Safety Safety Is Your Responsibility DANGER To avoid personal injury or death, carefully read and understand all instructions pertaining to the Anthony Liftgates product. Do not attempt to install, operate, or maintain our product without fully understanding all our instructions and safety precautions. Do not operate or work on a truck or liftgate unless you have read and understand all of the instructions and warnings in the Installation, Operation, and Maintenance manual. If any doubt or question arises about the correct or safe method of performing anything found in this or other manuals from Anthony Liftgates, contact your Anthony Liftgates dealer or call the Inside Sales and Service representatives at our main headquarters (85-84-3383). Proper care is your responsibility. Anthony Liftgates cannot anticipate every possible circumstance that might involve a potential hazard. The warnings in this manual and on the product itself are, therefore, not all inclusive. If tools, procedures, work methods, or operating techniques that are not specifically mentioned by Anthony Liftgates are used, you must satisfy yourself that it is safe for you and for others. Make sure the product or truck the liftgate is mounted onto will not be damaged or made unsafe by any operation, lubrication, maintenance, or repair procedures that you choose. DO NOT proceed if any doubt arises about the correct or safe method of performing anything found in this or other Anthony Liftgates manuals. Seek out expert assistance from a qualified person before continuing. The parts illustrated in the parts drawings are representative of typical parts used in the actual liftgate and may not look exactly like the part(s) on your liftgate. Part numbers and drawings are subject to change without notice. At the bottom of each page is the Anthony Liftgates Inc. Product Support phone number.. Installation, Operation, Troubleshooting, and Maintenance manual for LA-86 Model Liftgate, Form Number L-60.. Parts manual for LA-86 Model Liftgate, Form Number L-60P. Ordering Parts General Information DANGER Most accidents involving the operation, maintenance, or repair of products made by Anthony Liftgates occur because the owner/operator failed to observe basic safety rules or operating instructions. An accident can often be avoided by being alert and recognizing potentially hazardous situations. Any individuals operating, maintaining, or repairing products manufactured by Anthony Liftgates should have the necessary training, skills, and tools required to perform the functions properly and safely. The safety information in this manual serves as a basic guide in an attempt to prevent injury or death. We manufacturer a quality liftgate that requires very little maintenance or repair. However, should a part break or become damaged, our knowledgeable staff can make sure you receive the part(s) to put your liftgate back into operation. Contact Information For replacement decals, questions, or to order parts, contact: Anthony Liftgates, Inc. 03 West Howard Street Pontiac, Illinois 664 (85) 84-3383 www.anthonyliftgates.com 85-84-3383 3 Anthony Liftgates, Inc.
Serviceable Parts for LA-86 Base Assembly Item Part No. Description Quantity A-50889 Cover, Power Unit A-5059 Screw, Flanged Self-Tapping 4 3 A-5096 Liftbody Weldment 4 A-5086-L Latch Plate - Streetside (left) 5 A-5086-R Latch Plate - Curbside (right) 6 66 Lock Washer, 5/6 4 5434 Hex Bolt, 5/6-8 x 3/4 long, Grade 8 4 8 A-5069 Nylon Pad (/8" x -/" x 5-/8") 9 A-3090 Rivet, Stainless Steel, /4 diameter 6 0 54 Grease Fitting (straight, zerk) 6 A-50060 Retaining Ring, A-5006 Lifting Arm 3 A-44054 Flat Washer, 4 A-5006 Grommet, -/ ID 4 5 A-5066 Bushing, Spacer, -/ OD x ID 6 A-505 Cover (Power Unit) A-303 Screw, Button Head Allen, Stainless Steel, 5/6-8 x 34 long 4 8 A-580 Grommet, /6 ID 4 9 A-5063 Chain and Hook Assembly, Consists of: A-5098, S-Hook A-50069, Chain A-50068, Hairpin Cotter 0 A-50946 Plate A-3030 Rivot, Aluminum, 3/6 diameter 6 ATU-59 Bolt - Carriage, 3/8-6 x -/ long, Grade 8 (only used with bolt-on application) 5 Anthony Liftgates, Inc. 4 85-84-3383
0 Amp Fuse Holder 3 4 6 0 4 8 8 9 5 3 5 0 9 4 6 4 0 85-84-3383 5 Anthony Liftgates, Inc.
Serviceable Parts for LA-86 Platform Assembly Item Part No. Description Quantity 54 Grease Fitting (straight, zerk) 6 A-50060 Retaining Ring 6 3 A-44054 Flat Washer 4 A-504 Pin - Connecting Plate (-3/6" long) 5 A-50 Connecting Plate - Streetside (left) 6 A-303 Screw, Button Head Allen, Stainless Steel, 5/6-8 x 34 long 6 66 Lock Washer, 5/6 6 8 A-500 Platform Stop Angle Plate 9 A-500 Connecting Plate - Curbside (right) 0 A-5006 Cotter Pin A-50065 Flat Washer, / A-50066 Spring 3 A-506 Cable Assembly, Platform Latch 4 A-50 Torsion Bar 5 A-305 Set Screw, 3/8-6 x / long 6 09 Bolt, 3/8-6 x long 054 Lock Washer, 3/8 8 SG-0 Platform (85 x 4 + 6) 9 45 Bolt, Flange, 5/6-8 0 A-5090 Guide, Spring A-509 Spring A-50903 Cart Stop Latch 3 A-50904 Cart Stop Latch Spring 4 6608 Bolt, 5/6-8 x long Anthony Liftgates, Inc. 6 85-84-3383
8 3 6 4 5 4 5 6 6 8 9 3 0 4 8 9 4 0 3 0 85-84-3383 Anthony Liftgates, Inc.
