57cm Kettle Charcoal Grill Model# SRCG13007 User Manual
WARNING FOR YOUR SAFTY W A R N I N G CARBON MONOXID HAZARD BURNING CHARCOAL RLASS CARBON MONOXID WHICH HAS NO ODOR AND CAN CAUS SRIOUS INJURY OR DATH. NVR BURN CHARCOAL INSID HOMS, VHICLS OR TNTS. W A R N I N G PLAS CARFULLY RAD ALL SAFTY, ASSMBLY AND USAG PROCDURS CONTAIND IN THIS OWNR S MANUAL BFOR USING YOUR BARBCU GRILL. FAILUR TO FOLLOW SAFTY GUIDLINS CAN RSULT IN SRIOUS PRSONAL INJURY AND/OR PROPRTY DAMAG. 1. This grill is for outdoor use only, and shall not be used in a building, garage, or any other enclosed area. 2. This NOT for commercial use. 3. Do not use grill for indoor cooking or heating. Toxic carbon monoxide fumes can accumulate and cause asphyxiation. 4. Do not use lighter fluid, paraffin, or alcohol for lighting. 5. Do not use in an explosive atmosphere. Keep grill area clear and free from combustible materials, lighter fluid and other flammable vapors and liquids. 6. Do not store or use lighter fluid or other flammable liquids or vapors within 25 feet (7.62 m) of this appliance. 7. Instant light charcoal can burn at very high temperatures during initial startup. Make sure lid is open until charcoal turns to hot coals. 8. Keep all combustible items and surfaces at least 21 inches (53 cm) away from the grill at all times. DO NOT use this grill or any gas product under any overhead or near any unprotected combustible constructions. 9. Do not alter grill in any manner. 10. Do not use the grill unless it is completely assembled and all parts are securely fastened and tightened. 11. This grill should be thoroughly cleaned and inspected on a regular basis. 12. Do not use this appliance without reading Operating Instructions in this manual. 13. Do not touch metal parts of grill until it has completely cooled (about 45 min after use) to avoid burns, unless you are wearing protective gear (pot holders, gloves, grill mittens, etc.). 14. Never touch grates (charcoal or cooking), ashes, or coals to see if they are hot. 15. Do not use on wooden decks, wooden furniture, or other combustible surfaces. 16. Do not use in or on boats or recreational vehicles. 17. Position grill so wind can not carry ashes to combustible surfaces. 18. Do not use in high winds.. Never lean over the grill when lighting. 20. Do not leave a lit grill unattended, especially keep children and pets away from grill at all times. 21. Do not attempt to move grill when in use. Allow the grill to cool before moving or storing. 22. Always open grill lid carefully and slowly as heat and steam trapped within grill can severely burn you. 23. Always place your grill on a hard, non-combustible level surface. An asphalt or blacktop surface may not be acceptable for this purpose. 24. Do not remove the ashes until they are completely and fully extinguished. 25. Live hot briquettes and coals can create a fire hazard. 26. Always empty the ash catcher and grill after each use. Do not remove the ashes until they are completely and fully extinguished. 27. Do not place fuel (charcoal briquets, wood or lump charcoal) directly into bottom of grill. Place fuel only on the charcoal pan/grid. 28. Check to make sure the air vents are free of debris and ash before and while you are using the grill. 29. Make sure ash catcher is securely and completely in place before using the grill. 30. Always wear protective gloves when adding fuel to retain desired heat level. 31. Keep all electrical cords away from a hot grill. 32. Always use a meat thermometer to ensure food is cooked to a safe temperature. 33. The handle is used for pushing and pulling the cooking grid only, and should always be detached from the cooking grid when fire is on. 34.The hot cooking grid can only be operated by handle provided. 35. Do not touch the hot cooking grid by hand. 36.The handle should always be kept away from the cooking grid when the grill is burning. 37. Attention! This grill will become very hot. Do not move it during operation. 38. Caution! Do not use lighter fluid or comparable fluids for lighting or re-lighting! 39. Property damage, serious injury, or death may occur if the above is not followed exactly.
