encor! enetworks TM Version A.4, January 2013 Document Part Number 16568.0000 2013 Encore Networks, Inc. All rights reserved. BANDIT, C2C, and VSR-1200 Document Set List of Groups and Modules The BANDIT, C2C, and VSR-1200 Document Set contains the following groups and modules. Note: For the list of documents in each module, see the Detailed List of Groups and Modules. Overview and Start-Up Group A. Document Information Module B. Product Overview Module C. Start-Up Module Hardware Group D. BANDIT Products General Reference Module E. C2C Reference Module F. BANDIT II C2C Reference Module G. BANDIT II Reference Module H. BANDIT III Reference Module I. VSR-1200 Reference Module Wireless Group J. Wireless Set-Up Module K. GPS Module Software Configuration Group L. Software Configuration Module M.Port Configuration Module N. Routing Module O. Address Translation Module P. Protocols Module Q. VPN Configuration Module For information on trademarks, safety, limitations of liability, and similar topics, see Notices.
Page 2 BANDIT, C2C, and VSR-1200 Document Set R. PCM Voice Network Module S. Special Network Considerations Module Management and Upgrade Group T. Software Management Module U. Statistics Module V. System Upgrade Module Detailed List of Groups and Modules Note: Each document is assigned to a home module. A document retains numbering for its home module regardless of its use in other modules. Overview and Start-Up Group A Document Information Module Title Page Notices Copyrights and Trademarks Publication Notice Hardware Compliance Safety Information Product Warranty Technical Support Limitation of Liability Conventions Where to Find BANDIT Product Documentation B Product Overview Module Home Contents of the Product Overview Module The BANDIT Device in the Network Basic Safety Guidelines Site Planning Worksheets Glossary Default Passwords
Detailed List of Groups and Modules Page 3 C Start-Up Module QuickStart Packages We strongly recommend that you review all documents listed under General Start-Up (below) before you install and configure the BANDIT devices. However, if quick installation is the principal concern, see the following QuickStart packages. C2C QuickStart Package BANDIT II C2C QuickStart Package BANDIT II QuickStart Package BANDIT III QuickStart Package VSR-1200 QuickStart Package General Start-Up If quick installation is the principal concern, see the QuickStart Packages (above). However, we strongly recommend that you review all documents listed here before you install and configure the BANDIT devices. In addition to the QuickStart Packages, the module contains the following documents: Home Contents of the Start-Up Module Comments Before Installation The following documents also contribute to a smooth installation: Basic Safety Guidelines Site Planning Worksheets Using FastCONNECT Using the ELIOS Software Activating a Wireless Card in a Cellular Carrier Network Note: We recommend reviewing all pertinent documentation in the BANDIT, C2C, and VSR-1200 Document Set in order to plan and prepare the site well. Hardware Group D BANDIT Products General Reference Module Home Contents of the BANDIT Products General Reference Module Unpacking the BANDIT Product and Preparing It for Installation Parts Lists for BANDIT Products Returning a BANDIT Product Using a Standard DC Power Connector with a BANDIT Chassis Using a Three-Pronged DC Power Connector with a BANDIT Chassis Supervisory Port Settings for the BANDIT Products
Page 4 BANDIT, C2C, and VSR-1200 Document Set Setting Up a Telnet Connection to a BANDIT Device Adjunct module: C2C Reference Module Adjunct module: BANDIT II C2C Reference Module Adjunct module: BANDIT II Reference Module Adjunct module: BANDIT III Reference Module Adjunct module: VSR-1200 Reference Module Also see the following related discussions: Changing the Card in a BANDIT Product s Expansion Slot Changing the SIM in a BANDIT Product s GSM Card Port Configuration Module Wireless Set-Up Module E C2C Reference Module Home Contents of the C2C Reference Module ATM Quick Configuration Guide C2C Overview C2C Office Set-Up Guide C2C Configuration Guide C2C Wake-Up Ping C2C Power-Loss Alarm C2C Hardware Description and Specifications Adjunct module: BANDIT Products General Reference Module F BANDIT II C2C Reference Module Home Contents of the BANDIT II C2C Reference Module BANDIT II C2C Overview BANDIT II C2C Quick Installation Guide Using a Three-Pronged DC Power Connector with a BANDIT Chassis BANDIT II C2C Standard Configuration Guide BANDIT II C2C Hardware Description and Specifications Adjunct module: BANDIT Products General Reference Module
