FSS-95F11T-out SATELLITE TV on fiber Long Distances without loss Prevent Ground Loops Lightning Protection long Distances without loss SATfiber Use fiber when DISH-to-Receiver Distance is over 300ft Place Satellite Antennas anywhere you want Outdoor rated SatFiber TRANSMITTER to place at dish site No need for heated shack or enclosure by dish. Place TX units in box by dish, and run signals over long distance of SingleMode fiber optic cable, back to fiber optic receivers, and satellite receivers High signal levels reach control room, to feed many Sat Receivers Increase EbNo readings on finicky digital sat receivers Outdoor rated TRANSMITTER can be placed in box on back of dish, for use in hot or cold climates (operation from -40 to +158 degree F) satellite signals over long distances without loss SingleMode Fiber 500 feet to 50 miles Outdoor Enclosure with mounting panels, holds up to 6 SatFiber transmitter units. NEMA type to protect equipment from moisture ingress. Lockable door. Outdoor Rated power supply that can operate in temps from -40 to +158 degrees F. Power up to six SatFiber transmitters. Option for redundant power supply. Wall mounted SatFiber RECEIVER locate inside at far end of fiber run, in air conditioned location. Option for rack mounted RECEIVER with redundant powering. R R R R x x x x PULL-IT-YOURSELF FIBER CABLE. DAWNco will provide the fiber cable length you need, with connectors factory installed, or you can hire a local fiber contractor to run fiber cable to your viewing locations. Call for more info.
SATfiber TRANSMITTER Specs Satellite signals over long distances without loss Outdoor rated satellite fiber optic transmitter Features FSS-95F11T-out Optical transmitter for satellite signal distribution Wide bandwidth from 950 to 2050 MHz Built-in supply voltage 18 volt to LNB Compact package with SC/APC or SC/APC connector RoHS compliance Applications Satellite Signals Distribution Outdoor rated satellite fiber optic transmitter used with satellite downlink, to carry signals over long distance on Single Mode fiber optic cable. Transmitter unit can be placed in a NEMA box at the dish site, rated for operation in the -40 to +70C (-40 to +158 F) temperature range. Pass 950-2050 MHz satellite L band signals, input on 'F' connector, output optical signals to a compatible Fiber Optic receiver with 11 db optical loss range, output to single mode fiber via SC/APC connector. Requires separate +12 VDC power supply. Wall mounted. All connections in fiber must be angle polished connectors (APC). Purchase these items separately: Power supply, NEMA outdoor rated enclosure to hold TX modules at dish site, and compatible fiber optic L band receiver. LNB Optical Transmitter Optical Splitter Optical Receiver STB/TV You are entitled to the manufacturer's limited express warranty, if any, that accompanies the product. DAWNco makes no additional or independent warranty. All other warranties, express or implied, including the warranties of merchantability and fitness for a particular purpose are disclaimed. We do our best to be accurate. We are not responsible for any typographical, photographic or technical errors. See "Policies for DAWNco" under the "Answers" button at the DAWNco web site.
FSS-95F11T-out Optical Specifications SATfiber TRANSMITTER Specs Satellite signals over long distances without loss Outdoor rated satellite fiber optic transmitter Optical Wavelength Optical Input Level Optical Return Loss #FSS-95F11T-out Transmitter 1310±20 nm >55 db RF Specifications Operating Frequency Nominal Composite RF Input Nominal Composite RF Output Impedance #FSS-95F11T-out Transmitter 950~2050 MHz -30 dbm 75 ohm Link Performance Link Gain Third-order Inter-modulation Distortion (IMD3) CNR 22 db@-30 dbm/ch RF power and the transmitter output power is received directly -53 dbc@2 unmodulated carriers (f1=1000 MHz, f2=1100 MHz), RF power= -30 dbm per carrier 22 db@-40 dbm/ch RF power and -13 dbm optical received power (27 MHz bandwidth is assumed) General Specifications Operation Temperature Range Storage Temperature Range Power Supply Transmitter Power Consumption Receiver Power Consumption Dimension Weight in mm #FSS-95F11T-out Transmitter -40~70 degc -40~85 degc 9~18 VDC 5.4W typ. without LNB 12/18 VDC power supply 76Dx146Wx28H 320±15 g You are entitled to the manufacturer's limited express warranty, if any, that accompanies the product. DAWNco makes no additional or independent warranty. All other warranties, express or implied, including the warranties of merchantability and fitness for a particular purpose are disclaimed. We do our best to be accurate. We are not responsible for any typographical, photographic or technical errors. See "Policies for DAWNco" under the "Answers" button at the DAWNco web site.
