Cat Electronic Technician 2015A v1.0 Product Status Report 6/3/2015 4:41 PM



Similar documents
Cat Electronic Technician 2015C v1.0 Product Status Report 2/20/2016 4:34 PM

Cat Electronic Technician 2015A v1.0 Product Status Report 4/20/2016 2:49 PM

Cat Electronic Technician 2015C v1.0 Product Status Report 2/16/2016 9:19 AM

Cat Electronic Technician 2015A v1.0 Product Status Report 6/22/2015 3:34 PM

Cat Electronic Technician 2015A v1.0 Product Status Report 4/22/2015 5:01 PM

Cat Electronic Technician 2015A v1.0 Product Status Report 9/11/ :26 AM

Cat Electronic Technician 2015A v1.0 Product Status Report 3/15/2015 9:34 AM

THERMO KING TRUCK & TRAILER UNIT ALARM CODES THIS DOCUMENT SHOWS ALL CURRENT ALARM CODES FOR THERMO KING TRUCK AND TRAILER UNITS.

Electrical Systems - IQAN Digital Control System. IQAN Control System Components

IQAN MDM Operation Manual

Fault codes DM1. Industrial engines DC09, DC13, DC16. Marine engines DI09, DI13, DI16 INSTALLATION MANUAL. 03:10 Issue 5.0 en-gb 1

Note: This information obtained from internet sources and not verified- use at your own risk!!!!

Signature and ISX CM870 Electronics

Diagnostic Fault Codes For Cummins Engines

Asking Price: N/A Final Price: N/A OROPS BUCKET AUXILIARY HYDRAULICS GENERAL APPEARANCE. Good. Good

ACCUMULATOR INSTALLATION

301.7D. Mini Hydraulic Excavator

Introduction to Electronic Signals

C18 ACERT Fire Pump Tier bkw/ rpm

303.5E CR, 304E CR, 305E CR, 305.5E CR

830-II *330492* Cummins 4 Cylinder Engine Breakdown Rev. 00

Service Manual Trucks

304C CR Mini Hydraulic Excavator

CDS TROUBLESHOOTING SECTION I. VACUUM Weak vacuum at wand. Gauge reads normal (10hg to 14hg)

303.5C CR Mini Hydraulic Excavator

Energy Recovery System for Excavators Meng (Rachel) Wang, Chad Larish Eaton Corporation

DTC P1271/78 FUEL PRESSURE REGULATOR CIRCUIT MALFUNCTION (OPEN/SHORT) DTC P1272/78 FUEL PRESSURE REGULATOR SYSTEM MALFUNCTION

Basic Symbols. Lines. Circular. Square. Diamond. Miscellaneous Symbols. -continuous line - flow line. -dashed line - pilot, drain

308E CR SB. Mini Hydraulic Excavator with Swing Boom

Signature and ISX CM870 Fuel System

USER MANUAL OPERATION AND USE OF CAR WITH. Diego G3 / NEVO SEQUENTIAL GAS INJECTION SYSTEM

Diesel Engine Driven Generators Page 1 of 6

Kobelco Extended Warranty Program.

Centro-Matic Automatic Lubrication Systems System Controls

DTC Database (OBD-II Trouble Codes)

Schematic Symbols Chart (Design Hydraulic and Pneumatic circits)

Diagnostic Trouble Code (DTC) Charts

307E. Mini Hydraulic Excavator. Standard Bucket Size 0.33 m 3 Engine Model Cat C2.6 DI Turbo. Weights

net flywheel power 74 kw - 99 hp max operating weight kg PAT DOZER BLADE CAPACITY 2.19 m 3

Service Information Trucks

The Secret of Hydraulic Schematics. BTPHydraulics

RH 12.5 RH Crawler Excavator Specifications

E08 E10. Compact Excavators

E - THEORY/OPERATION

Electronically Controlled Clutchless or Variable Drive Compressors

Operational Overview and Controls Guide. Two or Three Pump IronHeart Lite with Variable Frequency Drives

Mini Hydraulic Excavator

Cooling system components, removing and installing

ON-Board Diagnostic Trouble Codes

TOYOTA ELECTRONIC CONTROL TRANSMISSION

Indoor coil is too warm in cooling mode or too cold in heating mode. Reversing valve or coil thermistor is faulty

303.5E2 CR, 304E2 CR, 305E2 CR, 305.5E2 CR

May, ArACBMENT I. Review of. Diesel Generator Alan and Control Circuitry. Indian Point Units No. 2 and 3. Docket Nos.