Detailed List of Groups and Modules Page 5 G BANDIT II Reference Module Home Contents of the BANDIT II Reference Module BANDIT II Hardware Description BANDIT II Hardware Installation Guide Mounting the BANDIT II on a Utility Wall BANDIT II and BANDIT III Quick Configuration Guide BANDIT II Hardware Specifications BANDIT II LEDs Adjunct module: BANDIT Products General Reference Module Also see the following related information: Unpacking the BANDIT Product and Preparing It for Installation Using a Three-Pronged DC Power Connector with a BANDIT Chassis BANDIT II and BANDIT III Expanded Configuration Guide Wireless Set-Up Module H BANDIT III Reference Module Home Contents of the BANDIT III Reference Module BANDIT III Hardware Description BANDIT III Hardware Installation Guide Mounting the BANDIT III in an Equipment Rack BANDIT II and BANDIT III Quick Configuration Guide The Fiber Optic Card Installing and Configuring the Fiber Optic Card Configuring Alarm Ports in the BANDIT III Serial Port Security in the BANDIT III BANDIT III Hardware Specifications Adjunct module: PCM Voice Network Module Adjunct module: BANDIT Products General Reference Module Also see the following related information: Unpacking the BANDIT Product and Preparing It for Installation BANDIT II and BANDIT III Expanded Configuration Guide Changing the Card in a BANDIT Product s Expansion Slot
Page 6 BANDIT, C2C, and VSR-1200 Document Set Changing the SIM in a BANDIT Product s GSM Card Wireless Set-Up Module Port Configuration Module I VSR-1200 Reference Module Home Contents of the VSR-1200 Reference Module VSR-1200 and RDU Hardware Description VSR-1200 and RDU Installation and Configuration Guide Virtual Broadband Redundancy System VSR-1200 and RDU Hardware Specifications Adjunct module: BANDIT Products General Reference Module Also see the following related information: Unpacking the BANDIT Product and Preparing It for Installation Supervisory Port Settings for the BANDIT Products Wireless Group J Wireless Set-Up Module Home Contents of the Wireless Set-Up Module Wireless Cards for BANDIT Products CDMA Wireless Cards GSM Wireless Cards HSPA Activating a Wireless Card in a Cellular Carrier Network Activating an EVDO Wireless Card in a Cellular Carrier Network (Including the Sprint Data Link Network) Wireless Card Configuration Submodule: GPS Module Also see the following related information: Changing the Card in a BANDIT Product s Expansion Slot Changing the SIM in a BANDIT Product s GSM Card
Detailed List of Groups and Modules Page 7 K GPS Module Home Contents of the GPS Module GPS in the BANDIT Products Setting Up BANDIT Hardware for GPS Configuring the BANDIT s ELIOS Software for GPS Note: GPS is a submodule of the Wireless Set-Up Module. Software Configuration Group L Software Configuration Module Home Contents of the Software Configuration Module Using FastCONNECT Supervisory Port Settings for the BANDIT Products Starting the ELIOS Software Using the ELIOS Software Identifying the BANDIT Device in the Network Changing a Password Characters Used in Passwords Using the Syslog Feature Copying the BANDIT Configuration Customizing the System Login Banner For details of product configuration, see one of the following: C2C Reference Module BANDIT II C2C Reference Module BANDIT II Reference Module BANDIT III Reference Module VSR-1200 Reference Module Adjunct document: Loading Operating Software into a BANDIT Product Submodule: Wireless Set-Up Module Submodule: Port Configuration Module Submodule: Protocols Module Submodule: Routing Module Submodule: VPN Configuration Module Submodule: Special Network Considerations Module
Page 8 BANDIT, C2C, and VSR-1200 Document Set M Port Configuration Module Home Contents of the Port Configuration Module Ports in the BANDIT Products HD26 Serial Port Specifications HD26-to-Winchester V.35 Serial Connection Configuring and Routing Ports Defining Global Paths Physical Port Configuration Port Data Configuration Logical Ports Dial-Up Ports for Primary and Backup Links Note: Port Configuration is a submodule of the Software Configuration Module. Also review the wireless ports in the Wireless Set-Up Module. N Routing Module Home Contents of the Routing Module Routing Configuration IP Routing in the BANDIT Products Configuring the BANDIT for OSPF or BGP Sample Revision of the OSPF Configuration File Sample Revision of the BGP Configuration File Routing with Frame Relay X.25 Routing Routing with SNA IP/VPN Policy IP Quality of Service Common TCP/UDP Port Numbers The BANDIT Device as Firewall Generic Route Encapsulation Submodule: Address Translation Module Note: Routing is a submodule of the Software Configuration Module.