FSS-95F11R satellite fiber RECEIVER with SC/APC connectors SATfiber RECEIVER Specs Satellite signals over long distances without loss Wall mounted satellite fiber optic receiver with SC/APC connectors Optical Specifications Optical Wavelength Optical Input Level Optical Return Loss RF Specifications Operating Frequency Flatness Nominal Composite RF Output Impedance RF Return Loss FSS-95F11R Receiver 1310±20 nm -13~+4 dbm >55 db FSS-95F11R Receiver 47~2600 MHz ±2 db -30 dbm@13db optical link budget 75 ohm 12 db Link Performance (related to use of FSS-95F11T-out Transmitter with FSS-95F11R Receiver) 26 db@-30 dbm/ch RF power and the transmitter output power is Link Gain received directly Third-order Inter-modulation -60 dbc@2 unmodulated carriers (f1=1000 MHz, f2=1100 MHz), RF Distortion (IMD3) power= -30 dbm per carrier CNR 22 db@-40 dbm/ch RF power and -13 dbm optical received power (27 MHz bandwidth is assumed) General Specifications Operation Temperature Range 0~50 degc Storage Temperature Range -20~60 degc Power Supply 9~18 VDC Receiver Power Consumption 4.1W typ. Dimension in mm 76Dx146Wx28H Weight FSS-95F11R Receiver 320±15 g You are entitled to the manufacturer's limited express warranty, if any, that accompanies the product. DAWNco makes no additional or independent warranty. All other warranties, express or implied, including the warranties of merchantability and fitness for a particular purpose are disclaimed. We do our best to be accurate. We are not responsible for any typographical, photographic or technical errors. See "Policies for DAWNco" under the "Answers" button at the DAWNco web site.
FSS-95F11T-out Diagram for EXAMPLE LAYOUT-1 Satellite signals over long distances without loss from customer s 4-feed DBS dish 4-Pack outdoor rated SATELLITE fiber link TX units 4 SatFiber at house, 4 SatFiber at out building Polarization locker DISH LOCATION customer provided 4-feed DBS dish TX TX TX TX QTY (1) #FWM045NEMA weatherproof box near dish and QTY (4) #FSS-95F11T-out outdoor rated SatFiber TX units placed inside box with QTY (1) outdoor rated power supply #FSS-95F11-PowSup-out (user provide AC power at box) QTY (1) Reel of 6-strand PULL-IT-YOURSELF singlemode fiber OPTIC CABLE with factory installed SC/APC connectors, Plus protective pulling eyes at both ends (one waterproof), #SM6io-SCA12-WtDr-400ft SATfiber HOUSE for satellite signals over long distances without loss Outdoor Rated TRANSMITTER and Power Supply Will operate reliably in -40 to +158F temperatures No need for air conditioned building near dish 1in x 2out optical splitters QTY (4) optical 1in x 2out splitters, to pass SatFiber 4-pack signals to 2 different locations, held securely in patch panel QTY (3) six port SC/APC adapter panels, to securely hold fiber cable ends in patch panel MultiSwitch to Sat Receivers QTY (4) #FSS-95F11R Satellite Fiber Link RECEIVERS for 4 satellite polarizations over 4 fibers Customer will take signals out of Sat Fiber units, into customer provided satellite multiswitch QTY (1) Reel of 6-strand PULL-IT-YOURSELF singlemode fiber OPTIC CABLE with factory installed SC/APC connectors, Plus protective pulling eyes at both ends (one waterproof), #SM6io-SCA12-WtDr-400ft Out Building MultiSwitch to Sat Receivers QTY (4) #FSS-95F11R Satellite Fiber Link RECEIVERS for 4 satellite polarizations over 4 fibers Customer will take signals out of Sat Fiber units, into customer provided satellite multiswitch OPTION: Rack Mounted TX or -OR-
FSS-95F11T-out Fiber Connection for SMALL DISH Perfect signals over long distances Secure Path for Military & FEMA System for DirecTV 2-feed service for 101 satellite, odd & even channels (use 1 SatFiber TX- set) System for DirecTV 5-feed service (use 5 SatFiber TX- sets) 1 2 Coaxial Cable 8 #1 1.0m offset dish P10FOS-LNBF 3 9 #2 LNBF with 2 ports KLNBFD1.0 #3 Stacker MS-STACKER 5 SingleMode Fiber 4 #4 Sat Fiber TX FSS-95F11T #5 Sat Fiber FSS-95F11R 6 7 #6 Un-Stacker MS-UNSTACK #7 MultiSwitch 6x8 MS68-AMP Coaxial Cable #8 DirecTV 5feed dish DTV.8FOS DBS Receiver DBS Receiver #9 Locker for LNBF MS-LOCKER You are entitled to the manufacturer's limited express warranty, if any, that accompanies the product. DAWNco makes no additional or independent warranty. All other warranties, express or implied, including the warranties of merchantability and fitness for a particular purpose are disclaimed. We do our best to be accurate. We are not responsible for any typographical, photographic or technical errors. See "Policies for DAWNco" under the "Answers" button at the DAWNco web site.
