California State University, Los Angeles Student Step by Step Instructions for IAP The instructions below are a step by step guide for completing an Individualized Advisement Plan (IAP). The IAP is not mandatory, but highly recommended. Firstly, once it is approved by an advisor, it serves as a roadmap to facilitate graduation requirements under your major, and if applicable, minor program(s). Secondly, it provides the opportunity to inform the university of courses you plan to enroll in and when. This information will allow the university to improve course offerings based upon demand. Before you can complete an IAP, you must consult with your major department about which requirements you will follow: the current quarter system catalog requirements or the new semester system catalog requirements. The procedures for determining which requirements will be more efficient for you will vary by major. In addition, it is possible to have different catalog requirements for University requirements (including GE) and major requirements. Once you have determined which set of University and major requirements you will be following, you will know what classes you need to put into your IAP. STEP 1: Go to www.calstatela.edu/. STEP 2: Click on MyCSULA at the top of the landing page. STEP 3: Enter your User Name and Password in the MyCSULA Portal. STEP 4: Click the Golden Eagle Territory ( GET ) icon on the left. STEP 5: Click Self Service. STEP 6: Click Student Center. If you have been identified as a student who may graduate after semesters begin (Fall 2016), you will see a pop up message alerting you of the university s conversion to semesters and instructing you to complete an IAP. Be sure to contact your major advisor to discuss which GE and major requirements you should follow to complete your degree(s) before completing an IAP. This pop-up message will be activated for students at different times depending upon how many units have been completed, so if you do not see it yet, you will need to wait to complete your IAP. 1
Read and click OK. Note: After speaking with your major advisor, return to your GET account. The Individualized Advisement Plan will be listed under your To Do List on the right side of the screen. STEP 7: Click Individualized Advisement Plan under the Academics section. STEP 8: If, with the help of an advisor, you decide to follow semester requirements for either your GEs and/or major(s), click the What-if report (blue link) on the right side of the screen. Proceed to STEP 9. If you will not follow the semester requirements, but will continue to follow quarter requirements to complete your degree(s), proceed to STEP 13. 2
STEP 9: Click CREATE NEW REPORT. Here, you will be able to see a report similar to your Degree Progress Report (CAAR) except with academic requirements under the semester catalog. Essentially, the What-If report means, what-if I decide to follow the semester requirements for my major(s) instead of my current quarter requirements? STEP 10: Under Career Scenario use the Career dropdown menu to select undergraduate or graduate. Use the Requirement Term dropdown menu to select either Fall Semester 2016 (if you want to follow semester system GE and University requirements) or Spring Quarter 2015 (if you want to follow quarter system GE and University requirements). 3
STEP 11: Under Program Scenario, use the Academic Program dropdown menu to select your college (ex. Arts & Letters, Natural & Social Sciences, etc.). Use the Area of Study dropdown menu to select your major. Use the Plan Term dropdown and select Fall 16. If applicable, use the Concentration dropdown menu to select your concentration/option. If applicable, also use the Subplan Term to select Fall 16. 4
Click Submit Request at the bottom of the screen. Click Print Report to print the report. Repeat STEP 11 if you re pursuing more than one major. STEP 12: View the remaining courses and requirements necessary for completing your degree(s). STEP 13: Now, select the remaining major courses you must take to complete your degree(s). You may select courses by clicking My Requirements. (This function however, only allows you to add major courses, not GE courses, to your IAP. You will use the Course Catalog function to add GE courses. In addition, the courses identified in this function are those that satisfy quarter requirements only. Thus, if you plan to follow semester major requirements, DO NOT add courses using My Requirements. Instead, use the Course Catalog function in STEP 16). STEP 14: Click a course needed. 5
STEP 15: Click add to planner. Continue to add all remaining courses necessary to graduate. Return to the planner screen. Proceed to STEP 16. STEP 16: Click Course Catalog. 6