Detailed List of Groups and Modules Page 9 O Address Translation Module Home Contents of the Address Translation Module IP Addresses Network Address Translation Address Masquerading and Dynamic Network Address Translation Static Network Address Translation Port Address Translation Private Address Translation Address Translation Traversal Configuring Address Translation Comparison of Address Translation Methods Note: Address Translation is a submodule of the Routing Module. P Protocols Module Home Contents of the Protocols Module Configuration of Asynchronous Protocols Configuration of Synchronous Protocols Configuration of Burroughs Poll Select Protocols SDLC Protocol Configuration Configuration of IP-Based Protocols Point-to-Point Protocol Configuration Packet Assembly and Disassembly Protocols Configuration of the Airline Line Control Protocol Configuration of the CDC Protocol The RADIUS Protocol Note: Protocols is a submodule of the Software Configuration Module. Q VPN Configuration Module Home Contents of the VPN Configuration Module The BANDIT Products in Virtual Private Networks Configuring a BANDIT Product for Virtual Private Networks Revising a BANDIT Product s VPN Configuration Testing and Tracking VPN Connections IP/VPN Policy
Page 10 BANDIT, C2C, and VSR-1200 Document Set VPNC Scenario for IPsec Interoperability Scenarios for Operation with a VPN Client Note: VPN Configuration is a submodule of the Software Configuration Module. R PCM Voice Network Module Home Contents of the PCM Voice Network Module The BANDIT III in a PCM Voice Network The BANDIT III E&M Signaling Chassis Configuring the BANDIT III s E&M Card for a PCM Voice Network Configuring the BANDIT III s T1 E1 Card for a PCM Voice Network Specifications for the Four-Wire E&M Card Table of DIP Switch Settings for the Four-Wire E&M Card Changing the DIP Switch Settings on the Four-Wire E&M Card Note: PCM Voice Network is an adjunct module of the BANDIT III Reference Module. S Special Network Considerations Module Home Contents of the Special Network Considerations Module Support for SCADA RTUs The Config Server Note: Special Network Considerations is a submodule of the Software Configuration Module. Management and Upgrade Group T Software Management Module Home Contents of the Software Management Module System Management Using the Telnet Protocol in a BANDIT Product Using SNMP in the BANDIT Products Port Data Capture ILR-100/SignalPath Quick Setup Guide Setting a BANDIT Device Up as a Terminal Server (Expanded Guide) Special adjunct document: Remote Access to SignalPath Devices 1 1. This document is from Encore Networks Signaling Documentation.
Detailed List of Groups and Modules Page 11 Adjunct document: Loading Operating Software into a BANDIT Product Submodule: Statistics Module U Statistics Module Home Contents of the Statistics Module Monitoring Statistics for a BANDIT Product General Unit Statistics Fiber Optic Statistics Logical Port Statistics IP Statistics ICMP Statistics SNMP Statistics TCP Statistics UDP Statistics Modem Statistics Network Loader Statistics Statistics for the Airline Line Control Protocol VPN Statistics Syslog Statistics Note: Statistics is a submodule of the Software Management Module. V System Upgrade Module Home Contents of the System Upgrade Module Changing the Card in a BANDIT Product s Expansion Slot Changing the SIM in a BANDIT Product s GSM Card Loading Operating Software into a BANDIT Product Reference Chart of Active and Inactive Software Code Regions Also see Basic Safety Guidelines
Page 12 BANDIT, C2C, and VSR-1200 Document Set