begin Page17
NMEA flow starts. NMEA Data Structure GGA Global Positioning System Fixed Data GLL Geographic Position - Latitude/Longitude GSA GNSS DOP and Active Satellites GSV GNSS Satellites in View RMC Recommended Minimum Specific GNSS Data VTG Course Over Ground and Ground Speed ZDA Time&Date Message GST GPS Pseudorange Noise Statistics ADV Position and Satellite information for RTK network operations Page18