Toll Zones And T geotchnical Network Infrastructure

Transcription

1 TEXAS EPARTMENT OF TRANSPORTATION FOR SH 99 GRAN PARKWAY SEGMENTS H, I-1 AN I-2 ATTAHMENT 21-1 TOLL SYSTEMS RESPONSIILITY MATRIX APRIL 30, 2015

2 LEGEN Toll s Responsibility Matrix Work escription oordination Responsibility Only FAILITIES Toll plaza design layout A N/A N/A N/A N/A N/A N/A Metered power service to roadside equipment cabinet Electrical conductors from equipment pad to Toll Zone equipment omplete backup power systems: generators, automatic transfer switches, and fuel tanks oncrete pad/foundation and conduits for backup power systems Uninterruptible power supplies for the lane controllers/tolling equipment at Toll Zones See Sec 21.3 of TPs A A A SI to provide power requirements and special requirements for ev to construct utilities near toll collection points A A A ev will coordinate access to A A A ev will coordinate access to A A A T to design for SI. ev to construct grading, earthwork and subgrade for SI work. ev will coordinate access to A A A ev will coordinate access to Lightning protection & grounding A A A ev will coordinate access to. ev to coordinate with SI for SI placement of conduit prior to ev placing pavement. TEXAS EPARTMENT OF TRANSPORTATION FINAL RFP SH 99 GRAN PARKWAY SEGMENTS H, I-1, I-2 PAGE 21-1

3 LEGEN Toll s Responsibility Matrix Work escription oordination Responsibility Only FAILITIES oncrete encased duct bank for dedicated toll needs Fiber optic cables in duct bank for toll systems Fiber optic data/ communication to termination cabinet ata/communication wire/fiber from termination cabinet to toll systems equipment Toll Zone pavement and structure, using special pavement section and conduit stub ups for pavement sensors (see Attachment 21-3 of Technical Provisions) A A A ev to install conduit in uct ank complete with pull strings A A A ev to provide fiber with 4 strands single mode dedicated fiber to each toll zone (E.g. 24 toll zones would require 96 fiber strands). No daisy chaining. ev to install pull strings, fiber optic markers, test stations and tracer wire with fiber optic cables A A A SI to provide communication/data requirements. ev to provide and test fiber to fiber termination cabinets adjacent to each toll zone equipment cabinet pad. A A A SI to install from roadside termination cabinet to toll systems equipment A A A SI to provide pavement loop details with stub-up locations. T will coordinate with ev for joint layouts. ev to construct Stub Ups to terminate in junction boxes, provided by ev, adjacent to toll zone pavement TEXAS EPARTMENT OF TRANSPORTATION FINAL RFP SH 99 GRAN PARKWAY SEGMENTS H, I-1, I-2 PAGE 21-2

4 LEGEN Toll s Responsibility Matrix Work escription oordination Responsibility Only FAILITIES Loop conduit from junction box to roadside equipment cabinet A A A ev will coordinate access to Gantry equipment conduit from roadside equipment cabinet to toll A A A ev will coordinate access to systems equipment Pavement sensors A A A ev to provide access to SI to saw cut and install pavement sensors Gantries and foundations (includes columns and trusses) A A A T to design and SI to construct. ev to provide access for T geotechnical borings and SI construction. Toll equipment mounts on gantries A A A SI to install any required equipment mounts on gantries. SI to coordinate with T during the design phase to incorporate any required framing to support equipment mounts. oncrete traffic barrier and foundation, MGF, barrier end treatments, Toll Zone drainage, SW3P and retaining walls within Toll Zone Roadside equipment cabinet concrete pads/foundations A A A All reinforcement (barrier, pavement, etc.) within the Toll Zone shall be epoxy coated. A A A T to design for SI to construct. ev to provide grading, earthwork and subgrade for SI s slabs. ev to provide SI access for construction. TEXAS EPARTMENT OF TRANSPORTATION FINAL RFP SH 99 GRAN PARKWAY SEGMENTS H, I-1, I-2 PAGE 21-3

5 LEGEN Toll s Responsibility Matrix Work escription oordination Responsibility Only FAILITIES Toll Zone maintenance driveways A A A T to design for SI to construct maintenance driveway pavement surface. ev to construct grading, earthwork and subgrade for SI work. Roadside equipment cabinets (incl power, comm and HVA systems) A A A SI to install complete. ev will coordinate access to. Toll rate signage A A A ev will coordinate access to. ELETRONI TOLL OLLETION SU-SYSTEMS (ET) Automatic Vehicle lassification and Image apturing (IS) Hardware omputer rack system, routers, hubs, switches, firewalls, VPN, modems, patch/distribution panels, A A A ev will coordinate access to. A A A ev will coordinate access to. Toll plaza host computer Lane controller hardware A A A ev will coordinate access to ommunication equipment A A A ev will coordinate access to. TEXAS EPARTMENT OF TRANSPORTATION FINAL RFP SH 99 GRAN PARKWAY SEGMENTS H, I-1, I-2 PAGE 21-4

6 LEGEN Toll s Responsibility Matrix Work escription oordination Responsibility Only ELETRONI TOLL OLLETION SU-SYSTEMS (ET) Support equipment at designated customer service center ommissioning and site acceptance testing A A A ev will coordinate access to roadway for testing Lane controller software Plaza computer Software Host computer software Toll collection system application software Maintenance Online Management Software Operational test A A A Training: (user and maintenance) ocumentation: (user and maintenance) ocumentation: ETS installation/electrical design and plans ocumentation: civil as-built drawings, and contract closeout documents TEXAS EPARTMENT OF TRANSPORTATION FINAL RFP SH 99 GRAN PARKWAY SEGMENTS H, I-1, I-2 PAGE 21-5

7 LEGEN Toll s Responsibility Matrix Work escription oordination Responsibility Only ocumentation: ETS as-built drawings F licenses/regulations as applies to toll systems TEXAS EPARTMENT OF TRANSPORTATION FINAL RFP PAGE 21-6 SH 99 GRAN PARKWAY SEGMENTS H, I-1, I-2