LIGHTNING The LIGHTNING is a commercial, miniaturized, tri-mode tracking solution with processor, GPS, on-board storage, 2G/3G cellular module, Iridium satellite module, multiple sensors, multiple wired interfaces, internal rechargeable battery, DC power connection and standalone active/passive GPS antenna support. Embedded software comes preinstalled on the LIGHTNING in order to support tracking applications including vehicles, assets and personnel. Cellular (UMTS/GSM) GSM Bands: 850, 900, 1800, 1900 UMTS: 800, 850, 900, 1700, 1900, 2100 SMS and Data: WCDMA (UMTS), GPRS, EDGE Recommended minimum report rate interval: 1 sec (cell data), 10 sec (SMS) MicroSIM pushbutton holder Iridium SBD Recommended minimum report rate interval: 30 sec Standalone Iridium antenna Multiple provisioning options (KEYW is an Iridium Value Added Reseller) Iridium NEXT ready Figure 1 Lightning device with stubby antennas Sensors GPS: active or passive antenna support, altitude, speed, heading, horizontal and vertical error, number of satellites, satellite power, climb rate, assisted GPS Accelerometer: motion and orientation detection Temperature: ambient temperature detection and system thermal safeties Light: physical tamper detection Battery fuel gauge: percentage energy left for internal LIPO battery Future capability: Digital compass, humidity, barometric pressure, aided GPS Power MicroUSB for programming, power and internal LIPO charging 10-30V DC connector with cable for direct power and charging Internal LIPO rechargeable battery for standalone/ backup power Single charge life: >3 months for 1hr report rate, >12 months for 12hr rate, dependent on communication mode and settings Physical Features Dimensions: 2.9 x 3.4 x1 with multiple mounting options via holes/features in case Designed for IP67 or better dust/water protection Designed for MIL-STD-810G impact, shock, vibe Operating temperature range: -20oC to 80oC. Storage temperature range: -40oC to 80oC Waterproof SMA connectors (x3): GPS, cellular, Iridium SBD Waterproof GPIO (x4), UART/Analog (x1), 3.3V output (x2) connectors Waterproof 10-30V DC power connector Short swing door design waterproofing microusb and pushbutton micro SIM card holder Configurable buttons/leds for power status, on/off, distress, POI, other
Other Capabilities Unique serial number for each device Encrypted messages Configure parameters and update firmware via USB with windows configuration tool Configurable communication priority options with auto switching Configurable log and report rates based on motion status, speed, course and other triggers Real time clock for second scale scheduling On board storage for data logging, parameters, geofences, firmware Up to six hardware stored geofences used for indication, comm priority, log rates, reports rates, triggers, etc. Four configurable GPIO for input triggers and outputs Cellular tower lookup based geolocation for challeneged GPS or non-gps based applications Physical and USB anti-tamper with zeroize function Programmable with Traditional Tracking Configuration (TTC) Windows tool Communicates with Translator Server Application for encrypted data translation and forwarding Compatiable with TrackComm App for alternate configuration and operation LIGHTNING Accessories :: Included Cellular stubby antenna and wired magnet cellular antenna Passive GPS stubby and wired magnet active GPS antennas Iridium stubby antenna and wired magnet Iridium antenna Easy to use magnet plate Easy to use IWB/OWB clips Micro USB cable USB to AC adapter USB to DC adapter (car cigarette adapter) 3ft 10-30V DC power cable Multiple 3ft GPIO/UART/analog cables Wire attachment accessories Multi-hex tool USB flash drive with manual Pelican with custom foam LIGHTNING KEYW PN: FA800017-10 SMS gateway or SMS capable dongle service required for SMS message routing Iridium SBD and cellular modems are FCC certified LIPO battery UN testing Figure 2 Two device Lightning Kit Configuration AS OF MAY 2015
Traditional Tracking Configuration TTC Tool The TTC (Traditional Tracking Configuration) Tool is a commercial Windows application for configuration of LIGHTNING, MARAUDER, WARHAWK devices to communicate to a server. It supports communication via cellular SMS, cellular data, and Iridium SBD. The TTC tool can be utilized to direct devices to communicate with a server operating the Translator application to allow for collection, decrypt, and export of tracking data. Configure communication priority options with auto switching Configure log and report rates based on motion and speed Enable/disable course change based reporting Set up to six hardware stored geofences and define geofence, button, and GPIO triggered parameters Configure up to four external general purpose inputs and outputs Enable/disable anti-tamper features Configure button and LED functions including enable/disable Configure power, distress and point of interest triggers Configure GPS antenna power: active or passive Enable/disable cellular tower lookup based geolocation Enable/disable sleep modes for power savings and non-gps geolocation capability Set advanced parameters such as: communication retries, GPS timeout, motion sensitivity, LEDs ON/ OFF, cellular preferences, SIM PIN, reporting start and stop dates including enable/disable Encrypted XML file export with unqiue device ID, device name and encryption keys (to be loaded into Server Translator Application) Option to use auto-update of Translator encryption keys and change keys per configuration of devices Create, edit, export, delete configuration profiles, geofence profiles and APN profiles Import and export of geofences in KML format Read and delete logged data history and export to a CSV or KML/KMZ file Read and export event log Inspect device battery life, all configuration parameters plus cellular IMEI, IMSI, Iridium IMEI Install and update firmware of devices Connect and configure multiple devices simulatenouly via USB Compatiable with Windows 7, Windows 8, Windows 10 Included Items :: USB flash drive with TTC Figure 1 Geofence definition options
Traditional Tracking Configuration TTC Tool KEYW PN: FS800009-00 SMS gateway service required for SMS message routing License available as single seat perpetual Discounts provided for 10 or more seat purchases Figure 2 Main device menu for inspection, configuration and data history retrieval Figure 3 Configuration profile tab menus snapshot AS OF APRIL 2015
Translator Application The Server Translator Application allows for decrypting and translating packets sent from LIGHTNING, MARUADER, and WARHAWK devices configured with the TTC tool. These translated packets can be exported and/or forwarded to other analysis and mapping tools. This tool supports traditional tracking data transport from a tracking device to a server and/or end applications. Recieves messages via cellular data transport through MQTT (requires public IP address) Recieves messages via cellular SMS data transport through SMS gatway or a cellular dongle Recieves messages via Iridium SBD via direct IP (requires public IP address) Configure method to forward messages, IP forwarding addresses and ports, email address and authentication settings, forwarding text format, forwarding encryption Messages are decrypted, parsed, and formatted in customer specified text-based format Formatted data will be exported to a file (CSV or KML), sqlite database, authenticated or unauthenticated email, and/or routed as XML via TCP/IP Import encryption key XML file from TTC tool Remote encryption key upload via TTC tool User configurable cellular based geolocation database lookup via remote services Windows and Linux OS variants supported Must be installed on a server with Internet access and a publicly addressable IP address Included Items :: USB flash drive with Translator install files and manuals Server Translator Application KEYW PN: FS800008-00 SMS gateway service required for SMS message routing License available as single seat perpetual Figure 1 Translator Server Application AS OF MAY 2015