INFORMATION SYSTEMS SERVICE NETWORKS AND COMMUNICATIONS SECTOR. VPN Remote Access Installation and Configuration Guide Operating System: Windows 7

Transcription

1 INFORMATION SYSTEMS SERVICE NETWORKS AND COMMUNICATIONS SECTOR VPN Remote Access Installation and Configuration Guide Operating System: Windows 7 ΥΠΣ ΕΔ/50 August 12 th, 2011

2 A. INSTALLATION OF THE CLIENT SOFTWARE B. CONFIGURATION OF THE CLIENT SOFTWARE 2

3 A. Installation of the Client Software Step A1: Open your browser and type in the following url You will then be asked to provide logon information username and password. These are the same credentials as those you use to access your University of Cyprus webmail. Enter your credentials and click on Logon: Step A2: A list containing four different clients in.zip format will appear. Click on the one that reads Download Cisco IPSec client for Windows if you have the 32-bit operating system edition. Otherwise, you will have to click on Download Cisco IPSec client for Windows 64 Bit. To determine which of the two system type editions your computer is running, follow these steps: 3

4 i. Click Start ii. Click All Programs iii. Right click on Computer iv. From the menu click Properties. v. On the following screen that will appear, you can see the System type (32-bit or 64-bit). Step A3: Once you have identified your computer s system type, select the appropriate client and click to Save it on your computer: 4

5 Step A4: Select where you wish to Save the client software and then click Open: Step A5: Right-click on the.zip file you have just downloaded and select the Extract Here to extract the contents of the compressed folder: 5

6 Step A6: Once you have extracted the contents of the.zip folder you downloaded, open the folder and double click the file vpnclient_setup.msi Step A7: On the following screen that will appear, click Next. 6

7 Step A8: Select the radio button that reads I accept the license agreement and then click Next. Step A9: It is recommended to keep the default destination folder as is. If you wish to change the installation location, click on Browse and select a different folder. Click Next. 7

8 Step A10: Click Next to proceed with the installation: Step A11: The following screen informs you on the successful installation of the VPN Client. Click Finish. 8

9 Step A12: You may be asked to restart your system for the configuration changes to take effect. Click Yes to restart your system. 9

10 B. Configuration of the Client Software Step B1: Launch the VPN Client by clicking on Start > All Programmes > Cisco Systems VPN Client > VPN Client: Step B2: At this point you will have to import the University of Cyprus.pcf file, even if the connection «University of Cyprus» appears under Connection Entry. Click on the Import button: 10

11 Step B3: Go to the folder where you downloaded and extracted the VPN Client. Unless you changed the download destination folder, this shall be found in your Downloads folder. Open it and search for the University of Cyprus.pcf file, select it and click Open. Note: this import process will not have to be repeated each time you wish to connect to the University of Cyprus network. In case the University of Cyprus was already imported, the following message will appear. Select Overwrite to overwrite the existent file and proceed with the steps as they appear in the guide: 11

12 Step B4: The University of Cyprus connection shall now appear. Select it and then click on the Connect button: Step B5: You will be prompted to enter your credentials at the following screen. Use the username and password that you use to access your University of Cyprus account. Enter your credentials and click OK: 12

13 Step B6: You are now securely connected to the University of Cyprus network. This is indicated by a yellow lock that appears next to the Connection Entry and on your computer s taskbar as well. If you wish to Disconnect, click on the Disconnect icon. 13