FSS-95F11T-out Feed signals from 1-dish to MULTIPLE SAT RECEIVER locations on SingleMode Fiber without need for RF amps Long Distances without loss Prevent Ground Loops Lightning Protection WIDEBAND SATELLITE FIBERLINK SYSTEM. The 2 main advantages are: 1) Locate the dish a long way away from receiver, using low-loss fiber optic cable. Better signal quality and lower cost than using copper coax cable. 2) Convert the signal at the dish to fiber, use low-loss fiber optic splitters to send identical satellite feeds to several different receiver locations. Each receiver location will have SatFiber receivers. Better signal quality and lower cost than using copper coaxial cable. Pass Satellite signals over long distance of fiber, to compatible multiswitch. SatFiber TRANSMITTER Optical SPLITTER SatFiber RECEIVER Utilize optical splitter on output of each SatFiber transmitter unit, to feed satellite signals to multiple receive points in a facility where fiber units are placed #FSS-95F12T standard Fiber optic TRANSMITTER can pass 250 to 2050 Mhz signals, which are output from each F connector located on SatDish mounted LNBF or LNB amplifiers. COMPATIBLE with DirecTV systems that pass the following RF bands: 250-750 Mhz, 950-1450 Mhz, 1550-2050 Mhz. COMPATIBLE with Dish Network systems that pass the following RF bands: 450-950 Mhz, 950-1450 Mhz. OPTION: #FSS-95F12T-Wideband Transmitter can pass 47 to 2600 Mhz signals. DAWNco 3340 S. Lapeer Rd Orion, MI 48359-1320 Ph (248) 391-9200 Fax (248) 391-9207 sales@dawnco.com
with two close dish farm locations, and one distant dish farm location LOCATION: DISH FARM NEMA box-north LOCATION: HEADEND customer provided satellite antennas and LNBs and signal cables 15 primary satellite LNBs weatherproof NEMA box w-fiber termination panel EXAMPLE of 32 path Outdoor Rated Satellite Fiber Link system 16 satellite fiberlink transmitters with LNB powering, all OUTDOOR rated 1 backup satellite LNB connected to customer provided motorized dish customer provided SM fiber customer provided headend equipment rack will hold new SatFiber receivers FSS-95F11T-out 34 satellite fiberlink receivers in rack chassis customer provided SM fiber redundant power supplies, OUTDOOR rated LOCATION: DISH FARM NEMA box-south customer provided satellite antennas and LNBs and signal cables 15 primary satellite LNBs weatherproof NEMA box w-fiber termination panel 16 satellite fiberlink transmitters with LNB powering, all OUTDOOR rated 1 backup satellite LNB connected to customer provided motorized dish disp comp disp comp L D L D OPTION-A: SATPACK-D42PMD-4CK MOTORIZED SATELLITE ANTENNA, for manual backup of satellite antennas & LNBs & SatFiber path OPTION-B: SFS3232 MATRIX SWITCHER customer provided SM fiber, long distance 20 db loss redundant power supplies, OUTDOOR rated T x L D T x L D LOCATION: DISTANT DISH SITE 2 long distance SatFiber transmitters in rack DAWNco 3340 S. Lapeer Rd Orion, MI 48359-1320 Ph (248) 391-9200 Fax (248) 391-9207 sales@dawnco.com