TE PUBLIC SAFETY DAS. Remote Repeaters and Sub System

Transcription

1 TE PUBLIC SAFETY DAS Remote Repeaters and Sub System TE Connectivity offers a new and flexible layer to traditional Distributed Antenna System (DAS) design with RF on fiber. Fiber optic cable is not only less expensive to purchase and install than its coaxial counterpart, but it is virtually bandwidth unlimited, making it ideal for multi-service solutions and applications where long runs of coax become cost prohibitive. As depicted in the diagram below, a Fiber Transceiver Unit (FTU) is required to perform the RF-to-optical conversion at the head-end. The FTU can be ordered in 1-port, 2-port, or 4-port per module, supporting up to 24 RRUs per 3U Mainframe Chassis. Multiple FTUs may be daisy-chained to accommodate N-port configurations, supporting virtually any number of RRUs. Consult the factory for assistance in determining whether an HRU or BSU may be required for your application. All of RRUs come standard with a with a GUI Alarm Monitor & Control Interface that sends a summary fault condition over the uplink fiber path to the headend Fiber Transceiver Unit (FTU). The summary fault condition appears as a dry contact relay at both the back panel of the FTU, and as a local alarm to the RRU. Headend Equipment DAS Headend Repeater Unit (HRU) Remote Repeater Unit #1 (RRU) Repeater Off-air configuration Direct-feed configuration Base Station Interface Unit (BSU) Fiber Transceiver Unit (FTU) SM Fiber Cable Remote Repeater Unit #n (RRU) DAS Fiber-Fed DAS Distribution Configuration

2 APPLICATIONS: Shopping Malls Airports Stadiums Warehouses Justice Centers Convention Centers Parking Garages Manufacturing Facilities Universities SPECIFICATIONS Remote Location Repeaters and Sub Systems Frequency(MHz) Max. RF Output Power (per 25 KHz FM Channel) Passbands (MHz) Minimum TX-to-RX Separation(MHz) Remote Repeaters Unit (RRU) Tx Rx 1P-out 2P-out 4P-out 8P-out PSD31RG-15B KHz 5 PSD31ER-15C PSD31RG-40C , 3, 5 9 PSD31RG-46C , 2.0, PSD31RG-48C PSD31RG-50C PSD31RG-7PC ,12 n/a PSD31RG-85C , 15, & 18 n/a PSD31RG-90C n/a PSD36R-TETRA n/a Compact Remote Repeater Unit (RRU) Tx Rx 1P-out 2P-out 4P-out 8P-out PSD31RC n/a PSD31RC n/a Dual Band Remote Repeaters Unit Tx Rx 1P-out 2P-out 4P-out 8P-out PSD32RG-8590C & & SMR & 900 SMR n/a PSD32RG-4085C & & , UHF & 800 SMR n/a PSD32RC n/a n/a PSD32RG-7080C and , 9, 15, & 18 (800 MHz), BB, NB (700 MHz) n/a PAGE 2

3 SPECIFICATIONS Remote Location Repeaters and Sub Systems System 4 dbo optical path loss(db) Gain Reduction(dB) Composite Output Power(dBm) Max. RF Input Level(dBm) Uplink Noise Figure Remote Repeaters Unit (RRU) Tx Rx Tx/Rx Tx Rx Rx PSD31RG-15B db continuous <12.1 db at 4dBo PSD31ER-15C (0.5 db Steps),63(0.5 db Steps) <5 db at 10dBo PSD31RG-40C db continuous <6 db at 4dBo PSD31RG-46C db continuous <6 db at 4dBo PSD31RG-48C db continuous <6 db at 4dBo PSD31RG-50C db continuous <6 db at 4dBo PSD31RG-7PC db continuous <6 db at 4dBo PSD31RG-85C db continuous <6 db at 4dBo PSD31RG-90C db continuous <6 db at 4dBo PSD36R-TETRA db (1 db Steps),30 db (1 db Steps) 36 n/a 10 <8 db at 4dBo Compact Remote Repeater Unit (RRU) Tx Rx Tx/Rx Tx Rx Rx PSD31RC db continuous 20 n/a -10 PSD31RC db continuous 20 n/a -10 PSD32RC db continuous 20 n/a db (@ max gain & <1 dbo) 10 db (@ max gain & <1 dbo) 10 db (@ max gain & <1 dbo) Dual Band Remote Repeaters Unit Tx Rx Tx/Rx Tx Rx Rx PSD32RG-8590C db continuous <12.1 db at 4dBo PSD32RG-4085C db continuous <12.1 db at 4dBo PSD32RG-7080C db (0.5 db Steps),20 db (0.5 db Steps) <11 db at 4dBo PAGE 3