SAS light Check Engine Malfunction Indicator Lamp

TECHNICAL DATA 50HZ MPMC POWERTECH CORP. DIESEL GENERATING SET

Wynn s Extended Care

Providing Answers For All Your Machine Tool Needs

Service Packages & Pricing

*.ppt 11/2/ :48 PM 1

Designed for multi-injector endurance testing, the

KODAK VERSAMARK, INC.

Technical Description LR 611 Crawler Loader

Electro-Mechanical Landing Gear System. Landing Gear and Brakes

KCU Communication. PC Software Installation and User s Guide For KCU-30 / KCU-40 / KCU-50 modules. System requirement: Windows XP or above

6. VVT-i (Variable Valve Timing-intelligent) System

V-MAC III Fault Assignments

P 602. This generator set has been designed to meet ISO 8528 regulation. This generator set is manufactured in facilities certified to ISO 9001.

Training Syllabus to Instruct/Prepare for the ASE Transit Bus HVAC Test

S KID S TEER L OADER SK818-5 SK818-5 SK NET POWER SAE J ,7 kw. OPERATING WEIGHT kg. OPERATING CAPACITY 870 kg

sip Sanyo Modbus Guide Technical Specification Pinouts, Cable Connections & Wiring Issue 2: February 2009 Synapsys Solutions Ltd, all rights reserved

JCB TELESCOPIC WHEELED LOADERS TM180 AND TM220

Operating Instructions Display, graphic. Numeric language

AUTOMATIC TRANSMISSION IN-CAR DIAGNOSTICS

Unit 8. Conversion Systems

Hydraulic Troubleshooting PRESENTED BY

Chapter 7 Hydraulic System Troubleshooting

Oildyne. 165 Series Hydraulic Power Units. Pressures to 241 bar (3500 psi) Flows to 5.4 lpm (1.4 gpm)

2. Crane standing on firm, horizontal ground.

DIESEL FUEL CONDITIONING

Module 6 Engine Control Module (ECM)

Electric Flow Boiler

Truck: A :22 PM ton. Maximize payload, maximize profit. LOADRITE X2650 Excavator Scales. transforming the way the world works

TOYOTA ELECTRONIC TRANSMISSION CHECKS & DIAGNOSIS

ELECTRICAL WIRING (R.H. DRIVE VEHICLES)

WHAT YOU DON T KNOW ABOUT ACCUMULATORS CAN KILL YOU!

Hybrid System Overview

PC18MR-3 PC20MR-3 PC27MR-3 PC30MR-3 PC35MR-3 PC45MR-3 PC55MR-3

New 27 hp 2 Cylinder Liquid-Cooled Engine

Defi Meter C Application User s Guide

Medical Air Systems: Scroll

R22. K Control. Indoor Unit. Nomenclature. Compatibility PL H 3 G K H B. Unit style Heat Pump Horse Power

RT100 ROUGH TERRAIN CRANE DATASHEET - IMPERIAL. Features:

Technical Specification. Generating Set with Waukesha engine burning natural gas

7.1. Part Lists. Hardware Insertion Machine. Instructions. Instructions

Electronic Diesel Control EDC 16

AVIATION SCIENCE LESSON 6: FUEL PUMPS AND FUEL SYSTEMS. Paul Ladegard, Alan Dick

Customer Support Agreements

RT 780. RT USt Lifting Capacity Rough Terrain Cranes Datasheet Imperial. Features