Serviceable Parts for LA-86 Hydraulic System Item Part No. Description Quantity A-50060 Retaining Ring, 8 A-5043 Pin - Upper Cylinder 3 A-50963 Hydraulic Lift Cylinder A-3035 Seal Kit, Hydraulic Cylinder 4 54 Grease Fitting (straight, zerk) 4 5 A-5044 Pin - Lower Cylinder 6 A-306 Fitting, Barbed Return Vent A-060 Stainless Steel Hose Clamp (/3" MIN. - 5/8" MAX.) 4 8 A-506 Air Return (vent) Hose (one 80 and one 64 ) 9 A-3009 Fitting, Tee, Barbed Return Vent 0 A-5000 Valve - Flow Control (.5 pgm) A-308 Hose, High-Pressure Hydraulic A-305 Fitting, Tee, High-Pressure 3 A-3089 Fitting, High-Pressure Swivel 4 A-30033 Fill Cap, Vented 5 A-306 Power Pack Volt DC (Monarch/Bucher) 6 64 Bolt, 3/8 x 3/4 lg. A-305 Bolt, M0 x.5 0 mm long 054 Lock Washer, 3/8 A-305 Lock Washer, 0 mm 8 058 Flat Washer 3/8 9 A-30063 Plug Anthony Liftgates, Inc. 8 85-84-3383
3 6 6 4 0 8 0 4 4 5 3 4 4 5 8 9 9 4 5 6 8 85-84-3383 9 Anthony Liftgates, Inc.
Serviceable Parts for LA-86 Electrical System Item Part No. Description Quantity A-3309 Power Cable, 4 Gauge, with 00 Amp Fuse Assembly A-350 Toggle Switch Assembly (Up & Down) with Recessed Switch Plate A-50455 Recessed Switch Plate - Steel (only) A-5043, Fuse Holder A-50438, Fuse, 0 Amp A-300, Decal, Fuse Holder 3 A-5009 License Plate Light 4 AR-8-54 Light - Clear, Back-up (w/grommet & wiring harness) 5 AR-8-53 Light - Red, Stop, Tail & Turn (w/grommet & wiring harness) 4 6 A-50465 Connector, Electrical Wire, Back Up and Tail Lights As Required A-3306 Fuse Holder Assembly 8 A-33048 Rubber Boot, Seal 9 A-33063 Fuse, 50 Amp 0 A-3036 Decal, Fuse Change Procedure Anthony Liftgates, Inc. 0 85-84-3383
0 Amp Fuse Holder View fuse through clear fuse holder, if blown, replace as follows: Liftgate fuse changing procedure. Warning! To avoid injury, disconnect the liftgates power from the battery(ies) before replacing the fuse, or before disassembling the fuse holder. Do not ignore this warning or an "arc" can occur and personal injury or property damage could result.. Pull back rubber boots from fuse holder.. Unscrew the fuse holder ends from the fuse holder body and pull apart. 3. Slide the fuse holder body one direction (left or right) to expose the blown fuse. 4. Loosen screw from each end of fuse, remove and replace 50 AMP fuse. Tighten screws. 5. Re-assemble in reverse order. Be sure the rubber boots seal around the fuse holder and cable. 6. Re-connect power after you are certain liftgate area is clear. Note: Check for spare fuse in liftgate manual packet. If fuses continue to blow contact a qualified mechanic to remedy the problem. 50 lb. MAXIMUM CAPACITY 8 5 6 4 3 9 0 85-84-3383 Anthony Liftgates, Inc.
Serviceable Parts for LA-86 Decals Item Part No. Description Quantity ATU-46 Decal - Stand Clear (shipped loose for attachment to vehicle) AR-8-6 Decal - Caution: Pinch Point 3 99840 Decal, Anthony 4 A-5060 Decal - Made In America 5 A-306 Decal, Zero Leak Concept 6 A-3065 Decal - Maximum Capacity 900# (shipped loose for attachment to vehicle) A-33 Decal - Operation (shipped loose for attachment to vehicle) 8 Q-00303 Decal - Urgent Warning (shipped loose for attachment to vehicle) 9 A-30 Decal - Disengage Latch (shipped loose for attachment to vehicle) 0 A-308 Decal - Weld Warning (shipped loose for attachment to vehicle) A-5038 Decal - Notice, Circuit Protection (shipped loose for attachment to vehicle) ATU-4 Decal - Secure Latch (shipped loose for attachment to vehicle) NS A-3036 Decal, Heavy Plastic - Fuse Changing Procedure (attached to power cable) NS A-5088 Decal Kit and Instruction Package (contains all decals and Operation Manual) 6 8 9 0 4 5 3 Anthony Liftgates, Inc. 85-84-3383
Serviceable Parts for LA-86 A-306 Power Unit Item Part No. Description A-5008 Motor ATU-0 Motor Start Solenoid 3 A-30 Lowering Valve with Coil 4 ATU-585 Lowering Coil 5 A-3056 Pump 6 A-50635 Plastic Reservoir A-30033 Plastic Reservoir Cap 8 A-5005 Suction Filter 9 A-5009 O-ring for Plastic Reservoir 0 ATU-565 Clamp, Plastic Reservoir A-5006 Suction Tube 3,4 5 6 0 9 8 85-84-3383 3 Anthony Liftgates, Inc.
NOTES Anthony Liftgates, Inc. 4 85-84-3383