Here, you may select the remaining courses you plan to take up until the time you graduate. This is similar to the process you use for enrolling in courses each quarter. Both quarter system classes and semester system classes will be available for you to select. Use information provided by your major department to make sure you have selected the courses you will need to meet all graduation requirements. STEP 17: Add courses to the Planner. Click the course subject (e.g., NURS ). Check the box to the left of the specific course you would like to select (e.g., 210 Introduction to Professional Nursing Process and Skills I ). You may select multiple courses from the same course subject (e.g., NURS 100, 210 and 211). 7
Click Add to Planner at the top or bottom of the screen. A yellow box will appear stating your course has been added (e.g., NURS 210 has been added to your Planner ). Repeat until you ve added all remaining courses in your planner you must take to complete your degree(s). Click back arrow button when finished. STEP 18: Assign courses to terms (when you plan to take each course). Click the checkbox to the left of a course. 8
Select a term for that course using the dropdown menu under Move Selected Courses to Term. For example, Spring Quarter 2015 or Fall Semester 2016. Click the Move button. You will see the course now listed under the selected term. Repeat for all of your remaining courses. Keep in mind that you should be taking one more course per term after semester conversion than you did in the quarter system to keep an equivalent course load. For example, three 4-unit classes in the quarter system require the same number of hours per week as four 3-unit classes in the semester system. See Semester Conversion Handbook for details. And remember, for a bachelor s degree, whether under the quarter or semester system, you should complete a minimum of 15 units per (primary) term to graduate in 4 years. This is also known as 15 to Finish! For additional information go to www.calstatela.edu/semester. 9
STEP 19: Add notes (optional). The Notes section to the right of each course may be used to add course specific comments. You and an advisor may add to, change, or delete these notes if desired. STEP 20: Enter University and major requirements catalog years in comments. Indicate in the Comment section at the bottom of the screen whether you will be following your current quarter system catalog requirements (pre-fall 2016 catalog year) or changing to the new semester system requirements (Fall 2016 catalog year). Do this for both University requirements and major requirements. The Comment section can also be used to add general comments by you and/or your advisor. Unlike course notes, these comments cannot be changed or deleted. STEP 21: Submit your IAP. When you have assigned ALL the courses you plan to take to a specific quarter or semester term up until the time you graduate, you are ready to submit your IAP. Click SAVE PLANNER. Click VIEW AS PDF to view all the courses you ve selected in PDF form. 10
Click SUBMIT IAP to submit an IAP to an advisor for approval. A pop up will confirm your submission, and you will also receive an email confirmation. STEP 22: An advisor will approve or return your IAP. If approved, you will be notified via email and a pop up message will appear when you log into GET. The IAP will be dated and stamped on the PDF you viewed before, and Individualized Advisement Plan will be removed from your To Do List. Congratulations, you re done! From here, you will continue to enroll and complete the courses necessary to graduate as planned. Note: the IAP does not automatically enroll you in courses. Please follow usual procedures for class enrollment. If returned, you will be notified via email and a pop up message will appear when you log into GET. Return to your IAP and review the comments provided by your advisor. Then make the necessary changes. Finally, resubmit for an advisor to again review. Once you receive approval via email or pop up message in GET, the IAP will be dated and stamped on the PDF you viewed before, and Individualized Advisement Plan will be removed from your To Do List. Congratulations, you re done! From here, you will continue to enroll and complete the courses necessary to graduate as planned. Note: the IAP does not automatically enroll you in courses. Please follow usual procedures for class enrollment. If you have decided to change to the new semester system requirements (Fall 2016 catalog year) for University and/or major requirements, work with your advisor to change your catalog year(s). Make sure to check your Degree Progress Report (CAAR) in GET to verify that your requirements have officially changed to semester system requirements. 11
*** If you re in need of assistance, please contact an advisor. You may locate an advisor by contacting your major department. Visit www.calstatela.edu/semestertransition-advising, or call the Office of Semester Conversion at (323) 343-5054. 12