RN Series Startup Form

Transcription

1 RN Series Startup Form Date: Job Name: Address: Model Number: Serial Number: Tag: Startup Contractor: Address: Phone: Pre Startup Checklist Installing contractor should verify the following items.. Is there any visible shipping damage? Yes No. Is the unit level? Yes No. Are the unit clearances adequate for service and operation? Yes No. Do all access doors open freely and are the handles operational? Yes No 5. Have all electrical connections been tested for tightness? Yes No 6. Does the electrical service correspond to the unit nameplate? Yes No 7. On 08/0V units, has transformer tap been checked? Yes No 8. Has overcurrent protection been installed to match the unit nameplate requirement? Yes No 9. Have all set screws on the fans been tightened? Yes No 0. Do all fans rotate freely? Yes No. Is all copper tubing isolated so that it does not rub? Yes No. Has outside air rain hood been opened? Yes No. Have the damper assemblies been inspected? Yes No. Are the air filters installed with proper orientation? Yes No 5. Have condensate drain and p-trap been connected? Yes No Supply Fan Assembly Number hp L L L Band Size VFD Frequency VAV Controls

2 Energy Recovery Wheel Assembly Wheel(s) Spin Freely Check Rotation FLA Number hp L L L Power Return/Exhaust Assembly Number hp L L L Outside Air/Economizer Dampers Operation Check Damper Actuator Type: Economizer Changeover Type and Operations: Damper Wiring Check Gears Check Ambient Temperature Ambient Dry Bulb Temperature F Unit Configuration Water-Cooled Condenser No Water Leaks Condenser Safety Check Water Flow GPM Water Inlet Temperature F Water Outlet Temperature F Ambient Wet Bulb Temperature F Air-Cooled Condenser Compressors / DX Cooling Number/stage L L L Head PSIG PSIG Crankcase Heater Amps

3 Refrigeration System Cooling Mode Discharge Refrigeration System Cooling Mode Discharge Refrigeration System Cooling Mode Discharge Refrigeration System Cooling Mode Discharge Refrigeration System Heating Mode (Heat Pump only) Discharge Refrigeration System Heating Mode (Heat Pump only) Discharge Refrigeration System Heating Mode (Heat Pump only) Discharge

4 Refrigeration System Heating Mode (Heat Pump only) Discharge Air-Cooled Condenser Number hp L L L 5 6 Water/Glycol System. Has the entire system been flushed and pressure checked? Yes No. Has the entire system been filled with fluid? Yes No. Has air been bled from the heat exchangers and piping? Yes No. Is the glycol the proper type and concentration ( if water)? Yes No 5. Is there a minimum load of 50% of the design load? Yes No 6. Has the water piping been insulated? Yes No 7. What is the freeze point of the glycol ( if water)? Gas Heating Natural Gas Propane Purge Air from Lines Verify Pilot Spark Stage Manifold (w.c.) Stage Manifold (w.c.) Electric Heating Stages Limit Lockout Aux. Limit Lockout Stage Amps Stage Amps

5 Maintenance Log This log must be kept with the unit. It is the responsibility of the owner and/or maintenance/service contractor to document any service, repair or adjustments. AAON Service and Warranty Departments are available to advise and provide phone help for proper operation and replacement parts. The responsibility for proper start-up, maintenance and servicing of the equipment falls to the owner and qualified licensed technician. Entry Date Action Taken Name/Tel. 5