xploded View 25 13 21 1 2 11 3 4 12 28 5 27 24 26 6 7 8 18 14 17 16 15 23 22 20 9 10 1. Thermometer 2. Lid 3. Lid handle 4. Cooking grid 5. Charcoal grid 6. Bowl handle 7. Leg support bracket 8. Leg cup 9. Front leg 10. Storage shelf 11. Lid hinge(pre-installed on lid) 12. Warming rack 13. Bowl hinge(pre-installed on bowl) 14. Bowl air vent 4 pcs 4 pcs 2 pcs 15. Ash cup support ring 16. Ash cup 17. Wheel Leg 18. Wheel. Fire bowl 20. Air vent handle 21. Thermometer back plate 22. Ash cup handle 23. Wheel cap 24. Grill cover 25. Lid air vent 26. Left side table assembly 27. Right side table assembly 28. Hooks 2 pcs 2 pcs 2 pcs
Hardwares List Parts No. Description Qty Parts No. Description Qty A M6X30 Bolts (pre-installed on legs) 4 pcs J M6 nut 8 pcs B M6X12 Bolt 8 pcs K M5 Nut 3 pcs C M5X12 Bolt 4 pcs L Pin D M8 Washer (pre-installed on thermometer) M M8 Wing nut (pre-installed on thermometer) M6 Large washer (4pcs preinstalled on legs) 16 pcs N Φ10 Bolt F M6 Fibre washer 8 pcs O M6 Connecting rod G M6 Small washer 5 pcs P M6 Wing nut 6 pcs H I M8 Locking nut M6 Locking nut 2 pcs Q R S M5 Wing nut M6X20 Bolt M6X15 Bolt 4 pcs 4 pcs ATTNTION: CHCK ALL PARTS BFOR ASSMBLY PRIOR TO INSTALL TH ABOV PARTS BFOR START TH FOLLOWING ASSMBLY STPS Tools Required Phillips Head Screwdriver (Not included) Adjustable Wrench (Not included)
Step 1 a. Install the (3) lid handle to the (2) lid with (P) M6 wing nuts and () M6 large washers. 3 P 2 b. First unscrew the (M) M8 wing nut and (D) M8 washer, which have been pre-installed on the (1) thermometer.install the (1) thermometer and (21) thermometer back plate to the (2) lid with (D) M8 washer and (M) M8 wing nut. 1 2 21 D M c. Attach the (25) lid air vent to the (2) lid with (C) M5 x 12 bolt, (Q) M5 wing nut and (G) M6 small washer. C 25 2 C M5x12 Bolt G Q D M8 Washer M6 Large washer G M6 Small washer M M8 wing nut P M6 Wing nut Q M5 Wing nut
Step 2 a. Install the (6) bowl handle to the () fire bowl with (P) M6 wing nuts and () M6 large washers. 6 P b. Install the (15) ash cup supporting ring to the () fire bowl bottom with 3pcs (C) M5X12 Bolts and 3pcs (K) M5 nuts. C 15 K C M5X12 Bolt 3pcs M6 Large washer K M5 Nut 3pcs P M6 Wing nut
Step 3 a. Put (N)Φ10 bolt through the center holes of the () fire bowl bottom and (14) bowl air vent. N L 15 20 14 Bowl air vent support b. Fix the (14) bowl air vent to the () fire bowl bottom by inserting the (20) air vent handle through the hole of (15) ash cup support ring, the two holes of (14) bowl air vent supports and the center hole of (N)Φ10 bolt bottom as illustration shown, then insert the (L) pin to the hole of the (20) air vent handle. L N 20 L Pin N Φ10 Bolt
Step 4 Install the (22) ash cup handle to the (16) ash cup with (P) M6 wing nuts and 4pcs (G) M6 small washers. P G G 22 G M6 small washer 4pcs P M6 Wing nut 16 Step 5 Lock the 3pcs posts on the (16) ash cup into the (15) ash cup support ring. 15 16 post Step 6 Install 4pcs (7) leg support brackets to the () fire bowl bottom with 8pcs (B) M6X12 bolts and 8pcs (F) M6 fibre washers and 8pcs (J) M6 nuts. J 7 F B B M6X12 Bolt 8pcs F M6 Fibre washer 8pcs J M6 Nut 8pcs
Step 7 a. Attach the 4pcs (8) leg cups to the 4pcs legs. 8 b. First unscrew the 4pcs(A) M6X30 bolts and 4pcs () M6 large washers, which have been pre-installed on the (9 &17)four legs. Connect the four legs (9&17) to the () fire bowl by inserting the four legs top ends to the 4pcs (7) leg support brackets with 4pcs (A) M6X30 bolts and 4pcs () M6 large washers. Make sure the 4pcs (A) M6x30 bolts are not fully tightened. Note: Make sure the two (17) wheel legs are at the same side of (13) bowl hinge. See finished illustration. A 13 7 17 9 c. Insert two ends of (10) storage shelf without threads into the holes of the (9) front legs. 9 18 10 17 A M6X30 Bolts 4pcs M6 large washer 4pcs
