QCapture Pro 7 Removing Problem Windows Update

QCapture Pro 7 Removing Problem Windows Update Purpose On trying to start QCapture Pro 7, an error was observed with the following messages where the program would not start at all. On Windows 7 (64-bit): On Windows XP (SP3): This issue was found to be caused by a Windows 7 automatic update. This was observed on Windows 7 64-bit versions and Windows XP (SP3) with updates as of January 10, 2013. This document describes the steps to remove the problem update as a temporary workaround on a Windows 7 and Windows XP computers. NOTE: When an update is removed, the next time Windows searches for updates, the same update will be marked for download and installation. So this uninstall procedure may be needed again if another automatic update is completed. It s recommended to disable automatic updates or keep the computer offline until there is long term solution. This will avoid having the problem update reinstall. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 1 of 16.

Relevant Updates The specific Windows updates that cause the issue is different on the different versions of Windows. See the following table for the relevant update(s) for the version of Windows you are using. Please note the update(s) to remove for the version of the operating system you are using. Then go to the relevant section for the removal procedure. Operating System Microsoft.NET Framework Version Windows Update to Remove Windows 7 32-bit Microsoft.NET Framework 3.5.1 Windows update KB2742598 Microsoft.NET Framework 4 Windows update KB2742595 Windows 7 32-bit SP1 Microsoft.NET Framework 3.5.1 Windows update KB2742599 Microsoft.NET Framework 4 Windows update KB2742595 Windows 7 64-bit Microsoft.NET Framework 3.5.1 Windows update KB2742598 Microsoft.NET Framework 4 Windows update KB2742595 Windows 7 64-bit SP1 Microsoft.NET Framework 3.5.1 Windows update KB2742599 Microsoft.NET Framework 4 Windows update KB2742595 Windows XP SP3* Microsoft.NET Framework 2 Windows update KB2742596 Microsoft.NET Framework 4 *Windows XP SP3 systems with Microsoft.NET Framework 3.X should not be impacted. Windows update KB2742595 Windows 7 Removal Procedure Page 3. Windows XP Removal Procedure Page 10. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 2 of 16.

Update Removal Procedure Windows 7 1) Go to the Control Panel and select System. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 3 of 16.

2) Please take note if Service Pack 1 is installed. It will be indicated just below the Microsoft copyright information. If it s not indicated, then it s not installed. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 4 of 16.

3) Go to the Control Panel and select Windows Update. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 5 of 16.

4) From the Update screen click on View Update History. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 6 of 16.

5) At the top of the list of updates click on see Installed Updates. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 7 of 16.

6) Depending on whether you have the Windows Service Pack 1 installed, you will need only to do A or B following (not both): A) If you have Service Pack 1 installed, click on the update numbered KB2742599 to select it and the line should be highlighted. B) If you do NOT have Service Pack 1 installed, click on the update numbered KB2742598 to select it and the line should be highlighted. C) Click on Uninstall to uninstall the update. Click here to uninstall Select only one update numbered: KB2742599 for Service Pack 1 or KB2742598 QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 8 of 16.

7) When prompted to uninstall click on Yes, then a wait prompt will appear while the update is removed. This may take a few minutes. 8) In the Update list as shown in step 6 above, click on the update numbered KB2742595 to select it and the line should be highlighted. Click on Uninstall to uninstall the update. Click on Yes when prompted to uninstall this update. This may take a few minutes to complete. 9) Once the update is uninstalled and the wait prompt disappears, close the Control Panel window and QCapture Pro 7 should start as expected. [This completes the removal procedure for Windows 7] QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 9 of 16.

Update Removal Procedure Windows XP 1) Go to the Control Panel and select Add or Remove Programs. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 10 of 16.

2) Check the Show updates check box to list all updates. The list may take some time to refresh. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 11 of 16.

3) Click on the update numbered KB2742596 under the Microsoft.NET Framework 2.0 heading to select it and the item will highlight. Click the Remove button. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 12 of 16.

4) When prompted to remove the update, click Yes and a wait prompt will be displayed while the update is uninstalled. This may take some time. Once the uninstall is complete you will be returned to the updates list. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 13 of 16.

5) On the udpates list, clikc on the update numbered KB2742595 under the Microsoft.NET Framework 4 Client Profile to select it and the item will highlight. Click the Remove button. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 14 of 16.

6) When prompted to remove the update, click Next and a wait prompt will be displayed while the update is uninstalled. This may take some time. QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 15 of 16.

7) Click Finish to close the uninstall complete notification window when appears. 8) Close the Control Panel window and QCapture Pro 7 should start as expected. --- [This completes the removal procedure for Windows XP] QCapture Pro 7 - Removing Problem Windows update.docx Jan 14, 2013 Page 16 of 16.