ACOME Complete systems for: radiant floor heating/cooling/plumbing.
Plumbing systems Hot and cold water distribution Principle: The appliances (plumbing, radiators, fan-coil units, etc.) are individually supplied from a header / distributor. Direct connection, without discontinuity or couplings, is done by ducted PEX-c or PB pipes incorporated into the structures (see diagrams) or by surface-mounted multi-layers. A complete system The components: PEX-c, PB or multi-layer pipes (with or without ducts) which meet with international requirements (see page 4, pipes can be supplied by ACOME). Complete range of NF or DIN crimped fittings Accessories for inlets and outlets in structures Header / Distributor Valves and accessories Manual or battery-operated crimping guns A large number of advantages: Easy installation = less time required Fewer nuisances = absorption of circulation area noises, decreased heat losses Increased safety = elimination of pipework corrosion and furring Complete system with adapted components that comply with regulatory restrictions.
Hydraulic under floor heating / cooling Installed with a concrete slab or a wet screed Hydraulic under floor heating Dry solution, installed without any concrete Hydraulic and electric Four comple ACOME under floor heating systems are used to provide total or partial heating or heating/coolin apartment blocks, and in the business sector: offices and factories. They are fully adapted to schoo stadiums. They can also be used outdoors to prevent the formation of black ice, as solar panels, etc PEX-c pipe Isolation slab on pads Anti-shrinkage web (if required) Concrete slab or wet screed Floor finish More than 20 years experience and references: over 30,000,000 m 2 of Acome floors have been laid across the world Innovation prizes Nominated at the Paris international Interclima 2004 trade show Installed within 22 mm! 2 PEX-c pipes PE /aluminium undercoat Floating floor PSE slab with aluminium film Real thi 22 m Thin system: taking 22 m Lightweight system: very System that can be laid o Easy system: very quick i Dry system: premises are
under floors heating te systems g. They can be used to cover all site configurations: new or retrofit works for family homes and s, hotels, restaurants and churches as well as sports complexes: gymnasiums, swimming pools and. Electric under floor heating, permanent output cable Installed with a concrete slab or a wet screed Permanent output cable on plastic mesh grid Isolation slab on pads Anti-shrinkage web (if required) Concrete slab or wet screed Floor finish Underfloor form (if required) Electric under floor heating, self-regulating cable Dry solution, installed without any concrete A real innovation! Installed within 22 mm! A world first: an easy to install round section self-regulating cable ckness Floating floor PSE slab with aluminium film PE /aluminium undercoat Self-regulating cable m m little added load ver existing floor nstallation immediately usable
Customised systems The components: With over 20 years experience and references across the world, ACOME obviously to be your industrial partner, allowing you to provide your clients with complete solutions, whether for hot and cold water distribution, radiators and convectors or for hydraulic or electric under floor heating systems. A few examples: The PEX-c pipe ACOME provides a full range of pipes, from DN 12 to DN 25, either uncovered or ducted. PSE pipe-guide slabs ACOME provides a range of PSE slabs, thickness according to requirements, for floor heating systems. Header/distributor kit This kit distribution between the generator and the heating unit. / The components meet the standards and certifications in force in the following countries: STANDARD CERTIFICATION STANDARD CERTIFICATION Germany Spain UNE EN 15875 AENOR Netherlands BRL 5606 BRL-K536 / 04 KOMO KIWA Switzerland BS 7291 BBA CSA B 137.5 CSA GB Canada USA France ASTM F876 / F877 NSF 14 NF T 54085 NSF ICC Technical assesment CSTBat certification Attestation of Sanitary Conformity Czech Republic Italy Belgium Please contact us for any further information required concerning our systems.
ACOME worldwide Industrial facilities France: Mortain / China: Wuhan and Xintai / Brazil: Irati Subsidiaries ans offices Agents and distributors Three fields of activity, systems dedicated Building sector Electrical equipment Telecommunications A few references 1 2 Castello-Vigevano (Piemonte - Italy) 1 Versailles Castle (Versailles France) San Gregorio church (Milan Italy) TGV Lyon/Satolas (Lyon France) 2 British Museum (London GB) Bercy Exhibition (Paris France) Institut du Monde Arabe (Paris France) Notre Dame de Fatima church ( Zapopane Poland) Benetton factory (Trévise Italy) Fabriano (Ancona - Italy) 3 Danone research centre (Palaiseau France) 3 Castello-Vigevano (Piemonte - Italy) 4 Skating rink (Courchevel France) 4 And a large number of industrial, residential and apartment block projects.