d. Insert two ends with thread of the (10) storage shelf into the holes of the (17) wheel legs and (18) wheels, and tighten with (H) M8 locking nuts. Then attach the (23) wheel caps onto the (18) wheels.then tighten the 4pcs(A) M6x30 bolts in step 7b. 18 23 10 H H M8 Locking nut 11 Step 8 Install the lid assembly to the fire bowl assembly by connecting the (11) lid hinge and (13) bowl hinge with (O) M6 Connecting rod and (I) M6 locking nut. O 13 I I O M6 Locking nut M6 Connecting rod
Step 9 a. Install the (26) left side table assembly to the () fire bowl with (S) M6x15 bolts, (R) M6 x20 bolts and 4pcs ( ) M6 large washers. S R S 26 R R S M6 Large washer M6X20 Bolt M6X15 Bolt 4pcs b. Install the (27) right side table assembly to the () fire bowl with (S) M6x15 bolts, (R) M6 x20 bolts and 4pcs ( ) M6 large washers. 27 S R M6 Large washer 4pcs R S M6X20 Bolt M6X15 Bolt NOT: MAXIMUM WIGHT ON SID TABL: 4.5 KGS/9.9 LBS
Step 10 a. Place the (5) charcoal grid, (4) cooking grid into () fire bowl in order as shown, then fix the (12) warming rack to the (2) lid and () fire bowl. 12 2 4 5 b. Hang the (28) hooks onto the () fire bowl. 28 28
Step 11 Table Operation a. To lower side table, lift the side table up slightly, and flip down as shown. b. To raise side table, flip up and push down slightly to position, proceed as shown.
asy access grate for refilling charcoal cooking grid
Operating lnstructions WARNING For Your Safety 1. The handle is used for pushing and pulling the cooking grid only, and should always be detached from the cooking grid when fire is on. 2. The hot cooking grid can only be operated by handle provided. 3. Do not touch the hot cooking grid by hand. 4. The handle should always be kept away from the cooking grid when the grill is burning. This appliance is designed for use only with quality charcoal briquette, lump charcoal and cooking wood. Attention! This will become very hot. Do not move it during operation. Do not use indoors! Caution! Do not use, lighter fluid or comparable fluids for lighting or re-lighting! Warning! Keep children and pets away. Lighting 1. Open lid and vents. 2. Make sure ash cup is empty. 3. Remove cooking grid. 4. Arrange and light fuel per instructions on fuel package. Direct Cooking 1. While wearing protective gloves, carefully spread coals evenly across grid with a long handle tool. 2. Carefully replace cooking grid. 3. Place food on cooking grid. 4. Cook with lid open or closed. Indirect Cooking Ideal for Roasts 1. While wearing protective gloves, carefully spread coals into a donut shape with a long handle tool. 2. Place a metal tray in center of donut to catch drippings 3. Carefully replace cooking grid. 4. Place food on cooking grid directly over the metal pan. 5. Cook with lid closed. Tips for Better Cookouts and Longer Product Life 1. Store fuel in a waterproof container away from sources of ignition. 2. Use a charcoal chimney for fast and easy startups. 3. Spray or coat cooking surfaces with vegetable oil before cooking to avoid sticking. 4. Place vegetables or delicate foods into aluminum foil pouches. 5. Use a quality grill brush after each event to keep cooking surfaces clean and rust free. 6. Remove all ash and dispose of properly after each use. 7. Once grill is cool, cover with a quality grill cover that is properly sized to your unit. Cleaning and Care Caution: 1. All cleaning and maintenance should be done when grill is cool. 2. DO NOT clean any grill part in a self-cleaning oven. The extreme heat will damage the finish. 3. Abrasive cleaners will damage this product. 4. Never use oven cleaner to clean any part of grill. Cleaning Surfaces 1. Wipe surfaces clean with mild dishwashing detergent or baking soda. 2. For stubborn surfaces use a citrus based degreaser and a nylon scrubbing brush. 3. Rinse clean with water. Direct cooking Indirect cooking 3-4cm of coals Charcoal Rails