FlexCON VoIP. Industrial VoIP GW and Serial Converter. FXO, FXS, VF, Serial Industrial VoIP Ddd. Ethernet. Features

Transcription

1 FXO, FXS, VF, Serial Industrial VoIP Ddd Ethernet FlexCON VoIP Industrial VoIP GW and Serial Converter Features The key feature of FlexCON VOIP is the Voice and Analog Channels transmission over modern Ethernet L2/L3 transmission media. And now VoIP is integrated into Industrial Grade Device. This unique Industrial VoIP device addresses to Voice and Analog transmission demands of Industrial and Utility Markets and fits well for Industrial Telephony and Emergency Phone Network Applications and Analog Channel Emulation over Ethernet/IP for old leased-line/pstn modems. Those are still widely used in the Industrial area for accessing remote sites. With unique proprietary Synchronization Protocol based on years of experience in circuit emulation over packet technology, the FlexCON VOIP provides perfect performance for Modem over IP applications due to eliminating certain behavior of channel parameters caused by packet nature of IP-network. The FlexCON VOIP can be used for cost optimization during an upgrade of the network to Ethernet type. For instance, some analog modem transmission for existing points may be kept, while the core network can be upgraded to Ethernet. This is more or less the same situation behind analog channels as a story with serial data over packet network transmission. That is why has designed this 2-in-1 unit, which combines Voice and Serial transmission capabilities in the single Industrial unit. Each FlexCON VOIP device provides up to 4 voice channels, in 2-by-2 combination, by pre-installing of daughter cards into 2 slots. Each card supports either 2x FXO, or 2x FXS or 2x Analog voice frequency ( Hz) channels (4 wire) with Type 5 E&M. The FlexCON VOIP also supports Voice Conferencing for each channel, Address book and Tone or Pulse dialing as well. Through the smart and flexible VoIP configuration engine the FlexCON VOIP units suits well not only Classic VoIP networks with SIP-server applications, but also offers a lot of Applications without SIP-server, such as: FXO-FXS (FXS Port Extender) Hot-line FXS-FXS P-t-P, P-t-MP and Onmi Analog Channel Emulation Distributed PBX Dispatcher network (with Conferencing) Distributed access to PSTN/PBX And they also may cover perfectly simple Dispatcher applications, Hot-line Phone applications, Radio-, Remote Paging and Public Announcement applications. The serial sub-system of the device has 2 on-board RS232/422/485 Serial Interfaces (fully SW configurable) with 16kV protection. Each interface supports bps transmission rates over TCP or UDP in Point-To-Point, Point-To- MultiPoint (up to 64 points), Broadcast and Com-Server Applications. Due to operating compatibility in Ethernet, Serial and Management of the FlexCON VOIP, MiniFlex and Orion Product Lines, now offers the great set of Integrated System Solutions for Industrial and Utility Networks. The next pages represent some of various FlexCON VOIP Applications. Voice data transmission over IP networks with SIP (RFC3261) or proprietary Voice over UDP protocol Serial data transmission over IP Up to 4 Voice channels: FXO, FXS or VF (Analog Voice Frequency Hz) channels (4 wire) with Type 5 E&M Unique Synchronization Technology for Robust Modem over IP Applications Voice Conferencing and Operation with and without SIP-Server G.711A/U codec support 2 channel Serial data (RS232/422/485 SW configurable) 2x 10/100BaseT interfaces VLAN, QoS support Point-to-Point, Point-to-Multipoint, Chain and Omni-bus Operation of Voice and Serial Console Port, Telnet, Web, SNMP v1, v2, v3 Management 48VDC Redundant Powered and Low Power Consumption Robust DIN-Rail Metal Enclosure Industrial Temperature Range Available Switzerland Page 1/6

2 Various Set of Interfaces for Any Device Connection: Possible Application: Ethernet, Serial and Voice connection to the Remote Production sites Switzerland Page 2/6

3 Possible Application: Omni-channel Application Possible Application: Distributed PBX Switzerland Page 3/6

4 Possible Application: Phone Line Extender Application with SIP-server Switzerland Page 4/6

5 SIP compliance: RFC2327 SDP: Session Description Protocol RFC2833/RFC4733 RTP Payload for DTMF Digits, Telephony Tones and Telephony Signals RFC2976 The SIP INFO Method RFC3261 SIP: Session Initiation Protocol (core methods: INVITE, CANCEL, BYE, REGISTER, OPTIONS, INFO) RFC3263 Session Initiation Protocol (SIP): Locating SIP Servers (DNS SRV) RFC3264 An Offer/Answer Model with Session Description Protocol (SDP) RFC3311 The Session Initiation Protocol (SIP) UPDATE Method RFC3515 The Session Initiation Protocol (SIP) Refer Method RFC3550 RTP: A Transport Protocol for Real-Time Applications RFC3581 An Extension to the Session Initiation Protocol (SIP) for Symmetric Response Routing (rport) RFC3605 Real Time Control Protocol (RTCP) attribute in Session Description Protocol RFC3665 Session Initiation Protocol (SIP) Basic Call Flow Examples RFC3986 Uniform Resource Identifier (URI): Generic Syntax RFC4028 Session Timers in the Session Initiation Protocol (SIP) RFC5245 Interactive Connectivity Establishment (ICE) RFC5389 Session Traversal Utilities for NAT (STUN) RFC5766 Traversal Using Relay NAT (TURN) RFC5768 Indicating Support for Interactive Connectivity Establishment (ICE) in the Session Initiation Protocol (SIP) RFC6314 NAT Traversal Practices for Client-Server SIP (partially supported) FlexCON VoIP and Serial DIN Rail Converter Physical FC-VOIP-RAILN-2SER/2Eth/2FXS/2VF 2x FXS and 2x VF ( Hz, 4-wire, E&M (Type 5)) RJ45 (Ethernet), RJ45 (FXS&VF), RJ45 (RS-232/422/485), Molex (Power), RJ45 (LCT) Physical FC-VOIP-RAILN-2SER/2Eth/2FXS 2x FXS RJ45 (Ethernet), RJ45 (FXS), RJ45 (RS-232/422/485), Molex (Power), RJ45 (LCT) Additional voice channels can be added by installing of second daughterboard Switzerland Page 5/6

6 Physical FC-VOIP-RAILN-2SER/2Eth/2FXO 2x FXO RJ45 (Ethernet), RJ45 (FXO), RJ45 (RS-232/422/485), Molex (Power), RJ45 (LCT) Physical Additional voice channels can be added by installing of second daughterboard FC-VOIP-RAILN-2SER/2Eth/2VF 2x VF ( Hz, 4-wire, E&M (Type 5)) RJ45 (Ethernet), RJ45 (VF), RJ45 (RS-232/422/485), Molex (Power), RJ45 (LCT) Additional voice channels can be added by installing of second daughterboard Physical FC-VOIP-RAILN-2SER/2Eth RJ45 (Ethernet), RJ45 (FXS/FXO/VF), RJ45 (RS-232/422/485), Molex (Power), RJ45 (LCT) Voice channels can be added by installing of second daughterboard FlexCON VoIP Daughterboards FC-VOIP-2FXO 2x FXO FC-VOIP-2FXS 2x FXS FC-VOIP-2VF 2x VF ( Hz, 4-wire, E&M (Type 5)) Switzerland Page 6/6