4 SPECIFICATIONS Remote Location Repeaters and Sub Systems Wideband Noise (dbm/hz) - Spurious Emission (dbm) Power Consumption Dimensions (W x H x D) inches Weight (approx) Remote Repeaters Unit (RRU) PSD31RG-15B Wall-mount: 24 x 24 x 9 Rack-mount: 19 x 14 x 21 Wall-mount: <100 lbs. PSD31ER-15C <-20 < C Wall-mount: 24 x 24 x 10 Rack-mount: 6RU Wall-mount: >80 lbs. PSD31RG-40C Wall-mount: 20 x 20 x 9.5 Wall-mount: <100 lbs, 0.5 & 2.0 MHz Bandwidths version= Wall-mount: 24 x 24 x & 2.0 MHz Bandwidth version=wallmount: <150 lbs. PSD31RG-46C 3.0 MHz Bandwidth version=wall-mount: 24 x 24 x & 2.0 MHz Bandwidths version=rackmount: 19 x 7 x MHz Bandwidth version=wallmount: <150 lbs. 0.5 & 2.0 MHz Bandwidth version=rackmount: <80 lbs. 3.0 MHz Bandwidth version=rack-mount: 19 x 14 x MHz Bandwidth version=rackmount: <100 lbs. PSD31RG-48C Wall-mount: 24 x 24 x 9.5 Rack-mount: 19 x 14 x 21 Wall-mount: <100 lbs. PSD31RG-50C Wall-mount: 24 x 24 x 9.5 Rack-mount: 19 x 14 x 21 Wall-mount: <100 lbs. PSD31RG-7PC Wall-mount: 16 x 18 x 9 Rack-mount: 19 x 14 x 21 Wall-mount: < 80 lbs. Rack-mount: < 60 lbs. PSD31RG-85C Wall-mount: 16 x 18 x 9 Wall-mount: < 80 lbs. Rack-mount: < 60 lbs. PSD31RG-90C Wall-mount: 16 x 18 x 9 Wall-mount: < 80 lbs. Rack-mount: < 60 lbs. PSD36R-TETRA n/a <-36 < 150 Watts Compact Remote Repeater Unit (RRU) Wall-mount: 20 x 20 x 9.5 Wall-mount: <100 lbs. PSD31RC-85 PSD31RC-90 PSD32RC-1544 Dual Band Remote Repeaters Unit PSD32RG-8590C PSD32RG-4085C -106 dbm/hz -106 dbm/hz -106 dbm/hz <-13 <30 Watts 8 x 12 x 3 (approx.) < 8 lbs. <-13 <30 Watts 8 x 12 x 3 (approx.) < 8 lbs. <-13 <30 Watts 8 x 9 x 3 (approx.) Wall-mount: < 8 lbs. <-13 <150 Watts Wall-mount: 16 x 18 x 9 Wall-mount: < 80 lbs. <-13 < C Rack-mount: < 60 lbs. PSD32RG-7080C <-13 <100 Watts Wall-mount: 16 x 18 x 9 Rack-mount: < 60 lbs. Wall-mount: < 80 lbs. PAGE 4

5 REMOTE REPEATER UNIT ENVIRONMENTAL SPECIFICATIONS Environmental Operational Temperature Range Humidity -5 to +50 C 10 to 95% Non-condensing Fiber Optic Parameters Wavelength Laser type Max. Optical Budget 1310 nm DFB Downlink: 4-10 dbo* Uplink: 10 dbo Fiber Optic Cable Type Single-mode 9/125 µm Connector Type Back Reflections SC/APC < -50 db typ. *Downlink fiber optic link budget is dependent un headend FTU configuration Electrical AC Power 50/60 Hz, VAC Local Alarms Dry Contact Relay 1. Laser Over Current 2. Opt. Rx 3. RA 4. Temp 5. Auxillary Remote Alarm Monitor & Control GUI-provided discrete Alarm Monitoring and Control capability available at Headend FTU, or locally at RRU. PAGE 5

