COMPETENCY ANALYSIS PROFILE. Rodworker 452A. (All unshaded skill sets must be demonstrated/ completed) Lift equipment and materials

Transcription

1 COMPETENCY ANALYSIS PROFILE Rodworker 452A (All unshaded skill sets must be demonstrated/ completed) PROTECT SELF AND OTHERS Wear personal protective (PPE) Lift and Apply housekeeping rules Interpret warning signs, labels and symbols Report hazards to supervisory and safety personnel U U U U U U Maintain safety devices and Respond to emergency situations Operate construction Maintain construction Inspect platforms, ladders and working surfaces U U U U U Install and secure platforms, ladders and working surfaces Maintain platforms, ladders and working surfaces Prevent fires Communicate with co-workers in the workplace Stress tendons U U U U U U PLAN, PREPARE AND SET UP FOR JOB Read and interpret drawings and specifications Plan tasks Determine installation procedures and sequences Set up Unload, sort/shake out and stage inventory U U U U U U Set up manual and power bending Operate manual and power bending U U

2 OPERATE AND MAINTAIN HAND, POWER TOOLS AND AERIAL WORK PLATFORMS Identify hand Select hand Use hand Maintain hand Identify power U U U U U U Select power Operate power Maintain power Identify oxygen Select oxygen and fuel gas U U U U U Set up and adjust oxygen and fuel gas Operate oxygen Maintain oxygen Identify posttensioning Select posttensioning Set up and adjust U U U U U Operate posttensioning Maintain posttensioning Identify aerial Select aerial work platforms U U U U U Set up aerial work platforms Operate aerial Maintain aerial U U U

3 RIG AND HOIST MATERIALS AND EQUIPMENT Perform rigging and hoisting calculations Select slings Assemble slings Inspect and maintain slings Select rigging U U U U U U Assemble rigging Inspect and maintain rigging Select hoisting Assemble hoisting Inspect and maintain hoisting Reeve or lace blocks U U U U U Tie and render Splice fibre rope knots, hitches and bends Establish hand, voice and radio communications with co-workers and operators U U U U

4 PLACE REINFORCING MATERIALS Identify Select Sort Identify bar supports U U U U U U Select bar supports Install bar supports Install for beams, columns and walls for slab for footings U U U U U Pre-assemble bar columns, beams, walls, cages and components Splice bars Hoist bar assemblies Place bar assemblies Position welded wire fabric Secure welded wire fabric U U U U U inspection of U U PLACE POST- TENSIONING AND BAR TENDONS Perform preinstallation procedure and layout Order work site and for tendon placing Install bearing plates and bursting steel Install tendon and sheathing supports, chairs, sheathing and couplers Install bonded cables in sheathing U U U U U U Install unbonded cables on supports Assemble dead-end anchors inspection of posttensioning U U U

5 STRESS AND GROUT POST- TENSIONING AND BAR TENDONS Interpret engineering instructions for bar and cable stressing and cable stress sequence Order work site and for tendon stressing and grouting Install anchor head and wedges and stressing plates Select stressing jacks and hydraulic pumps Position stressing jacks and hydraulic pumps U U U U U U Apply stress to and bar tendons Crop cables to specified strand projection length Perform pregrouting grouting U U U U