MAX ENERGY POWER PROGRAMMER PART #52001/52501 REFERENCE GUIDE AND INSTALLATION MANUAL ADDENDUM JEEP WRANGLER WITH ENHANCED OFF-ROAD FEATURES

M.S Ramaiah School of Advanced Studies - Bangalore. On completion of this session, the delegate will understand and be able to appriciate:

Transcription:

Cat Electronic Technician 2015A v1.0 Product Status Report 6/3/2015 4:41 PM Product Status Report Parameter Product ID Equipment ID Comments Value DHK00407 Machine Control 320D/323D (DHK00407) Parameter Value Product ID DHK00407 ECM Part Number 2218874-02 ECM Serial Number 00407980EM Software Group Part Number 2797611-00 Software Group Release Date NOV2005 Software Group Description 300D HEX CONTROL Active Diagnostic Codes Present No Logged Diagnostic Codes [Diagnostic Clock = 6237 hours] - Machine Control 320D/323D (DHK00407) Code Description Occ. First Last 2300-9 Switch Panel : Abnormal Update Rate 36 4080 5802 1160-5 Hydraulic Lock Solenoid : Current Below Normal 1 4597 4597 41-6 8 Volt DC Supply : Current Above Normal 2 4095 4339 190-8 Engine Speed Sensor : Abnormal Frequency, 1 4339 4339 Pulse Width, or Period 588-9 Monitor System Display : Abnormal Update Rate 1 4095 4095 167-12 Alternator Charging Voltage Sensor : Failure 19 1183 1184 Logged Event Codes [Diagnostic Clock = 6237 hours] - Machine Control 320D/323D (DHK00407) Code Description Occ. First Last E043 (2) Low System Voltage Warning 39 4441 4597 Active Diagnostic Codes - Machine Control 320D/323D (DHK00407) Code No Active Codes Description Current Totals - Machine Control 320D/323D (DHK00407) Total Operating 6238 hours Engine Maintenance 6236 hours

Engine Oil 5629 hours Engine Oil Filter 5629 hours Engine Coolant 6236 hours Fuel/ Water Separator 0 hours Fuel Filter 6236 hours Secondary Fuel Filter hours Tertiary Fuel Filter hours Fuel Tank Cap hours Hydraulic Pump 6236 hours Hydraulic Pilot Oil Filter 6236 hours Hydraulic Case Drain Oil Filter 6236 hours Return Hydraulic Oil Filter 6236 hours Attachment Hydraulic Oil Filter 0 hours Hydraulic Oil 6236 hours Final Drive Oil 6236 hours Swing Drive Oil 6236 hours Travel Motor 699 hours Tool #1 0 hours Tool #2 0 hours Tool #3 0 hours Tool #4 0 hours Tool #5 0 hours Tool #6 0 hours Tool #7 0 hours Tool #8 0 hours Tool #9 0 hours Tool #10 0 hours Return Hydraulic Oil Filter 9.4 hours Bypass Return Hydraulic Oil Filter 3.9 hours Bypass at Cold Temperature of Operation at High 124.1 hours Hydraulic Pressure of Operation at Relief Hydraulic Pressure 74.4 hours - Machine Control 320D/323D (DHK00407) Product ID DHK00407 Fuel Economy Mode Enable Status Economy Mode Off Travel Alarm Installation Status Installed Water Separator Level Switch Fuel Filter Differential Pressure Switch Config