6 ORDERING INFORMATION Type Bandwidth Comments Model No. Remote Repeater Units (RRU) Remote Fiber Optic Repeater MHz 1 Watt Version PSD31RG-15B Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD31RG-46C Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD31RG-48C Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD31RG-50C Remote Fiber Optic Repeater MHz 2.5 Watt Version, -20dBm spurious limit PSD31ER-15C Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD31RG-40C Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD31RG-7PC Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD31RG-85C Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD31RG-90C Remote Fiber Optic Repeater MHz 2 Watt Version, -36dBm spurious limit PSD36R-TETRA Dual-Band Remote Repeater Units (RRU) Dual Band Remote Fiber Optic Repeater MHz 5 Watt Version, -20dBm spurious limit PSD32RG-8590C Dual Band Remote Fiber Optic Repeater MHz & MHz 5 Watt Version, -20dBm spurious limit PSD32RG-4085C Dual Band Remote Fiber Optic Repeater MHz & MHz 5 Watt Version, -20dBm spurious limit PSD32RG-7080C Compact Remote Repeater Units (CRRU) VHF/UHF Compact Rem. Fiber Optic Repeater MHz Compact low version PSD32RC MHz Compact Rem. Fiber Optic Repeater MHz +20dBm Version, -20dBm spurious limit PSD31RC /900MHz Compact Rem. Fiber Optic Repeater MHz +20dBm Version, -20dBm spurious limit PSD31RC-90 PAGE 6

7 ORDERING INFORMATION Part Number Model Number Bandwidth options WDM - Wavelength Division Multiplexing MHz Passbands MHz Passbands MHz Passbands MHz Passbands W N Tx & Rx signals are multiplexed onto a single fiber Tx & Rx signals are on separate fiber strands 07 7 MHz Passbands 09 9 MHz Passbands MHz Passbands MHz Passbands MHz Passbands Example: PSD31RG-40C 0.5WMN Enclosure Type RM Rack mount version WM Wall mount (indoor rating) 4X Wall mount NEMA 4X enclosure 40 Wall mount NEMA 4 enclosure 65 Wall mount IP65 enclosure 66 Wall mount IP66 enclosure Part Number PSD32RG-7080C Bandwidth options (700 MHz Options) WDM - Wavelength Division Multiplexing 06 6 MHz Passbands ( and MHz) W Tx & Rx signals are multiplexed onto a single fiber MHz Passbands ( and MHz) N Tx & Rx signals are on separate fiber strands Bandwidth options (800 MHz Options) Enclosure Type 07 7 MHz Passbands 09 9 MHz Passbands MHz Passbands RM WM 4X Rack mount version Wall mount (indoor rating) Wall mount NEMA 4X enclosure MHz Passbands 40 Wall mount NEMA 4 enclosure 65 Wall mount IP65 enclosure * For PSD36R-TETRA ordering informational, refer to TETRA data sheet. 66 Wall mount IP66 enclosure PAGE 7

8 te.com TE Connectivity, TE connectivity (logo) and Every Connection Counts are trademarks. All other logos, products and/or company names referred to herein might be trademarks of their respective owners. The information given herein, including drawings, illustrations and schematics which are intended for illustration purposes only, is believed to be reliable. However, TE Connectivity makes no warranties as to its accuracy or completeness and disclaims any liability in connection with its use. TE Connectivity s obligations shall only be as set forth in TE Connectivity s Standard Terms and Conditions of Sale for this product and in no case will TE Connectivity be liable for any incidental, indirect or consequential damages arising out of the sale, resale, use or misuse of the product. Users of TE Connectivity products should make their own evaluation to determine the suitability of each such product for the specific application TE Connectivity Ltd. family of companies All Rights Reserved AE 08/14 Original PRODUCT SHEET Contact us P.O. Box 1101 Minneapolis, Minnesota USA Tel: x Fax: