Setting up the virtual modem and the longdistance data transmission connection under Windows XP/2000

Transcription

1 GmbH Ansbacher Str. 2a D Zirndorf Tel: / Fax: / info@lucom.de Installing a new modem: Select Start - Settings - Control Panel - Phone and Modem Options and there "Modems - Add" tab. The wizard assisting you in setting up a new modem is started: Select Don't detect my modem. select: I will select it from a list. Netx Seite 1

2 Select your modem from the following window: (default modem type) -> default modem 33,600bps Next Select the interface on your PC to which your Lobix or Xcome is connected: COM1 or COM2 Next Finish The installation of your modem is thus completed. In the next step, the modem properties are set. Select Start - Settings - Control Panel - Phone and Modem Options and there select the new modem: Seite 2

3 "General" tab Make sure that Use this device (enable) is selected "Modem" tab: Select as the maximum transfer rate. "Diagnostics" tab: Nothing need be entered here. "Advanced" tab: Nothing need be entered here. "Driver" tab: Do not make any changes here. OK Installing the long-distance data transmission connection Select Start - Settings - Control Panel - New Connection Wizard: The wizard assisting you in establishing a new connection is started Next Seite 3

4 Select : Connection to the Internet Next Select : Connect using dial-up modem Next Select the modem you have just installed Next Seite 4

5 Assign the long-distance data transmission connection a name Next Enter any number Next Add a shortcut to this connection on my desktop Finish After setting up is completed, the connection to the IE-GPRS-I/O can be called directly by clicking on the shortcut on the desktop. To do so, the Internet Explorer need not be reconfigured. Seite 5

6 Call the connection to the Lobix Factory setting: User name: ( for Xcome = xcome for Lobix = ) Password: Save this user name and password fort he following users: Me only Proberties "General" tab: Make sure that only the previously installedd modem is selected. Proberties Modem configuration: bps Enable hardware flow control Enable modem error control Enable modem compression Enable modem speaker OK Seite 6

7 "Dialling Rules" tab My Location - The once selected location is displayed. OK "Options" tab Display progress while connecting Prompt for name and password, certificate, etc. Redial attempts: Time between redial attempts: Idle before hanging up: 3 1 minute 20 minutes Seite 7

8 "Security" tab Security options Typical Allow unsecured password No further checkboxes must be set "Network" tab Type of dial-up server I am calling: PPP Windows 95/98/NT4/2000 Internet Settings Enable LCP extensions OK Internet Protocol (TCP/IP) Properties Seite 8

9 "General" tab Obtain an IP address automatically Obtain DNS server address automatically Advanced.. Use default gateway on remote network PPP-Link: Use IP header compression must not be selected. Seite 9

10 "DNS" tab Append primary and connection specific DNS Suffixes Append parend suffixes of the primäry DNS Suffix Register this connection's addresses in DNS "WINS" tab Disable NetBIOS over TCP/IP must be set OK Back to "Properties of Lobix Seite 10

11 Advanced - Settings tab "On" must not be set! OK OK until all windows are closed. Seite 11