Secondary Fuel Filter Differential Pressure Switch Config Attachment Hydraulic Oil Filter Switch Auto Lube Warning Indicator Enable Switch Machine Overload Pressure Sensor Installation Heavy Lift System Installation Status Engine Fan Type Direct Drive Engine Cooling Fan Map Standard Machine Application Bucket Main Pump Flow Limitation Pressure Solenoid Installation Status Attachment Valve #1 Attachment Valve #2 Attachment Valve #3 Attachment Valve #4 Attachment Valve #1 Combiner Variable Relief Valve Type Travel Speed Shift Low Delay 0.4 sec Travel Speed Shift High Delay 0.4 sec Travel Speed Shift Low Pres 2611 psi Travel Speed Shift High Pressure 4641 psi One Touch Engine Speed Setting 1100 rpm AESC Setting 1300 rpm AESC Delay Time 5.0 sec Throttle Dial Position 1 Engine Speed 1000 rpm Throttle Dial Position 2 Engine Speed 1100 rpm Throttle Dial Position 3 Engine Speed 1200 rpm Throttle Dial Position 4 Engine Speed 1300 rpm Throttle Dial Position 5 Engine Speed 1470 rpm Throttle Dial Position 6 Engine Speed 1590 rpm Throttle Dial Position 7 Engine Speed 1700 rpm Throttle Dial Position 8 Engine Speed 1800 rpm Throttle Dial Position 9 Engine Speed 1900 rpm Throttle Dial Position 10 Engine Speed 1980 rpm Throttle Dial Position 1 Hydraulic System 20.0 % Throttle Dial Position 2 Hydraulic System 40.0 % Throttle Dial Position 3 Hydraulic System 60.0 % Throttle Dial Position 4 Hydraulic System 81.2 % Throttle Dial Position 5 Hydraulic System Throttle Dial Position 6 Hydraulic System

Throttle Dial Position 7 Hydraulic System Throttle Dial Position 8 Hydraulic System Throttle Dial Position 9 Hydraulic System Throttle Dial Position 10 Hydraulic System Engine Oil Recommended Maintenance Engine Oil Filter Recommended Engine Coolant Recommended Fuel/ Water Separator Recommended Maint Fuel Filter Recommended Maintenance Secondary Fuel Filter Recommended Tertiary Fuel Filter Recommended Fuel Tank Cap Recommended Hydraulic Pilot Oil Filter Recommended Hydraulic Case Drain Oil Filter Recommended MI Return Hyd Oil Filter Recommended Maint Attachment Hydraulic Oil Filter Recommended Final Drive Oil Recommended Hydraulic Oil Recommended Maintenance Swing Drive Oil Recommended Advanced Machine Security System Installation Status AccuGrade System Installation Status Hydraulic Cab Riser Installation Status Hydraulic Cab Riser Raise Snubbing Angle Hydraulic Cab Riser Raise Snubbing Rate Hydraulic Cab Riser Lower Snubbing Angle Hydraulic Cab Riser Lower Snubbing Rate 100.0 % 500 hours 500 hours 3000 hours 0 hours 500 hours hours hours hours 1000 hours 1000 hours 2000 hours 0 hours 2000 hours 2000 hours 1000 hours Status - Machine Control 320D/323D (DHK00407) Status Last Successful Completion Attachment Valve #1 Extend Failed

Attachment Valve #1 Retract Failed Attachment Valve #2 Extend Failed Attachment Valve #2 Retract Failed Attachment Valve #3 Extend Failed Attachment Valve #3 Retract Failed Attachment Valve #4 Extend Failed Attachment Valve #4 Retract Failed Engine Speed Success 0.3 hours Left Joystick Thumbwheel Failed Right Joystick Thumbwheel Failed Left Attachment Pedal Failed Right Attachment Pedal Failed PRV - Pressure Gauge Failed PRV - Flow Meter for Two Failed Pump Flow Combined PRV - Attachment Valve #1 Failed Flow Limit PRV - Combined Attachment Failed Valve Flow Limit PRV - Power Shift Pressure Success 0.4 hours Boom Cylinder Extend Pilot Success Never Successfully Calibrated Pressure Limit Solenoid Cal Stick Cylinder Retract Pilot Success Never Successfully Calibrated Pressure Limit Solenoid Cal PRV - Variable Relief Pressure Failed Solenoid 1 PRV - Variable Relief Pressure Solenoid 2 Failed Active

Monitor Parameter Value ECM Serial Number 064J1138AJ Personality Module Part Number 2705555-00