The novero car kits TheTrustyOne and TheTrulyOne are designed for easy installation and an attractive fit to all cars. This installation guide is written for professional installers to provide help on selecting the best installation method for a given car and to provide the car kit-specific information needed for the installation. It describes: The most common Where to install and how to connect the components of the car kit The pin-out of the car kit system cable The specific verification features of novero car kits. Updates and additional information will be made available at www.novero.com.
radio connectors (DIN/ISO) radio connectors (other) AUX-in for music AUX-in for phone & music separate speaker
radio connectors* (DIN/ISO) +12V negative ground only verify IGNS/VBAT signals select Radio Mute (CRM) cable Radio B A C *Same audio installation for phone and music
radio connectors* (other) Look for a suitable adapter between ISO connectors and the radio connectors of your car. These adapters are available from car, car stereo or adapter cable manufacturers. +12V negative ground only *Same audio installation for phone and music
1. Get audio cable with 3.5 mm stereo jack, e.g. from the car or car radio manufacturer. 2. Plug into main unit (auto-detection, no configuration needed). AUX Radio phone installation with system cable, as above
AUX-in for phone and music Phone: 1. Connect one speaker output of the car kit system cable (from ISO B connector) to the phone-in connector of your car radio. 2. Use the car kit system cable to connect power, ground, ignition (IGNS) and car radio mute (CRM). AUX Phone-in music as above _ where to find IGNS and CRM
1. Connect the speaker to a front speaker output. Use the ISO B connector of the car kit system cable, or cut the wires and connect the speaker directly. 2. Use the car kit system cable to connect power, ground, ignition and radio mute signals. +12V negative ground only _ where to find IGNS and CRM
1 1 * 2 2 2 ** 4 3 4 3 4 * Adjust microphone: point towards driver ** Only TheTrulyOne
* ** *Audio cable with 3.5 mm jack (not included) **Only TheTrulyOne
1. Check IGNS and +12V configuration in the reference document of your car stereo. If swapped, exchange red and blue cables at the fuses of the car kit system cable. 1 2 2. Check Radio Mute configuration in the reference document of your car stereo and connect cable with label Radio Mute with either Mute 1, Mute 2 or Mute 3. A1 A3 A5 A7 B1 B3 B5 B7 A2 A4 A6 A8 B2 B4 B6 B8 system cable pin-out _ read more swap detection _ read more
system cable pin-out A1 A3 A5 A7 A2 A4 A6 A8 A1 Mute1 D9 A2 Mute2 D10 A3 Mute3 D11 A4 IGN/VBAT D12 A5 - D13 A6 - D14 A7 VBAT/IGN D15 A8 GND D16 D1 D2 D3 D4 D5 D6 D7 D8 RR- Spkr RR+ Spkr RF- Spkr RF+ Spkr LF- Spkr LF+ Spkr LR- Spkr LR+ Spkr B1 B3 B5 B7 B2 B4 B6 B8 B1 B2 B3 B4 B5 B6 B7 B8 RR- Radio RR+ Radio RF- Radio RF+ Radio LF- Radio LF+ Radio LR- Radio LR+ Radio RR Spkr FR Spkr FL Spkr RL Spkr RL Radio FL Radio FR Radio RR Radio VBAT* GND 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 RR Spkr + FR Spkr + FL Spkr + RL Spkr + RL Radio + FL Radio + FR Radio + RR Radio + Radio Mute Ignition *+12V negative ground only
Check the car configuration: Select an installation method. Some require additional parts. Make sure you have these available. Car audio systems have different configurations for the radio mute signal. Check the reference document of your car stereo system. Car audio systems have different configurations for power and ignition signal. Check the reference document of your car stereo system. Caution: Unplug the battery before connecting the car kit. Do not install any component or cable in an airbag deployment area. Do not install a component in a head impact area.
1. Switch car kit on and off with ignition key. 2. Automatic detection of VBAT and IGNS swap will provide a warning: Alternating blinking 3. To correct, exchange red and blue cable at the fuse holder of the novero car kit system cable. + 30s
TheTrustyOne > 5s or Mono TheTrulyOne beep ringtone beep mic. test Radio mute & Settings 2s pause General settings Stereo General settings Audio test sequence left right left right No radio mute &
If the car does not provide an ignition signal connection at the car stereo connector, search for ignition signal at the cigarette lighter or switch for the lights of the car. Cable manufacturers offer adapters from DIN/ISO to many car-specific car radio adapters. There may also be dedicated cable harnesses for car/car kit combination. If there is no audio in case of usage of an adapter cable, check if the pins of the adapter cable are properly fitting inside the connector housing.
To update the software of the car kit, go to www.novero.com and download the novero software update tool. Please install it on a PC and then connect the car kit with a USB cable through the micro USB connector on the remote control. Please check www.novero.com for additional or contact the novero line.
Always have a qualified professional handle the installation or any repairs on your car kit. Please refer to the installation guide for more information. Make sure that the car kit components are fastened in places where 1. they are not close to an airbag or area where they could harm you in case of a collision 2. they are in arm s reach from the driver s seat 3. they do not impair the operation of the vehicle. Never try to dismantle the product yourself. None of the internal components can be replaced or repaired by users. Only authorized dealers or service centers may open the product. If any parts of your product require replacement for any reason, including normal wear and tear or breakage, contact your dealer. Keep out of reach of children. The plastic bags, which this product and its parts are wrapped in, are not toys for children. The bags themselves or the many small parts they contain may cause choking if ingested. ACA TS028 Ignition of flammable atmospheres: Do not use your car kit in environments with risk of ignition of flammable gases. Dispose of all product parts in accordance with local regulations. If in doubt, please consult your local or state authorities. The product must be taken to separate collection at the product end-of-life. Do not dispose components of this product as unsorted municipal waste. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of novero is prohibited. novero is a registered trademark. Other product and company names mentioned herein may be trademarks or trade names of their respective owners. novero products are trademarks or registered trademarks of novero GmbH. 2009 novero All rights reserved For more information, please go to www.novero.com